HT201263 my ipad restart repeatedly and cant stop it restarting. what can i do? pls help me.
my ipad restart repeatedly and it cant stop from that. what can i do pls help me.
iPad: Basic troubleshooting
http://support.apple.com/kb/TS3274
iTunes: Specific update-and-restore error messages and advanced troubleshooting
http://support.apple.com/kb/TS3694
Cheers, Tom
Similar Messages
-
my kids entered the passcode several times wrong and now it is disabled and written on it"connect to itunes" , when i did connect it to itunes it said "can not connect to ipad because it is locked with a passcode" what can i do pls?
You may need to put the iPad into recovery mode : http://support.apple.com/kb/ht1808 - you should then be able to reset the iPad and restore/resync your content to it.
If you do it via a different computer that it's not normally synced to then (from here) :
If you restore on a different computer that was never synced with the device, you will be able to unlock the device for use and remove the passcode, but your data will not be present. -
Ipad is disabled and forgotten pin number. What can I do??
Ipad is disabled and forgotten pin number. What can I do??
You have to restore the device within iTunes. You want to use the same computer that you always sync with so that you can restore your iTunes content. You can restore with any other computer, but you will lose everything on the iPad.
Instructions can be found here.
http://support.apple.com/kb/ht1212
You will probably need to restore using Recovery Mode. You can read about it here.
http://support.apple.com/kb/ht4097
Or you can follow these Recovery Mode Instructions
Disconnect the USB cable from the iPad, but leave the other end of the cable connected to your computer's USB port.
Turn off iPad: Press and hold the Sleep/Wake button for a few seconds until the red slider appears, then slide the slider. Wait for iPad to turn off.
If you cannot turn off iPad using the slider, press and hold the Sleep/Wake and Home buttons at the same time. When the iPad turns off, release the Sleep/Wake and Home buttons.
While pressing and holding the Home button, reconnect the USB cable to iPad. When you reconnect the USB cable, iPad should power on.
Continue holding the Home button until you see the "Connect to iTunes" screen. When this screen appears you can release the Home button.
If necessary, open iTunes. You should see the recovery mode alert that iTunes has detected an iPad in recovery mode.
Use iTunes to restore iPad. -
My iPad is 2 years old and it stop rotatating. What can I do?
My iPad does not rotate. What can I do?
Make sure rotation lock is not turned on. Depending on how its set up, it is either in Control center, or using the side switch.
If roattion lock is not on, try a reset.
Hold down on the Home and power/sleep buttons at the same time until the Apple Logo shows up. Let the iPad reboot. No data should be lost. -
i have bought a second hand iphone 4s and when i tied to boot up on i tunes says lost by owner tried every thing i can but cant contact any one any ideas please
In this case the owner of the phone should get notified automatically.
-
Hallo i cant active my ipod i forget icloud id but i am owner what can i do pls help
i just remaber some litters aooa and agga
and i use this apple id [email protected]
pls helpYou have to recover use of the ID
Is there a way to find my Apple ID Name if I can't remember it?
Yes. Visit My Apple ID and click Find your Apple ID. See Finding your Apple ID if you'd like more information.
How do I change or recover a forgotten Apple ID Password?
If you've forgotten your Apple ID Password or want to change it, go to My Apple ID and follow the instructions. SeeChanging your Apple ID password if you'd like more information.
If you have the Apple sales receipt Apple will help
Contact iTunes -
forgot password on ipad air and cant sync with itunes what can i do ?
How can I unlock my iPad if I forgot the passcode?
http://www.everymac.com/systems/apple/ipad/ipad-troubleshooting-repair-faq/ipad- how-to-unlock-open-forgot-code-passcode-password-login.html
iOS: Device disabled after entering wrong passcode
http://support.apple.com/kb/ht1212
How can I unlock my iPad if I forgot the passcode?
http://tinyurl.com/7ndy8tb
How to Reset a Forgotten Password for an iOS Device
http://www.wikihow.com/Reset-a-Forgotten-Password-for-an-iOS-Device
Using iPhone/iPad Recovery Mode
http://ipod.about.com/od/iphonetroubleshooting/a/Iphone-Recovery-Mode.htm
You may have to do this several times.
Saw this solution on another post about an iPad in a school environment. Might work on your iPad so you won't lose everything.
~~~~~~~~~~~~~
‘iPad is disabled’ fix without resetting using iTunes
Today I met my match with an iPad that had a passcode entered too many times, resulting in it displaying the message ‘iPad is disabled – Connect to iTunes’. This was a student iPad and since they use Notability for most of their work there was a chance that her files were not all backed up to the cloud. I really wanted to just re-activate the iPad instead of totally resetting it back to our default image.
I reached out to my PLN on Twitter and had some help from a few people through retweets and a couple of clarification tweets. I love that so many are willing to help out so quickly. Through this I also learned that I look like Lt. Riker from Star Trek (thanks @FillineMachine).
Through some trial and error (and a little sheer luck), I was able to reactivate the iPad without loosing any data. Note, this will only work on the computer it last synced with. Here’s how:
1. Configurator is useless in reactivating a locked iPad. You will only be able to completely reformat the iPad using Configurator. If that’s ok with you, go for it – otherwise don’t waste your time trying to figure it out.
2. Open iTunes with the iPad disconnected.
3. Connect the iPad to the computer and wait for it to show up in the devices section in iTunes.
4. Click on the iPad name when it appears and you will be given the option to restore a backup or setup as a new iPad (since it is locked).
5. Click ‘Setup as new iPad’ and then click restore.
6. The iPad will start backing up before it does the full restore and sync. CANCEL THE BACKUP IMMEDIATELY. You do this by clicking the small x in the status window in iTunes.
7. When the backup cancels, it immediately starts syncing – cancel this as well using the same small x in the iTunes status window.
8. The first stage in the restore process unlocks the iPad, you are basically just canceling out the restore process as soon as it reactivates the iPad.
If done correctly, you will experience no data loss and the result will be a reactivated iPad. I have now tried this with about 5 iPads that were locked identically by students and each time it worked like a charm.
~~~~~~~~~~~~~
Try it and good luck. You have nothing more to lose if it doesn't work for you.
Cheers, Tom -
Hi chaps. FaceTime question. I can FaceTime by phoning my iPhone 4 from my iPad 2 but cannot phone my iPad from the iPhone. When facetimeing from phone to iPad the phone says it's busy. The iPad rings once and then stops. Any ideas. Regards Jon
Perhaps this discussion will help with your issue,
https://discussions.apple.com/message/16502324#16502324 -
Itunes on my PC displays an error message " This iphone cant be synced , you dont have enough privilege" everytime I start syncing thiss message shows up and everything stops. So , what to do now? even wifi sync isnt working and not able to sync files onto my iPhone.
Try:
Close iTunes, click the Start button > All Programs > iTunes folder > RIGHT CLICK iTunes Program icon > Select> Run as Administrator. -
I had my ipad restored today and cant locate a book I purchased in IBooks. is there a way to locate this book ithout purchasing it again
As long as the book is still in the store, and you haven't changed countries since buying it, then it should show in the Purchased tab in the iBooks app on your iPad for redownloading. If it's still in the store but doesn't show in Purchased then check to see if it's hidden : iTunes Store: Hiding and unhiding purchases.
-
My iphone cant boot. it begins but restarts when it gets to the desktop. what can i do?
my iphone cant boot. it begins but restarts when it gets to the desktop. what can i do?
Hello Nadersalah,
It seems you're experiencing multiple issue with your iPhone. Based on the information you have provided, it appears your iPhone needs to be serviced. The following link should help you get started with the process and has links with additional information on topics such as warranty and service pricing, battery replacement, and express replacement service.
iPhone Repair and Service - Apple Support
Thank you for contributing to Apple Support Communities.
Cheers,
Bobby_D -
I'm trying to install windows 8 on mac, but after partitioning and restarting, it stucks on blue logo and i waited 20 minutes but nothing happened, what can i do, please help.
I think there's some remmants left over from when Apple transferred stuff over. We can try a quick fix, but if that doesn't work, I think the only option is to clean install OSX and then install Windows.
open disk utility, confirm that you only have 1 partition (mac journaled)
restart and PRAM reset
open disk utility and repair permissions twice
restart boot camp assistant
Does it work?
If not, I would boot holding command+R, choose disk utility from the menu and completely erase your HD (formatting it as mac journaled again). Then, install OSX on this HD. Once OSX is installed, don't copy your files over from the backup yet. Instead, start boot camp assistant and see if you can get Windows installed. You can copy back your other files after we get Windows installed. -
Why and how do I fix this? When I go into cellular data and view account it says my ipad is activated and ready to go. What gives???
It was working fine up until I upgraded the OS which I hadn't done in many versions so the ipad was not working as well as it should. Now it is searching for the network.
.Hello noodles074!
Let's get your device working again! It's possible that your device just needs to be reprovisioned on our network. Please go to Settings>General>Reset>Subscriber Services>Reprovision Account. This may take several minutes. After allowing about 5 minutes for completion, please power your iPad off and back on, and test it again. Let us know if this takes care of it!
Thank you,
MichelleH_VZW
Follow us on Twitter @VZWSupport -
As soon as i open itunes it comes up with the message 'itunes has stopped working'. i have uninstalled everything to do with apple/itunes and reinstalled it 5 times and it keeps happening . What can i do? Please HELP
Hi,
i have tried all that and it still comes up with the same message or doesnt open at all . I have also i have created a new user and itunes works fine on that account. -
my ipad is disabled permantly and i dont want to loose my pictures i keep going through the 5 steps and each time it says "itunes cannot connect to ipad because it is locked with a passcode" WHAT DO I DO PLEASE HELP ME. thank you. sorry about spelling.
FORCE IPAD INTO RECOVERY MODE
1. Turn off iPad
2. Turn on computer and launch iTunes (make sure you have the latest version of iTune)
3. Plug USB cable into computer's USB port
4. Hold Home button down and plug the other end of cable into docking port.
DO NOT RELEASE BUTTON until you see picture of iTunes and plug
5. Release Home button.
ON COMPUTER
6. iTunes has detected iPad in recovery mode. You must restore this iPad before it can be used with iTunes.
7. Select "Restore iPad"...
Note:
1. Data will be lost if you do not have backup
2. If you did not do step 4 properly, start all over again.
Maybe you are looking for
-
Hi, I'm programming a quite big app and doing a simple test, I get a strange error. I want to stop a thread if it blocks during execution. So my test is the following : I launch my app and I create a little GUI when I click start button the app start
-
How to create Current Year Filter at Universe Level ?
Hi, I want to create a Current Year, Next Year and Last Year filters at Universe Level. Can anyone help me with this. I am using Netezza database and not able to find the appropriate date function in Netezza to accomplish this. Any suggestions ? Than
-
Videos just won't load over >50% and most of the time it's less than that. It's not even just youtube either. It's all online videos.
-
I have Oracle 9i Database installed When I log into the oracle management server in OEM, I don't know the <host name> for the Management server where do I get this info? I am getting the default of my ISP address!
-
im new to java & self-taught, so i may be incorrect. i wish to create a stand-alone logon dialog (frame) that can be invoked prior to any server program. The user would enter server, userid, & password, then press logon button. the logic would try to