I have a MacPro 2008 workstation without Airport or Airport Extreme CArd isntalled. Can I use Airport Express to connect (wireless) to my wireless network? If so, can I then connect my Airport Extreme to my MAcPro by a ethernetcable ?

I have a MacPro 2008 workstation. It has no Airport/Airport card so I have to use an ethernetcable to connect to my modem. As the MAcpro
is in my office in the attic and the wireless modem is in the basement I have a problem. I wonder if it is possible to use Airport Express to connect to the wireless network? Itshould be like this: in my office I connect the MacPro with AE through an ethernet cable. If I can then get AE to connect (wireless...) to my wireless network I should be ablle to connect my MacPro to internet/wireless network. Is this possible???? Any suggestions are very much appriciated. Thank you.

Apple calls this configuration a ProxySTA.
To activate ProxySTA, you must set up the Express to join a wireless network and then enable the Allow Ethernet Clients setting; both settings are located in the Wireless tab of AirPort Utility.

Similar Messages

I have an airport extreme and express, if I use the extreme as a base station connected to my old router can I use the express to extend the signal while also creating a new network that only I can use?

I have an airport extreme and express, if I use the extreme as a base station connected to my old router can I use the express to extend the signal while also creating a new network that only I can use? Essentially having two wifi connection off the same network? If so how do I set this up?

Extending using a wireless connection always results in a performance compromise.
If the Express is going to extend using a wireless connection, then the Express will need to be located about half way between the AirPort Extreme and the general area where you need more wireless coverage. The more that you have line-of-sight between the Extreme and Express, the better the network will operate.
Remember......the Express can only "extend" the quality and signal speed that it receives, so it needs to be located where it can get a very good signal from the Extreme. Although Apple cleverly uses the term "extend", a more accurate term for the Express would be "repeater".
If the Express will extend by connecting to the Extreme using a permanent, wired Ethernet cable connection......highly recommended for best performance.....then the Express can be located exactly where you need more wireless coverage. There is no signal loss at all through the Ethernet cable, so the Express gets a full speed signal no matter where it might be located.
Post back to let us know which way to you want to go.

Can you use the apple time capsule as just a wireless hard drive without using it as a router

Can i use the apple time capsule as just a wireless hard drive without using a router

You can, but this type of configuration is not recommended or supported by Apple.
Two cautions if you want to try this:
1) The Time Capsule has to be configured to "Join" your existing wireless network in this type of setup...and to do that, you must know the exact type of wireless security that your network is using.
2) Backups are going to take twice as long. The wireless signal must travel from your computer to the wireless router and then from the wireless router back to the Time Capsule. Two "hops"......even if the computer is located close to the Time Capsule.
If you want to try this, we can tell you how....but with no guarantees on your results....since this is not officially supported.

Hi sir i have revoked the distribution certificate , and in one of my iPhone app i had used the same certificate if i will upload the next version of same app then will it create any problem or with the new certificate i can upload my next version of myap

hi sir i have revoked the distribution certificate , and in one of my iPhone app i had used the same certificate if i will upload the next version of same app then will it create any problem or with the new certificate i can upload my next version of myapp or not plz tell me as soon as possible

Sounds like you need to ask your question in the developers forums.

Since i have downloaded the new version of OS mavericks 10.9, i can't use adobe pdf and java anymore (all the softwares are updated) what can i do?

Hello,
Since i have downloaded the new version of OS mavericks 10.9, i can't use adobe pdf and java anymore (all the softwares are updated) what can i do?
thank you for the help

Uninstall version 6, Google for a download site for version 5.1. Problem solved.

How can I use firefox between windows 7 & windows XP on a network, where we are using Samba server. If a user logs on different workstation(and OS) with same account.

we have a Linux fileserver with Samba share and have several users.
The users tend to be in different locations and need to login at different workstations, sometimes the workstation may be WindowsXP and othertimes it is windows7.
How can we use Firefox & Thunderbird in this situation.
I find that Windows7 uses compressed files to store the location information.
when a user logs on to win7 it creates a new account.

we have a Linux fileserver with Samba share and have several users.
The users tend to be in different locations and need to login at different workstations, sometimes the workstation may be WindowsXP and othertimes it is windows7.
How can we use Firefox & Thunderbird in this situation.
I find that Windows7 uses compressed files to store the location information.
when a user logs on to win7 it creates a new account.

I have microsoft outlook installed on my Mac book pro, I can only use the outlook with the office server where it was setup, I can't use outlook else where, is there any way I can reset the settings in order to be able to use outlook every where?

I have microsoft outlook installed on my Mac book pro, I can only use the outlook with the office server where it was setup, outlook won't work out of office, is there any way I can reset the settings in order to be able to use outlook every where?

I can see my folders by clicking the X next to my name on the Inbox Folder. So I have my folders now, just cannot see them in the left colum or see multiple windows on Outlook. At this point, I can use the folders, just with limited functionality. Thanks -Gina

Hi All! I have an iphone 4s. I want to buy an ipad but torn between wifi or wifi cellular. Can I use for sure, my iphone 4s as the wireless hotspot for my ipad if I get the ipad wifi only? And if yes, is the signal/connection good? Thank you.

Hi all! I have an iphone 4s. I want to buy an ipad but I'm torn between wifi or wifi+cellular because of the price difference. Can I really use my iphone 4s as the wireless hotspot for my ipad? If yes, is the signal good and fast? Thank you for your response.

Yes you can if:
1: Your cellular provider offers a data tethering option.
2: You have subscribed to this option.
Speed will be as it is with your existing iPhone.

I have 3 apple Id accounts and put a15 dollar cift card on one of them and i put the wrong e-mail address to it and can not verify by I tunes

I have 3 apple Id counts and put a cift card on one of them, but I puy the wrong e-mail address to it to verify with I tunes? HELP PLEASE!!!!!!

I would contact iTunes:
http://www.apple.com/support/itunes/contact/

How can i use a express change for my iphone without a care plane?

i want to usw the express change but there is only a option to send it in! can u help me to find this? or a nuber to order this. is have made it last year but now it dosent work so.

You don't say where you are located. Here's a list of Apple's worldwide support numbers:
http://support.apple.com/kb/HE57

Dead Airport Extreme card?

For the last three days I have had issues with my G5 dual 2GHz and OS X 10.4.2, the latest updates to Airport software and firmware.
The signal strength meter in the menu bar or in Internet Connect is greyed out and the connection cannot be made -- eventually it gets to the point where the G5 cannot even remember any of my precvious connections. The Macwireless.com widget shows the connection and signal strength as bouncing from 0 to about 70% for all connections that are still recognized, with each location bouncing from the top of the list to the bottom and then sometimes disappearing altogether. After a short while the locations don't reappear... Once they're gone, they're pretty much gone without a trace (Airport Admin either cannot connect to the Airport, telling me an error occurred while trying to access it, or it doesn't see anything to get an error message from).
My G4 sits right next to the G5 and has shown no problems. Strangely, after a full day trying to troubleshoot this, the G5 started up today at full signal strength -- I'm using it now to write this message! Nothing has changed on this machine in the past week, except for me trying to get the Airport Extreme Card to function as it had for the month or two I've had it. Yesterday I lost connection altogether -- neither restarting the Mac nor a full shut down, wait a minute or two, restart would restore my connection. At one point, I shut down the machine for about an hour while I reseated the AE Card and let the computer become room temp (roughly 70 F). Still no go...
After eliminating all the variables I could think of, I've come to the conclusion that the Airport card is probably bad -- possibly malfunctioning with heat build-up (?). Problem is, how do I show this problem to a tech? Especially since it's a half-hour drive to the closest Apple store and longer to a third-party Apple repair shop. And knowing that once it's been off for a while and is on a workbench, it will behave like all intermittently faulty equipment and work perfectly. :-/
If anyone has trouble shooting suggestions, or can help me determine for sure that the card is the problem, please help!

Hi Julia,
Well, the card may have problems too, but I now think there's a software problem as others have suggested. It's odd because everything seemed fine for some time after applying the updates, so it appeared as if the card was bad or going bad. For me, I spent three days trying everything I could, including removing and re-seating the card, antenna wire and antenna, trying various configurations, resetting the Airport itself and so on. All to no avail.
On the last day, I had the strangest situation, where Mail could not see the Airport and could connect to nothing, but Safari was able to access the Internet! I used Safari to access sites I hadn't visited in months just to be sure I wasn't seeing cached versions of the pages... Eventually though, Safari lost contact, and that was it for the day.
After all that, the next day I turned on the Mac to see a solid connection that's been stable ever since except for the incident in my previous post where the Airport widgets knocked the connection out. Turning off those Widgets and closing Dashboard brought the connection back up immediately -- I haven't tried them again, and probably won't!.
Once I had the solid connection, I used Onyx to repair permissions, optimise the System and to empty the Network cache. I also deleted the various Locations I'd set up in the Network Preferences to get it back to just the one connection to choose from. If you're comfortable with Onyx (or Cocktail or one of the other utilities) you could try at least clearing the cache(s) and repairing permissions.
Have you tried a complete shut down and leaving the computer off overnight? Do you have anything set to open on startup that may try to connect with the Internet (like Mail or Safari)? Try removng them from your Startup Items (you can do this from the Dock -- click and hold on the icon and a mini menu should pop up with that option).
Have you looked at the info in System Profiler, and does it show the Airport card? (you can access System Profiler from the About This Mac item in the Apple Menu and clicking the button: More Info...) The card should show up under Network>Airpport Card.
Since you have a Powerbook, you have the option to take your computer to an Apple tech (Apple Genius at an Apple store, or to a dealer with a repair crew) and have them troubleshoot it. My guess is they'll end up reinstalling your OS and/or replacing the card... My G5 is far too heavy for me to throw it in the car -- and I found out the hard way yesterday that my computer is just 2 weeks out of warranty, so I'm ineligible for AppleCare. grrr... (my fault, but grrr...)
Let us know if anything good happens -- best of luck!

What model of Airport Extreme Card for 2007 Mac Pro 2.6GHz

I am trying to find what model of Airport Extreme Card I need to install into my 2007 Mac Pro 2.6GHz
I understand that there is a 2008 card which is incompatible, so I don't want to buy the wrong one.
Any help appreciated.
Laus.

Its really confusing when Apple calls their internal wireless card on a Mac an AirPort Extreme card......and they also market an outboard wireless router called an AirPort Extreme. See info below:
http://www.apple.com/airport-extreme/
You posted in the support community for the Apple wireless routers.....AirPort Express, AirPort Extreme and Time Capsule.
While it is possible that someone here might be able to answer your question, you will likely receive a much faster and more informated response if you post your question again in the support area for the Mac Pro.
The link to that support area is here:
Mac Pro

Using airport extreme card to connect iPhone to internet of mac ?

Is it possible to use a mac as wireless"base-station" for a iPhone by using an airport extreme card , if the mac is connected only by wire?
I created a network on my mac and my iPhone is connected to it, but it says the network is not connected to internet.
So can I connect the airport extreme card on my mac to the ethernet of my mac by changing the network settings on my mac?

Read here:
http://computers.tutsplus.com/tutorials/how-to-share-your-macs-internet-connecti on--mac-60309

Using a wire connected mac as wireless base-station by using airport extreme card

Is it possible to use a mac as wireless"base-station" for a iPhone by using an airport extreme card , if the mac is connected only by wire?
I created a network on my mac and my iPhone is connected to it, but it says the network is not connected to internet.
So can I connect the airport extreme card on my mac to the ethernet of my mac by changing the network settings on my mac?
If not, is there another way?

ok, i got the answer from another discussion. http://computers.tutsplus.com/tutorials/how-to-share-your-macs-internet-connecti on--mac-60309

Can I use an Airport Extreme and an Airport Express

Disappointed that the Extreme doesn't have a stereo input and an extra usb port so I can't use both my external drive, hook up the printer and have the stereo plugged in.
Can I use an express for iTunes and printer and at the same time have my external drive and internet hooked up to the Extreme?
At the moment I use an express for internet, music and printer.
Thanks.

lostinlondon, Welcome to the discussion area!
Disappointed that the Extreme doesn't have a stereo input...
None of Apple's base stations have stereo (audio) input. The AirPort Express (AX) has an audio output.
Can I use an express for iTunes and printer and at the same time have my external drive and internet hooked up to the Extreme?
Yes
But can I create a network with the airport express and airport extreme to use airtunes and airfoil?
Yes

I have a MacPro 2008 workstation without Airport or Airport Extreme CArd isntalled. Can I use Airport Express to connect (wireless) to my wireless network? If so, can I then connect my Airport Extreme to my MAcPro by a ethernetcable ?

Similar Messages

Maybe you are looking for