I cannot get my PC to recognise my Harrier when plugging in the supplied cable
Can you advise me as to how I can get my PC to recognise that I've plugged in my Harrier with the USB cable from the box.It worked a few days ago but now there is no response.Thank youIM
Hi ,
Welcome to the EE Community.
Have you tried using a different USB cable to rule out a fault with that?
Thanks
James
Similar Messages
-
please help! my iphone randomly went unresponsive, when plugged into itunes it flashes apple logo and itunes doesnt recognise it and when plugged into the mains its in recovery mode, asks to be connected to itunes, but immediately turns off when unplugged from mains
You could try to do a hard reset, sometimes resetting the phone helps. Hold down the sleep/wake button on the top and the home button until you see the apple logo, this make take a minute or two but this might help.
-
App store tried to update iBooks app. I can only see Newstand app on my screen and cannot get to bookstore. How can I delete and download the iBooks app again. iBook still appears in the settings menu as version 2.1
Tx
iPad 2, iOS 5.0.1, iBooks 2.1Hi,
the settings are gone, i guess. But even worse, I cannot get the iPad2 to play Full HD thru the Apple digital AV adaptor using apps that support (and advertise this), like AVPlayer HD. This definiteley used to work before one of the last iOS upgrades. (I am now at 5.1.1). -
i cannot get my phone out of recovery mode, when I tried to restore on itune it gives me error 1608. please help me
While YOU may not have attempted to jailbreak the phone, SOMEONE ELSE did. Error 1015 occurs by attempting to restore a previously jailbroken phone.
It's very likely you may NEVER get your phone out of recovery mode and your phone may be rendered permanently bricked.
Terms of Use of this forum prohibit the discussion of jailbroken phones. You'll have to scour the internet for a solution to your problem, if indeed one exists. -
I cannot get my Mac Pro (Original) MacPro1,1 to boot with the 64 Bit kernel in 10.6.8 (this is a 2 x 3Dual-Core Intel Xeon machine).
Firmware = MP11.005C.B08 (EFI 1.2) 1.7f10 (SMC 1.1)
Will it not run the 64 bit kernel?
Is there a firmware upgrade to allow this?
Should I bother?
It won't boot with the Key 6 & 4 method.
or using Terminal command;
sudo systemsetup -setkernelbootarchitecture x86_64
Any suggestions?
Thanks in advance...
EricBecause it can't and doesn't have a 64-bit supported firmware.
UEFI (EFI64) was not finalized and adopted until very late 2007 and introduced in 2008, by Apple, Intel, other members of EFI Group and Unified EFI. The Mac Pro Mid-2010 was the first time though that 64-bit mode was the default.
Does it matter? not really. you can't install 48GB RAM anyway, while there are some improvements from 64-bit kernal.
Also can't boot Windows 7 64-bit DVD to install properly. But you can run Windows 64-bit kernel because you have a 64-bit Xeon.
Macs that use 64-bit kernel
64-bit kernel mode Snow Leopard
Booting with 32-bit or 64-bit kernel
Mac OS X- 64-bit kernel questions
http://macperformanceguide.com/SnowLeopard-64bit.html -
Can't add albums in library to iPhone.
Full question: I have several albums in my library that I cannot get onto my device. I have tried manually adding the albums, but it doesn't work. I can view the albums in "Music," but when I click on "iPhone" they are gone. How can I transfer them over?
-
icloud was originally set up wrong and I cannot get in to change my settings and no longer know the password
Go to http://appleid.apple.com and click 'Forgot password'. Enter the ID you set iCloud up with. A new password will be sent to your associated email address.
-
I cannot get my iPhone3 to sync playlists. If I create the play list on my iPhone, when I sync the playlist is deleted. If I create te playlist on iTunes, when I sync, it will not transfer to my iPhone. Help!
Hello jmazumba
Continue your troubleshooting with the article below to resolve the issue with connecting to iTunes. It will walk you through checking the drivers as well as third party security software for any conflicts.
iOS: Device not recognized in iTunes for Windows
http://support.apple.com/kb/ts1538
Regards,
-Norm G. -
We cannot get our iPad Air to charge. We have tried the wall plug and the computer plug in. It just gives a message saying it's not charging.
Could be the charger, cable or iPad. Plug the USB cable into your computer. It may say "Not Charging", however, it is charging slowly and will verify that the cable is good.
Try this first - Reset the iPad by holding down on the Sleep and Home buttons at the same time for about 10-15 seconds until the Apple Logo appears - ignore the red slider - let go of the buttons. (This is equivalent to rebooting your computer.)
The quickest way (and really the only way) to charge your iPad is with the included 10W or 12W (5W on Mini) USB Power Adapter. iPad will also charge, although more slowly, when attached to a computer with a high-power USB port (many recent Mac computers) or with an iPhone Power Adapter (5W). When attached to a computer via a standard USB port (2.5W, most PCs or older Mac computers) iPad will charge very slowly (but iPad indicates not charging). Make sure your computer is on while charging iPad via USB. If iPad is connected to a computer that’s turned off or is in sleep or standby mode, the iPad battery will continue to drain.
Apple recommends that once a month you let the iPad fully discharge & then recharge to 100%.
How to Calibrate Your Mac, iPhone, or iPad Battery
http://www.macblend.com/how-to-calibrate-your-mac-iphone-or-ipad-battery/
At this link http://www.tomshardware.com/reviews/galaxy-tab-android-tablet,3014-11.html , tests show that the iPad 2 battery (25 watt-hours) will charge to 90% in 3 hours 1 minute. It will charge to 100% in 4 hours 2 minutes. The new iPad has a larger capacity battery (42 watt-hours), so using the 10W charger will obviously take longer. If you are using your iPad while charging, it will take even longer. It's best to turn your new iPad OFF and charge over night. Also look at The iPad's charging challenge explained http://www.macworld.com/article/1150356/ipadcharging.html
Also, if you have a 3rd generation iPad, look at
Apple: iPad Battery Nothing to Get Charged Up About
http://allthingsd.com/20120327/apple-ipad-battery-nothing-to-get-charged-up-abou t/
Apple Explains New iPad's Continued Charging Beyond 100% Battery Level
http://www.macrumors.com/2012/03/27/apple-explains-new-ipads-continued-charging- beyond-100-battery-level/
New iPad Takes Much Longer to Charge Than iPad 2
http://www.iphonehacks.com/2012/03/new-ipad-takes-much-longer-to-charge-than-ipa d-2.html
Apple Batteries - iPad http://www.apple.com/batteries/ipad.html
iPhone: Hardware troubleshooting (Power/Battery section also applies to iPad)
http://support.apple.com/kb/TS2802
Extend iPad Battery Life (Look at pjl123 comment)
https://discussions.apple.com/thread/3921324?tstart=30
iOS 7 Battery Life Draining Too Fast? It’s Easy to Fix
http://osxdaily.com/2013/09/19/ios-7-battery-life-fix/
New iPad Slow to Recharge, Barely Charges During Use
http://www.pcworld.com/article/252326/new_ipad_slow_to_recharge_barely_charges_d uring_use.html
iPad: Charging the battery
http://support.apple.com/kb/HT4060
Best Practices for iPad Battery Charging
http://www.ilounge.com/index.php/articles/comments/best-practices-for-ipad-batte ry-charging/
How to Save and Prolong the battery life of your new ipad
https://discussions.apple.com/thread/4480944?tstart=0
Prolong battery lifespan for iPad / iPad 2 / iPad 3: charging tips
http://thehowto.wikidot.com/prolong-battery-lifespan-for-ipad
iPhone, iPod, Using the iPad Charger
http://support.apple.com/kb/HT4327
Install and use Battery Doctor HD
http://itunes.apple.com/tw/app/battery-doctor-hd/id459702901?mt=8
To Extend a Device’s Battery Life, Get to Know It Better
http://tinyurl.com/b67c7xz
iPad Battery Replacement
http://www.apple.com/batteries/replacements.html
In rare instances when using the Camera Connection Kit, you may notice that iPad does not charge after using the Camera Connection Kit. Disconnecting and reconnecting the iPad from the charger will resolve this issue.
Cheers, Tom -
I have an Retina display MacBook Pro with HMDI out port. I also have an HDMI to Component cable with Audio Plugs. How can I get HDMI out to work with this cable when plugged into the MacBook Pro and connected to the TVs Component and Audio in ports.
Will not work. To my knowledge, dual converting like that isn't supported. The Mac must detect the connected video output device and that sort of info cannot be done across an analog component uni-directional connection.
-
I was an apple beta tester for iOS7 and now my iPhone 5 shut down, it's unresponsive it gets recognized by iTunes when plugged into the computer but that's it. Since I was a beta tester is there any way to fix my iPhone??
Are you still running iOS 7 bet?. If so go to the private developer section for help. We cannot help you here with beta software.
-
How do i get rid of my first apple id when i got the phone
how do i get rid of my first apple id when i bought the phone
I don't think this is the easiest way. Have you concidered creating a new account and just... ignoring the last one? If this idea is not to your liking, just simply ring up apple. From what I know, you cannot cancel and account, but, I think that apple might be able to.
-
how do you get your old scores on your games when you transfer the games between devices ive signed into game center and my scores are there but when I open the games Im at 0 again
Did you do this?
iOS: Transferring information from your current iPhone, iPad, or iPod touch to a new device -
My iPad is not being recognized by the computer, therefore, cannot sync. It charges when plugged to the wall, but not when pugged to iMac.
Most common culprits include the cable. Try swapping it out for a different one.. or not having the most recent version of itunes. I once even solved this problem by shutting down the computer for 2 minutes. (the longer the better), with the ipad plugged in. starting it up... then itunes recognizes it, launches, and syncs.
Apple has a troubleshooting assistant on this topic:
http://www.apple.com/support/ipad/assistant/itunes/
It will advise you to reboot. I recommend shutting down instead.
--Sam
P.S The ipad should charge when asleep and plugged into your Mac. The charging behavior is normal. There isn't enough power out the USB ports to charge the ipad while it is on on some older Macs and nearly all PCs. -
How to get rid of /j2ee prefix from URL when I use the OC4J via Oracle HTTP server
In 9iAS 9.0.2 Oracle HTTP Server (OHS) is pre-configured to assign requests to the Home OC4J instance via the URL-prefix "/j2ee"/
For example, the TEST servlet under OC4J would be passed through OHS using:
http://urmachine:urApachePort/j2ee/TEST
whereas in the standlone OC4J version, this URL works:
http://urmachine:urOC4JPort/TEST
How to get rid of /j2ee prefix from URL when I use the OC4J via Oracle HTTP Server?It is getting the url prefix from mod_oc4j.conf
under /ora9ias/Apache/Apache/conf
You can read more on this at
http://otn.oracle.com/docs/products/ias/doc_library/90200doc_otn/web.902/a92173/confmods.htm#1008977
-Prasad
Maybe you are looking for
-
Data transfer from CRM to SAP R/3
Hi All, Please let us know how to transfer the data from CRM(sibel) system to SAP R/3. I want to pull oppurtunity data from CRM to R/3 system.Could somebody throw some idea on this please. Regards Mahesh
-
Satellite A300: Only one fingerprint sign at start up but two user accounts
Hi I have a Toshiba Satellite A300 Laptop which has the TrueSuite Access Manager software installed. There are two accounts on the computer but I have been unable to work out how to get the two accounts to appear on the sign on screen, so that whoeve
-
How to send 1000 records per each time through JDBC adapter
Hi all, In my JDBC to File scenario, SQL Server database having 10,000 records. I want to split these records into 1000 records and process 1000 records each time. How we can do in JDBC adapter. Is there any options in JDBC adapter. Please give me re
-
Unusual FIX calculation - Weird Issue - Whats Wrong?
Hi All, I'm facing a weird issue today, not sure if I'm missing on something: substitution variables defined: &RangeYears= "FY13":"FY16" &F1stYr= "FY13" Sample script: FIX("E1","P1", &RangeYears) <sample scripts here> FIX(&F1stYr) <calculate account
-
Why won't my MacBook Pro play my DVDs?
I've had my MacBook Pro since Dec 25, 2013. (It's the mid 2012 version) And I haven't tried using the DVD player until today. For some reason, I tried putting a DVD in the disk drive but it won't accept it. I tried pushing the DVD in, but I didn't wa