HT2173 I turned off my desktop to plug it into a surger protector and now I'm not sure how to turn it back on
I turned off my computer so I could plug it into a surge protector. Not sure how to turn computer back on.
Making sure the surge protector is turned on, plug in the computer and press the power button on the right rear of the machine.
Similar Messages
-
NOT SURE HOW TO TURN OFF RESTRICTIONS AS i DO NOT HAVE A PASSCODE
not sure how to turn off restrictions
Are restrictions enabled? If they are and you don't know the restrictions passcode:
If You Are Locked Out Or Have Forgotten Your Passcode
iTunes 10 for Mac- Update and restore software on iPod, iPhone, or iPad
iPhone, iPad, iPod touch: Wrong passcode results in red disabled screen
iOS- Understanding passcodes
If you have forgotten your Restrictions code, then follow the instructions
below but DO NOT restore any previous backup. If you do then you will
simply be restoring the old Restrictions code you have forgotten. This
same warning applies if you need to restore a clean system.
A Complete Guide to Restore or Recover Your iDevice (if You Forget Your Passcode)
If you need to restore your device or ff you cannot remember the passcode, then you will need to restore your device using the computer with which you last synced it. This allows you to reset your passcode and re-sync the data from the device (or restore from a backup). If you restore on a different computer that was never synced with the device, you will be able to unlock the device for use and remove the passcode, but your data will not be present. Refer to Updating and restoring iPhone, iPad and iPod touch software.
Try restoring the iOS device if backing up and erasing all content and settings doesn't resolve the issue. Using iTunes to restore iOS devices is part of standard isolation troubleshooting. Restoring your device will delete all data and content, including songs, videos, contacts, photos, and calendar information, and will restore all settings to their factory condition.
Before restoring your iOS device, Apple recommends that you either sync with iTunes to transfer any purchases you have made, or back up new data (data acquired after your last sync). If you have movie rentals on the device, see iTunes Store movie rental usage rights in the United States before restoring.
Follow these steps to restore your device:
1. Verify that you are using the latest version of iTunes before attempting to update.
2. Connect your device to your computer.
3. Select your iPhone, iPad, or iPod touch when it appears in iTunes under Devices.
4. Select the Summary tab.
5. Select the Restore option.
6. When prompted to back up your settings before restoring, select the Back Up
option (see in the image below). If you have just backed up the device, it is not
necessary to create another.
7. Select the Restore option when iTunes prompts you (as long as you've backed up,
you should not have to worry about restoring your iOS device).
8. When the restore process has completed, the device restarts and displays the Apple
logo while starting up:
After a restore, the iOS device displays the "Connect to iTunes" screen. For updating
to iOS 5 or later, follow the steps in the iOS Setup Assistant. For earlier versions of
iOS, keep your device connected until the "Connect to iTunes" screen goes away or
you see "iPhone is activated."
9. The final step is to restore your device from a previous backup.
If you can not restore your device then you will need to go to recovery mode.
Placing your device into recovery mode:
Follow these steps to place your iOS device into recovery mode. If your iOS device is already in recovery mode, you can proceed immediately to step 6.
1. Disconnect the USB cable from the iPhone, iPad, or iPod touch, but leave the other end
of the cable connected to your computer's USB port.
2. Turn off the device: Press and hold the Sleep/Wake button for a few seconds until the
red slider appears, then slide the slider. Wait for the device to turn off.
If you cannot turn off the device using the slider, press and hold the Sleep/Wake
and Home buttons at the same time. When the device turns off, release the Sleep/Wake
and Home buttons.
3. While pressing and holding the Home button, reconnect the USB cable to the device.
The device should turn on. Note: If you see the screen pictured below, let the device
charge for at least ten minutes to ensure that the battery has some charge, and then
start with step 2 again.
4. Continue holding the Home button until you see the "Connect to iTunes" screen.
When this screen appears you can release the Home button.
5. If necessary, open iTunes. You should see the following "recovery mode" alert:
6. Use iTunes to restore the device.
If you don't see the "Connect to iTunes" screen, try these steps again. If you see the "Connect to iTunes" screen but the device does not appear in iTunes, see this article and its related links.
Additional Information:
Note: When using recovery mode, you can only restore the device. All user content on the device will be erased, but if you had previously synced with iTunes on this computer, you can restore from a previous backup. See this article for more information. -
I have an iPhone 4 and plugged it into itunes on my computer for the first time. Only to discover my sister has obviously plugged hers into my itunes account and now I have lost all my photos and numbers. Please help me!!
It can't do that by itself. You had to click through several prompts telling it to restore it from a backup of an old phone for that to happen.
If the phone was not backed up to iCloud before this happened, or to another computer, then the data is gone. There is no way to recover it. -
my iphone5s is dead...plugged it into computer to charge, and it says "internal device error" how can i fix....i already tried plugging it into all other ports
tried another computer?
if it works there then your itunes install have gotten defect -
my iphone fall in the sea and now it's not working how i can take off my photo and numbers ? and do u thing it will be work or what plz help me !!!!!!!!!!!!!!!
Sea water and electronics don't mix. The salinity fries the internal circuitry of the phone. Your phone is toast.
Certainly the user of any device which can be lost, stolen, or dropped in the sea would be smart enough to have had the data backed up, rght? Your photos and numbers should be safely backed up on your computer or in the cloud.
If you didn't do this, there's no way to recover those data now. Backups are meant to be done BEFORE disaster strikes, not after. -
I just got the iPhone 5s the Friday it came out. So today i decided to turn it off because some of the apps are not working. Now that i turned it off, it will not let me turn my phone back on until i plug it into iTunes. But i have and now its saying that until my iPhone is restored i can not plug it into iTunes. I already have . alot of stuff such as picture and contacts that i do not want to lose. What is going on and what can i do? This is honestly the most frusterating thing about IPHONEs. PLEASE HELP, I CAN'T HANDLE MUCH MORE. This should not be happening. I did NOT pay 300$ for this to happen in a less than a month of coming out.
Make sure you have the Latest Version of iTunes (v11) Installed on your computer
iTunes free download from www.itunes.com/download -
Iphone turned off whilst plugging it into a docking station and now wont turn on
Hi everyone.
So i plugged my Iphone into a docking station to play the radio last night and it completely turned off and now wont turn back on.
I have done the following:
12hour wall charging
Computer connected
All resets done.
Still nothing. Anyone shed any light? I'm going crazy!
ThanksConnect iPhone to Wall Charger and Reset, hold both Home and Power buttons until the iPhone begins to start. Usually takes 20 seconds of holding both buttons.
-
should have typed in here...
If your computer is a 2011, you can stop the blue screen by turning off graphic card switching. Under apple, system preferences, energy, uncheck box. Temporary fix. Your logic board may need to be replaced if you are under warranty or have apple care otherwise $1000.00. May be software or firmware problem but apple has provided no info. Replacing logic board has corrected problem for some users and not others. Everything I've mentioned only applies to 2011 MBPs.
-
I just hooked up apple tv not sure how to turn it off
Hooked up apple tv it's a wonderful accessory but I don't know how to turn it off
Under the setting menu you will find a "sleep now" option, which will turn it off. The factory settings on the ATV is to turn off after 15 or 30minutes of inactivity.
-
By the way, I am using 2013 MacBook Air.
Photoshop CC is in the Application folder. You can Ctrl-click on Photoshop CC.app and create an alias (shortcut icon) and drag it ti the Desktop.
You can also keep it in the Dock. -
It is safe to say that i need help..................
let me start at the beginning.
I have 1 2008 imac. always a pleasure never been a problem. Attached to it i have an iomega 500gb ext drive. also been ok.
until now!!
The HDD would not mount. Disk utility suggested that it was ok so i tested the imac HD. I got error code 4MOT/2/40000004: HDD- 1502. This doesnt worry me at the moment.
I attached iomega to my Mac book pro and again it would not mount. The disk utility did tell me that the iomega needed repair. it advised that i should wipe it and restore.
So I used the MB Pro disk utility to create a DMG. and saved it to the desk top. I then erased the iomega. did a repair and it all seemed ok. So then i try to do a restore.
After a very long time it said internal error with the dmg. using disk utility i did a convert dmg (compressed) and saved it to the iomega. middle of the night job!!
got up this morning and indeed it had sent the DMG to the iomega. But i could not open it. The iomega itself seemed dandy asking me if i wanted to use it as a time machine etc and it mounted ok and i saved a small jpeg to the iomega as well. I then thought that maybe when i did the convert as a compressed file i made a mistake. i'm guessing it should be a read and write so i started all over again.......... wiped iomega (which was quite quick) then tried the convert tool again.....it trys for a while then says there is not enough disk space...........I'm not sure which disk it is refering to.??
I have purchased a 1tb hard drive today incase the iomega is some how full up.
So really my question to the world is .........Help?well no reply from the community. sniff- do i stink!? - probably a little bit. If i have lost all that data then I'm gonna really really pong.
Any ways i have purchased a 1tb usb HDD and have managed to duplicate the dmg file onto it. however still unable to mount the **** thing. so now i have ordered disk warrior which will be in my possession tomorrow.
fingers toes eyes crossed. -
How do I turn off Mavericks' word "correction"?
Its vocabulary is too limited and the changes it makes to my work turn proofreading into a nightmare.Check out this link
http://support.apple.com/kb/ph13919 -
turned off my desktop mac, now both my mouse and keyboard are not connected. i am not logged in yet as well, dont know what to do ?
Try resetting the SMC (no peripherals required).
Barry -
How can I turn off battery charging when plugged in to power on a plane?
Hi,
is there an app that can turn off battery charging while plugged in?
I regularly fly from Australia to Europe (22 hours on the plane!) but the power outlet usually stalls when draining too much power
(e.g. 85 Watts for my Macbook Pro battery).
Any solutions available?
I used to just take out the battery, however, that is not possible anymore on the Macbook Pro.
Thanks for your help.
ChristophBut why turn off battery charging, makes no sense in this case. You either run off the battery or plug it in and run off the battery while it is charging.
The power draw won't change appreciably.
My bad power consumption will change
It would seem the best strategy would be to get on with a fully charged battery plug in the laptop and let it trickle charge as you use it. Given the length of the flight this should give you the longest use with the minimum amount of draw from the seat outlet. -
Hi guys well huge issue my Ipod 4th generation shuffle died and I tried to chrge it I plugged it into the USB port and the red light came on and after 5seconds turned off the whole Ipod is dead and I've tried in wall chargers as well that doesn't charge what should I do is there a solution or should I claim my warrenty and have it fixed??
Also my Itunes and computer won'r reconize it
Maybe you are looking for
-
How do i turn off block to access my banks e-mail account?
While accessing my banks e-account to download my statement, it informs me that Firefox is blocking it.
-
I am getting error from R12 while starting the app services... ERROR: apdevmgr@bhap0006-/opt/pbn1oebd/inst/apps/PBN1OEBD_bhap0006/admin/scripts # ./adstrtal.sh You are running adstrtal.sh version 120.15 Enter the APPS username: apps Enter the APPS pa
-
Web interface displays via Portal using Mozilla or Firefox
We have several web interfaces (BW-BPS) and have created iViews on our Portal (EPP 6.0). These iViews properly execute in IE 6.0. However, when we execute the BPS iViews using Mozilla or Firefox we see significant display discrepancies. For example,
-
Change richtexteditor backgound-image
Hi experts. I'm using jDeveloper 11.1.1.6.0. I have 2 richtexteditor in my jspx. The first rte must show img1.jpg (like watermark) in your panel editor (panel blank for edition on richinputtext) and the second rte must show img2.jpg. I want to change
-
Probably Project Properties Problem....Not Sure
Hi Everyone, I'm new to Mac's, Final Cut and of course, Live Type. I'm putting a project together and I'm having a problem with Live Type and the only thing that I can think of is that my settings are not set correctly. My project in FCE is set to be