HT4623 my ipad has been disabled due to entering wromh password. how do i enable it again? Thanks and Regards

my ipad has been disabled due to entering wromh password. how do i enable it again? Thanks and Regards

See Here  >  http://support.apple.com/kb/HT1808
You may need to try this More than Once...  Be sure to Follow ALL the Steps...
Pay particular attention to Steps 3 and 4.
Some users have reported as many as 8 or 9 attempts were necessary before success
After you have Recovered your Device...
Re-Sync your Content or Restore from the most recent Backup...
Restore from Backup  >  http://support.apple.com/kb/ht1766

Similar Messages

  • HT1212 my ipad has been disabled due to lack of password.  I hooked it up tp the computer but it did not work

    Imy ipad is disabled and I can not remember passcode

    Hope these instructions are clearer.
    1. Turn off iPad
    2. Turn on computer and launch iTunes (make sure you have the latest version of iTune)
    3. Plug USB cable into computer's USB port
    4. Hold Home button down and plug the other end of cable into docking port.
    DO NOT RELEASE BUTTON until you see picture of iTunes and plug
    5. Release Home button.
    ON COMPUTER
    6. iTunes has detected iPad in recovery mode. You must restore this iPad before it can be used with iTunes.
    7. Select "Restore iPad"...
    Note:
    1. Data will be lost if you do not have backup
    2. You must follow step 1 to step 4 VERY CLOSELY.
    3. Repeat the process if necessary.

  • My iPad has been disabled due to wrong passcode which I have forgotten,How can open it again?I'm so desperate right now

    My iPad has been disabled due to wrong passcode which I have forgotten,How can open it again?I'm so desperate right now

    If you cannot remember the passcode, you will need to restore your device using the computer with which you last synced it. This allows you to reset your passcode and resync the data from the device (or restore from a backup).
    If you restore on a different computer that was never synced with the device, you will be able to unlock the device for use and remove the passcode, but your data will not be present.
    You may have to force iPad into Recovery Mode
    http://support.apple.com/kb/ht1808

  • HT3562 I activated my voiceover and now i cannot enter my passcode to unlock my phone. phone has been disabled due several entering of passcode, phone says connect to iTunes but am unable since phone is still locked. kindly assist

    I activated my voiceover and now i cannot enter my passcode to unlock my phone. phone has been disabled due several entering of passcode, phone says connect to iTunes but am unable since phone is still locked. kindly assist

    If you have an iTunes backup that includes the photos you may be able to extract them from the backup using a 3rd party utility such as http://www.wideanglesoftware.com/ibackupextractor/

  • TS2446 My apple ID has been disabled. I changed my password. Signed out then in again. Still disabled. What should I do?

    My apple ID has been disabled. I changed my password. Signed out then in again. Still disabled. What should I do?

    try this website https://ssl.apple.com/emea/support/itunes/contact.html

  • HT201363 my ipad has been disabled due to one of my household trying the 4 digit pin to unlock it ..they obviously got it wrong..i have plugged ipad into myitunes on my laptop and it is still disabled..how do i re enable it ?

    my ipad mini has been disabled due to one of my household trying the 4 digit pin to unlock it..they obviously got it wrong...i have plugged into my itunes as requested on screen into my laptop but it is still disabled ..what do i do to unlock and re enable??

    Hey ade17768,
    Thanks for the question. The following resource outlines what to do if your device is disabled:
    iOS: Forgotten passcode or device disabled after entering wrong passcode
    http://support.apple.com/kb/HT1212
    If you have previously synced your device with iTunes, you may be able to reset the passcode by restoring the device:
    1. Connect the device to the computer with which you normally sync and open iTunes.
    Note: If iTunes asks you to enter the passcode, try another computer that you have synced with. Otherwise, go to "If you have never synced your device with iTunes, or you do not have access to a computer" section below.
    2. If the device is still disabled, or if iTunes does not automatically sync your device, sync the device with iTunes.
    3. When the backup and sync is complete, restore your device.
    4. When iOS Setup Assistant asks to set up your device, choose "Restore from iTunes backup".
    5. Select your device in iTunes and choose the most recent backup of your device.
    Thanks,
    Matt M.

  • HT204390 my ipad has been disabled due to the pin number being entered incorrectly too many times.  how do we resolve this?

    how do we reinstate ipad use when it has been disabled by pin number being entered incorrectly too many times. it is now locked

    This article contains instructions on what to do if your device is disabled:
    iOS: Forgotten passcode or device disabled after entering wrong passcode
    http://support.apple.com/kb/ht1212

  • My ipad has been disabled, my younger brother changed password and forgot it.  i no longer have the laptop i synced it with last. what do i do? can somebody please help..? thank you

    i cant use my ipad it has been disabled.  my younger brother changed the password and no longer remembers it.... Now i am stuck as the laptop i last synced the iPad with no longer works and the ipad is disabled.  Can anyone help...????

    And you are going to maintain regular backups of the computer that holds the data synced from your iPad? You know, just in case your iPad AND your computer get a problem?

  • HT1386 ipad has been disabled due to blocked password, how to solve it?

    And iTunes cannot connect to it due to the password trouble. How do I solve it???

    You have to restore the device within iTunes. You want to use the same computer that you always sync with so that you can restore your app data and settings. You can restore with any other computer, but you will lose everything on the iPad.
    iOS: Device disabled after entering wrong passcode

  • TS2446 My iphone 5s has been disabled do to forgotten pin #. How do I enable the phone

    I have a company IPhone5s. In working with my settings i inadvertantly assigned a new pin and then forgot what is is. I tried a few times to access my phone with what i thought was the correct pin, but after trying several times my phone became disabled. How do i enable the phone again

    iOS: Forgotten passcode or device disabled after entering wrong ...

  • My iPad has been disabled due to not having enough storage for backup in iCloud. I attempted to download photos to my computer, however, I get the message that no photos were found. In the meantime, I cannot access my pad.

    iPad4 - unable to backup due to lack of iCloud storage . The pad is frozen. Cannot access any info.

    However, if the iPad is frozen, a reset may allow you to get back into it again. It hurts nothing to try this. It is like rebooting your computer.
    Reset the iPad by holding down on the sleep and home buttons at the same time for about 10-15 seconds until the Apple Logo appears - ignore the red slider if it appears on the screen - let go of the buttons. Let the iPad start up.

  • Ipad has been disabled

    Hi all, My ipad has been disabled due to incorrect password keyed. I know I can recover it by connecting it to the old pc that was used to sync with this ipad.Yet, my real problem is that that old PC has was not working any more...pls help...:(

    You have to restore the device within iTunes. There is no other way to do it. You need a computer. You can restore with any other computer, but you will lose everything on the iPad.
    This will tell you how to restore
    iTunes: Backing up, updating or restoring iOS software
    If you cannot restore that way, you may have to use recovery mode
    iPad: Unable to update or restore

  • My ipad has been disabled how do undisable it so i can use it again

    My Ipad has been disabled because i enterd the password to many times how do i make it so i can undisable it please help this is my life line for work?
    Thanks Kdrobbin

    You will have to restore/erase it to remove the Disabled status, then you can restore form a backup once it's up and running again, if you have a backup on iTunes or iCloud.
    Source: iOS: Forgotten passcode or device disabled after entering wrong passcode
    If you have Find My iPhone enabled, you can use Remote Wipe to erase the contents of your device. If you have been using iCloud to back up, you may be able to restore the most recent backup to reset the passcode after the device has been erased.
    Alternatively, place the device in recovery mode and restore it to erase the device:
    Disconnect the USB cable from the device, but leave the other end of the cable connected to your computer's USB port.
    Turn off the device: Press and hold the Sleep/Wake button for a few seconds until the red slider appears, then slide the slider. Wait for the device to shut down.
    While pressing and holding the Home button, reconnect the USB cable to the device. The device should turn on.
    Continue holding the Home button until you see the Connect to iTunes screen.
    iTunes will alert you that it has detected a device in recovery mode. Click OK, and then restore the device.
    iOS: Back up and restore your iOS device with iCloud or iTunes

  • My Ipad has been disabled. What do I do next?

    My Ipad has been disabled. What do I do next?

    Disabled device due to entering wrong passcode?
    You will need to connect the device to the computer that you normally sync to and you should then be able to reset the device and re-sync your content to it (http://support.apple.com/kb/HT1212) - you may need to put the device into recovery mode :http://support.apple.com/kb/ht1808

  • HT1212 Hi, My IPAD has been disabled and says try again in 22,641,304 minutes and when I go into ITUNES there is no window to open the IPAD with a password. How do I enable my IPAD as I have also moved to a new MAC from my old Lenovo that the IPAD was ori

    Hello,
    My IPAD has been disabled as I lost it in the office and it was just recently returned to me. It says on the screen that IPAD DISABLED and says please try again in 22,641,304 minutes. Can you please advise how to enable this as the computer I am using now (MAC RETINA) is not the original computer that the IPAD was synced on.
    Thanks

    Locked Out, Forgot Lock or Restrictions Passcode, or Need to Restore Your Device: Several Alternative Solutions
    1. iOS- Forgotten passcode or device disabled after entering wrong passcode
    2. iPhone, iPad, iPod touch: Wrong passcode results in red disabled screen
    3. Restoring iPod touch after forgotten passcode
    4. What to Do If You've Forgotten Your iPhone's Passcode
    5. iOS- Understanding passcodes
    6. iTunes 10 for Mac- Update and restore software on iPod, iPhone, or iPad
    Forgotten Restrictions Passcode Help
    You will need to restore your device as New to remove a Restrictions passcode. Go through the normal process to restore your device, but when you see the options to restore as New or from a backup, be sure to choose New.
    Also, see iTunes- Restoring iOS software.

Maybe you are looking for

  • Can i use iCloud for my small business

    I have a small business with 50 employees and want to know if iCloud could be used as an alternative to 365?

  • How to share music with others through AIM

    music that i purchase through itunes can not be shared. if i send a song through AIM the person recieving it will get a message. asking for my password. why is that?

  • Discoverer Viewer Actions changed by User (version Oracle 10.1.2)

    Does anyone know if it is possible to control the list of available actions to selected users of discoverer Viewer? I'm using a Portal Dashboard to display Discoverer worksheets. The user can click on the analyze link, which brings up the Discoverer

  • Error showing disp+work.exe while starting management console

    Hai, I tried to install ABAP 7.01 trial version to practice webdynpro.. I did almost like installing msloopback adapter installed maxdb installed AS installed SAPGUI When I try to start management console it is giving disp+work.exe error . With refer

  • PK column. where to find it ?

    Hi guys I need to know wich column is the primary key of my table. First I looked in user_tab_cols select * from user_tab_cols where table_name = 'MY_TABLE' but it retrieves all the columns... where can I find only the primary key column ? thanks, Fe