HT201270 Problem with iPad carrier settings update

I have done this update and now I get a repeat message to do it again every time I sync my iPad. How can I stop this happening?

I have exactly the same problem, I am in the UK on the O2 network. It is definitely a network provider problem, I can tell you exactly when this problem started for me. In the UK there was new legislation brought in to block the Pirate Bay domain.
Ever since the the carriers in the UK had to update their settings on their mobile devices this problem started and it seems to be absolutely no way to get it resolved.
I have tried, in vain, to get O2 to do something to this problem that they are unable to do so.

Similar Messages

Problem with IPad , did an update as requested now it does nothing, but display a graphic that shows I should connect to ITunes . So I connect it to my IMac run ITunes nothing happens. Try restore pop up says not eligible for restore.

Wow what a pile of crap you must wade through to ask a question .
Ok so the problem is I did an update on my IPad and now it does nothing but show a graphic showing the power cable connecting to ITunes
So I connect iPad to my IMac and prompt iTunes nothing happens. So I try sinc nothing happens.
So I try restore and the popup says I am not eligible for restore.
What is going on with this stupid machine

Machines are incapable of being stupid. Not so of their operators.
Placing your device into recovery (DFU-Device Firmware Upgrade) mode:
Follow these steps to place your iOS device into recovery mode. If your iOS device is already in recovery mode, you can proceed immediately to step 6.
   1. Disconnect the USB cable from the iPhone, iPad, or iPod touch, but leave the
       other end of the cable connected to your computer's USB port.
   2. Turn off the device: Press and hold the Sleep/Wake button for a few seconds
       until the red slider appears, then slide the slider. Wait for the device to turn off.
              * If you cannot turn off the device using the slider, press and hold the
                Sleep/Wake and Home buttons at the same time. When the device turns off,
                release the Sleep/Wake and Home buttons.
3. While pressing and holding the Home button, reconnect the USB cable to the
       device. The device should turn on. Note: If you see the battery charge warning,
       let the device charge for at least ten minutes to ensure that the battery has some
       charge, and then start with step 2 again.
4. Continue holding the Home button until you see the "Connect to iTunes" screen.
       When this screen appears you can release the Home button:
5. If necessary, open iTunes. You should see the following "recovery mode" alert:
6. Use iTunes to restore the device.
If you don't see the "Connect to iTunes" screen, try these steps again. If you see the "Connect to iTunes" screen but the device does not appear in iTunes, see this article and its related links.
Additional Information:
If you have a problem getting into recovery mode then try: RecBoot: Easy Way to Put iPhone into Recovery Mode.
Note: When using recovery mode, you can only restore the device. All user content on the device will be erased, but if you had previously synced with iTunes on this computer, you can restore from a previous backup. See this article for more information.

Problem with iPad's after updating to 8.0.2 (12A405)

After updating to 8.0.2 my iPad2 and iPad Air searching and do not log on to the telephone network. After reboot iPad log on to network until they disconects.
Best...
Jack

Hey j@cek,
Thanks for the question. I understand that you are experiencing issues with your cellular connection on your iPads. The following resource may provide a solution:
Get help with the cellular data connection on your iPad (Wi-Fi + Cellular Model)
http://support.apple.com/kb/TS4249
Thanks,
Matt M.

HT201270 My ipad is displaying the carrier settings update box but does not respond to either the "update now" button or the "not now" button and has totally frozen. The ipad cannot switch off as I need to clear this box before I can "slide to shut down".

Can anyone help me with carrier settings??? My ipad is displaying the carrier settings update box but will not respond when I press "update" or "not now". I have tried to switch the ipad off, but cannot "slide to shut down" as I need to clear the carrier settings box first!! HELP PLEASE!!!!

Have you tried a reboot? Hold down the power and home buttons simultaneously. Ignore the Slide to Power Off prompt if it pops up. The display should go dark, and the Apple logo should appear as it begins a reboot. This is a soft reboot - it does not erase data.

HT201270 I have an iPad 3rd gen. A carrier settings update notification has appeared on my screen, and it doesn't do anything when I press either 'update' or 'not now' . Because the notification is still there, I am unable to use any apps or shut it down.

I have an iPad 3rd gen. A carrier settings update notification has appeared on my screen, and it doesn't do anything when I press either 'update' or 'not now' . Because the notification is still there, I am unable to use any apps or shut it down. What should I do?

Have you tried a reset by pressing and holding the sleep/wake button and the home button for 20 seconds (maybe longer) until the Apple logo appears, ignore the red slider. Then turn back on. You won't lose any data doing the reset.

Having problems with ipad mini and Siri. Works sporadically, will work once and then the second time not. Worked all the time with the original Mailbox app. Then started doing the same thing when I installed the new update so wondering if it is software?

Having problems with ipad mini and Siri. Works sporadically, will work once and then the second time not. Worked all the time with the original Mailbox app. Then started doing the same thing when I installed the new update so wondering if it is software?

Hi,
I have the check box on a second Partition but not on the Time Machine one
I forget what I did now to get this called "Recovery HD"
For the rest try https://discussions.apple.com/docs/DOC-4055 User Tip that links to Pondini's work on Time Machine.
10:17 pm Friday; May 2, 2014
 iMac 2.5Ghz i5 2011 (Mavericks 10.9)
 G4/1GhzDual MDD (Leopard 10.5.8)
 MacBookPro 2Gb (Snow Leopard 10.6.8)
 Mac OS X (10.6.8),
 Couple of iPhones and an iPad

Frozen iPad screen; non responsive. MSG: carrier settings update....choose not now or update.... Neither respond and iPad will not totally shut down...date

MY husbands iPad screen is frozen. Will not shut down. Non responsive. Message: Carrier settings update....choose Not Now or Update.... Completely frozen & non responsive.

THank you Demo from Pittsburgh, PA. Holding the home button and power on button together for 25 seconds worked! Rebooted his system thx for the tip!

I inherited my husband's iphone 4s. After erasing all of the previous settings, updating to ios 8 I went on icloud to set it up. During the set up, the screen froze on "carrier settings update". I can reboot, but the message comes right back.

This is a phone re-set from a previous user. Reset from icloud. Froze during set up, on "carrier settings update" and has the phone number pad with it. I reboot but it comes back and I can't get past it.

Hey Jackie,
Welcome to Apple Support Communities,
Take a look at the article linked below, it provides troubleshooting suggestions that’ll solve issues like the one that you've described, where your iPhone 4s has a blank black screen.
Get help with the screen on your iPhone, iPad, or iPod touch - Apple Support
If you see a solid color screen (black, white or blue)
Plug in your device to a power source. If you see the low-battery screen when you plug in, let your device charge for at least 10 minutes (20 minutes for iPad) before using it.
Reset your device while it's plugged in.
If resetting doesn’t fix the issue, restore your device.
If you still see the issue after you restore, contact Apple Support.
Cheers,
-Jason

4G LTE iPhone 5: Carrier Settings Update never came

Hello,
Just to say, before I start: This question is related to Switzerland's Swisscom's 4G LTE network and iPhone 5.
I have updated to iOS 6.1 (for Swisscom 4G LTE compatibility, it's now compatible), but didn't get the carrier settings update, and when I reset the iPhone (including erase all content), I got the Carrier Setting Update and it enabled 4G LTE, but I have progressed in lots of apps and games (mainly apps), and it will be very difficult to do a full restore and recover all my progress etcetera. How can I get the Carrier Settings Update? I went to Swisscom, and they said to erase the iPhone, but again this would be a big inconvenience and I am trying to avoid it.
Sorry about any problems: I'm not very tech savvy with iOS devices, and this is my first post here so I may have put in the wrong section.
Thanks a lot in advance

Well, I've connected my phone to iTunes, and still nothing has come. My friend's iPhone 5 did have enable LTE, when he updated and I believe he got it over the air, and didn't connect it to iTunes. iTunes is still syncing...
Thank you very much for helping
It's suddenly appeared. My three friend's iPhone 5's carrier settings update came straight away after updating this morning (we updated together), and mine has come about 7 and a half hours later... but still, it's come. I don't think this was related to iTunes (by the looks of it).
Thanks a lot for helping me, and for the quick replies.
Message was edited by: chetan20k

I'm having problems with iPad 2 and my smart cover. The attachment seems to be depolarized and it moves around causing the device to toggle and flash like its coming on or shorting. Anyone having problems?

I'm having problems with iPad 2 and my smart cover. The attachment seems to be depolarized, trys to connect using the back (curved) edge of the magnetized bracket. When I try to attach it, it moves around causing the device to toggle in a way that looks like the camera flash. Anyone having problems? Help.

Update. My carrier says the antenna of my iPhone 4s is not so good as the one in the iPhone 3G. They can't solve the problem. Their signal is too weak for the 4s at places I spend most of my time. Not the answer I expected, but I'm free to choose an other carrier. Hope this will help.
This was not the correct answer, I accidentially clicked the button..
Message was edited by: vasch

Carrier settings updates updating... & updating... &...

My iPad's carrier settings updates http://support.apple.com/kb/HT1970 are updated again and again, every time iTunes starts up or my iPad gets in its reach.
Am I the only one? And does anyone know what I might do about it?
Thanks a lot!

Did you manage to fix the problem? I just posted the same exact question...

HT1977 I have a problem with iPad 1 16 GB begins when a message comes Altaatpet Phil Altaatpet sync itunes

I have a problem with iPad 1 16 GB begins when a message comes Altaatpet Phil Altaatpet sync itunes

gianlucastr,
an EXC_BAD_ACCESS exception type with a KERN_PROTECTION_FAILURE exception code typically has one of two causes — either a programming error, or faulty RAM. If this was due to a programming error, then you can check to see if there’s an applicable patch to your version of Outlook, or wait for the next Mavericks update from Apple, to see if either of these would fix this problem. If it’s due to faulty RAM, then you can try running your MacBook Pro’s Apple Hardware Test to see if it can detect any RAM problems. (It’s not able to detect all possible RAM problems, so no error detected by the AHT is not a guarantee of non-defective RAM.)

Activation problems with ipad 2 wifi gsm

i have been having activation problems with ipad 2 ever since it was launched in sptemeber 2013. its gets stuck on server busy try later or try using itunes. even with itunes it does not activate. went to a apple reseller. he tried updating it through some DFU mode but did not go through. now he says that the ipad will have to be sent to US for repairs. any help or advise from the users ? thanks

I have the same problem.I hope somone comes up with a solution or it is fixed in the ios 7.1 update

HT201177 I am having some problems with downloading, possibly settings are incorrect, esp. flashplayer upgrade will not install - i have iMac 8.1 osx v10.5.8 - processor: 3.06 ghz intel core2 duo mem: 2 gb 800 mhz ddr2 sdram

I am having some problems with downloading, possibly settings are incorrect, esp. flashplayer upgrade will not install - i have iMac 8.1 osx v10.5.8 - processor: 3.06 ghz intel core2 duo mem: 2 gb 800 mhz ddr2 sdram - i am considering making an appt with Apple store nearby since we have a few in vicinity but thought i would give the online support a try.

The latest version of Adobe FlashPlayer can be obtained from here:
http://www.adobe.com/shockwave/download/download.cgi?P1_Prod_Version=ShockwaveFl ash
You can check here what version of Flash player you actually have installed: http://kb2.adobe.com/cps/155/tn_15507.html
You can check here: http://www.adobe.com/products/flash/about/ to see which version you should install for your Mac and OS.
You should first uninstall any previous version of Flash Player, using the uninstaller from here (make sure you use the correct one!):
http://kb2.adobe.com/cps/909/cpsid_90906.html
and also that you follow the instructions closely, such as closing ALL applications first before installing. You must also carry out a permission repair after installing anything from Adobe.

Dear i have a problem with the fingerprint after updating to ios 7.1 when plugged in electricity works like a charm

dear sirs.
i am an apple customer since first iphone but right now i am having problems with fingerprint sensor after updating to ios 7.1.
when plugged to electricity it works but when unplugged sometimes work.
please solve this issue by a quick update and thanks.

I have been on the phone twice today with my carrier. They reset it the first time, it worked for an hour then messed up again. They reset it a SECOND time.. It worked for 6 hours, then messed up again. I don't know if this is a software issue or what but if ANYONE has any insight, I would appreciate it greatly.

HT201270 Problem with iPad carrier settings update

Similar Messages

Maybe you are looking for