HT201210 hey my iphone software died and everytime i restore it ,it fails please help me
hey my iphone software died and every time i restore it , it fails please help me
i get an erorr telling me the iphone could not be restored
State the exact error message, including any numbers.
Similar Messages
-
Hi all,
I lost all data in my iphone when I was trying delete unwanted contents. my iphone is blank and I cant start it or switch it off. It only starts automatic once I switch it to the power outlet and cant switch it off when it has power.
Please how can i restore all the settings.
LochPut it in recovery mode and restore it: http://support.apple.com/kb/ht1808.
-
Help please I changed my passcode and must've clicked different numers than I thought becuase now I've tried the wrong passcode so many times it just says connect to itunes. So i plugged my phone into my computer but it says the iphone is locked and I need to enter the passcode! what should i do!?
No problem! Just follow these instructions-
turn your device completely off
UnPlug it from your computer
Hold the home button (square button)
Plug your device into computer while still holding the home button
Hold until iTunes says it detected a device in recovery mode
Hit restore at the top
Done! -
My iphone completely blackout and the phone keep vibrating. how? please help...thanks.
My iphone blackout suddenly and the phone keep vibrating. please help !!! thanks
Try resetting your iPhone by pressing the home and sleep buttons until you see the Apple logo, ignoring the slider. Takes about 5-15 secs of button holding and you won't lose any data or settings.
-
I woke up this morning - xmas day of all days and had a message on my phone that it needed to be restored via itunes. I connected it to my laptop and it tried to restore but failed at the point of iphone firmware update. I have back-ups etc - I have tried it on two different laptops and have tried at least 10 times but keeps failinhg at the same point - has anyone else had this and found a cure or is the phone dead. Its on ios 6.0.0.1
Error -1 could indicate a hardware issue. You may need to take the device to an Apple Store and have it looked at
Read here > http://support.apple.com/kb/TS3694
Sorry for the bad news -
I have been using my appletv for the last 4 months, gone to ue it today and the airplay icon dose not appear on me ipad2 running iso5 where is has been. I have also tried on my iphone 4 running iso 5 and again no joy.
I have compleated a soft reset on all devices and checked that they are all conected to the same wifi which they are.
Can you HelpThanks Winston, restarting my router worked for me too. Seems that somehow the DCHP (maybe due to the Mountain Lion upgrade?) had assigned the same IP address to both the AppleTV and my iMac. The AppleTV stopped appearing as an AirPlay device for my iPhone and Mac, but still the AppleTV had Internet access.
Restarting the router reassigned IPs and without fanfare, the AppleTV is now available to AirPlay. -
HT201263 iPod touch 4th gen is stuck in recovery mode and won't restore with iTunes. Please Help!
I had jailbroken my ipod touch then decided it didnt do much of anything, so I decided to restore my ipod. But itunes didnt finish the restore and left me in recovery mode. Now it says iTunes has detected an ipod in recovery mod, but when I try to restore it, it says something like could not connect to apple restore firm and I'm back to square one.
Any Help is appreciated!Jailbreaking
Jailbreaking voids the Apple warranty and also means that you will not get any support from Apple, including from this Apple forum. Jailbreaking can't be discussed in this Apple forum.
Unauthorized modification of iOS has been a major source of instability, disruption of services, and other issues
Try DFU mode and then restore
How to put iPod touch / iPhone into DFU mode « Karthik's scribblings
Try on another computer -
Does anyone know how to make an appointment with a genius on the net please? Also is there a chat room that can be accessed on the net? My iphone has died and I desperately need to take it in to get fixed/replaced. I can't find anything..............help!!!
Apple Retail Store - Genius Bar
What kind of chat room?
Have you tried basics from the manual? restart, reset, restore -
My iPhone 4G died and will not turn on with hard reset.
My iPhone 4G died and will not turn back on. I got an e-mail and then took a phone call. After ending the call I went to text, but nothing. Screen was black with no warning. I plugged it up on a charger and nothing. I tried a soft rest and a hard reset and still nothing. I have it plugged up to my computer and without it coming on it will not recognize it on iTunes to do a restore. Any ideas or help would be greatly appreciated. Is this fixable or should I write it off and replace the phone? It is 1yr and 1 month old.
Thanks,
JohnIt's been a day and no luck, so I guess I have to get a new battery?
-
My hotmail account will not verify on my iPhone at all and everytime I go on the web to sign in it says page not found
You need to turn off find my ipad in settings
Then restore to factory settings ipad will then be
as new then enter you Apple ID and password
bsydd uk -
I up graded my iPhone software yesterday and now I am not getting personal hotspot. Can any one help?
Did you check for a carrier settings update?
Copied from iOS: System requirements for Personal Hotspot
To confirm that your iPhone or iPad Wi-Fi + 4G can share its cellular data connection using Personal Hotspot, tapSettings > General > Network > Personal Hotspot.
If you don't see this option and your carrier supports this feature, check for a carrier settings update. If you still cannot enable this feature, contact your carrier for additional information. -
My iPhone 4 died and I have tried charging it and plugging it into the computer, but nothing happens execpt the dead battery thing that pops up when you charge it when it's completely dead.
Try:
- iOS: Not responding or does not turn on
- Also try DFU mode after try recovery mode
How to put iPod touch / iPhone into DFU mode « Karthik's scribblings
- If not successful and you can't fully turn the iOS device fully off, let the battery fully drain. After charging for an least an hour try the above again.
- Try another cable
- Try on another computer
- If still not successful that usually indicates a hardware problem and an appointment at the Genius Bar of an Apple store is in order.
Apple Retail Store - Genius Bar -
I just transfer the new software to my iphone 4 and now it has no network. Please help me
I just transfer the new software to my iphone 4 and now it has no network. Please help me
I don't know what really happened and why and how it 'came back to normal again' but thank you so much you guys. I'm new at this, as you may seen, and i'm portuguese, and my english is terrible. you reallyyyyy helped me, i has just almost having an heart attack. This was my b-day gift and here in portugal apple stuff are very expensive (at least for me)
-
HT1688 My iphone 4S died and will not charge. It is just dead!
My iphone 4S died and it will not charge or turn on. It it totaly dead. Any tips on bringing it back to life. It is 2 years old.
Hi there HeatherC12,
You may find the troubleshooting steps in the article below helpful.
iPhone: Hardware troubleshooting
http://support.apple.com/kb/ts2802
Will not turn on, will not turn on unless connected to power, or unexpected power off
Verify that the Sleep/Wake button functions. If it does not function, inspect it for signs of damage. If the button is damaged or is not functioning when pressed, seek service.
Check if a Liquid Contact Indicator (LCI) is activated or there are signs of corrosion. Learn about LCIs and corrosion.
Connect the iPhone to the iPhone's USB power adapter and let it charge for at least ten minutes.
After at least 30 minutes, if:
The home screen appears: The iPhone should be working. Update to the latest version of iOS if necessary. Continue charging it until it is completely charged and you see this battery icon in the upper-right corner of the screen . Then unplug the phone from power. If it immediately turns off, seek service.
The low-battery image appears, even after the phone has charged for at least 20 minutes: See "iPhone displays the low-battery image and is unresponsive" symptom in this article.
Something other than the Home screen or Low Battery image appears, continue with this article for further troubleshooting steps.
If the iPhone did not turn on, reset it while connected to the iPhone USB power adapter.
If the display turns on, go to step 4.
If the display remains black, go to next step.
Connect the iPhone to a computer and open iTunes. If iTunes recognizes the iPhone and indicates that it is in recovery mode, attempt to restore the iPhone. If the iPhone doesn't appear in iTunes or if you have difficulties in restoring the iPhone, see this article for further assistance.
If restoring the iPhone resolved the issue, go to step 4. If restoring the iPhone did not solve the issue, seek service.
Issue not resolved
My issue is still not resolved. What do I do next?
Contact Apple Support.
-Griff W. -
my iphone 5 died and when i went to plug it in to charge the apple sign came up and it wont go away it has been stuck for 2 hours. i cant turn it off because my lockbutton is broke. what do i do?
Make an appointment at an Apple Store to have your device examined by a technician. Or contact Apple Support. Get your lock button fixed then you can restore your phone.
Maybe you are looking for
-
Is there a confirmed release date for the itouch 5g?
-
Trusted sites in safari in maverick
Ever site from my book markers when go on them I get is this a trusted site, what gives?????
-
What is the best approach to capture TBOM's for a SAP SRM system/functionality?
Hello SCN Community, It would be much appreciated if somebody could share some information about the following.... What is the best approach to create TBOM's for a SAP SRM system? The SRM functionality is basically consisting out of multiple ABAP Web
-
Hi there, I have a form based on a table that contains several Select LOV's with Submit and I have set everything to only go to source if value is null etc. The form works without errors. My problem is however that if I change/make a selection using
-
hi guru's, i have design a payslip in PE51 but problem is that i dont know how and where i will include it or how i'll call it? can anyone please tell me step by step procedure? its urgent. regards nitin.