HT201210 im getting error code 1669, will not let me restore. I have already updated itunes on computer as suggested
I have tried to restore my phone, each time im getting so far then getting error 1669. I have re-installed itunes as suggested still no joy, is there anything else i can do?
Hi luvthesuns,
Thanks for using Apple Support Communities. Based on what you stated, it sounds like you are getting a few error codes. I would recommend that you read these articles, they may be helpful in troubleshooting your issue.
iTunes: Possible iTunes Store errors - Apple Support
iTunes Store reporting error 0x80090318
Apple software on Windows: May see performance issues and blank iTunes Store
Troubleshooting Home Sharing - Apple Support
Cheers,
Mario
Similar Messages
-
.I dont know what to do. I have windows XP.Latest version of iTunes.
Try recovery mode, as described here:
http://support.apple.com/kb/HT1808 -
Why do I get "error code 3: Could not load front panel" when I run my executable.
I have a LV 8.5 VI that controls only an agilent spectum analyzer. The agilent VIs call DLLs rather than SCPI commands. I created an application and an installer to load on a non LV machine and ran setup which was successful. When I run the EXE I get "error code 3: Could not load front panel" for each of my agilent spectrum analyzer VIs. I have to click "OK" about ten times, once for each VI. (My executable runs fine on all machines that have labview 8.5) The front panel does load with a broken arrow. The errors listed when the arrow is clicked for all of the Agilent VIs state: Missing subVI AGE444xInitialize.VI (or close.VI or read.VI etc.)
There is an AGE444x32.DLL in the data folder with the EXE file so I included as support both the DLL and all of the agilent drivers in the application build. Still no luck. I have built the application and installer about 6 times in various forms. I NEED AIR SUPPORT.
Unfortunately I do not have access to the internet at my jobsite so bear with me.
RobHi V-rob,
I'm glad to hear the executable is working now that NI-VISA is installed. Thanks for posting the solution!
Jennifer R.
National Instruments
Applications Engineer -
My phone will not let me restore it, I tried several times and when I install the frimware gets error and nothing is installed. What can I do?
My phone will not let me restore it, I tried several times and when I install the frimware gets error and nothing is installed. What can I do?
-
iPhone 4s will not turn on, a screen shows up telling me to connect to iTunes to restore and update to iOs7, but when I try to restore error 2001 comes up and will not let me restore. I still cannot turn my phone on. None of the troubleshooting tips work, help??
Error 20, 21, 23, 26, 28, 29, 34, 36, 37, 40
These errors typically occur when security software interferes with the restore and update process.
FollowTroubleshooting security software issues to resolve this issue.
In rare cases, these errors may be a hardware issue.
If the errors persist on another computer, the device may need service. -
TS3694 Why am I getting error code 3194 when i try to restore my ipod?
Why am I getting error code 3194 when I try to restore my ipod touch 4th generation
This device is not eligible for the requested build: Also sometimes displayed as an "error 3194." If you receive this alert, update to the latest version of iTunes. Third-party security software or router security settings can also cause this issue. To resolve this, follow Troubleshooting security software issues.
Downgrading to a previous version of iOS is not supported. If you have installed software to perform unauthorized modifications to your iOS device, that software may have redirected connections to the update server (gs.apple.com) within the Hosts file. First you must uninstall the unauthorized modification software from the computer, then edit out the "gs.apple.com" redirect from the hosts file, and then restart the computer for the host file changes to take affect. For steps to edit the Hosts file and allow iTunes to communicate with the update server, see iTunes: Troubleshooting iTunes Store on your computer, iPhone, iPad, or iPod—follow steps under the heading Blocked by configuration (Mac OS X / Windows) > Rebuild network information > The hosts file may also be blocking the iTunes Store. If you do not uninstall the unauthorized modification software prior to editing the hosts file, that software may automatically modify the hosts file again on restart. Also, using an older or modified .ipsw file can cause this issue. Try moving the current .ipsw file, or try restoring in a new user to ensure that iTunes downloads a new .ipsw.
Error 3194: Resolve error 3194 by updating to the latest version of iTunes. "This device is not eligible for the requested build" in the updater logs confirms this is the root of the issue. For more Error 3194 steps see: This device is not eligible for the requested build above.
http://support.apple.com/kb/TS3694#error3194
Also see:
iPhone Error 3194 - How to Fix iTunes Error 3194? -
I have just purchased an iMac which has no CD Drive, when I downloaded my Elements 8 from my external drive onto my new iMac I just get Error Code 150.30 does this mean that I have no way of retrieving my existing software?
According to Adobe instructions installation files are not available for Elements 8?
Languages
Mac OS X
Windows
English—International
English—Universal
German
Japanese
French
French—Canada
Chinese—China
Dutch
Italian
Portuguese—Brazil
Spanish
Spanish—Latin America
Spanish—North America
Swedish
Not available
File 1 of 2 (1.2 MB)
File 2 of 2 (1.1 GB) -
my ipod generation 5 will not come out of recovery mode. i was simply updating my software and this happened. it will not let me restore it comes up with and error. please help, thanks.
Hey erinoneill24,
Thanks for using Apple Support Communities.
Sounds like you can't update your device. You don't mention an error that it gives you. Take a look at both of these articles to troubleshoot.
iPod displays "Use iTunes to restore" message
http://support.apple.com/kb/ts1441?viewlocale=it_it
If you can't update or restore your iOS device
http://support.apple.com/kb/HT1808?viewlocale=de_DE_1
If you started your device in recovery mode by mistake, restart it to exit recovery mode. Or you can just wait—after 15 minutes the device will exit recovery mode by itself.
Have a nice day,
Mario -
iPhone 5, updating using iTunes, iphone could not be updated, error code 3014, iphone is in recovery mode, I have re-installed iTunes twice and each time got the same message
Error 3014
This error occurs when iTunes can't reach gs.apple.com in a timely fashion. Follow the steps below to contact the iOS software update server gs.apple.com. -
I have forgot my Iphone passcode. Itunes will not let me restore it, i do not have icloude,or find my iphone,and the closest itunes store is 4 hours away how can i unlock, or reset my phone?
Try this:
Placing your device into recovery (DFU-Device Firmware Upgrade) mode:
Follow these steps to place your iOS device into recovery mode. If your iOS device is already in recovery mode, you can proceed immediately to step 6.
1. Disconnect the USB cable from the iPhone, iPad, or iPod touch, but leave the
other end of the cable connected to your computer's USB port.
2. Turn off the device: Press and hold the Sleep/Wake button for a few seconds
until the red slider appears, then slide the slider. Wait for the device to turn off.
* If you cannot turn off the device using the slider, press and hold the
Sleep/Wake and Home buttons at the same time. When the device turns off,
release the Sleep/Wake and Home buttons.
3. While pressing and holding the Home button, reconnect the USB cable to the
device. The device should turn on. Note: If you see the battery charge warning,
let the device charge for at least ten minutes to ensure that the battery has some
charge, and then start with step 2 again.
4. Continue holding the Home button until you see the "Connect to iTunes" screen.
When this screen appears you can release the Home button:
5. If necessary, open iTunes. You should see the following "recovery mode" alert:
6. Use iTunes to restore the device.
If you don't see the "Connect to iTunes" screen, try these steps again. If you see the "Connect to iTunes" screen but the device does not appear in iTunes, see this article and its related links.
Additional Information:
If you have a problem getting into recovery mode then try: RecBoot: Easy Way to Put iPhone into Recovery Mode.
Note: When using recovery mode, you can only restore the device. All user content on the device will be erased, but if you had previously synced with iTunes on this computer, you can restore from a previous backup. See this article for more information. -
Time Machine will not let me restore from backups after June, 2013. I can see the files on the external hard drive but Time Machine skips all of them and goes back to June, 2013. Does anyone have any idea what the problem is?
rtilghman wrote:
telling me to buy a new router is NOT a solution.
And why not? Apple is selling these things like BigMacs. They can't make enough of them. You've been suffering since May because you refuse to get a decent router.
Can you imagine if a company that makes a refrigerator told me that I needed to upgrade my electrical system to rectify a problem with their device? What kind of response IS that?!?!
What if the problem with their device is that it requires a new-fangled "grounded" outlet and your circa 1890 house doesn't have grounded outlets. Would you refuse to purchase a $ 25 adapter on principle? -
Will not let me log in, first time installing on this computer.
Will not let me log in, first time installing on this computer.
What is the error message you see when it will not let you log in... is it one of the below problems?
Sign Out When Sign In http://forums.adobe.com/thread/1450581?tstart=0 may help
-and http://helpx.adobe.com/creative-cloud/kb/unable-login-creative-cloud-248.html
And, just in case you ever have this problem...
BLANK Cloud Screen http://forums.adobe.com/message/5484303 may help
-and step by step http://forums.adobe.com/thread/1440508?tstart=0
-and http://helpx.adobe.com/creative-cloud/kb/blank-white-screen-ccp.html
Mac Spinning Wheel https://forums.adobe.com/message/5470608
-Similar in Windows https://forums.adobe.com/message/5853430 -
it seems my iphone 3GS has lost all software.. it will not let me restore the firmware on itunes? what is the best thing to do?
Any error numbers given?
If yes, check this article:
Update and restore error messages on iPhone and iPod touch
Has any modified software been installed before you updated?
Unauthorized modification of iOS has been a major source of instability, disruption of services, and other issues -
My phone will not let me download the most recent update for iOS 7.1. It says I need a wifi connection and will not allow me to push the 'Download & Install' button, even when I am at home and my wifi is on. How do I fix this?
Unfortunately yes, though technology would never move on if it kept to older standards and did not strive to do more.
The app store always gives you the option to use a previous version of the app IF it is available for your device.
Sorry but you are stuck without new hardware.
PJRS
Maybe you are looking for
-
How to upload site created with Dreamweaver via FTP to the iWEB server?
Hi everyone, I recently created a site on Dreamweaver and want to upload the site, via FTP to the iWEB server. My questions are the following: 1. What is the FTP host address? 2. How do I connect to my website via FTP? Any help on the following quest
-
Need help with resolution problem
I previously used Vista/PSE6/HP1200 laserjet to print B&W photographs on transparencies. The photographs were very high quality -- you couldn't see the pixels. My computer crashed, and now I'm using Windows 7/PSE8/the same HP1200 laserjet. No matte
-
This question is tricky let's see who answers it right - monica give it try... Q1. If i have three trigger written at the block level namely- pre-delete pre-insert pre-update and then i do three operations update,delete and insert onthe table what wi
-
My iMac had a Trojan Horse virus and I had to reformat and install it's OS again. Now I cannot download any of my video's that I purchased from the iTunes store of Amerian Idol in 2009. How could I get them back? Thanks in advance for your help.
-
I have a project with a few vids on it. What setting do I have to have in Standard mode that would play my 16:9 vids on a regular 4:3 screen (ie full view with the black bars on top and bottom.)