HT201210 My iphone is in recovery mode and it won't open help
I tried to install the new version of iOS via itunes and at the end of the installing it stopped and showed an error massage says "iphone couldnt be stored error (14)" and now my iphone is in recovery mode I tried to open it with DFU mode but it didnt work out HELP
What "new version" of iOS did you attempt to install, exactly?
Here is troubleshooting information specifically for the error 14 you mentioned: http://support.apple.com/kb/ts3694#error14
Error 13, 14, 35 and 50 (or -50)
These errors are typically resolved by performing one or more of the steps listed below:
Perform USB isolation troubleshooting, including trying a different USB port directly on the computer. See the advanced steps below for USB troubleshooting.
Put a USB 2.0 hub between the device and the computer.
Try a different USB 30-pin dock-connector cable.
Eliminate third-party security software conflicts.
There may be third-party software installed that modifies your default packet size in Windows by inserting one or more TcpWindowSize entries into your registry. Your default packet size being set incorrectly can cause this error. Contact the manufacturer of the software that installed the packet-size modification for assistance. Or, follow this article by Microsoft: How to reset Internet Protocol (TCP/IP) to reset the packet size back to the default for Windows.
Connect your computer directly to your Internet source, bypassing any routers, hubs, or switches. You may need to restart your computer and modem to get online.
Try to restore from another known-good computer and network.
Similar Messages
-
HT201210 my iphone is in recovery mode and wont turn on?
my iphone is in recovery mode and wont turn on?
recovery mode
open itunes on computer
plug cable into computer not iOS device
turn device off
hold home button and plug cable into IOS device. do not release home button until an itunes graphic appears on IOS device.
look to computer should have message about recovery mode click ok and restore
Peace, Clyde
if u need an article see
http://support.apple.com/kb/HT1808 -
HT201210 my iPhone is in recovery mode and iTunes gives me a error 2001 when I'm trying to fix it
and everything is up to date need help
Hi djsparxx,
If you are having issues restoring your iPhone, you may find the following article helpful:
Apple Support: If you can't update or restore your iOS device
http://support.apple.com/kb/ht1808
Regards,
- Brenden -
HT201210 my iPhone is in recovery mode and iTunes can fix it and i have an error number 17
what i can do
Hi djsparxx,
If you are having issues restoring your iPhone, you may find the following article helpful:
Apple Support: If you can't update or restore your iOS device
http://support.apple.com/kb/ht1808
Regards,
- Brenden -
pls. help my iPhone stuck in recovery mode and iTunes wont recognize it..i tried the other options that posted here,,,pls tell me what to do..before it was just stuck in an apple logo but when i tried recovery mode to itunes then it stuck..
Hi awison,
If your iPhone is not recognized by iTunes on your Windows computer you may want to use the steps in this article to troubleshoot -
iOS: Device not recognized in iTunes for Windows
http://support.apple.com/kb/TS1538
This may also resolve your recovery mode issue. If it does not, use the steps in this article to resolve it -
Use iTunes to restore your iOS device to factory settings
http://support.apple.com/kb/HT1414
Thanks for using Apple Support Communities.
Best,
Brett L -
Hi, my iphone its in recovery mode and when i restore my iphone 5s loading show the blue screen and show note on itunes (unknown error 14) please i need your help please . thanks
In the article Resolve iOS update and restore errors this is what it says about error 14:
Check your USB connections
Related errors: 13, 14, 1600, 1601, 1602, 1603, 1604, 1611, 1643-1650, 2000, 2001, 2002, 2005, 2006, 2009, 4005, 4013, 4014, or “invalid response."
If the USB connection between your device and computer is interrupted, you may be unable to update or restore.
To narrow down the issue, you can also change up your hardware:
Use the USB cable that came with your device, or a different Apple USB cable.
Plug your cable into a different USB port directly on your computer. Don't plug it into your keyboard.
Try a different computer.
If necessary, resolve any further issues with the USB connection, then with your security software.
If you're still seeing the error message, check for hardware issues by following the next section. -
i tried to up date my i phone 4 to iOS 5 then it wiped my phone and now it tells me to connect to iTunes and that the iPhone is in recovery mode and when i connect it goes to preparing to install to iPhone but never goes any further how do i restore the phone
by reset option do you mean the DFU restore? worked for me, have you tried that?
if not - hold the lock and home button until the power down bar comes up. then hold the lock button for ten seconds - next continue to hold the lock button and press the home button for ten seconds - next release the lock button and hold the home button for 10 seconds. this should be done with the phone tethered. If done right and your itunes is configured as such, the phone will reload the drivers and start up itunes, and then prompt for a restore/update. -
my iphone is on recovery mode and i can´t turn on it, when i try to recover it from itunes i get: unknown error (36), i´ve tried to do lot of things but i can´t solve my problem. please help!!
Hi, i had the same problem. Try to find the file "apple" or "itunes" don't know it anymore exactly. Ahm well you need to delet any information or just plug in your iphone into an other computer. important is that your iphone never has been pluged in this computer before. This was what i did, and it worked!
-
My iphone4 has been stuck on the connect to itunes logo for a few hours. I connected it to itunes and it says that the iphone is on recovery mode and that I need to restore it to use it with itunes. I'm afraid that if I restore it I will loose everything help please!!
AT this point whatever data you have on yoru phone is already gone since it is in recovery mode.
However you can restore from your backup, when your phone reboots from recovery.
YOu do have a backup right? -
my iphone is in recovery mode and when i try to restore it, its doesn't go all the way threw this happen right after i try to upgrade my phone. what do i do HELP ME!!!
Hi, are you doing it through Settings or via iTunes? If doing it through Settings, try plugging it in via USB and updating with iTunes. Hope this helps.
-
It says that my iphone is in recovery mode and needs to restore. (it is an ipod touch)
It says that my iphone is in recovery mode and i need to restore it, but it isan ipod touch. I cannot restore it because itunes is telling me that the software for the iphone is not currently available. Do I download the software for an iphone?
this happened to me a while ago and im not sure wht to do
-
I try to update my iphone 4 to ios 7.1.1. But now my iphone stucks in recovery mode and can't connect to itune. i use windows 7
Try the iTunes troubleshooting advice here:
Windows - http://support.apple.com/kb/ts1538 -
help me
My iPhone is in recovery mode and I do not see it on my laptop and on iTunes. Moreover, I can not turn it off and when I try it comes up all the time in the recovery mode.Hey Yan Heng,
Thanks for the question. It sounds like your iOS device is not recognized in iTunes for Windows, while in recovery mode. The following resource may help to resolve your issue. While you should run through each step, the specific information related to your symptom is outlined in Step 5 (If the device is not recognized while in Recovery Mode).
iOS: Device not recognized in iTunes for Windows
http://support.apple.com/kb/TS1538
Thanks,
Matt M. -
My Iphone is in recovery mode and won't restore, what do I do?
My Iphone is in recovery mode and won't restore, what do I do?
Hi ...
Try here > iOS: Unable to update or restore
Cute user name -
I have a iPhone 4 in recovery mode and it will not restore to factory settings.
I have a iphone 4 in recovery mode and it will not restore to factory settings. I get the error message error 21 and 2001. What can I do? I have tried all the steps.
Alextails998 wrote:
I have tried all the steps.
All what steps?
Did you go through the troubleshooting information here: http://support.apple.com/kb/TS3694?viewlocale=en_US&locale=en_US
Check for hardware issues
Related errors: 1, 3, 10, 11, 12, 13, 14, 16, 20, 21, 23, 26, 27, 28, 29, 34, 35, 36, 37, 40, 1000, 1002, 1004, 1011, 1012, 1014, 1667, or 1669.
Try to restore your iOS device two more times while connected with a cable, computer, and network you know are good. Also, confirm your security software and settings are allowing communication between your device and update servers. If you still see the error message when you update or restore, contact Apple support.
and
Check USB connections
Related errors: 13, 14, 1600, 1601, 1602, 1603, 1604, 1611, 1643-1650, 2000, 2001, 2002, 2005, 2006, 2009, 4000, 4005, 4013, 4014, 4016, “invalid response,” and being prompted to restore again after a restore completes.
If there’s an issue with the USB port, cable, dock, or hub, or if the device becomes disconnected during restore, try troubleshooting the USB connection, then troubleshooting your security software.
To narrow down the issue, you can also change up your hardware:
Use another USB cable.
Plug your cable into a different USB port on your computer.
Try a different dock connector (or no dock).
Add (or remove) a USB hub between your device and computer.
Connect your computer directly to your Internet source, with no routers, hubs, or switches.
If you checked your connections and are still seeing the error message, check for hardware issues.
If so, then it's a hardware problem. Make an appointment at the genius bar and get it replaced. Based on the "it was water damaged", I think it's a safe bet that it's toast.
Maybe you are looking for
-
Wifi syncing iPhone - what's the point
While it's mildly useful syncing your iPhone with your computer wirelessly, it doesn't really blow me away. Here's why. I still have to go to my computer to add new content or create new playlists to include new content (added through a smart 'recent
-
Lightbox works on computer but not on web...
Help! I have used Lightbox2 and other lightboxes before, so I am a little used to how they work. I wanted to not clutter my site any more than necessary, and so I left the Lightbox files in the original Lightbox2 folder; my files are outside the fold
-
We are tyring to deploy a simple application using form-based authentication on iPlanet Application Server 6.0 SP 2. The login form shows up, however regardless of userid/password entered we get the following error: // on the screen GX Error (GX2GX)
-
Pricing date control for new tax code rate
Hi All I have changed the tax code rate , now have few old POs where I want to capture tax as per the new rate. But PO was picking up old tax rate as pricing date was coming as the PO creation date. Now I changed the pricing date in PO to current dat
-
Upgrade to Photoshop CS6 from CS3
Hi, I had bought Photoshop CS3 sevaral years ago and used it for little bit and did not used it since and upgraded my computer, so no longer have the Photoshop on my computer. I lost the serial # during the move to another state.(not the only thing I