I have a Mac Desktop that is running OS 10.10.1, I am trying to upgrade my iPhoto to 9.6, but nothing happens after the perceived download. I even retarted and still my iPhoto is in not available, why?
My iMac = Desktop 20", 2GHz processor, 4 GB memory, running OS 10.10.1
I am tring to upgrade my iPhoto and when I follow Apple's instructions on how to do so, the download seems to occur, I click on the upgrade package and nothing changes.
I have restarted the computer after the download and still no change.
What am I missing?
leonie,
Thanks for the reply, I finally got it solved. I had to find the upgrade in the Utilities folder of the Finder...
Similar Messages
-
What is the newest Mac desktop that will run OS9.1?
What is the newest Mac desktop that will run OS9.1?
Everymac web site with Apple model listing - http://www.everymac.com/systems/apple/index-apple-specs-applespec.html
Check the above web site. Unless somebody can give you a concise answer here you can start browsing different models and their boot requirements. The system information is located in the lower half of each model's page. Look at G4s and early G5s.
Note that anything that can run 10.4 or earlier will also support Classic. Not all applications run well in Classic but many do. If the primary purpose of the computer is to run this software it can be a bit tiresome to have to have Classic running all the time. I find it okay to use but only work with it once a month for an hour or less.
My computer (G4 Quicksilver) boots to early OS9 natively but can also run anything up to OSX 10.5. I can boot to OS9 but have neve needed to do so. -
I have a mac pro that is running slow. what can be done?
I have a mac pro that is running slow. what can be done?
Read the last two replies in this thread: https://discussions.apple.com/message/24218682#24218682
Reply here, not there. -
after upgrading to IOS 5.1 I no longer can see Verizon at the top of my Iphone and under settings>general>Network>says Not Available Why is this? Did the upgrade cause this?
steveSee this tip --> http://support.apple.com/kb/TS1559
If this doesn't resolve it you most likely have a hardware failure. Fortunately, your phone is in warranty, so if you take it to an Apple store they will replace it. -
I have a mac book pro (2009) running OS X 10.5.8. Can I upgrade it to Mountain Lion so I can get icloud? I can't see how to upgrade to Leopard to begin or is 10.5.8 Leopard?
Click here and read all three steps to the bottom.
(72520) -
My iPhone 4 died and I have tried charging it and plugging it into the computer, but nothing happens execpt the dead battery thing that pops up when you charge it when it's completely dead.
Try:
- iOS: Not responding or does not turn on
- Also try DFU mode after try recovery mode
How to put iPod touch / iPhone into DFU mode « Karthik's scribblings
- If not successful and you can't fully turn the iOS device fully off, let the battery fully drain. After charging for an least an hour try the above again.
- Try another cable
- Try on another computer
- If still not successful that usually indicates a hardware problem and an appointment at the Genius Bar of an Apple store is in order.
Apple Retail Store - Genius Bar -
My ipod nano was working fine until i uploaded some new tunes today. It sync properly and once disconnected it just switched off and would not even turn on. I have put it on charge for a few hours but nothing happens, infact the charger is getting hot. Pleaseeeeeeeeeeee help I need my ipod.
The backlight burned out from getting it wet. You will have to replace the screen at a 3rd party shop, buy a screen and replace it yourself, or make a Genius Bar appointment at your nearest Apple Store and do an out-of-warranty replacement for $199 USD.
-
I have ab HP 3250 e all in one printer. I have downloaded the software and installed on my Mac Book Air running OS X Mavericks. When I try to print from the Mac Book it shows that it is printing but nothing happens at the printer end. Why?
For some reason I cannot synch my iPhone notes with the Mac Book. How dodo I do this?
How do I change my primary email address on the Mac Book?Hello Bruarong,
It sounds like you are unable to print to your printer from Mac OS X Lion. I recommend the troublehsooting from the article named:
Troubleshooting printer issues in OS X
http://support.apple.com/kb/ts3147
Follow these steps until the issue is addressed:
Make sure that the printer is powered on, has ink / toner, and that there are no alerts on the printer’s control panel. Note: If you cannot clear an alert on the printer's control panel, stop here and check the printer's documentation or contact the manufacturer for support.
Ensure the printer is properly connected to a USB port on the Mac or AirPort base station / Time Capsule. If the printer is a network-capable printer, make sure that it is properly connected to your home network.
Use Software Update to find and install the latest available updates. If an update is installed, see if the issue persists.
Open the Print & Scan pane or Print & Fax (Snow Leopard) pane in System Preferences.
Delete the affected printer, then add the printer again.
If the issue persists, try these additional steps:
Reset the printing system, then add the printer again.
If the issue still persists, reset the printing system again. Download and install your printer's drivers. Then, add the printer again.
Contact the printer vendor or visit their website for further assistance.
Thank you for using Apple Support Communities.
Take care,
Sterling -
I turned my iphone off when visiting the doctor's surgery and now it won't turn back on. It had 73% battery left and I have tried connecting it to my computer with USB but nothing happens. I have taken out and replaced the sim card too. Any suggestions
If wjosten's tip doesn't work try plugging it into a USB charger (not through your computer), wait about 30 seconds and it should come on. If it doesn't remove the cord from the phone and keep trying this. I've had this same issue and found a combination of the reset & charging cable tends to work. Sometimes it takes about 5 minutes for the phone to respond.
Best of luck. -
I tried to reset and the light blinks but nothing happens after that. It won't allow me to move the cursor on the home screen. Any suggestions?
Unplug the device from power and plug it back in.
If it still fails to respond properly, connect it to a computer via microUSB and restore via iTunes. -
when I launch it nothing seems to happen, if I look in processes in task amanegr it seems to be running but nothing happens on the screen, after a few minutes I get a run tme error.
The window could be opening off screen.
*See --> http://www.sevenforums.com/tutorials/75291-offscreen-window-move-back-desktop.html
'''If this reply solves your problem, please click "Solved It" next to this reply when <u>signed-in</u> to the forum.''' -
4 hours ago my iphone randomly turned off and now i cant get it to turn back on. Ive tried everything, trying to reset it, charging it but nothing works! the charging symbol doesnt even come up when i plugged in the charger. Please help!
Hello there, LaruaGalliers.
The following Knowledge Base article provides some great troubleshooting steps for your issue:
iPhone and iPod touch: Charging the battery
http://support.apple.com/kb/HT1476
Particularly:
Battery does not charge
Verify that the outlet being used is working.
Try another USB power adapter if available.
If no other USB power adapter is available, try connecting to a high-power USB 2.0 port (not a keyboard). The computer must be turned on and not in sleep or standby mode.
Try another USB cable if available.
iPhone or iPod touch displays the low-battery image and is unresponsive
If you see the image below, charge the iPhone or iPod touch with USB power adapter for at least 15 minutes.
You should see this image when iPhone or iPod touch begins to charge:
If the screen still displays the low-battery icon, try turning the iPhone or iPod touch off and then on again.
If the issue persists, follow these troubleshooting steps.
Thanks for reaching out to Apple Support Communities.
Cheers,
Pedro. -
My download has started but nothing happens. I can't threw it away and start again...how to do?
It has been loading all night, still in the beginning and nothing moves.Did I help you? That's great! I'm glad I could help
-
each time i try syncing my ipod with itunes, it freezes itunes and i end up having to shut down my computer. This started happening after the latest download and my latest purchase. The latest purchase doesn't show up on my iPod and itunes freezes at synching step 2 on 2. Any suggestions?
You should Reset your iPod, by
1. Press Menu and Center button simultaneously for about 10 Secs till the Apple Logo comes ON.
2. Disconnect the sync cable.
3. Check the iPod Welcome screen, select language, go to menu (if you are lucky, your music are still on the iPod.)
if your iPod doesn't show the Welcome screen, bring it to Apple Store.
If the above is okay, (can see Menu but no Music)
4. Close iTunes and Reboot your PC.
5. Start iTunes
6. Connect the iPod to the Sync cable.
7. if iTunes ask to Restore, please do so.
8. Sync your iPod. ( I would advise you to disconnect from Internet and stop the Antivirus program when doing this.)
Good Luck. -
iphone fails to turn on. The apple logo shows up but nothing happens after that
Hi Haleynichole_99!
I have an article here with some troubleshooting steps that can help you resolve this issue with your iOS device:
iOS: Unable to update or restore
http://support.apple.com/kb/HT1808
Thanks for using the Apple Support Communities!
Cheers,
Braden
Maybe you are looking for
-
Spry dropdown z-index problems in IE
Hello I'm having some trouble with the spry horizontal dropdown in IE, and it's interaction with SmoothGallery. In every browser (with the exception on IE 6&7 of course) the higher z-index values of the menu cause it to overlay the JS image gallery b
-
Insert or replace last content
HI Forum, I do need a little tweak on this script... Thing is, i want to find the last paragraph, last line, last character and make it as full stop... eg. • can do anything if you need; (";" to replace with "."). it is doing that,,, but if there
-
Most annoying bugs and one mighty strange one!
Ok so ive tried using logic 8 for time sensitive projects but ive switched back to 7.2 for now due to a pretty long list of bugs, some of which i outlined in another post. but the most annoying for me are the following. - on closing a project with al
-
Hi, I would like to submit a PDF form created with Live cycle designer ES2, I have set up the email creation & this is working well. One issue is I would like to be able to rename the attachment (the form) to a value for the form itself, at the mom
-
How to fix a corrupt file without the OSX Installation disk
I have a corrupt volume file, but need the OSX installation disk which I not longer have. How do I repair the corrupted file? http://www.pinterest.com/pin/create/extension/http://www.pinterest.com/pin/create/extension/