HT3529 Why is my messages sending green and not blue

Why is my messages sending green and not blue

Green means the message was sent as an SMS/MMS.
Blue means the message was sent as an iMessage.
If sent as green, the recipient doesn't have an iPhone with iMessage enabled or if they do, they have turned iMessage off.

Similar Messages

When texting why are the messages sometimes green and sometimes blue?

Why are text messages sometimes green and sometimes blue?

Blue = iMessage...
Green = Text message... SMS
You may find the Information in this link of Interest...
http://howto.cnet.com/8301-11310_39-20107458-285/how-to-get-started-with-imessag e/

It's sending my messages as a text message when I'm texting another iPhone. How can I fix that? The messages are green and not blue. This just starting during half my conversation.

I was texting another iPhone when right it the middle of my conversation, it turned from blue to green. Now its sending all my messages as text messages and not iMessages. How can I fix this?

It could be that your signal dropped to GSM which is why it sent as a normal text. You need wi-fi, 3G or HSPDA to send as an iMessage. As does the receiver

Why when I send messages from my iphone to other iphones, they come up green and not blue? I have all the settings on for I message, but my number comes up grey and not Black? Help someone please!

Why when I send messages from my iPhone to other IPhones, they come up green and not blue? I have all the settings on for I message b ut my number comes up grey and not black? Please someone help!

Hi evan191,
Thanks for using Apple Support Communities. This article has some steps you can try if your messages aren't sending as iMessages:
iOS: Troubleshooting Messages
http://support.apple.com/kb/ts2755
If you still can't send or receive iMessages
Ensure that iMessage is turned on in Settings > Messages.
To send and receive iMessages, your device must have a valid cellular or Wi-Fi data connection.
iPhone: Troubleshooting Cellular data
iOS: Troubleshooting Wi-Fi networks and connections
iMessage registration validates your Apple ID for use with iMessage. If you are unable to activate iMessage, follow this article.
If an iMessage cannot be sent, it will be resent using SMS or MMS, depending on the content. You can turn this behavior on or off in Settings > Messages > Send As SMS. Carrier messaging rates may apply.
Verify that the Apple ID or phone number is listed in Settings > Messages > Send & Receive.
Cheers,
- Ari

Why are some instant messages colored green and some blue

why are some instant messages colored green and some blue

Green is SMS, Blue is iMessage.
http://manuals.info.apple.com/en_US/iphone_user_guide.pdf#page66

Sometimes when iMessaging text show up green and not blue

Some times when I massaging tex show up green

To be correct.
iMessages are blue. Only those with a Mac computer or iOS device can receive iMessages. iMessages are sent using data, not yoru text messaging plan.
SMS/MMS are green. iPhones can receive SMS/MMS and iMessages. SMS/MMS require a text messaging plan.

Why we dont need sender agreement and comm channel in IDOC to file scenario

Hi,
there are 2 queries:
first query :
Scenario is "Idoc to file transfer"
why we dont need sender agreement and communication channel for IDOC to file ,while we do need
both of these for "File to RFC "
Answer : which i got is because IDOC sits at ABAP stack but same is valid for RFC also.
Then why For "IDOC to file" we dont need that.
Second query:
Also when i did scenario for File1-RFC-File2 scenario using BPM i have created a interface
between XI-RFC synchronous to send data which we got from file1 in XI to RFC importing parameter
and getting data from RFC back to File2.
Here in IDOC to file scenario why we dont need any interfface for IDOC-XI Asynchronous.
Regards,
Mayank
Edited by: mayank verdia on Jan 13, 2009 11:49 AM
Edited by: mayank verdia on Jan 13, 2009 11:50 AM

Dear All,
For file to idoc scenario is there any possibility to get line items details or xml details i.e the segments and its related field details using reference id, transaction id or interface name or message id in SAP PI 7.0. I know we need to click each and every message in sxi_monitor and look for details.
For SAP(R3 System) I can create a report and set the job for specific time period so automatically it throws the details(like reference no, document date, invoice no from) in ftp path as .csv file. The same ftp path is maintained in program.
I wanted to check FTP--->PI postings and I have set the job at r3 system it is working fine and Im monitoring it too.
Now the end to end scenario is FTP--->PI--->ECC(R3 system). Please help.Many Thanks.

Why is the text bubble to the same person with another iPhone sometimes green and sometimes blue?

Why is the text bubble sometimes green and sometimes blue when I text to the same person/number who has an iPhone 4s?

Ebe68 wrote:
the colors indicate if the message receiver has a iphone or not. Blue for iphone, green for other.
Not necessarily an iPhone but rather if they have iMessage support at the address you're using.
If you're using an email address they could have an iOS device or a Mac.

I cannot receive texts on my phone. They are coming into my iPad. What happened? I can send texts, but they are now green and not the blue color. ??

I cannot receive texts on my phone. They are coming into my iPad. What happened? I can send texts, but they are now green and not the blue color. ??

Turn iMessage on for your devices.
Settings > Messages > iMessage.

HT4993 Why iPhone 4S keeps sending double and triple texts, and random words I never typed. Any ideas?

Why iPhone 4S keeps sending double and triple texts, and random words I never typed. Any ideas?

Jailbroken?
is this happening to SMS and iMessages?

Unfortunately messaging has stopped and not receiving text messages

I, am also having issues with "unfortunately messaging has stopped", AND, NOT receiving text messages. I also have 2 other Droid Ultra's on my account doing the same thing. This is totally unacceptable!!! I am not paying $600 for a piece of crap phone that does not work. I had my phone recently replaced because Verizon thought that was the problem. I can't even get the message screen to stay up long enough to type a message, if it opens at all!
Also I am getting tired of NOT receiving messages sent to me! When I do get them, the icon tells me I have a message with a number usually no more than a designation of 2 but reverts back to a 1, and, when I open the message, read it, and close out of it, if it does not close out on its own because of stopped messaging, the number on the message icon does not clear out. I have to turn off the phone and restart it to clear it. This is not acceptable and I would expect better from Verizon, not the run around!! If I had to send an urgent message and get a reply, do to the fact I am disabled, and this is my only way to communicate, that this is extremely unacceptable!!!!
I expect this to be resolved yesterday, not when you all get around to it, OR, issue me a Samsung!!! I am sure all of the others would agree!!!
I look to hear from you ASAP!!

Hello,
I am using the messaging app that was preloaded with the phone, the green face icon. I do not have an "Android Keyboard" app, but I have cleared the cache on the "Messaging" app, several times. I have also gone to the Verizon store where an associate did a soft reboot, telling me that would work. A very short time later, the error message started appearing again--so this did not work either.
The error message comes very sporadically. Sometimes several in a few minutes, other times not for hours.

Since I downloaded the new update on my iphone 4s I no longer see the delivered message under my text when sent. Also the message is green instead of blue. Does anybody know how to fix this?

Since I downloaded the new update on my iphone 4s I no longer see the delivered message under my text when sent. Also the message is green instead of blue. Does anybody know how to fix this?

You are sending SMS messages. iMessages are blue. Go to Settings>>Messages>>iMessage ON.

I have 100's of CDs that I have downloaded to my itunes library and they are in the library playable but they do not show up in the C drive under the iTunes Music folder under users. Why are they in the libary and not in the itunes music folder. Win 7 OS

I have 100's of CDs that I have downloaded to my itunes library and they are in the library playable but they do not show up in the C drive under the iTunes Music folder under users. Why are they in the libary and not in the itunes music folder. Win 7 OS. When I look in the library under the get info screen it says they are in the folder itunes music, under the c: drive but when I actually go to that folder to look for them they are not there....HELP!

Hello RumDog,
I think this article will help you find the media in your library.
Where are my iTunes files located?
http://support.apple.com/kb/ht1391
Discovering and changing the iTunes Media folder location
Note: You would usually only change the iTunes Media folder location to share music between accounts on the same computer. See this article for specific steps on how to accomplish this. Also, see this article if you want to know how to move your music to a new computer.
Mac OS X: Click the iTunes menu and choose Preferences.
Windows: Click the Edit menu and choose Preferences.
Click the Advanced pane. iTunes displays the location of your iTunes Media folder.
You can then:
Note where your media folder is, such as for backing up your media.
Use the Reset button to reset it's location to the default (which is the iTunes folder).
Click the Change button to select a folder for a new location. Once you change this location:
If you make a new or alternate iTunes library, the new location will be used by that library.
Existing files will not be moved unless you choose File > Library > Organize library and choose the option to "Consolidate files."
From: Where are my iTunes files located?
http://support.apple.com/kb/ht1391
Cheers,
Sterling

Why do i get 2 curves and not just 1 when i create a diagram from a row of data in a table ?

Why do I get 2 curves and not just i when I create a diagram from a row af data in a table ?

Erik,
Thank you for giving me the points. Generally you wait to award points until your problem is solved. It is totally your at your descretion.
OK.
This is still not clear. To post a screenshot get the "stuff" you want to show in view on your screen, then type the key combination <Command>+<Shift>+3. The cursor will change to a crosshair. Click and hold on the top-left corner, then drag to enclose what you want to show (to the bottom-right corner), then release. The screenshot will appear on your desktop and will be named something like "".
Now click the camera icon in the tool bar for this forum:
, click the text box to allow you to navigate to, and select your screenshot.
Here is what you sent me:
The graph does not seem to be associated with the table of data you are showing. Generally when you highlight a graph the corresponding table will highlight and show the source of each of the series in the graph (dark and light blue).
This is what I would expect to see when highlighting a graph:
Right now I think there is ANOTHER table arround that is the source for the graph and the table you show is "just another table". You can move your data into the table the graph refers to by copy and paste, or simply typing the values. You can change how many series there are by grabbing the little circle at the bottom right of the highlighted cells (when you have the graph highlighted) and dragging as shown:
The Numbers Users' Guide is a great resource you should utilize and can be found here:
http://support.apple.com/manuals#macosandsoftware
The chapter on graphing (or charting) is 7 and starts on page 134.

Why IPC uses CRM as database and not R/3 ?

Hi ,
can any one help me with an answer for the following question :
<b>Why IPC uses CRM as database and not R/3 ?</b>
Points will be rewarded for helpful answer
thanks
ritu

Hi
IPC have Sales Pricing Engine, Pricing Configuration engine and TTE which helps to maintain the similar R3 pricing settings. As you are aware pricing in R3 is determined by Sales area, Cupp, DPP, so IPC is capable of determining the Pricing using same R3 standard procedure. T
This is not available in CRM, so CRM needs IPC to undertake the determine pricing/ calculate the pricing of the products.
Regards
Nagarj

HT3529 Why is my messages sending green and not blue

Similar Messages

Maybe you are looking for