HT201407 Your iPad could not be activated because the activation server is temporarily unavailable

sir I had IOS 7 beta version and it was working properly, after the launch of official IOS 7 I got "Your iPad could not be activated because the activation server is temporarily unavailable" . I can't access to my device or even back it up or restore it!!! can you help me please

The iOS 7 beta has expired.  Since you had it, you were obviously a developer. 
You need to log on to the Developer Forum with your developer credentials, where you will find information on how to reactivate your phone.
Discussion of beta software is prohiibited on this general forum.
Best,
GDG

Similar Messages

  • Your phone could not be activared because the activation server is temporarily unavilable

    your phone could not be activared because the activation server is temporarily unavilable

    Hello dhawalkc,
    Welcome to the Apple Support Communities. if you are having issues with activation, the following article will guide you through troubleshooting the issue.
    iPhone: Troubleshooting activation issues
    http://support.apple.com/kb/ts3424
    Resolution
    Perform the following steps if you receive one of the messages above:
    Restart the iPhone.
    Try another means of reaching the activation server and attempt to activate.
       Try connecting to Wi-Fi if you're unable to activate using a cellular data connection. 
    Try connecting to iTunes if you're unable to activate using Wi-Fi.
    Restore the iPhone.
    If you receive an alert message when you attempt to activate your iPhone, try to place the iPhone in recovery mode and perform a restore. If you're still unable to complete the setup assistant due to an activation error, contact Apple for assistance.
    Regards,
    -Norm G.

  • HT1414 i have tried to restore my i phone 3GS connection through usb cable to i tunes.The phone seems to have restored but i am getting this error message;"your phone could not be activated because the activatation server is temporarily unavailable."

    Hi
    I have tried to restore my i phone 3gs using a USB cable connecting to itunes.The process has gone smoothley but i am now getting this message on my i phone;"your i phone could not be activated because the activation server is temporarily unavailable.Try connecting your i phone to itunes to activate it,or try again in a few minutes.I have been trying and trying again and switched off my firewall too.but still getting this message.Can anyone please advise me?

    That is almost always because the phone was hacked to unlock it from the original carrier.

  • I updated my 3gs iphone and tryed to activate it with thehelp of wifi but it displayed : your iphone could not be ativated because the activation server is temporarily unavailable

    i need support to activate my iphone 3gs upgraded

    Generally a sign that either the iPhone is jailbroken or the computer
    you are using to activate the iPhone has been used to jailbreak an iPhone.
    Is either of these the case?

  • HT201210 I am stuck with "The iPad could not be restored because the firmware file was corrupt" message.

    Hi
    I have an iPad mini and it was on iOS 6.1.3, my friend came and he said that he knows how to install iOS 7 for me. I gave it to him and he tried to install it, but apparently he failed to do so and an "Activation Error" is appearing on the screen now asking me to register in the developers program.
    Now, we are trying to restore it back to iOS 6.1.3 using iTunes, the software downloads well and it starts restoring but that I keep getting this error message "The iPad could not be restored because the firmware file was corrupt.".
    I am sure that the file is not corrupted because it's downloaded via iTunes regular download and it's not from an outside source.
    I am stuck with this now and my iPad is useless this way.
    Please any suggestions ?

    basselsamo wrote:
    Please any suggestions ?
    Yes, don't download Beta Software that you have no business or legal right to download and quit taking bad advice from friends.
    Now to maybe get you out of the restoring jam, the only thing that I can think of that might work is to use recovery mode, unless you already tried it and it didn't work.
    You can read about it here, but the instructions are posted below.
    http://support.apple.com/kb/ht4097
    Disconnect the USB cable from the iPad, but leave the other end of the cable connected to your computer's USB port.
    Turn off iPad: Press and hold the Sleep/Wake button for a few seconds until the red slider appears, then slide the slider. Wait for iPad to turn off.
    If you cannot turn off iPad using the slider, press and hold the Sleep/Wake and Home buttons at the same time. When the iPad turns off, release the Sleep/Wake and Home buttons.
    While pressing and holding the Home button, reconnect the USB cable to iPad. When you reconnect the USB cable, iPad should power on.
    Continue holding the Home button until you see the "Connect to iTunes" screen. When this screen appears you can release the Home button.
    If necessary, open iTunes. You should see the recovery mode alert that iTunes has detected an iPad in recovery mode.
    Use iTunes to restore iPad.

  • IPad won't sync.  Getting message "The iPad "Jennifer iPad" could not be synced because the sync session failed to finish."

    Getting message "The iPad “Jennifer iPad” could not be synced because the sync session failed to finish."  Or it looks like its going to sync but then I see it flash, "Cancelling Sync."  The only thing I can think I have done differently is I purchased a video from iTunes on my iMac.  Want to transfer it to the iPad.
    Thanks... this is so frustrating!!! 

    Not sure if this will help but I would try disconnecting your iPad then restarting your computer. Also reboot your iPad. Press and hold the Home and Sleep buttons simultaneously ignoring the red slider until the Apple logo appear. Let go of the buttons and let the iPad restart. See if that fixes your problem. After both have started back up reconnect your iPad and try to sync again.
    Im presumming here that you had been able to sync your ipad before you purchased the new video. If it fails to sync after the restart I would deselect the new video you purchased and try syncing. It just could be there is something wrong with that video file.

  • I try to restore ipad to ios 7.0.4 but the tunes show error ,the ipad could not be restore because the firmware file was corrupt, i have the latest update from itunes and windows and i turn off antivirus and firewall and the error is the same , what i do?

    i try to restore ipad to ios 7.0.4 but the tunes show error ,the ipad could not be restore because the firmware file was corrupt, i have the latest update from itunes and windows and i turn off antivirus and firewall and the error is the same , what i do?, my ipad is show apple logo
    please what i do

    Hello JD_NINJA,
    Thanks for using Apple Support Communities.
    Error 9006 when restoring your iOS device indicates that there is security software on your computer which is preventing connection to the Apple server or your device.  To troubleshoot this issue please follow the directions below.
    Check your security software
    Related errors: 2, 4, 6, 9, 1611, 9006. Sometimes security software can stop your device from communicating with either the Apple update server or with your device.
    Check your security software and settings to make sure that they aren't blocking a connection to the Apple servers.
    Get help with iOS update and restore errors - Apple Support
    When restoring your iPhone, please make sure to follow the directions in the link below to properly restore.
    Restore your device from an iCloud or iTunes backup - Apple Support
    Take care,
    Alex H.

  • TS1538 The Ipad could not be sync because the sync session failed to start

    The Ipad could not be sync because the sync session failed to start

    Sometimes simply quitting everything and restarting will fix this. Quit iTunes, restart your computer, restart (or reboot) your iPad and try again.
    Restart the iPad by holding down on the sleep button until the red slider appears and then slide to shut off. To power up hold the sleep button until the Apple logo appears and let go of the button.
    If you need to try rebooting - Reboot the iPad by holding down on the sleep and home buttons at the same time for about 10-15 seconds until the Apple Logo appears - ignore the red slider if it appears on the screen - let go of the buttons. Let the iPad start up.

  • The iPad could not be synced because the sync session failed to finish

    Please help.
    I've tried resetting my iPad several times and yet when I simply try to sync to iMac and deselect everything but music all I get is the message:
    The iPad "J's Ipad" could not be synced because the sync session failed to finish.
    I've tried everything - any advice would be gratefully received!
    Thanks,
    J.

    Make sure you have the most recent version of iTunes. If not update and then try again. Of you still receive this error then attempt to backup the iPad. Then perform a restore from the backup.
    The only time I have received this error was because iTunes was not updated to the most recent release.

  • When i connect my ipad to itunes it says "this ipad could not be used because the required software is not insatlled.Run the itunes installer to remove iTunes,then install the 64-bit version of itunes."

    When i connect my ipad to itunes it says "this ipad could not be used because the required software is not insatlled.Run the itunes installer to remove iTunes,then install the 64-bit version of itunes." I tried uninstalling and reinstalling itunes. so then i tried intsalling a stand alone if apple mobile device support (amds) but still it doesnt work. Plz help. using itunes 11.5 and windows

    so then i tried intsalling a stand alone if apple mobile device support (amds) but still it doesnt work
    Did you get an error message when you did the standalone AMDS install? If so, what does it say? (Precise text, please.)

  • Your submission could not be processed because the token has expired. Please reload the window.

    Your submission could not be processed because the token has expired.
    Please reload the window.
    This is an error that is very common on message boards, and only seems to happen fore firefox...people on chrome, IE, etc don't seem to get it. This error has been occuring since the very first version of firefox and has never been fixed since.
    You get this error when you have a thread open in a tab and try to reply to it after somet ime has passed. Refreshing it doesn't fit the problem unless you use ctrl+f5. It's very annoying, when is it going to get fixed?

    Well yes, ctrl+f5 will fix it...but why doesn't this problem happen in other browsers (apparently)?
    It's particularly annoying when i close the browser at the end of every day and have to manually refresh all my message board tabs the next day to post.

  • HT4623 Hi everyone, I updated my iphone 3gs to ios6. But, when it come to the activation screen, It showed up could not activate iphone because the activation server is temporarily unavailable. I tried to restore many times already but it still the same.

    Hi everyone, I updated my iphone 3gs to ios6. But, when it come to the activation screen, It showed up could not activate iphone because the activation server is temporarily unavailable. I tried to restore many times already but it still the same. Help me please! T-T

    Please see the  More Like This  section on the right.

  • HT4623 i tried to download the ios7 and when my phone rebooted it now says could not activate phone because the activation server cannot be reached, so now I can't get into anything on my phone

    i tried to download the ios7 and when my phone rebooted it now says could not activate phone because the activation server cannot be reached, so now I can't get into anything on my phone

    The activation servers are probably overloaded with everyone trying to update to iOS 7 today.  You might need to wait and try again later. 

  • HT201210 my ipad could not be restored because the firmware file is not compatible

    my ipad could not be restored because the firmware file is not compatible
    what can i do???

    iPad: Basic troubleshooting
    http://support.apple.com/kb/TS3274
    Update and restore alert messages on iPhone, iPad, and iPod touch
    http://www.buybuyla.com/tech/view/012953a0d412000e.shtml
    iOS: Resolving update and restore alert messages
    http://support.apple.com/kb/TS1275
    iPad: Unable to update or restore
    http://support.apple.com/kb/ht4097
     Cheers, Tom

  • IPad could not be restored because the firmware file is not compatible.

    Hi, i have the latest 3rd gen iPad 32GB and iTunes 10.6. I have the IOS 6 beta downloaded on my windows laptop. I had someone add my UDID to there apple developers acount. However when i press Shift+Restore and select the beta file a i get an error sayng 'iPad could not be restored because the firmware file is not compatible.' Has anybody got any idea on how to restore my iPad to the IOS 6 beta file i have downloaded?
    Thanks in advanced
    Joseph.

    You should ask this question in the Apple Developer Forums
    Since iOS 6 is not officially released nobody else can help.

Maybe you are looking for

  • Confused with Raid Sata drivers

    Sata,Raid Should I install these Drivers? Which one. Do I need a raid card? Building Computer for my wife.Ready to install OS. I got a floppy with MB.Says drivers for VIA sata raid. Floppy has two folders Pide and Raid. Checked with manual but still

  • Error downloading Mountain Lion

    Hi all, I just bought the new imac (late 2012). I did a migration from a time machine backup and everything was ok. After that I changed my mind and tried to start with a fresh new installation of the Mountain Lion so I went to App Store. I tried to

  • How to  calculate salesperson commission from receivables TRX

    Hi All I need to know how i calculate salesperson commission from receivables trx Regards;

  • Jdbc-odbc bridge with Connection pool datasource

    I have created a little j2ee app in which an enterprise bean accesses a ms sql server table by creating a JNDI datasource using sun.jdbc.odbc.JdbcOdbcDriver. I can successfully deploy it and run it on the jsdkee 1.3 J2EE server. However, when I attem

  • How can I speed up PDF generation?

    I am working on 2 manuals in Frame 10, unstructured. I have installed all the latest FM patches. The smaller manual is 270 pages with 200 graphics inserted by reference. It takes 2.5 hours to "Save as PDF." The larger manual is 500 pages, 250 graphic