HT4623 My iPhone 3G will not stay connected to wifi
Can anyone tell me how to get my phone to stay connected to wifi?
Settings > General > Reset > Reset Network Settings.
Power cycle the router.
Similar Messages
-
iPad 3 and iPhone 5 will not stay connected to wifi although I am close to router and have strong signal. I have to keep joining the network or restarting devices or forgetting network and rejoining it. As a side note my 1st gen iPhone which I upgraded to iPhone 5 yesterday always stayed connected!
The steps to try would be to:
1. Restore the iPhone to Factory.
2. If that does not solve the problem replace the iPhone.
If Verizon is offering to replace the iPhone for free under warranty I would go with that option. -
My iphone 5 will not stay connected to wifi anywhere. I cant get it to connect at all. What can I do to get this fixed?
does this only happen at your home network or with multiple networks?
have you tried everything here? http://support.apple.com/kb/ts1398 -
TS1398 Iphone 4s will not stay connected to wifi after update
I can see my network, it connects for a few seconds and then disconnects. This started after the update. I have tried reseting the router, the phone..............everything 100X.
All my other devices work fine and other types of phones can connect to my network. It's a specific problem wth this phone.Hello Danielle,
Thank you for the details of the issue you are experiencing with Wi-Fi on your iPhone 4s. I recommend the following steps:
Be sure you're in range of your Wi-Fi router (access point).
Tap Settings > Wi-Fi and turn Wi-Fi off and on. If your W-Fi setting is dimmed, follow these steps.
Confirm that your Wi-Fi router and cable or DSL modem are connected to power, turned on, and connected to the Internet. If not, refer to your network administrator or Internet service provider (ISP) for assistance.
Restart your iOS device.
Tap Settings > Wi-Fi and locate the Wi-Fi network to which you're connected.
Tap and Forget this Network.
Try to connect to your desired Wi-Fi network.
Note: You may need to enter your Wi-Fi password again if your network requires one.
Turn your Wi-Fi router off and on2. If your ISP also provides cable or phone service, check with them before attempting this step to avoid interruption of service.
Update your device to the latest version of software.
Update your Wi-Fi router to the latest firmware2. For AirPort Base Stations, install updates using the AirPort Utility.
If the issue is still unresolved Wi-Fi disconnects or signal strength is less than expected
Move closer to the Wi-Fi router (access point).
Check for sources of potential interference.
Remove any case, stand, or other accessories from your iOS device and see if signal strength improves.
Reset network settings by tapping Settings > General > Reset > Reset Network Settings. Note: This will reset all network settings including
previously connected Wi-Fi networks and passwords
recently used Bluetooth accessories
VPN and APN settings
You can find the full article here:
iOS: Troubleshooting Wi-Fi networks and connections
http://support.apple.com/kb/ts1398
Thank you for using Apple Support Communities.
Best,
Sheila M. -
My iphone 4s and my ipad both will not stay connected to wifi since the latest update ios.6
my iphone will not stay connected to wifi since the ios 6.0 update
Hello DickChris,
The following article provides some useful troubleshooting steps and information that can help establish and stabilize Wi-Fi connections on your iPad.
iOS: Troubleshooting Wi-Fi networks and connections
http://support.apple.com/kb/TS1398
Cheers,
Allen -
HT204409 iphone 4s will not stay connected to verizon mi-fi 4510L device
iphone 4s will not stay connected to verizon mi-fi 4510L device
Reboot your router by removing all power from it for about 15 seconds.
-
IMac and Mac Book Pro will not stay connected to WiFi on TC
Hi,
I'm a new Mac owner, and I changed completely over to Apple over the weekend. Have na iMac and Mac Book Pro with a 2 TB Time Capsule. Hooked everythng up and all seems to be working, except everytime my computers go into sleep mode when I wake them up they ask me to select my wireless network again because I lost connection. Once I select my network it works fine until the computer goes to sleep. WhenI wake it up, it asks me again. I have it set to automatically connect to known networks, but it doesn't. I have to click on it everytime I wake up the computer. Before I hooked up the TC, I was using my old wireless router and it stayed connected. Now that I put the TC in as my wireless neteork it asks me to select my network. Is there something I'm not doing that may help the iMac and Mac Book Pro stay connected?
Thanks.For that particular WiFi update, yes - it means you can't download it. However, that update may have been included already in M-L 10.8 ...
I feel your pain regarding these anomalies - I had the same problems on my year-old iMac that I just exchanged with Apple for a new one - I had worked these software/network issues on the old one for over five months, and finally, I demanded a new system as a replacement. Just too many problems. For me, Update 10.7.3 for Lion was the cause of my network problems. The WiFi update/patch solved the sleep issue for me, but not the auto-connect problem for system start-up's and restart's. After system start-up's and restart's, I would have to manually select my router address to connect via WiFi. But after manually selecting the address, the WiFi connection would stay-on - it wouldn't drop-off.
Again, with this replacement iMac, I don't even trust its WiFi capability - and with a desktop, why should I ? I simply purchased a Cat-6 Ethernet cable, and wired it into my Time Capsule ... To heck with WiFi ! ... Remember: don't download ANY system updates wirelessly ! Don't do it. ... Apple will rue the day they did away with Ethernet connectors on their computers ... - The same goes for CD-based software, or at least some other "physical" means for software installation ...
But, as for future system updates, and how they affect this new iMac ? - If they screw it up, I'm not messing with it ! - Apple's getting it back, the next day ! I'm not going to go through five months of testing, repairs, forced new purchases, etc. etc. ever again ... -
My IPad 2 with 5.0 will not stay connected to WIFI
Since I upgraded to 5.0 on my Ipad 2 I cannot stay connected for more than a minute or two and then it loses the signal and I have to completely shut down and power up again. This only works for a minute or so and then it tells me there is no signal. I am in Lima Peru and newer routers are not likely to be here for a year or two, if old routers are a problem. I have tried the Ipad on several routers, different hotspots and the result is the same.
Tried all of the above. My wife's Ipad works where mine does not. Did restore to factory settings, twice, and still drops Wifi. IPad is under warranty and Apple said to send it in for warranty replacement. Problem is I am in Lima Peru so that is a little tougher to exchange. The "store" that sells Apple here is only a shadow of a real Apple Store and are of little use or value except to buy new things in boxes at higher prices and limited inventories.
Thanks for your suggestions however! -
Wifi will not stay connected after Lion upgrade - help?
I upgraded to Lion last week on my iMac and now my computer will not stay connected to wifi... it is fine if I restart my computer, but then it looses its connection, settings when it goes in to screen saver mode - very frustrating, please help!
This has been well discussed on another thread here: https://discussions.apple.com/thread/3191630?start=2055&tstart=0
(There appear to be no moderators on these forums to make sure that new threads with the same topic don't get linked to a parent !?)
Anyway... The issues appear for many to be related to a specific Airport card type & firmware version.
I've had constant disconnect problems with my Mini since upgrading to Lion.
My Airport card specs are:
Card Type: AirPort Extreme (0x168C, 0x86)
Firmware Version: Atheros 5424: 2.1.14.9
Connecting to my Time Capsule distributing on:
PHY Mode: 802.11a
The Atheros firmware version appears to be the issue depending on certain wifi network conditions.
After some playing about today I think I've managed to force my Mini to connect on a better frequency, without having to roll back the firmware to the Snow Leopard version or mess with the Mini Airport card settings (via Terminal) by changing some settings in my router (Time Capsule).
These are the changes I made:
Airport Utility > Wireless > Wireless Options
Set Radio Mode to 802.11 a/n - b/g instead of 802.11 a/n - b/g/n (Automatic)
Set 2.4 GHz Channel to 13 instead of Automatic
Set 5GHz Channel to 48 instead of Automatic
My Mini now connects on:
PHY Mode: 802.11g
Signal / Noise: -64 dBm / -96 dBm
Transmit Rate: 54
instead of previously
PHY Mode: 802.11a
Signal / Noise: -73 dBm / -96 dBm
Transmit Rate: 36
This appears now to be stable (no drops in the last 4 hours). It's a low transmit rate still, but better than before.
The iMac is still connecting on
PHY Mode: 802.11n
Signal / Noise: -69 dBm / -88 dBm
Transmit Rate: 216
and all is right with the world (hopefully for the long term) -
IPod touch - not staying connected to WiFi
Just bought an iPod touch for my daughter. It will not stay connected to wifi. Everyday we are having to reconnect and enter our password. All our other devices are fine (MacBook, iPhones, iPads etc). Any suggestions?
Does the iPod connect OK to other networks?
Try:
- Reset the iPod. Nothing will be lost
Reset iPod touch: Hold down the On/Off button and the Home button at the same time for at
least ten seconds, until the Apple logo appears.
- Power off and then back on the router
- Reset network settings: Settings>GeneralReset>Reset Network Settings
- iOS: Troubleshooting Wi-Fi networks and connections
- iOS: Recommended settings for Wi-Fi routers and access points
- Restore from backup
- Restore to factory settings/new iPod.
- Make an appointment at the Genius Bar of an Apple store.
Apple Retail Store - Genius Bar -
My Ipad 2 is not staying connected to WiFi
My Ipad 2 will not stay connected to Wifi. It will stay on they go off. Never had this problem till about 10 days ago. What do I need to do. Help!
WiFi Troublshooting
http://support.apple.com/kb/TS1398 -
I have an IPhone 5 and the bluetooth will not stay connected with my 2011 Chrysler 200. I was told by Chrysler service department that it is a problem with the IPhone 5. Is there an update or a fix so i can use the bluetooth in my vehicle?
Iran uses GSM, so the iPhone 5 will work. It is already unlocked. Just put local Iranian SIM in phone.
-
Iphone will not stay connected "invalid response received from the device."
I have an older iPhone (8gb) and for some reason whenever I plug it into the usb port on my computer it will not stay connected whatsoever. Itunes freaks out, it'll come up for a little bit and then just as soon as it appeared, 'Josh's iPhone' disappears. When I say "won't stay connected" I mean you'll hear the "new usb device" sound over and over again continuously and the iPhone goes crazy too. Like it's connected, disconnecting, connecting, disconnecting, etc.. The error I get during all this madness is "itunes could not connect iPhone because it received an invalid response from the device."
I've used this ( http://support.apple.com/kb/ts1286 ) link to no avail (yet.) I am about to restart my computer right now. If it works after that I'll just simply delete this post. But anyway it's in a usb 2.0, it's plugged directly into the computer, etc etc
Also I'm not sure if this has anything to do with it but I put ringtones on the phone as well, I tried adding about 5 or 6 of them through itunes and it only uploaded two of them, except one of those two appears FOUR TIMES.
Thanks in advance for anyone who can help!Okay, after the updates I am still having the same problem. I'll try explaining it as detailed as possible, hoping somebody has an answer because this is pretty weird to me.
-I have 5 files, Ringtone1.m4r, Ringtone2.m4r, Ringtone3.m4r, Ringtone4.m4r and Ringtone5.m4r.
-I add them to the "ringtones" section under "Devices"
-ON ITUNES they show up perfectly fine. In order, and if I play them through itunes, all the ringtones are correct, just how they should be.
-I eject iPhone, go to settings > sounds > ringtone, and under custom, what I see is:
Ringtone1
Ringtone1
Ringtone1
Ringtone1
Ringtone1
Why on Earth could this be? -
i have had my iphone 4s for less than 3 months and i always have it in a protective case, recently my bluetooth that i use daily will not stay connected, my alarm clock will not ring, any suggestions on whats going on??
Basic troubleshooting from the User's Guide is reset, restart, restore (first from backup then as new). Try each of these in order until the issue is resolved.
-
i have pressed start to install updates, but now my iphone 4 will not stay on, screen showing picture of cable & itunes sign when i attach to computer it only ask me to restore to factory setting and i dont want to lose my photos ect,
Thanks AngelaYour phone is in recovery mode. All your data are already gone.
Maybe you are looking for
-
Function Module to get the Screen
Hello All, Can anybody provide me a Function Module to get the Screen by giving Program Name and Screen Number. Thanks,
-
one person Jan month payroll is run. But in Feb its 0003 is deleted by mistake. What should i do .
-
Hi guru How create a new client similar to client000. Points will be rewarded for the responses. Thanks in advance Vijay.
-
How to keep tracks together in shuffle mode?
When playing in shuffle mode you can't hear tracks in line together while they should be, e.g. in conceptalbums. Is there a way to overcome this? (You can do it with complete albums when downloading in the Library, but what can you do when the tracks
-
How to uninstall HP ProtectTools from Compac NC8430 WinXP laptop
How to uninstall HP ProtectTools from Compac NC8430 WinXP laptop