I have tried a hard reset, plugged into my imac, and into the wall. The iphone 4 will not turn on.
I seriously need my phone. I did the hard reset. Didn't work. I waited longer. Didn't work. I plugged the phone into the wall. Didn't work. I tried hard resetting while plugged into my computer with iTunes on. Didn't work Anymore ideas? I really need my phone. iPhone 4. I hate this phone. My blackberry never caused me this much grief!
Paul's suggestion may work, but if the Hard Drive was writing when the power was cut abruptly, there may be data corruption, file index corruption or even physical damage to the drive as the read/write heads clash.
If the SMC reset doesn't work, first see if the installation DVD can be inserted. If it can, start up with the C key held down. OK the language screen, ignore the installer and select the Utilities menu at the top of the screen, open Disk Utility. Select the HD in te left pane and click repair (not repair permissions).
If you get a message that repairs were carried out, run the repair again until you either get "the volume xxxxx appears to be OK" or a message that repair can't be carried out.
If it won't boot to the disc, or the disc can't be inserted, try a single-user mode boot - hold down ⌘ and S on start up until the Unix prompt appears.
Type carefully this command
fsck -fy
then press return.
As before, if the prompt reappears with the message that repairs were carried out, run the check again until you either get "the volume xxxxx appears to be OK" or a message that repair can't be carried out (and assume the latter if it hasn't given an OK within 4 tries).
Type
reboot
and press return to attempt to start up normally.
If it still won't start, it's fair to say the HD is dead.
Similar Messages
-
Why can I print from my iPhone and not my iPad? I have been able to do it in the past. I have tried a hard reset but it still cannot find the printer.
In addition to rebooting the router and the iPad, I would reset the printer as well. Unplug the printer from power and do the same with the router. Leave the router unplugged for about 30 seconds. Plug the router in first and let it totally start up, plug the printer in again, and then reboot/reset the iPad.
Reboot the iPad by holding down on the sleep and home buttons at the same time for about 10-15 seconds until the Apple Logo appears - ignore the red slider if it appears on the screen - let go of the buttons. Let the iPad start up.
If that doesn't work, you can try resetting all settings. Settings>General>Reset>Reset All Settings. You will have to enter all of your device settings again.... All of the settings in the settings app will have to be re-entered. Your WiFi passwords, location services, device preferences all have to be re-entered. You will not lose any data or media whatsoever. -
my iPhone4 will not turn on or show that is working at all, i have tried to charge it so that the screen will light up but it won't work, when plugged into the computer iTunes does not show any sign it is plugged in, what do i do?
There is a hardware problem. Whether it's worth it to you to have no working phone for 2 months until you can update vs paying for replacement/repair now is a question only you can answer.
-
My iPhone 4 will not turn on. When I plug it into Itunes it says it is n recovery mode. I try to restore it and the error code code 3194. I have tried all the steps what now?
It is usually given as a communication error between Apple, iTunes (your computer), iPhone. Somewhere they are not communicating, so the iOS you are trying to install cannot be approved by Apple. Trouble shooting steps include, making sure you have Current iTunes installed, make sure your Hosts file of computer is not blocking Apple. Try restoring on another computer.
-
i plugged in my iphone 5S and locked the screen 20 minutes later I tried to open the phone it will not turn on i treid reset and that wont work I have a black screen,
I tried just holding down the power key...NOTHINGDo a reset, hold down the home/sleep button together until you see the apple logo and then release.
-
I just bought an AirPort express. Currently I have a qwest wired router plugged into the back of my computer via an ethernet cable. Can I just unplug the ethernet cable and plug it into the AirPort express, then use the setup utility? Most of the discussions involve an existing wireless network. I don't have one.
Correct. That's the way to set up the AirPort Express. After connecting your AirPort Express to the router, open AirPort Utility (in /Applications/Utilities) and follow the steps
-
my iPhone 5 will not turn on. The apple comes on and off every 4 seconds. I tried a hard reset. I tried connecting to Itunes. Wazup?
See Here > http://support.apple.com/kb/HT1808
You may need to try this More than Once... -
I have an iPhone 3gs that is out of warranty. I purchased this phone from AT&T. Last night my phoone went completely dead (battery percentage was at 96% just moments before) and now will not turn back on. I have tried just about everything I have found on discussion boards- trying hard reset, plugging into itunes, charging for15-20 mins then holding down sleep and homebuton..... NOTHING works. This phone will not light up AT ALL. My computer wont even recognize it. Is there anything else I can do?
Make an appointment at an Apple store if there is one nearby.
-
When my phone is not plugged into the charger or computer, it will not turn on at all; even though it is not dead. When it's plugged into the computer, it will go to a white screen with a grey apple icon and then it will turn off again and repeat. IOS7 and iPhone 5.
http://support.apple.com/kb/HT1808
Try this step and if you cannot get your device into recovery mode there is a chance you have a hardware failure and you need to call apple to see what service options you have. -
My Iphone 4 will not turn on. I have tried resetting it by holding down the lock and home buttons but no luck. I do not know how to reset it and it is only about 3 months old. Need help.
You might get more responses if you asked your question in the iPhone section. This section is devoted to iPad problems.
-
Does anyone know what "other" means in the sync summary bar? I have 850mb using storage space in my iphone and can't understand what that is. I have tried to delete everything, restore to factory settings and change the icloud account. Thanks.
Hi there AnthPy,
You may find the troubleshooting steps in the article below helpful.
OS X Mail: Troubleshooting sending and receiving email messages
http://support.apple.com/kb/ts3276
-Griff W. -
My iphone 4s will not turn on, It was working properly and then I noticed the battery was at 1% I then proceeded to charge my phone like normal but nothing happened. The phone was unable to turn back on it's been two hours I already, tried to reset but nothing works. I tried different chargers, my ihome nothing is working.
.
-
My iphone 3gs will not turn on. I plug it in to the wall and still get nothing...I plug into my computer and itunes nor my computer recognizes it, any ideas?
Could be a problem with the 30-pin connector port or the cable. Is there an Apple Store or Apple authorized support center nearby?
-
This afternoon I was used my iPhone 3G. I then put it aside (it was left on) for about an hour. When I went to use it again, nothing happens. The home button will not call up the lock screen. The lock button will not turn the phone on, off, or lock it. When I plug it into iTunes, it recognizes it to sync. Also if someone tries to call me it will ring on their end, but nothing on my end.
The iPhone is over two years old (purchased in April 2009), so it is out of warranty. Also, everything is up to date on the iPhone.
Does anyone have any idea what the issue might be?
Thank you in advance.
ShannonWhat iPhone do you have? You can check in settings>>general>> about.
If you have a 3G you cannot update beyond iOS 4.2.1. The 3G is over 4 years old an was discontinued over 2 1/2 years ago. You need the latest ios to run the latest versions of some apps. If you have a 3GS you can update.
If your phone is not responding, reset it by pressing and holding down both the home button ad lock/ sleep button simultaneously until the Apple logo appears. -
My iphone 5 will not turn on ....I have held both buttons down at the same for a long time and get nothing ...it is fully charged ....and other suggestions?
The screen on my iPhone 5 (iOS 8.1.3) went dark after unplugging it from the PC. I could still could see a backlight on the screen, but unresponsive. iOS was hung in this state.
I opted to try a reset holding power and home button, which succeeded in turning off the phone.
After that, the screen went completely off. Power button didn't appear to turn on the phone.
Upon plugging back to iTunes, I discovered, even as the screen was pitch black, the phone was actually able to power on, or off if I repeated the reset....I could hear the USB connection chime on the PC every time I powered on or reset. The iOS was in some sort of corrupted state with no screen output.
I couldn't restore to factory settings, as iTunes requires I disable "Find My Phone" on the phone itself, which I couldn't do without screen output. Also tried to put the phone in "Recovery Mode"...didn't work either.
I finally succeeded by:
Logging in via web browser to iCloud, locating the phone with the "Find My Phone" web app, and triggering [Erase]. iCloud reported the phone was successfully erased.
After a minute, the phone rebooted itself and screen output worked again.
I then restored my data and settings from my last backup using iTunes without further issues.
Hope this helps others.
Maybe you are looking for
-
Thinkpad T530 Hard Drive Cloning
Hello, I'm looking for best practices, recommendations, lessons learned, etc. for copying the hard drive contents of one T530 to nine other identical T530s recently purchased for software engineering usage. A current snap shot of our old laptops sho
-
10.9.2 2nd monitor fix
I called apple today 3/3/14 I got a great guy. MacPro 2.66 Nehalem 8 core I updated 5 days ago from 10.9.1 to 10.9.2 as soon as it was complete my 23" apple display stopped working (this is my main display). I use an acer 22" as a 2nd display this co
-
How to retrive multiple measures of a dimension in a single query
I am working on Hyperion Essbase.My front end is Alphabox.I need to retrive multiple members of a same dimension at one one query.Suppose i have product as 5 products, and locations as 5 locations, if i need to pull the data for products P1,P2,P4 and
-
Create Table with Compress for OLTP and error ORA-14464
Hello, i have a Oracle-DB 11.2 and want to use Advanced Compression. I want to create a table: CREATE TABLE TD_GE_1990 ( "name_id" NUMBER(1,0), "name_txt" VARCHAR2(100 BYTE) ) COMPRESS FOR OLTP; But i get: SQL-Fehler: ORA-14464: Kompressionstyp nicht
-
Disappearing List BG problem in IE - white block instead of transparent
Hi all, I have a frustrating Disappearing List Background issue... only in IE, all other browsers fine... PROBLEM: the drop down item 'Three Lounge' bar under 'Bars' should have a transparent background, but instead appears with a white block with th