HT201263 My ipod is dead and wont charge. Anything I have read says to press the sleep/awake button. What is that ?

I didnt charge my ipod last night because i fell asleep to early and i woke up this morning and it wasnt working. Any ideas about what to do? What is the sleep/wake button?

Try:
- iOS: Not responding or does not turn on
- Also try DFU mode after try recovery mode
How to put iPod touch / iPhone into DFU mode « Karthik's scribblings
- If not successful and you can't fully turn the iOS device fully off, let the battery fully drain. After charging for an least an hour try the above again.
- Try on another computer
- If still not successful that usually indicates a hardware problem and an appointment at the Genius Bar of an Apple store is in order.
Apple Retail Store - Genius Bar       
The Sleep/Wake buttin in the button on the upper right top of the iPod.

Similar Messages

  • My iPod nano will go into the sleep mode while a song is playing a second after the screen goes blank; the song will stop and I will then have to press the sleep/awake button to pick up where the song left off.  How do I fix this?

    My iPod nano will go into the sleep mode while a song is playing a second after the screen goes blank; the song will stop and I will then have to press the sleep/awake button to pick up where the song left off.  How do I fix this?

    Your problem is that your iPod is not sensing that your headset is inserted. There is a pin inside the headphone port on the Nano that senses if it is inserted fully. If it does not sense anything, it will pause playback to save battery power when the screen dims. Here are the solutions:
    Insert it fully. This will fix it for most of you. Press that thing in there all the way. You should feel and hear a full click when it is fully seated. If you can see ANY silver of the headset jack, it is not fully inserted.
    Debris inside the headset port. If you are totally unable to push the headset jack all the way, the most likely problem is that you have crud inside your headphone jack. Try blowing it out or slapping it against your palm with the headset port facing your palm to try and get the stuff out. If you look into he jack with a light, you should be able to see to the bottom. The entire inside of the headset port is white, so if it looks dark at the bottom, that is the crud that is keeping your nano from working.
    Headset jack or plug issue. If you cannot solve the problem with 1 or 2, then there is likely something physically wrong with either the headset jack on your headphones or the headset port on the nano.
    If none of the above works, you need to take it to the Apple store or wherever you purchased it. I think they are still under warranty.
    i

  • My Iphone 4 keeps trying to turn itself off and also takes random screen shots.  I think it might have something to do with the Sleep/Awake button but any help would be greatly appreciated.

    My Iphone is constantly trying to turn itself off and also taking screen shots when I'm not touching it.  I think it may have something to do with the Sleep button but would welcome any suggestions. I have already restored it to Factory settings but it didn't help.
    Thanks,

    Did you try to set it up as new device, without using the latest backup?
    How to back up your data and set up as a new device

  • My ipod went dead and wont do anything. is it locked or something?, my ipod went dead and wont do anything. is it locked or something?

    my ipod went dead while i was using it, and now wont do anything, is it locked or something?

    Try a hard reset.
    Basic troubleshooting steps  
    17" 2.2GHz i7 Quad-Core MacBook Pro  8G RAM  750G HD + OCZ Vertex 3 SSD Boot HD 
    Got problems with your Apple iDevice-like iPhone, iPad or iPod touch? Try Troubleshooting 101

  • My ipod is completely dead and wont charge. What should I do?

    Ipod completely dead and wont charge. I've had it plugged in for days to multiple things. never happened before. please help!

    Try:
    - iOS: Not responding or does not turn on
    - Also try DFU mode after try recovery mode
    How to put iPod touch / iPhone into DFU mode « Karthik's scribblings
    - If not successful and you can't fully turn the iOS device fully off, let the battery fully drain. After charging for an least an hour try the above again.
    - Try on another computer
    - If still not successful that usually indicates a hardware problem and an appointment at the Genius Bar of an Apple store is in order.
    Apple Retail Store - Genius Bar       

  • I 'think' my Ipod Touch is in recovery mode and people say to hold the power and home button for 10 sec and i did, but its still not turning back on. Plus its dead and wont charge

    I 'think' my Ipod Touch is in recovery mode and people say to hold the power and home button for 10 sec and i did, but its still not turning back on. Plus its dead and wont charge. PLZ HELP ME!!!!

    - If in recovery mode the screen will have an iTunes logo with an USB plug.
    - Have you tried connecting it to your computer for a n hw and then see if it appears in iTunes. If it does restore the iPod.
    - If screen is blank, try placing he iPod in recovery mode and then restoring. For recovery mode:
    iPhone and iPod touch: Unable to update or restore

  • HT1349 my iphone went dead and wont charge at all, please help :(

    my iphone went dead and wont charge. I tried plugging it on the wall and via the usb to my laptop but still no luck. any suggestions on how to make it work?

    Try using a differnt USB cord.   Or hold down the power/home button together for 10 to 15 sec or until you see the apple logo and then release, wait for your phone to boot back up.

  • Droped my ipod touch 5g and wont charged (screen cracked)

    Droped my ipod touch 5g and wont charged (screen cracked)

    Apple will exchange your iPod for a refurbished one for this price:
    Apple - Support - iPod - Repair pricing
    A third-party place like the following maybe less. Google for more.
    iPhone Repair, Service & Parts: iPod Touch, iPad, MacBook Pro Screens

  • My question is what if I have troubleshooted with holding the sleep/awake button and power and it's not changing to any other screen what should I do? It doesn't even show the battery strength wheither its completely dead or charging at all.

    My question is what if I have troubleshooted with holding the sleep/awake button and power and it's not changing to any other screen what should I do? It doesn't even show the battery strength wheither its completely dead or charging at all.

    - If you did not charge the iPod for a couple of hours before you did the reset then charege and reset:
    Reset iPod touch:  Hold down the On/Off button and the Home button at the same time for at
    least ten seconds, until the Apple logo appears.
    - Then connect to your computer and if iTunes sees the iPod restore via iTunes. 
    - Next see if recovery mode will allow iTunes to see the iPod so you can restore the iPod. For recovery mode:
    iPhone and iPod touch: Unable to update or restore
    - Last, make an appointment at the Genius Bar of an Apple store.

  • HT1212 my ipod is frozen and wont do anything!!! what do i do????

    my ipod is frozen and wont do anything!!!!!! i need help on restarting it. it is stuck on my lock screen

    If still problem try the remaining items of:
    - iOS: Not responding or does not turn on
    - Also try DFU mode after try recovery mode
    How to put iPod touch / iPhone into DFU mode « Karthik's scribblings
    - If not successful and you can't fully turn the iOS device fully off, let the battery fully drain. After charging for an least an hour try the above again.
    - Try on another computer                            
    - If still not successful that usually indicates a hardware problem and an appointment at the Genius Bar of an Apple store is in order.
    Apple Retail Store - Genius Bar                                     

  • My Ipod touch is acting very annoying. When i press the sleep/wake button to turn it on it just turns on with the apple logo and stays there. The screen will then blink white occasionally and the process will start again.

    My Ipod touch is acting very annoying. When i press the sleep/wake button to turn it on it just turns on with the apple logo and stays there. The screen will then blink white occasionally and the process will start again. Once when it turned white. i pressed the power and home buttons at the same time and then the above process continued.

    Sounds like your iPhones software may be corrupt. Try placing the iPhone into recovery mode. To do this, follow the steps in this article:
    http://support.apple.com/kb/HT1808
    Hope this helps
    - Greg

  • Hello all,     I have a 6G iPod Nano that I currently use as my primary watch. A week or so ago I started to experience a blank white screen when I press the "sleep/wake" button instead of the watch face (I have it set to wake from sleep to display the cl

    Hello all,
    I have a 14.88G iPod Nano that I currently use as my primary watch. A week or so ago I started to experience a blank white screen when I press the "sleep/wake" button instead of the watch face (I have it set to wake from sleep to display the clock). When I hard reset it, it will come back fine and the screen will respond and work as normal, as soon as I manually put it to sleep by pressing the "sleep/wake" button and then try to wake it the same thing happens and I have a blank white screen that doesn't respond to touch gestures or anything.
    What I have tried so far to no avail:
    Numerous hard restarts (holding the "sleep/wake" button with the volume - button).
    Tried this: iPod nano (6th generation): Hardware troubleshooting
    Changed the watch face to display.
    Recharged the device overnight (without full discharge).
    Since none of this works I'm out of ideas. Eventhough I have a 6G Nano it should no longer be under warranty since I was sent it as a replacement for a different (older) product.
    Any ideas? Is this a known problem? Thanks in advance for any insight any of you could provide. Also, what time is it??
    Regards,

    Hey,
    I have the exact same problem as you have described. I also used my ipod as a watch but starting from today, whenever I unlock it the screen turns white until a reset is done. Even a factory reset through itunes didn't fix it.
    Have you found any solution?
    Bah, this is annoying.
    //Gubbar

  • I have to restore my iphone 4s becasue it is saying "disabled connect to itunes" and it's never been synced with itunes. However the sleep/wake button is broken on the phone is there still away to restore without using it?

    I have to restore my iphone 4s becasue it is saying "disabled connect to itunes" and it's never been synced with itunes. However the sleep/wake button is broken on the phone is there still away to restore without using it?

    You can try, but the problem with that is you need battery power in order to restore. Once your phone has enough power to restore, it will still show the same message. To get the phone into either recovery mode or DFU mode requires the ability to first turn the phone off. But, you've got nothing to lose, so you might as well give it a shot.

  • HT1414 my ipad with retina eye updated to IOs 7 not able to boot ....the normal way of pressing the sleep/wake button and the  home button does'nt work....any ideas i think that IOs 7 is a crap cos form the time i loaded it it was shaky...now my ipad is d

    my ipad with retina eye updated to IOs 7 not able to boot ....the normal way of pressing the sleep/wake button and the  home button does'nt work....any ideas i think that IOs 7 is a crap cos form the time i loaded it it was shaky...now my ipad is dead

    If it is one year old minus one day it is still under warranty. If it is more than a year since you purchased it then yes, the warranty has expired.
    Millions of iPads have been sold. Most continue to function long after their warranty has expired. Check the many requests about updating the iOS on the original iPad on these forums and you'll see that there are many iPads still working after three years. My iPad 2, which I had for over two years is still working well for my son in law who took it over from me when I bought a new one.
    Given that there will always be a few iPads that fail early. Most of those will be covered under warranty. But some will fail after the warranty has expired and before the owner expected it to. I'm sorry to hear that you are in this category. Take your iPad to an Apple store and have it looked at. They will provide you with alternatives, one of which is to purchase a like model to the one that failed at a discount. You can then know your options and make the best choice for you.

  • I hv a 3GS iphone. it could not be boot up.  When i press the sleep/wake button, the apple logo appeared for a while and then disappear.  My phone could not be start up.  When i go to itune, it does not have the logo for me to sync.

    I have a iphone3GS.  It could not be boot up.  When i press the sleep/wake button, the apple logo appear and then disappear.  The password login screen didnt' come on.  When i tried to connect my phone to the itune on my laptop, there isnt this button that i can sync my phone with the laptop.

    Sounds like your iPhones software may be corrupt. Try placing the iPhone into recovery mode. To do this, follow the steps in this article:
    http://support.apple.com/kb/HT1808
    Hope this helps
    - Greg

Maybe you are looking for

  • Created .rpd file but how do I connect in OBIEE Answers?

    I have created a .rpd file using an Essbase connection but am now stuck on how I connect an Answer query to it in the OBIEE dashboard tool itself. When I create a new analysis, I do not see my newly created .rpd in the list of available connections.

  • Problem in epm 11.1.1.3 configuration with websphere

    hi there, i am have installed epm 11.1.1.3 with websphere(ver 6.1) , but when i try to configure the workspace with websphere it asks me to give path for web server plug ins where mod_was_ap20_http.dll are installed . i have also installed ibm http s

  • Preference Error: Could not load Sharing (Mac OS X 10.4.9 PPC)

    I just noticed it today, but I'm unable to open my Sharing preferences anymore. It's probably been a few weeks since I last opened my Sharing prefs. That last major change to my Mac was installing the Mac OS X 10.4.9 update. Not sure if that had anyt

  • What is the location for Sandoxed solution dll

    Hi All, Can anybody please tell me what is location for Sandboxed dll. Where does it get save? How does it work in office 365? is it saved in Database rather than file system? If saved in database, how could the database will allow a .dll file in DB?

  • Half sized frames

    i did a 2 year search and found others had my symptoms, some had answers relating to hd issues, others went unanswered. i have a simple sony digital 8 camcorder. used to import great. recently i couldn't import into quick time (latest version)(just b