I have a power shot sx 40 & need to know : when up magnify a pic how do you save it on your camera ?
I have a power shot 40 & I learned how to zoom in/maginfy a pic but i can't figure out how to save the maginfied image.
Thanks ~
Solved!
Go to Solution.
Im not sure what you mean but if you mean when you zoom in on a photo in playback mode there is a way to save the zoomed area seperately from the original photo on the camera.
To begin select Trimming on the Playback menu.
Use the Zoom lever to resize the frame and you can press points on the Control Dial to move the frame around also.
You can also press the Disp to change the orientation.
When you are finished press Set and it will ask to Save New Image, select Ok.
Press Menu and when your promtped to Display New Image select Yes or No.
You might want to consider a book written specifically for your SX40. I own the SX50 and bought that book because much of it still applies. It is called A Short Course in Canon Powershot SX40 HS Photography written by Dennis P. Curtin.
The procedure I just told you came from that book which is clearer than how I would have decribed it mysef
Similar Messages
-
I have a Power Shot SD4500 IS and after battery is fully charged battery runs down without any use.
I have a Power Shot SD4500 IS and after charging battery then placing in camera and within a day the battery is dead. I have tried replacing with a new battery and have the same problem. Any suggestions?
The last time (2 years ago) I had a problem with my previous ELPH I was told it was less expensive to replace the camera than to repair, but after buying 2 in 5 years with limited use, this is getting old.
HELPPharmboy007,
I would like to ask a couple questions to see if I can determine what is causing the issue.
How long is the camera sitting before you are using it and finding out that the battery is no longer charged?
Does this happen with other batteries, or just the one battery?
If this is a time sensitive-matter, additional support options are available at Contact Us.
Did this answer your question? Please click the Accept as Solution button so that others may find the answer as well. -
I have a power PC that makes abunch of noise when plugged in but the power light just blinks when I press it and shows no graphics wht is wrong
Click here for information; if the computer beeps three or fewer times, remove and reinsert the computer's RAM. If it beeps four or more times, it needs to be repaired. If it's a G5, it will ignore RAM modules that aren't part of a matching pair.
(76386) -
I have a 3g iPhone and I need to know how to delete old photos. Need to free up space and there is no clear way to delete these photos!! Can someone please let me know how to get rid of these pictures!!!! Help!!!
There are a number of ways to delete pictures from the Camera Roll. One is to open Camera Roll in the thumbnail view, tap the arrow button (top right), tap all the pictures you want to delete, tap the Delete button ant the bottom. Photo Library pictures are deleted by unchecking Sync Photos on the Photos tab of your iTunes sync settings, followed by syncing your phone.
-
I have just purchased a new macbook and need to sync my iphone with itunes, i understand that you can only sync your phone with one itunes account. I do not want to wipe my iphone when syncing with this new itunes account. Any advice welcome
1) authorize iTunes on the new machine for your iTunes store account(s)
2) connect your device and right-click or control-click it in the iTunes Source list, then choose transfer purchases from the shortcut menu that appears.
3) sync the device
iTunes will wipe the iPhone but, since you transferred your purchases in the previous step, your content will be in your library and you can re-populate the iPhone with it. -
My computer crashed. I now have a new one and I need to know how to sync my iPad without losing the photos, contacts, podcasts, apps, etc I have on my iPad. Can anyone help?
Downloading past purchases from the App Store, iBookstore, and iTunes Store
Some items cannot be redownloaded. You will need third-party software for them - Phone to Mac - Pod to Mac | Macroplant.com or Phone to PC | macroplant.com depending on your hardware.
You might consider modifying your profile information so we will know what your hardware, OS, etc. is. Makes it easier to provided assistance. -
How to pull sales orders based on a Campaign ID??( I have created one Campaign and i need to know,for how many orders it was applicable)
Hello,
as far I understand you are talking about campaign determination. Once a sales order is generated having a campaign determined the campaign creates a reference to the sales order. The best way to track the assigned sales orders is using the related transactions function:
The same feature is available for trade promotions as well.
The data is available in table CRMD_BRELVONAE - you can also write a report selecting on OBJGUID_A_SEL with the campaign or TP guid and OBJTYPE_A_SEL with BUS2010020 for campaigns and BUS2010030 for trade promotions.
Is this answering your questions?
best regards,
Johannes -
I have a new MacBook Pro and need to know what I need to do to open Microsoft Office files?
Use a product such as OpenOffice, LibreOffice, Google Docs, iWork, or Microsoft Office 2008 or newer. In the case of Word documents, you can also use TextEdit.
(82026) -
I have an IPOD Touch and I need to know if there is a way to get the songs stored on the touch into my computer in I-Tunes.
This also says how to do for non-iTunes purchases
Recovering your iTunes library from your iPod or iOS device: Apple Support Communities -
can you have multiple Apple TV's in the same house and network? If so how do you know which one to pick from your Idevice?
Yes, there are even defaults for naming them, such as LivingRoom, Bedroom, etc, or you can even enter your own name with the remote for each AppleTV.
-
How do you make room on your start up disk. i am trying to do the update but don't have enough space
how do you make room on your start up disk. i am trying to do the update but don't have enough space
Try this:
1. Open "Finder", then navigate to "Movies" on the left side. Click on "iMovie Projects"
2. Move desired movies and clips to trash, or your flash drive.
*PS* Its dangerous to have a full hard drive, I would recommend either trashing, or transferring files to another computer. Trash applications you no longer use as well. -
When I go to do an update for my apps on my iPhone 4S it says that I am connected to the Chinese iTunes Store and tha I need to switch to the US store. How do you do that?
Settings > iTunes & App Stores > Apple ID: > View Apple ID > Country/Region...change here.
-
How do you date and time stamp iCal entries? We share an event calendar and need to know when a new event was entered into iCal.
BKBK,
Thank you for your response. That does adequately cover the
client-originated sessions, but still leaves the ability I am
looking for unavailable.
It did serve to definitively answer my most pressing
question, however, with this statement:
Note: ColdFusion cannot create a session if an initiator
application uses a SendGatewayMessage method to start an
interaction with a client, such as an SMS user. In this case, the
sending code must keep track (for example, in a database) of the
messages it sends and their destinations. When a response event
arrives, it can look up the origniatorID to determine whether it
was in response to an outgoing message.
I will play around with the Application scope to see if there
might be a workable solution there.
RLS -
I need to know when to sell the new Ipad 3.
I need to know when to sell the new Ipad 3 ?
Are you asking when to sell your new iPad (you can sell your iPad whenever you want to), or when it will be sold in your country (which you haven't said where that is) ?
-
I don't have enough storage space on my iPhone 4S to download the new OS7 so how do I save it to iCloud and remove it from my iPhone to make room but not loose the deleted stuff from iCloud?
You can't use iCloud like that. It isn't a general file storage service; it's designed to sync data across your devices.
Some options are to sync all your music or other media off your device, then sync it back on after you update. Another is to import your photos to your computer (http://support.apple.com/kb/HT4083), then sync them back to your phone after you update by putting them in a folder, then selecting the folder on the Photos tab of your iTunes sync settings and syncing.
Maybe you are looking for
-
Deployment Error : "No valid iviews"
Hi, I am new to Visual Composer. I have created a sample model using the example given in help.sap.com, During deplyment i got the error "No Valid iviews". Can anybody help me resolvng this error. Thanks Vinit
-
Address Book, importing text tab file, custom fields not there
Searched thru all past posts. Found some that are close but not what I am trying to do. Open Address Book, go into Preferences, select Template and under the Names field (friend, assistant, father, etc) I add a custom field called "Keyword". I also a
-
The emails from my hotmail account aren't syncing with both my ipad and iPhone. I have tried turning it on and off, deleting and reloading the account. The iPhone briefly worked on 3G but is now not working with that. Help please!
-
Problem with TypeDef and Ring constants
Hi folks! I've got a problem with my Ring-TypeDef. I defined a ring control as a Strict TypeDef, hoping that all constants of this Ring will be updated when I change the definition as it does with Enums. This does not work. Changes of the TypeDef tak
-
How to install Ant in Windows XP
Er, what do I do? I've downloaded the binary distribution from Apache; where do I put it so it will work from the command line?