HT5114 i lock my ipod and it says on the front to connect to itunes what do i do
my ipod is lock and it says to connect to itunes
Sounds like it's gone into recovery mode - you will need to connect it to your computer's iTunes, and you should then be able to reset it and restore/resync your content to it
Similar Messages
-
My iPod touch screen says it is disabled. Connect to iTunes. When I connect the device to the computer a window pops up and said that the iPod is locked and I need to enter the passcode on the iPod..... I can't get it to do anything. Any ideas?
Place the iOS device in Recovery Mode and then connect to your computer and restore via iTunes. The iPod will be erased.
iOS: Wrong passcode results in red disabled screen
If recovery mode does not work try DFU mode.
How to put iPod touch / iPhone into DFU mode « Karthik's scribblings -
Locked my ipod and it says ipod is disabled connect to itunes - have tried everyting - can not rememb er password - can someone please type good instructions for me to get back in - thank
Place the iOS device in Recovery Mode and then connect to your computer and restore via iTunes. The iPod will be erased.
iOS: Wrong passcode results in red disabled screen
If recovery mode does not work try DFU mode.
How to put iPod touch / iPhone into DFU mode « Karthik's scribblings -
TS1702 my daughter lock her ipod and don't remember the password, how do i get to reset?
my daughter lock her ipod and don't remember the password, how do i get to reset?
Connect the iOS device to your computer and restore via iTunes. Place the iOS device in Recovery Mode if necessary to allow the restore.
If recovery mode does not work try DFU mode.
How to put iPod touch / iPhone into DFU mode « Karthik's scribblings
For how to restore:
iTunes: Restoring iOS software
To restore from backup see:
iOS: How to back up
If you restore from iCloud backup the apps will be automatically downloaded. If you restore from iTunes backup the apps and music have to be in the iTunes library since synced media like apps and music are not included in the backup of the iOS device that iTunes makes.
You can redownload iTunes purchases by:
Downloading past purchases from the App Store, iBookstore, and iTunes Store -
I tried to update my phone last night. When I woke up, it said it needed to be connected to iTunes. I restored my phone and now it won't turn on and keeps saying it needs to be connected to iTunes.
probably need pc or mac update for ios 6 on your home device
-
Hello, my iPad has been disabled, and it says that I need to connect to iTunes. As instructed I connected to the find my iPad/iPhone site to put it on the recovery mode. However, I accidentally erased my account, so please help!!! Also, I browsed a lot to find a solution, but none of them were helpful, sorry. Hopping you could help, thank you.
However, I accidentally erased my account,
How did you erase your account? A lot of people would like to know. No one has found a way of erasing an Apple id account.
Robert -
What do I do when I am trying to install my new version of itunes, and it says this: The installer encountered errors before iTunes could be configured. Errors occurred during installation. Your system has not been modified.
I had this, and after a large number of fruitless attempts, I had to reload Windows, which solved it. This was of course a real pain, but I had to do it since updating iTunes was necessary in order to get the new iOS version. But before doing such a drastic thing, you could try to restore Windows to a previous point in time by picking a restore point. This of course presumes that you really have some issues with your Windows (which I had) and that you can make a decent guess on when the system was ok (which I couldn't), i.e that you can decide a good date to restore to.
-
help! techo phobe online. I have an unlocked iphone 3 with an unlocked sim. i have plugged the phone into the computer to set up itunes, but it just says on the phone screen "connect to itunes" nothing else is happening/
Sounds like the device was dropped at some point and damaged as a result.
Take it to Apple for evaluation and a replacement. -
Trying to update my apps on the iPhone 3. When I type in user name and password, I get the message "Cannot connect to iTunes Store" How can I connect?
I have the same problem. Any suggestions?
-
TS1424 My iPod wont download apps it tells me "cannot connect to iTunes " what should I do?
my ipod wont let me download apps it tells me its bot connected to itunes what should i do?
The Complete Guide to Using the iTunes Store
http://www.ilounge.com/index.php/articles/comments/the-complete-guide-to-using-t he-itunes-store/
Can't connect to the iTunes Store
http://support.apple.com/kb/TS1368
iTunes: Advanced iTunes Store troubleshooting
http://support.apple.com/kb/TS3297
Cheers, Tom -
my phone was disabled after several passcode atempt by my son,it says connect to itunes,itunes says phone is locked with passcode.I remember my passcode.I dont want to loose my contacts,what hould i do.
If your phone is now disabled, you've already lost all of the data on the phone. That's the whole point of the passcode. Your only choice now is to force the phone into recovery mode and restore it, as described here:
http://support.apple.com/kb/ht1212 -
Help please!!!!
Placing your device into recovery (DFU-Device Firmware Upgrade) mode:
Follow these steps to place your iOS device into recovery mode. If your iOS device is already in recovery mode, you can proceed immediately to step 6.
1. Disconnect the USB cable from the iPhone, iPad, or iPod touch, but leave the
other end of the cable connected to your computer's USB port.
2. Turn off the device: Press and hold the Sleep/Wake button for a few seconds
until the red slider appears, then slide the slider. Wait for the device to turn off.
* If you cannot turn off the device using the slider, press and hold the
Sleep/Wake and Home buttons at the same time. When the device turns off,
release the Sleep/Wake and Home buttons.
3. While pressing and holding the Home button, reconnect the USB cable to the
device. The device should turn on. Note: If you see the battery charge warning,
let the device charge for at least ten minutes to ensure that the battery has some
charge, and then start with step 2 again.
4. Continue holding the Home button until you see the "Connect to iTunes" screen.
When this screen appears you can release the Home button:
5. If necessary, open iTunes. You should see the following "recovery mode" alert:
6. Use iTunes to restore the device.
If you don't see the "Connect to iTunes" screen, try these steps again. If you see the "Connect to iTunes" screen but the device does not appear in iTunes, see this article and its related links.
Additional Information:
If you have a problem getting into recovery mode then try: RecBoot: Easy Way to Put iPhone into Recovery Mode.
Note: When using recovery mode, you can only restore the device. All user content on the device will be erased, but if you had previously synced with iTunes on this computer, you can restore from a previous backup. See this article for more information. -
Ipad Locked(forgotten passcode) and error message when I try to connect to itunes
Ok so I've forgotten my passcode to my Ipad. I have tried too many times so now the screen says Connect to itunes. When I try to connect it there is a error message saying: Cannot connect to itunes becuase it is locked with a passcode. I have never used this itunes computer with my ipad so I haven't synced or anything. Is there anything I can do to unlock my IPad? Thanks in advance.
If you can't remember the Passcode, you need to restore the device from the computer it was last synced with.
Follow the instructions for putting the device in recovery mode > iPhone and iPod touch: Unable to update or restore -
hey my lil brother just got an ipod touch and its saying connect to itunes and its plugged into my computer and im at the itunes website but i can't get it to connect can anyone HELP ME??!! my mom said that she wants his ipod to be connected so that its on my itunes account so i can see if he buys anything.
PLEASE HELP ME !!!
~MaddieiOS: Device not recognized in iTunes for Windows
iPhone, iPad, iPod touch: Device not recognized in iTunes for Mac OS X
If you have iTunes 11 turn on the Sidebar. Go to iTunes>View and click on Show Sidebar. You can also do a Crtl+S to show the sidebar -
A week ago, I was burning CDs, no problem. This week, I tried to burn a CD from the same playlist, but all of the songs now have a "!" in front of the title. When I click on it, it says that the original cannot be found. More and more of the songs are having this same "!" showing up. What happened? And how do I get the music back? There are thousands of songs with this "!"!!!!! And, I'm a music teacher, so this is my life!
The ! Means that the link is broken between what is shown in the Library and where the file is located. You will need to relink the items. You can search you HD to see where the files are located then use CMD-O to relink.
Did you move any items using the Finder?
iTunes is a data base manager and if you move items outside of the iTunes interface then iTunes might not keep track/find the move.
You might find a script here to relink the tracks with ! - http://dougscripts.com/itunes/
MJ
Maybe you are looking for
-
Dreamweaver 8 templates not displaying flash files
Dear friends: I have developed an interactive banner with animation and links using Flash 8. I imbeded the banner into a Dreamweaver 8.0.2 document and published it to test the banner. Everything worked just fine. I then saved that document as a temp
-
I am an ex Windoze PC based person who is accustomed to a context menu item that is a "Send File to" style of thing that will allow one to select a file or group of files from the a files and folders list (i.e. selected in Finder in MAC the world) an
-
Migration from Sun to HP Unix to Windows
Hi , There is hardware and OS migration activity is scheduled in my current project. To give you the detail, BI system will be migrated from SUN to HP servers and OS will be changed from Unix to windows. I am asked to test the system to check that an
-
Has anyone built an application using ODBC with Forte? We are in the process of doing this but have no clear understanding of what we have to do to use ODBC. Do we get rid of all the SQL we have created? Do we by-pass Forte's database access function
-
HT1491 Forget security question can log in account
Forget security question can not purchase apps.how to recover the answer