HT3406 my iphone 5...was working awesome but after erasing i powred it on.....later it required a sim card....i installed a srilankan service provider (DIALOG) sim......it dosn't work.......
my iphone 5...was working awesome but after erasing i powered it on.....later it required a sim card....i installed a srilankan service provider (DIALOG) sim......it dosn't work.......please help me how can a recover my iphone back......
It sounds as though your phone had been hacked to remove the network lock.
When you restored the phone it relocked itself to the original network and it will now only work if a sim from the original network is used.
Similar Messages
-
Please my iphone is on the activation page and i can't do nothing, there is a sim card into but itune don't recognise it, and the phone don't want to activate. I tried everything, and before the reboot the iphone 3 was worked verry well. Please help me !
Hello there, rebeccallouche.
The following Knowledge Base article offers up some great steps and links to some additional information that is pertinent when having activation issues with your iPhone:
iPhone: Troubleshooting activation issues
http://support.apple.com/kb/ts3424
Additionally, if the iPhone is not being recognized in iTunes this article will be useful as well:
iOS: Device not recognized in iTunes for Windows
http://support.apple.com/kb/ts1538
Thanks for reaching out to Apple Support Communities.
Cheers,
Pedro. -
My iphone 4 was working good until IOS6 update, now I can't hear anything, my ear phone donot response ...Speaker are ok..if some one call me...they can hear me ...but I can't hear them.....please desperately need help...plz suggest...all reset is done...except restore ...
Anyone? . . . :S
-
my iphone 4s was working fine then it just turned off and wont turn back on but my home button dosent work what do i do?
Apart from the battery being dead (make sure by plugging into a power source for 15 minutes), hold the sleep/wake button and home button together for 10 - 20 seconds or until the apple logo appears.
If your iPhone, iPad, or iPod touch doesn't respond or doesn't turn on - Apple Support -
purchased Iphone 4 tonight......will not let me get to yahoo email....says "cannot connect to yahoo server" My iphone 3 was working just fine tonight and then I traded it for this! help
Do a hard reset
Settings / general / Reset / Reset All Settings
Now setup your Yahoo mail. -
hi pls help me my iphone is forest i update but after my iphone is devices open is not working i click but sim card installed , attempting to activate this one coming pls help me answer me
Sounds like your phone was hacked to use with your carrier. Updating it has relocked the phone to it's original carrier. You will not get the phone working again without a SIM from the original carrier.
-
am not able to activate my iphone it was working fine i restored it . i have entered the correct apple id and pass still its not able to activate
i am the original owner of the iphone 5s i been using for a month the and the apple id and pass is the correct one
i just restored it and i am entering the same apple id and pass still its giving the error msg . but with the same id and pass iam able to log in to itunes ,icloud -
my iphone 5 was 26% baterry, but it's suddenly turned off and not turn on what should i do ?
I bought a iphone 5 from a boy 2 months ago,and in 24 december when my phone was on charging ,automatically stop.I don”t know why ,but there was never openly
After that i try to solve the problem, but guess what?! the phone in the apple sistem appear stolen.But how could i use it ?I am very disappointed of Apple.It seems that it is a problem with the processor so i can trow to the trash the phone because it is usefull.
i think you have same problem .So nothing ...
it is a processor problem -
My iPhone 4 was working and then just closed down
Hi. My iPhone 4 was working perfectly until about an hour ago. Now it won't even turn on or update through iTunes. Anyone else had this problem?
Have you tried resetting it:
Press the Sleep/Wake button & Home button at the same time, keep pressing until you see the Apple logo, then release. -
My IPhone 4 was working fine, and now it's not
My IPhone 4 was working fine, an hour later I looked at it again and it was turned off and it wouldn't start again. I tried plugging it into different wall outlets and I have it plugged in to the computer I synced it to, it still won't turn on. does any one have any suggestions?
If justinav's reply does not work:
Plug your iPhone into the wall charger (not a computer), and hold down the sleep/wake button ('power button' on top) and the home button for 20-30 seconds. I find this helped when it happened to my phone once. Plugging it into the wall charger appeared to give it the juice I needed to get up and running again... -
IPhone 4S was working fine until recenty after updating the software to the 5.1 version
My iPhone 4s was working fine until I recently updated the software to version 5.1, now it locks up on nearly any screen and reverts back to the main screen. Even in settings, if I go in a few tabs in settings all of a sudden it takes me back to the main screen. I have done a total reset on the phone and it has not helped.
Also, it is now completely frying the battery goes from 100% to 35% in about 4 hours. I have killed all apps running and it is still hot and using up the battery.I have done all of the above suggested restart, reset and restores using iTunes and without. No luck.
What I have found is that under Settings; General; About; Diagnostics & Usage; there is an error message populating every single minute that says low memory. It appears that the reset back to the main screen coincides with this error message. I have very little data stored on the phone, 13 Gig available.
How does one go about emptying this memory? -
my Iphone 5s was working perfectly before downloading the IOS 8.0.1 and later IOS 8.0.2. When my Iphone run out of battery, I connected it to Itunes, however the phone never turned on, and kept trying to sync, however got an itunes failure message.
Any help in this regards please.Hello douraid,
Start with the article below to get your iPhone to take a charge. Once you get it powered back on, you will want to sync again to make sure nothing was lost during the attempted sync.
iPhone and iPod touch: Charging the battery
http://support.apple.com/kb/HT1476
Regards,
-Norm G. -
I made a purchase from an app on my iPhone, I was charged twice but I only received the product once, how can I get a refund?
Hi .
Click here > How to report an issue with Your iTunes Store purchase
And explain that you were charged twice here > Apple - Support - iTunes Store - Contact Us -
I've just had my new iphone which was a update but my music or apps are not on my new phone
I have just had my new iphone which was an update but my i tunes music or apps are not on the new phone
did you sync your new phone to itunes?
-
Received an authorized unlock code from apple/AT&T for my off-contract 3GS (8GB). Per the “Completing Authorized iPhone Unlock” instructions, I connected to iTunes to back up and restore so my iPhone can be unlocked! But after the restore my iPhone is stuck at the activation screen, it will not activate saying “Your iPhone cannot be activated because the activation server is temporarily unavailable”. I tried this again and again for countless times, no way! I have my old AT&T simcard and other carrier’s simcard. Both will not help. Please help me to activate and start using my phone.
Hello,
I got like the same problem, last days I get message to restore my iPhone, so I did it yesterday and it work very well. In the afternoon I saw that at top in the left corner show invaild sim card or so (only knew the german version). so I restore it again but now it won`t activate after I enter SIM-PIN and it accept it, it shows "No Service".
Anybody can help? My Carrier is o2 Germany.
Thanks!
Maybe you are looking for
-
Why my ExceptionDemo won't compile??
public class ExceptionDemo{ public static void error(int i) throws FirstException, SecondException{ if (i==1) throw new FirstException(); if(i==2) throw new SecondException(); else System.out.println("no exception!"); pu
-
Making event scripts generic between environments
At present we have a couple of FDM event scripts which construct some MaxL statements and then execute them against the Essbase database (to clear data before loading). The problem we have is that the MaxL scripts require hard-coded usernames, passwo
-
I am in need of some help, so I have been playing around with sharpeoint for some time now and Users are having authentication issues. When a user logs in and opens a document from SharePoint. He/she gets prompted for than twice. I have found out tha
-
How to quickly switch a writing language? Pencil's...
Hello there. I have to switch a writing language very often, so using the pencil's menu is quite long way for me. And many colleagues of mine agree with me. I'm not kidding. Does anybody know any 3rd party apps which allow define a short-key combinat
-
Dispacting navigation events from creation complete.
Why does this event work if it's triggered from a button (Changing a viewstack event) <<BUTTON CODE>> <mx:Button id="linkToReg" label="Need to Register?" click="clickToRegistrationHandler(e