HT201263 my phone went suddenly went out and wont start even with connection to itunes

any suggestions ? the phone wont start even with itunes

Connect iPhone to Wall Charger for 10 minutes, it may turn ON itself. If still nothing, keep on charger and Reset, hold both home and power buttons for about 20 seconds until the iPhone begins to start.

Similar Messages

  • Since iOS 7.1 my phone won't turn on and is asking me to connect to iTunes. I connect to itunes and it says it needs to be restored. Not sure why. I try to restore it and then it says something went wrong and it won't work. So I've been without my phone

    Since iOS 7.1 my phone won't turn on and is asking me to connect to iTunes. I connect to itunes and it says it needs to be restored. Not sure why. I try to restore it and then it says something went wrong and it won't work. So I've been without my phone for a couple days now. It gives me error code (29). The phone almost reboots and then 3/4 of the way through it gives me the error message.

    If using windows...
    Temporarily disable your firewall and antivirus software and try again...
    http://support.apple.com/kb/TS1379
    See iTunes Connection Issues here...
    iTunes for Windows: Troubleshooting security software issues
    NOTE:
    Make sure you have the Latest Version of iTunes (v11.1.5) Installed on your computer
    iTunes free download from www.itunes.com/download

  • Hi, My iphone has locked me out and says iphone is disabled connect to itunes. but my itunes wont connect with my iphone. i've tried everything i can think of and my phone is still locked and i cant sync it with itunes. what else can i do??

    Hi,
    My iphone has locked me out and says iphone is disabled connect to itunes. but my itunes wont connect with my iphone. i've tried everything i can think of and my phone is still locked and i cant sync it with itunes. what else can i do??

    While connected to iTunes, try...
    http://support.apple.com/kb/HT1808

  • When I was updating my ipod touch 4g 8g 4.3.3 the USB came out and now it just shows connect to itunes and when i try to update it comes with error 6. I do all of the help things and nothing

    When I was updating my ipod touch 4g 8g 4.3.3 the USB came out and now it just shows connect to itunes and when i try to update it comes with error 6. I do all of the help things and nothing happoned

    First see if placing the iPod in Recovery Mode will allow a restore.
    Next try DFU mode and restore.
    How to put iPod touch / iPhone into DFU mode « Karthik's scribblings
    If not successful then time for an appointment at the Genius Bar of an Apple store. You are not alone with this problem.

  • HT201263 my phone is in recovery mode and wont restore.  instead i receive the error message 1604.  i have used alternative usb cables and am at a loss. has anyone else had this problem?

    Hi,
    my phone is in recovery mode and wont restore.  instead i receive the error message 1604.  i have used alternative usb cables and am at a loss. has anyone else had this problem?

    Hi there hstear93,
    You may find the information in the article below helpful.
    iOS: Not responding or does not turn on
    http://support.apple.com/kb/ts3281
    -Griff W. 

  • HT4623 try to update and went black and wont start up again

    try to update my phone now black and wont start up

    Same thing happened to me. I took it to the Apple store and they told me they would be happy to replace the phone for me for $149.
    <Edited by Host>

  • HT201263 The restore stops encountering an error and then i see the connect to itunes image and nothing happens.

    The restore stops encountering an error and then i see the connect to itunes image and nothing happens.PLEAS HELP

    Are you trying to restore as new or from a back up? Is iTunes  and your computer all up to date?

  • HT5704 My Wireless conectivity option in my phone settings has greyed out and wont conect anymore.. anyone else had this?

    My Wireless connectivity option in my phone settings has stopped working and is greyed out...? Has anyone else had this happen??

    Search this forum and you'll find out.

  • HT1212 i forgot my password to my new 5s phone and i got locked out and it says iphone disabled connect to itunes i tried to reset it but it didnt work

    i forgot my password to my new gold 5s iphone got it 2 days ago. i got locked out after trying mant codes i did one very fast and got in i tried to change the password but i forgot it again! i got locked out again and it says iphone is disable connect to itunes.i tried to reset my phone but i didnt work.

    1: Connect the device to Your computer and open iTunes.
    2: If the device appears in iTunes, select and click Restore on the Summary pane.
    Restoring  >  http://support.apple.com/kb/HT1414
    Make sure you have the Current Version of iTunes Installed on your computer
    iTunes free download from www.itunes.com/download
    3: If the device doesn't appear in iTunes, try using the Steps in this article to force the device into Recovery Mode.
    Note on Recovery Mode.
    You may need to try this More than Once... Be sure to Follow ALL the Steps...
    After you have Recovered your Device...
    Re-Sync your Content or Restore from the most Recent Backup...
    Restore from Backup  >  http://support.apple.com/kb/ht1766

  • My ibook suddenly shut down and wont start up. please help!!!

    hi, im new to macs so i need help! my ibook g3 700hmz was acting completly normal and i was using elmedia player on it, suddenly it went on hybernate while i was using it. i could not revive it no matter what i did and i could not shut it down so i took the battery out. now it will not start up, power on, or do anything at all. it makes no difference if i plug it into the charger, take battery out or anything. i tried to reset the PMU but had no success. i took out the ram and tried to start it but still nothing. someone sugested it could be the logic board but would it just suddenly die all of a sudden? another suggested the hard drive but it should still power on with a bad harddrive shouldnt it? could it be the dc board? the battery is low but when you press the button on it one light does come on and blinks for about 10 sec. i have no way of testing the charger but it worked fine the night before. any help would be apreciated.

    It's really hard to tell whether the battery would have enough capacity to boot. Lack of bootability may be due to hard drive corruption, as well. Having the CDs (or DVD, as the case may be with Mac OS X 10.4, from which to boot could help you figure out whether that is a problem, although I would expect it to at least start up to a flashing question mark folder if it were a hard drive problem.
    When a battery doesn't charge properly, the most likely problem is the battery.
    The next-most common problem is the adapter. They do wear out, and it's entirely possible that this may be the cause of the problem.
    Next in line for consideration is the power input (DC-in) board. This is the part of the iBook that houses the adapter port. Usually when it goes out, the adapter doesn't work at all. It won't charge the computer, and it won't run the computer. In this case, once the battery runs down, the only way the computer will run is with a battery that has been charged externally (by another iBook or an external battery charger).
    The least frequent cause of a battery not charging is the logic board. The power management unit (PMU) can be permanently defective. If this is what is going on, you probably won’t see any charge to the battery at all, but, in my experience, the adapter does run the iBook (unlike when the DC-in board is at fault).
    My best estimate in your case is that the battery died completely, since you were using it from the battery when this happened. My 800 MHz iBook came back from a logic board repair with a defective logic board that wouldn't allow me to use the battery at all. As soon as I unplugged from the adapter, the iBook died. It didn't just go to sleep, though, it died completely. So if you had a sudden failure of the logic board, I wouldn't expect it to just go to sleep. Suspect, in this order: battery, adapter, DC-in board, and, finally, the logic board. Because of the way this happened, unless you dropped it or spilled something on it, I would not expect it to be a logic board problem (but that's just my best assessment of the situation, based on my experience). If you want to have it analyzed by professionals, DT&T Services in Fremont, California may be your best bet. They do free diagnostics, but it would cost you shipping charges both ways in order to find out what's wrong with it for certain. They also offer the cheapest logic board repair I've found, often less than what you'd pay for a logic board without labor, and they have a six-month warranty on the part(s), but I'm not sure whether that six-month warranty includes labor. You'd need to ask.
    Good luck.

  • Hi I was wondering if anyone has experienced ios 7 problems on the iphone 4s as mine often blanks out and wont start up all I get is a white screen and when (if) it comes on the backgroung is not normal?

    Hi I was wondering if anyone has experienced probs with the ios7 on iphone 4s, as mine keeps going white screen and wont turn on reboot unless im lucky. When, if it comes on it blurrs and fades out after a couple of minutes the screen also jitters and dies often. I dont know if this is due to the software update or a faulty screen etc... any thoughts?

    Sno problems here at all.

  • My screen suddenly turned black and wont start again

    I was using my computer as usual when the screen suddenly turned off. It wont start again! I'm a musician and work with my computer!! Today I have a show and wont be able to use it!! I'm desperate Please, can anybody help!!
    Thanks a lot!!!

    It sounds like you had a hardware failure. You can try doing a SMC reset, read the instructions carefully though as they cover multiple models of Macs. If that doesn't help I think it's time to contact a AASP. The AASP site is for the US, you will need to find one in Brazil though.
    Good luck!
    Roger

  • My iphone 3gs turned off and wont turn on or connect to itunes. its fully charged, and told me to reactivate it, but it wont connect. what do i do?

    what do i do?

    I have the same problem.  My iPhone 3GS was working just fine until I upgraded the OS to 5.0.1 a couple of days ago. When it complained about SIM card, I got that replaced and still the problem persisted. I tried to activate the Phone using my Wi-Fi and that also did not work.  The phone has become unusable now.
    When I contacted the CSR, he says that my phone already would have broken and that is why the upgrade did not go through which is not a fact after seeing these postings.
    Apple, instead of finding a solution to this, recommend buying another equipment.  Is there a way to revert back to older OS?

  • My phone shut off on me and wont start up agian

    My phone shut off twice in the last two days and it wont turn back on. Does that mean I need to get a new one? I need help!

    What if you hold home button plus power does it respond?

  • Mini ipad black screen and wont start even after reset

    My mini ipad went black. I tried pressing power button and home button simultaneously for more then 10 seconds and didn't work. Tried plug onto a charger for more then 10 minutes also didn't work. Tried both simultaneously also didn't work. Thanks for any assistance. Btw, my check with apple websites said the mini ipad is no longer under warranty.
    Shaiful, Malaysia

    Hello, Shaiful Affandi.  
    Thank you for visiting Apple Support Communities.  
    I understand that your device will not power on and you have some troubleshooting steps with the issue persisting.  There are just a couple more steps that I could recommend in the article below.  
    If your iPhone, iPad, or iPod touch doesn't respond or doesn't turn on
    http://support.apple.com/HT201412
    Cheers, 
    Jason H.  

Maybe you are looking for

  • Vendor excise details in J1ID

    for a factory which is not taking cenvat credit of their packing material but they are going to maintain chapter id for that material. is it necessery to maintain vendor excise details in t code j1id?

  • How can I find out which color toner in my Officejet 6700 is out?

    My printer stopped printing on a print job, and said replace a color cartridge to continue.  However, there are 4 cartridges and I was not told which one to replace.  Is there any way to get that information from the printer?

  • Adobe Connect dropouts talking to Adobe Support in India

    This may be the wrong place to raise this. I don't usually use Adobe Connect. But this week I've been spending hours on the phone to Adobe technical support in India. They use Adobe Connect to see my desktop in an attempt to fix my problems (with Ado

  • Sending to Windows = no mail

    My wife is still using a Windows-based PC (I still love her anyway), but when I send her email from my Mac.com address, she does not receive it. It does not show up in either her junk file or her spam filter, either. Nor does it bounce back to me as

  • Save control as image, without vi header etc

    Hello, I want to save a control (xy graph) as image - it works partly, but does save a kind of frame as well, with the vi header and footer etc - is there an easy way to avoid this? I am using invoke node get image, and write jpeg/bnp/... Thanks for