HT201210 how to put ipod in recovery mode

all my ipod does is show connect to itunes

If not successful, try placing the iPod in in DFU mode and then restore via iTunes.
How to put iPod touch / iPhone into DFU mode « Karthik's scribblings

Similar Messages

  • How to put ipod in recovery mode without a home button ???

    how to put ipod in recovery mode without a home button and i cant get in to my devise what can i do ???????????

    Place the iPod in recovery mode using one of these programs:
    For PC
    RecBoot: Easy Way to Put iPhone into Recovery Mode
    or
    http://joshuabailey1997.wordpress.com/2010/09/02/recboot-v1-3/
    If necessary:
    Download QTMLClient.dll & iTunesMobileDevice.dll for RecBoot
    and                                           
    RecBoot tip
    RecBoot may have problems on 64X windows, then try:       
    Tenorshare ReiBoot – Enter & Exit iPhone, iPad, iPod Recovery Mode with a Single Click
    For MAC or PC       
    The Firmware Umbrella - TinyUmbrella
    Installs blootware on PC too

  • I found my old ipod and i forgot the passcode. It doesnt have an home button so i dont know how to put it in recovery mode so i can restore it. Ive been using the assisted touch method. But what should i do to put it in recovery mode

    i found my old ipod and i forgot the passcode. It doesnt have an home button so i dont know how to put it in recovery mode so i can restore it. Ive been using the assisted touch method. But what should i do to put it in recovery mode so i can restore it.

    Use this program to place the iPod in recovery mode
    RecBoot: Easy Way to Put iPhone into Recovery Mode

  • Ok im trying to put ipod in recovery mode went through all the steps but when the itunes and ubs icon comes up nothing happens ?

    ok i am trying to put my ipod in recovery mode but when the itunes and ubs icon comes up on the ipod im not sure what to do next how do i connect ?

    You then have to connect the iPod to your computer and restore via iTunes.
    iTunes: Backing up, updating, and restoring iOS software

  • How do I put ipod in recovery mode?

    I am locked out of my IPOD touch as my kids put a passcode on it and now I have to connect it to I tunes but I dont understand this all

    Options for when an iOS device gets locked because of forgotten passcode:
    Restore (and reset passcode) on your device by connecting it to the last computer to which it was connected:
    iTunes: Backing up, updating, and restoring iOS software - http://support.apple.com/kb/HT1414  ( https://discussions.apple.com/thread" - A restore erases the iPod. If you restore from backup the iPod will be like it was IF the iTunes library includeds all the synced media like apps and music since those are not included in the backup.")
    If you cannot connect it to the computer to which the device was last connected (or the device was never connected to a computer) you will have to use recovery mode to completely reset the device, losing all data:
    iOS: Unable to update or restore - http://support.apple.com/kb/HT1808 - recovery mode (e.g., cannot connect to computer last used to sync device, iTunes still asks for a password)

  • Itunes put ipod into recovery mode. how do i get out

    I was updateing my ipod and then my plug came out of the ipod. Now it says its in recovery mode and i have to restore it. Is there any way i can get out of recovery mode so i wont lose pictures and videos?

    If this program will not get the iPod out of recovery mode you will have to restore via iTunes and erase the iPod.

  • How to pu ipod in recovery mode

    i don't know how to put my ipod into recovery mode

    See this: http://support.apple.com/kb/HT1808

  • Put ipod in recovery mode fix w/o restoring?

    is it possible to get out of recovery mode with out having to restore?

    i did it! just hold the home and power button till the apple appears!! whooO!!!!!!!!!! no points for you but thanks anyway!

  • How to put your ipod in recovery mode

    how do i put my ipod in recovery mode because i forget my password

    See:
    iOS: Unable to update or restore

  • HT201263 how do i put the ipod in recovery mode

    How do i put the ipod in recovery mode so that i can unlock it... Thank you

    If You Are Locked Out Or Have Forgotten Your Passcode or Just Need to Restore Your Device
    iTunes 10 for Mac- Update and restore software on iPod, iPhone, or iPad
    iPhone, iPad, iPod touch: Wrong passcode results in red disabled screen
    iOS- Understanding passcodes
         If you have forgotten your Restrictions code, then follow the instructions
         below but DO NOT restore any previous backup. If you do then you will
         simply be restoring the old Restrictions code you have forgotten. This
         same warning applies if you need to restore a clean system.
    A Complete Guide to Restore or Recover Your iDevice (if You Forget Your Passcode)
    If you need to restore your device or ff you cannot remember the passcode, then you will need to restore your device using the computer with which you last synced it. This allows you to reset your passcode and re-sync the data from the device (or restore from a backup). If you restore on a different computer that was never synced with the device, you will be able to unlock the device for use and remove the passcode, but your data will not be present. Refer to Updating and restoring iPhone, iPad and iPod touch software.
    Try restoring the iOS device if backing up and erasing all content and settings doesn't resolve the issue. Using iTunes to restore iOS devices is part of standard isolation troubleshooting. Restoring your device will delete all data and content, including songs, videos, contacts, photos, and calendar information, and will restore all settings to their factory condition.
    Before restoring your iOS device, Apple recommends that you either sync with iTunes to transfer any purchases you have made, or back up new data (data acquired after your last sync). If you have movie rentals on the device, see iTunes Store movie rental usage rights in the United States before restoring.
    Follow these steps to restore your device:
         1. Verify that you are using the latest version of iTunes before attempting to update.
         2. Connect your device to your computer.
         3. Select your iPhone, iPad, or iPod touch when it appears in iTunes under Devices.
         4. Select the Summary tab.
         5. Select the Restore option.
         6. When prompted to back up your settings before restoring, select the Back Up
             option (see in the image below). If you have just backed up the device, it is not
             necessary to create another.
         7. Select the Restore option when iTunes prompts you (as long as you've backed up,
             you should not have to worry about restoring your iOS device).
         8. When the restore process has completed, the device restarts and displays the Apple
             logo while starting up:
               After a restore, the iOS device displays the "Connect to iTunes" screen. For updating
              to iOS 5 or later, follow the steps in the iOS Setup Assistant. For earlier versions of
              iOS, keep your device connected until the "Connect to iTunes" screen goes away or
              you see "iPhone is activated."
         9. The final step is to restore your device from a previous backup. If you do not have a
              backup to restore, then restore as New.
    If you are restoring to fix a forgotten Restrictions Code, then skip Step 9 and restore as New.
    If you really do need to put it in recovery mode (DFU):
    Placing your device into recovery mode:
    Follow these steps to place your iOS device into recovery mode. If your iOS device is already in recovery mode, you can proceed immediately to step 6.
       1. Disconnect the USB cable from the iPhone, iPad, or iPod touch, but leave the
           other end of the cable connected to your computer's USB port.
       2. Turn off the device: Press and hold the Sleep/Wake button for a few seconds
           until the red slider appears, then slide the slider. Wait for the device to turn off.
                  * If you cannot turn off the device using the slider, press and hold the
                    Sleep/Wake and Home buttons at the same time. When the device turns off,
                    release the Sleep/Wake and Home buttons.
      3. While pressing and holding the Home button, reconnect the USB cable to the
           device. The device should turn on. Note: If you see the screen pictured below,
           let the device charge for at least ten minutes to ensure that the battery has some
           charge, and then start with step 2 again.
      4. Continue holding the Home button until you see the "Connect to iTunes" screen.
           When this screen appears you can release the Home button:
      5. If necessary, open iTunes. You should see the following "recovery mode" alert:
      6. Use iTunes to restore the device.
    If you don't see the "Connect to iTunes" screen, try these steps again. If you see the "Connect to iTunes" screen but the device does not appear in iTunes, see this article and its related links.
    Additional Information:
    Note: When using recovery mode, you can only restore the device. All user content on the device will be erased, but if you had previously synced with iTunes on this computer, you can restore from a previous backup. See this article for more information.

  • My ipod touch has been disabled for 22 million minute. i cant put it into recovery mode because my lock button doesnt work. how do i fix it??? please help

    please help

    If you cannot remember the passcode, you will need to restore your device using the computer with which you last synced it. This allows you to reset your passcode and resync the data from the device (or restore from a backup).
    If you restore on a different computer that was never synced with the device, you will be able to unlock the device for use and remove the passcode, but your data will not be present.
    You may have to force iPad/iPod into Recovery Mode
    http://support.apple.com/kb/ht4097

  • I have an ipod 5g and when i turn it on it stays on the apple screen and i have put it into recovery mode and restored it twice but i cant get it to work

    i need my ipod but i have been up for hours looking up what to do and trying to fix it but i dont know waht to do it just gets stuck on the apple screen. PLEASE HELP!!!!

    Try:
    - iOS: Not responding or does not turn on
    - Also try DFU mode after try recovery mode
    How to put iPod touch / iPhone into DFU mode « Karthik's scribblings
    - If not successful and you can't fully turn the iOS device fully off, let the battery fully drain. After charging for an least an hour try the above again.
    - Try on another computer                            
    - If still not successful that usually indicates a hardware problem and an appointment at the Genius Bar of an Apple store is in order.
      Apple Retail Store - Genius Bar                              

  • HT1212 Im trying to put my ipod in recovery mode because it is disabled.  Nothing seems to happen when the ipod comes back on.

    Im trying to fix my son's ipod.  It is disabled.  Ive been trying the recovery method that is described but nothing happens.  Im not sure what to do next.

    If recovery mode does not work try DFU mode.
      How to put iPod touch / iPhone into DFU mode « Karthik's scribblings

  • My ipod is disabled i put it in recovery mode pluged it in itunes and it keep cutting off and going to the disabled screen what do i do

    my ipod is disabled i put it in recovery and hooked it up to itunes and pushed restore it would start downloading then after a while it cuts off and goes to the disabled screen what do i do to fix this i cant put my password in cause it wont let me
    P.S. i really need help my mom is getting really mad that i cant fix it

    Try placing in DFU mode and then restore.
    How to put iPod touch / iPhone into DFU mode « Karthik's scribblings

  • How to get out of recovery mode in ipod touch 4thgen?

    Hello Apple i am rohith. iam having ipod touch 4th gen. it has ios version 4.1. recently i tried to update it, i have downloaded the update also but while installing an errour has occured and it has gone to recovery mode. can u please give your answer how to get out of recovery mode. it has some imprtant notes belonging to my office

    Without knowing what the error message said:
    Try:
    - iOS: Not responding or does not turn on
    - Also try DFU mode after try recovery mode
    How to put iPod touch / iPhone into DFU mode « Karthik's scribblings
    - If not successful and you can't fully turn the iOS device fully off, let the battery fully drain. After charging for an least an hour try the above again.
    - Try on another computer          
    - If still not successful that usually indicates a hardware problem and an appointment at the Genius Bar of an Apple store is in order.
    Apple Retail Store - Genius Bar       

Maybe you are looking for

  • Getting error in transporting table ztable...

    HI i am getting the below error from basis whne moving a table and table maintainence.... the field error which is being given i already delted from table  and replaced with the corect one ie zcusemail-email_id but it is giving error of old one? why

  • Qosmio G10: DVD-R and DVD+RW are CDs when inserted

    When viewing my empty DVD drive via Windows Explorer, it displays "DVD-RAM Drive". When I put a blank DVD-R or DVD+RW (brand new Phillips) into the drive, the drive description immediately changes to "CD Drive", and I only get audio options. I have n

  • Problem on Join in ODI

    Hi, I'm working on a migration case as follows: I have 1 source table, 1 reference table and 1 target table (All are in ORACLE). While the interface execution, the source will join the reference to get the UID from the reference table (FK to the targ

  • Any way to Lock the Decoration Free Label in place so that the Clean Up Diagram process doesn't move it soemplace unreasonable?

    Any way to Lock the Decoration Free Label in place so that the Clean Up Diagram process doesn't move it soemplace unreasonable? The Clean Up Diagram process moves things to very strange places and often makes the diagram more complicated than it need

  • Transaction key KDM (OBYC) in Subcontracting scenario

    Hi gurus, Our client has the following scenario: KDM has been configured in OBYC for foreign exchange differences between GR and IR. The GL account maintained for KDM gets picked up when we do GR and IR for a standard PO. However, when we do a subcon