I cant get my iphone 3gs past the emergency calls screen

i cant get my iphone 3gs past the emergency calls screen,all i am getting is the picture of the charger cable and thats it.

So did you connect to your computer and iTunes and restore it?

Similar Messages

  • How do I get past the Emergency call screen iphone 5 ios 6

    I upgraded my iphone 5 to ios 6.1 and now I can't get past the Emergency call screen.
    I try to hook it into my computer with iTunes but it says I need to unlock the phone with my password but I can't find anywhere to do that.
    I tried the reset but that didn't help.

    There should be a Black Button with a White Arrow pointing left at the Bottom of the screen.

  • How do i bypass the emergancy calls screen for iphone 3g

    my phone is stuck on the emergancy calls screen and id like to know how to bypass that?

    Try resetting:
    Hold both the home and power buttons at the same time until the Apple boot logo appears. No data will be lost.

  • My phone needs a restore but I can not because my pass code is active. It only allows me to go to the emergency call screen. I can't type in my pass code What should I do?

    My phone needs a restore but I can not because my pass code is active. It only allows me to go to the emergency call screen. I can't type in my pass code What should I do?

    Thank you so much I actually did have restrictions enabled. Ur too sweet thanks again for your help

  • TS1702 i updated to ios 6.1.3 and now i cant use my iphone 3gs after the update it keeps asking me to setup the phone as a new iphone and register on apple afresh but when i try following the steps they keep telling me they are unable to continue with the

    please can someone tell me what to do so i can be able to use my iphone again after updating the ios 6.1.3 software i cant do anything with mt phone again apart from being able to make emergency calls. please help. at first it was a hearing problem when i recieve or make a call after the software update and now there is no way i could even do anything with it.

    Is there a sim in the iPhone?
    Has the iPhone been jailbroken or modified to work with other
    than the original wireless provider?
    If you can get that far, what does it say when you look at
    Settings=>General=>About=>Carrier?

  • HT201401 my phone wont go past the emergency calls and imeiunown and iccid unown can anyone help please

    my phone wont conect it keeps stayining on emergency calls only

    IMEI unknown indicates a critical hardware failure.  You'll have to take to the Apple store for replacement.  Out of warranty replacement for the iPhone 4 is $149 (US).  If it's jailbroken you're out of luck.

  • HT4623 I cant get my Iphone to off the ITunes connect so I am unable to use my phone all together

    I was installing the update and now my phone doesnt go to its screen it only shows connect to computer and the Itunes

    So did you connect to your computer and iTunes and restore it?

  • I have an iphone 2g and its stuck on the emergency call screen, how can i fix this? jailbreak?

    help!

    It seems the SIM requirements for this situation are different for the 2G.  From that document...
    If you no longer have the SIM that was used with the original iPhone, and the original iPhone displays the "Connect To iTunes" screen, contact your carrier to get a replacement SIM.
    I don't know if you'll need an account or not... sorry, I don't have experience with a 2G.

  • Iphone 3G stuck in Emergency Call Screen

    I have an imac, ipad2, two iphone3GS, and recently my sis came down to india from NZ with an iPhone3G, which is not working.
    I put in the SIM card. After putting it on, it takes me to the Apple logo with the iTunes connector image. Also iTunes does not detect this iPhone3G, whilst it detects all my other apple devices.
    Have tried it even on Windows based iTunes, no luck.
    Can you help us find a solution to this problem?
    Sam

    This was solved!  What we had to do is go to the admin consule of the exchange server and delete the mobile device from the user account. Once that was done, we re-added the exchange account to the iPhone 3G and it took the password. Case closed.

  • IPhone stuck at emergency call screen!

    Hi everyone!
    My iPhone stuck at the 'emergency call' screen. I restored it and at the end I had to 'activate' the phone... But when I try to activate it (connect to iTunes) iTunes
    gives me a message: ...The Network connection is timed out... Please try again later. But I can open the iTunes Store and download apps and music, and the Network is in order... Anyone knows what to do? Or how to 'activate' the iPhone without iTunes?
    Please Help!

    You can't activate your phone without itunes. The most common reasons for the network timed out error during a restore or software upgrade are firewalls, anti-virus & anti-malware. So, turn off or disable all of that stuff, especially windows firewall & try again.

  • Iphone 3gs stuck at emergency screen after 4.01 update

    1st of all i would like to say sorry if this has been posted before.. i did a search and it turns out to be a gazillion hits... no time to search all of them.
    i bought the iphone from malaysia last week.. and the ppl activate it while it was still on 3.1.3 firmware..now im back in my country ( Brunei Darussalam) and ive update it to 4.01.. and now im stuck at the emergency call screen.. it wont activate with itunes as it stated the sim is not supported...
    if anyone knows how to overcome this please do tell... thanks..
    p/s never been jailbreak before...

    The device was jailbroken when you purchased it most likely.
    When you did the upgrade, it relocked to the original carrier.
    The solution now is:
    1)Sell it and buy an iPhone intended for your country.
    2)Jailbreak it.
    3)Contact the carrier it was originally intended for and see if they offer unlocking.

  • I updated my IPhone 3GS to the newest software version, now I can't get past the activation stage. AT

    I updated my iPhone 3GS to the new version 6.1.3 and installed the new software. After doing this, I can't get past the activation stage in the process. I had AT&T and the phone doctors look at it and they couldn't figure it out. Apple wants $175 for me to send it in but I shouldn't have to pay for an update malfunction. I am at the mercy of the good folks in Apple land to help me.

    Is your carrier still AT&T? What error message do you get when you try to activate it?
    Have you tried a new SIM? Was the phone jailbroken? Was the computer you used to update it ever used to jailbreak a phone? In general, this problem is caused by one of the following:
    1. Your antivirus is blocking access to gs.apple.com.
    2. Your phone is jailbroken.
    3. Your computer has been used at some time in the past to jaibreak some iOS device (not necessarily the phone with the problem), and its network database was corrupted by the hacking software that was used.
    4. Apple's activation servers are down (very rare, and never for more than an hour or so).
    For 1. try disabling your antivirus.
    For 2. & 3. you need to go somewhere other than an apple forum for help. Although you can try deleting lines containing gs.apple.com from your "hosts" file on your computer.

  • HT2731 how do i get past the emergency number pad to set up my iphone 3gs

    how to get past the emergency screen to setup my iphone 3gs

    Have you tried pulling the batteries out of the damaged ones so that they are completely off; then shutdown your Mac Mini via the power button on the back right. Turn on your new keyboard and trackpad then power your Mini back up? The auto detection should find your new keyboard and trackpad.

  • HT4623 i cant get past the resuce email screen during the upgrade

    i cant get past the resuce email screen during the upgrade

    Hello DionSimmons,
    The following article provides information and troubleshooting steps that can help get your iPhone activated.
    iPhone: Troubleshooting activation issues
    http://support.apple.com/kb/TS3424
    Cheers,
    Allen

  • I'm trying to update my iphone 3GS to the 4.3.4 version and I am getting the error message "This version of itunes (version 9.1.1) is the current version.  How do I update my PHONE and why is an itunes update being confused for my iphone?

    I'm trying to update my iphone 3GS to the 4.3.4 version and I am getting the error message "This version of itunes (version 9.1.1) is the current version.  How do I update my PHONE and why is an itunes update being confused for my iphone?

    You need iTunes 10.0 or greater to update your phone...iTunes isn't confused at all. If you're on a Mac, you'll need OS X 10.5.8 or greater to update iTunes to 10.0 or greater.

Maybe you are looking for

  • How can I transfer my Contacts from one partition to another

    Hi. I want to transfer my contacts from Mountain Lion  on one partition, to Mountain lion on another.  I have a lot of junk on the first one which I did not wish to transfer to the new one. Thanks. David.

  • Using getApplicationModule in the VO Constructor

    I'm trying to use a the getApplicationModule in the constructor of my VO but it returns null. Is there any way to avoid this behaviour ? I suspect there's a problem related to the loading time and order (but I'm sure the ApplicationModule was already

  • IPad 2 Podcasts show in iTunes, but not playable in iPad

    Podcasts update regularly in iTunes, like they should.  I plug in the iPad to the computer, it syncs, like it should.  In iTunes I can see the podcasts on my iPad.  Go to the iPad (music->podcasts) and there are icons for each podcast, but they won't

  • Create SOFM object instance from PDF

    Hi All, I am using 4.6 version of SAP where FM 'sap_wapi_attachment_add' is does not exit. My query is to create an attachment (SMARTFORM coverted in PDF) in ABAP progam which i have to send as attachment with a Decision Task in the workflow. I am ab

  • Time Machine Lock a "restore point".

    Time Machine is circular: when disk is full it destroys oldest backup to add the latest one.  I would like to "lock" an older backup of known integrity and have it never overwritten.  Is this possible and if so, how?