HT5163 I tried to update my iPhone and locked it up.

I connected my iPhone to iTunes and it told me that I needed to update it. So I said to go ahead and update. Well, I received an error message and iTunes no longer recognizes my phone. So I can't eject it, can't find it. The phone shows on the screen that it's still connected to iTunes but it does not show that on the iTunes.
Any suggestions on how to reset the phone or something so I get my phone back?

Whilst plugged into itunes, Hold down the power (top button) and the home button (the round one at the bottom) for a few seconds together until it forces a shut down, dont hold too long or it will reboot. after its shut down wait around 20-30 seconds then do the same again but this time count to about ten secs then release the top button (power) but keep holding the home (bottom) button for around 8-10 secs, you should here ur pc/iphone connect to each other with that usb detection sound, this should place ur phore into recovery or DFU mode which will enable you to restore ur phone or restore from backup etc.

Similar Messages

Maybe you are looking for

  • Issue with 32 bit mapping while doing the job configuration.

    Hello,                From my end, facing a strange issue while execution of job in 32-bit mode. As part of the solution implementation, do have one excel file which has to be imported to my database. For this activity, have created a package in SQL

  • Mavericks upgrade and Thunderbolt firmware update?

    Hi Guys, last week I installed mavericks to an external hard drive and am currently using my early 2011 MBP as a dual boot using Lion and Mavericks. The main reason is because my audio software is no longer being updated in Lion. My next purchase onc

  • Bapi for requistion

    Hi can anybody tell that while creating requistion can we pass units of measure. iam ordering amaterial lets say iam ordering material no 123 say a quantity of 4 vl. where vl is marc-ausme i.e unit of issue. but when i create a purchase requistion it

  • External Document class - Timeline

    Quick question, is it possible to take an external .as file and recode it to work within the time line? Thanks in advance, Khester

  • Adding trim marks with tiled printing

    Hi, I'm trying to print a large sized document to tile, but I'd like each page printed to have a boxed border around it (trim marks) instead of just the small "+" in each corner. Is this possible? I have searched online over and over and can't seem t