HT5569 How do I print using a wireless printer when I'm using wifi for Internet at the same time

I can't figure out how to print via wifi when I'm using wifi for Internet at the same time please help

You need to have your printer & ipad connected to the same wifi router.  ( This would be my best guess. )
Robert

Similar Messages

  • How can I use a wireless printer and the internet at the same time?

    Hi there, I just installed a wireless printer but to use it I have to click on the Airport icon and select the printer in the 'devices' list. This deselects my connection to my wireless modem. Is there any way I can print and look at the internet at the same time? This does not seem right to me, I print a lot of info from the net and don't want to spend time selecting and waiting for connection back and forth all the time.
    Bo

    I have a Linksys WAG54G2 wireless G router. This router has a Wireless Protected Setup button which I understood would initiate a search for wireless devices and aid setup but it seems to do nothing. I made the mistake of tryig to use the linksys installation disk to access a setup wizard and that just reset my entire network back to factory settings and it took me 4 hours to reconfig my system. Won't be touching that again. It all seems odd, the printer is compatible with the router as far as I can see but I don't know how to get the router to recognise the printer.
    bo

  • Is there a way to use the computer(internet)at the same time I'm watching a movie on my tv using mirror displays?

    I'm trying to browse the internet while i'm watching a movie on my television using mirror dispalys. is there a way i can see the movie and browse the internet at the same time? without interrupting the movie.

    Rather than mirror the display, set it to 'extended desktop' and have the browser on one screen and the movie on the other.
    CMD F1 will toggle between mirror and extended.
    Regards,
    Captfred

  • Cannot stream to iTunes and join wireless internet at the same time

    I have a home network with an Airport Extreme base station, and Airport Express connected to my home stereo and to my existing wireless network in client mode. I receive internet via a wireless signal throughout my apartment building. My laptop receives the signal via the built-in airport express card. Neither the Airport Extreme or Air Express are connected directly to the internet, since I only have a wireless signal in the building (no ethernet).
    With Airport turned on the wireless internet signal appears as a list of networks alongside my own network.
    I can't seem to get the settings right such that I can join my Home network and be connected to the internet at the same time, since I have to join either one or the other from the drop down list. Therefore, I can't sream music wirelessly from my laptop to my airport express and be connected to the internet at the same time.
    Is there any way around this?
    Powerbook 17"   Mac OS X (10.4.8)  

    Leosia, Welcome to the discussion area!
    Your Mac only has a single radio receiver therefore it can only join one wireless network at a time.

  • I have an iPad 2 (wifi 3G). Is it correct to use wifi and 3G at the same time ? Or one at time depending on connectivity? Thanks.

    I have an iPad 2 (Wifi + 3G). Is it correct to use the Wifi and 3G at the same time, or one at a time, depending on connectivity? Thanks in advance.

    Your iPad will use wifi first if available. If wifi is not available, it will use 3G.
     Cheers, Tom

  • How can i synchronize analog output and analog input timings to generate and measure voltage at the same time.

    how can i synchronize analog output and analog input timings to generate and measure voltage at the same time.

    Read this Tutorial
    http://zone.ni.com/devzone/cda/tut/p/id/3615#toc3
    And also refer to this link where You have repeated this question.
    PS: Please stick to one thread. That way, its easier to keep track of your query and answers

  • Yesterday, I downloaded I.O.S. 8 to both my iPhone and my wife's iPad at the same time.  She wants I.O.S. 8 removed.  How do I remove it from both devices?  I am willing to resort to my old IOS7.1.2.

    Yesterday, I downloaded I.O.S. 8 to both my iPhone and my wife's iPad at the same time.  She wants I.O.S. 8 removed.  How do I remove it from both devices?  I am willing to resort to my old IOS7.1.2.

    Sorry...downgrading is not supported.

  • How to use 2 webcam for java at the same time?

    hi there,
    I have a question to ask regarding webcam and java. Basically i want to know whether is it possible to have 2 web cam running in java at the same time? I have no problem when running one usb webcam since i m using "
    ml = new MediaLocator("vfw://0") ;
    what parameter must i use to specify when using 2 web cam
    many thanks
    sun

    Hi
    I am making a project in which i have to capture a image through webcam. How can I do it will you please guide me or if can provide me code. Many thanks for your support. My email id is [email protected]

  • Why can't i use wifi and bluetooth at the same time?

    I recently bought a Philips docking speaker that has bluetooth connectivity for streaming music wirelessly from my Ipod Touch. The bluetooth/speaker works great, but, my Touch won't allow me to be online AND use the bluetooth at the same time. This is really annoying when you want to listen to music and check your emails. Am I doing something wrong?? Any  help would be gratefully received.

    I can use by BT headphones while my iPod is connected to the internet via wifi with no problems. I am uncertain how the Philips' system works.  Does it have its own BT transmitter/receiver or doe it use the iPods to stream to its speaker?

  • Can not connect to printer and internet at the same time

    I use my airport to connect to the internet via the ethernet port. Internet was working fine until I connected my printer to airport via its USB port. Now the printer works fine but I can't connect to the internet using the same connection.
    I can still connect to the same server using its wireless service, but I have to keep hitting the drop down list in the menu bar to select that connection. Can't I just keep connected to the same connection without having to switch back and forth? I thought these mac products were supposed to be all user friendly... I don't have time for this.

    The only way to print and use the internet (or university network) at the same time is to do one of the following:
    (1) Connect the printer via USB to your computer.
    (2) Connect the AirPort Extreme base station (AEBS) via Ethernet to the university's network and then configure the AEBS to act as a bridge (not sharing a single IP address).
    The AEBS can NOT wirelessly join the network.

  • Airport express and wireless internet at the same time???

    hello,
    i recently replaced an airport express that broke. before i replaced it, my house was set-up with my macbook in one room, airport express in the living room and home-internet router in the office.
    i dont remember how i did it, but i set it up so that i could be connected to the internet and airport express at the same time. right now, its one or the other. either connect to the airport and listen to music, or connect to the router and get internet...
    now, i understand you can do this if u plug an ethernet into the airport express, but its in a different room than the router.
    so somehow i need the router and airport to connect to each other wirelessly????????

    Configure the AirPort Express (AX) using the instructions in KB 302153, AirPort Express: How to join an existing wireless network in client mode.

  • Can I use my New Imac as a server and a workstation/client at the same time ?

    I havea  brand new (2 months Old) Imac - 4 Gig, fully loaded and want to use it as a server using lion server app.  I want to use it for ical server, Addressbook and fileshareing with a bit more security.  I dont want to buy a new computer, just use the existing one to do these services.  At the same time, I want to still use this computer for my regular work. 
    There will be a few users with low traffic.  At the beggining, there will be only 1 other user for the calander, addressbook and file server.  Later it might grow to 4.
    Any thoughts would be appreciated !!!
    PS - Any advice on how to set this up or tricks would be appreciated
    Thanks Again

    Arik From Tel Aviv wrote:
    great Idea !!  Lets assume I dont want to go virtual - what is your thought on that ?
    Lion Server is a "layer" on top of client. The services run in the background and do consume resources like the RAM, CPU, and HD, while you're using the computer as a client. That said, when running a VM with say VMWare Fusion you dedicate Cores and RAM to VM, even if the VM doesn't need all the CPU horsepower or RAM for your server tasks. So it may be that running a full blown Lion Server as VM along side client is more resource intensive on your computer than just running Lion Server while also using it as a workstation.

  • Using Aiport Express and internet at the same time?

    I was just wondering if anyone could offer any advice on this subject please?
    I've got a Macbook running through a wireless BT ADSL modem. I have also managed to connect the Macbook to my Aiport Express to allow me to wirelessly pipe iTunes through my stereo. I am aware that you cannot run both at once (i.e pipe music and browse the web) due to the Macbook being able to be only connected to one wireless network at a time.
    My questions is whether there is anyway round this? If I bought an Aiport Extreme base station, connected that to my wireless router and used the Airport Extreme base station for the wireless connection would I be able to add the Aiport Express to that wireless network and subsequently have the internet and the Aiport Express running on the same wireless network - hence being able to pipe the music wirelessly and also browse the web at the same time?
    Or is there another way round it?
    Any info anyone could offer would be a great help
    Thanks in advance
    James

    Ahh am I right in thinking this is the way to do it?
    http://docs.info.apple.com/article.html?artnum=302153
    Thanks
    James

  • Can I use DIO 32HS in pattern I/O and Unstrobed I/O in the same time?

    I work with a pci dio 32 HS(programming with labview) and i want to know if it is possible to configure 3 ports in unstrobed output mode (24 static digital lines) and 1 port in pattern I/O mode which can read AND(not "or") write data(using internal clock)in the same VI.moreover in pattern I/O mode am i obliged to use these port combinations (16 bits: (port0,Port1) or (port 2, port 3) , 32 bits: (port 0,1,2,3))and not an other one and can i configure one port in output and input at the same time (for example aquiring and generating data at the falling and rising edge of the internal clock)?? please give me all possibilities of lines, ports and groups direction (input output bidirectionnal) with more de
    tails (i'm not sure of what i can do using the 653X user manual). else, I can't observe with my oscilloscope TEK the internal clock signal(squarewaveform TTL) onthe REQ pin as it is said in the user manual, WHY????
    Thank you for your answers.bye

    Hi,
    No, you cannot configure 3 ports together. On the PCI-DIO-32HS, there are two main port groups, each group consisting of two ports: group 1 (ports 0,1) and group 2 (ports 2,3). You can configure two 8-bit ports (0 and 2), two 16-bit ports (0,1 and 2,3) and one 32-bit port (ports 0,1,2,3); you can configure each group independently.
    Regards,
    RamziH.

  • Is it possible to use Airport Express as a repeater and as an airplay device at the same time?

    Hi,
    I am using airplay with airport express stations in combination with conventional speakers for my home entertainment. Works great. Only thing is that I have a massive block of concrete in my flat. Is it possible to use one of my express stations as a repeater and at the same time as a streaming device for airplay? Thanks!

    Sure it works only with apple routers? Cause than I could stop trying.
    Yes, it's proprietary like everything else Apple. You could look at this:
    http://www.amazon.co.uk/dp/B006BBYXPA/?tag=hydra0b-21&hvadid=9550946469&ref=asc_ df_B006BBYXPA
    I have had great success installing these for BT Home Hubs and VM Superhubs.
    @JoeMY - If it is "joined" to the FritzBox then it won't work, it only works with Apple routers connected via Ethernet or as the main router.

Maybe you are looking for