I have tried everything to get itunes to recognize my ipad2. What can I do.
I have tried everything to get itunes to recognize my ipad. What do I do?
Try this, Plug your iPhone back into your computer make sure you exit iTunes, Try going into your device manager and see if your iPhone shows up, if you see it the right click on it and select uninstall. Then restart your computer and watch the system install your iPhone drivers again.
Similar Messages
-
I have a ipod 5th gen and i changed my password because everyone knew it. I had forgotten it and now it is fully disabled. I can not get it online anymore and i have tried everything to get it restored. Please help as I am really worried
Disabled
Place the iOS device in Recovery Mode and then connect to your computer and restore via iTunes. The iPod will be erased.
iOS: Wrong passcode results in red disabled screen
If recovery mode does not work try DFU mode.
How to put iPod touch / iPhone into DFU mode « Karthik's scribblings
For how to restore:
iTunes: Restoring iOS software
To restore from backup see:
iOS: Back up and restore your iOS device with iCloud or iTunes
If you restore from iCloud backup the apps will be automatically downloaded. If you restore from iTunes backup the apps and music have to be in the iTunes library since synced media like apps and music are not included in the backup of the iOS device that iTunes makes.
You can redownload most iTunes purchases by:
Downloading past purchases from the App Store, iBookstore, and iTunes Store
If problem what happens or does not happen and when in the instructions? When you successfully get the iPod in recovery mode and connect to computer iTunes should say it found an iPod in recovery mode. -
I have tried everything to get my iPhone 4S to ring out loud. It will only vibrate.
I have tried everything to get my iPhone to ring aloud. It will vibrate when someone calls but it will not ring at all. Please help me!! Thanks
You have gone to Settings > Sounds and the volume is set at a high level, you have selected a Ringtone for the sound, and it still does not ring? Try a reboot by holding both the power and home buttons until the apple logo appears and it restarts, ignoring the red slider if it appears.
If that does not help, visit an Apple store genius bar and have the iPhone tested to see if there is a hardware failure. -
I cannot connect to itunes store but my network connections are fine and I have tried everything on the itunes support site. I just want to authorize my computer. Can anyone help?
If you are still having these type of problems after trying the winsock reset, refer to this article to identify which software in your system is inserting LSP:
iTunes 10.5 for Windows: May see performance issues and blank iTunes Store
http://support.apple.com/kb/TS4123?viewlocale=en_US -
ITS ALMOST BEEN A WHOLE MNTH I HAV TRIED EVERYTHING I DID ALL THE RESETS AND RESTORE YOU CAN DO. CAN ANYBODY TELL ME HOW TO FIX MY PROBLEM OR HAVE ANY OTHER SUGGESTION I WOULD BE ABLE TO DO ON MY PHONE OR HAVE I PRETTY MUCH TRIED EVERYTHING THAT I CAN DO AND NOW NEED TO TAKE IT UP TO AN APPLE REP AT THE APPLE STORE?
There's a whole lot to read in your post, and frankly I have not read it all.
Having said that, this troubleshooting guide should help:
http://support.apple.com/kb/TS1538
In particular, pay attention to the mobile device support sections near the bottom, assuming you have already done the items above it. -
My iPhone will not restore the process starts and then a message pops up saying 'we are unable to continue with your activation at the time' I have tried a few times now and the same. What can I do ? As I can't use iPhone at all now!!
Sorry... But...
The discussion of Jailbroken Devices is against the Terms of Use of this Forum.
You will need to look elsewhere.
Unauthorized modification of iOS
http://support.apple.com/kb/HT3743 -
I have creative cloud on my lap top but downloaded the second on my desktop. It is only allowing me to use the trial of After effects and I have tried everything and it still won't let me. It keeps asking for a serial number.
make sure you used the correct adobe id (the one you used to subscribe).
if you did, check for connectivity problems, Sign in, activation, or connection errors | CS5.5 and later
if that fails to reveal the problem,
contact adobe support, https://helpx.adobe.com/contact.html -
MY internet sharing wont work at all have tried everything to get it working
Hey guys it still doesnt work for me i have tried everything here is photo to show what is showing on my screen. it just stays gray and does nothing else
I have tried rebooting it and everything but still no and it is giving me a killer headache please helpWho's sharing network is this?
-
I can't seem to get my Imessages to send on my mac. I have tried everything, and it says it is synced to my phone.. Not sure what else to do to fix it??
..any joy finding an answer? I am stumped, too. Every day I convert Pages Docs to Word and PDF to forward to clients .. and all of the sudden last night Pages wouldn't let me convert. it was late -- I was frustrated, so I thought it was just me. Shoot me an answer if you found one. Tried rebooting, and no joy.
Thanks
T -
Recently I have not been able to open iTunes,I tried removing and reinstalling it but still won't open. I now get the message The file "iTunes Library.itl cannot be read because it was created by a newer version of iTunes. Any suggestions on how to get iTunes to work again ?
Thanks
<Edited by Host>Empty/corrupt library after upgrade/crash
Hopefully it's not been too long since you last upgraded iTunes, in fact if you get an empty/incomplete library immediately after upgrading then with the following steps you shouldn't lose a thing or need to do any further housekeeping. In the Previous iTunes Libraries folder should be a number of dated iTunes Library files. Take the most recent of these and copy it into the iTunes folder. Rename iTunes Library.itl as iTunes Library (Corrupt).itl and then rename the restored file as iTunes Library.itl. Start iTunes. Should all be good, bar any recent additions to or deletions from your library.
See iTunes Folder Watch for a tool to catch up with any changes since the backup file was created.
When you get it all working make a backup!
tt2 -
HELP ME PLEASE!!!!!
Hi,
You can have monitoring latency and hardware latency and this sounds like hardware latency. What interface do you have and have you done a loopback test?
"Even when I record with the track muted, and I have tried this several times with vocals that are dead on time. When I play it back the track is slow. I know they're recording right, because I can drag the entire track forward a little and get it to sync"
Because you can drag the whole track forward it means that your vocal, despite being in time with itself, is not in sync with the already recorded tracks.
Do a loopback test.
Record a transient sound (hi hat is good) make sure it is dead on the beat, use a midi hi hat and then turn it into audio, Route the recorded audio (hi hat) out of your interfave and then back into your interface to record it on a fresh track. Make sure you don't route them to the main outs to avoid a feedback loop.
Once you have both tracks of hi hat zoom in. The second track will be out with the original and this is the latency of your interface. Zoom right in, you can use the timeline to calculate how many samples it is out. My Motu 828 Mk2 is 58. You then offset this in the Recording Sample offset in your Preferences (not in front of Logic right now so I can't remember the exact term).
Once you have set the offset, do the loopback test again, you can keep all the tracks just make sure you're always using your original, smack on the beat track as your original.
Once the re-recorded matches the original you will have compensated for your interface latency. You do not need to change this if you change sample rate or bit depth. Once you have set it, it stays that way.
Try it and see how you go. If you get stuck there are a few other walk throughs of a loopback test on this very forum.
Hope it helps. -
My iPhone 4S has lost some of my purchased from iTunes music. I have been unable to get it back. why
Hello mvanderkooi
You would have to wait the 90 days is up before associating it again with that computer. The article below will explain about link your Apple ID with iTunes and devices.
iTunes Store: Associating a device or computer to your Apple ID
http://support.apple.com/kb/ht4627
Regards,
-Norm G. -
My Apple 4s does not appear in my Itunes. I downloaded Itunes again. I rebooted my phone. Still nothing. My phone will not sync with my computer. What must I do?
randers4 wrote:
Go through the troubleshooting steps in this article: iOS device not recognized in iTunes for Windows.
Thats what I just posted -
I purchased a new laptop with windows 7 and i am using mozilla firefox as browser and i cannot get itunes to download at all. it will download to 99% with a few seconds remaining but will not complete the download. Any suggestions on what to try next as i have tried turning off firewalls etc. I have wiped the computer and reloaded everything again but still i cannot get itunes to load
I purchased a new laptop with windows 7 and i am using mozilla firefox as browser and i cannot get itunes to download at all. it will download to 99% with a few seconds remaining but will not complete the download. Any suggestions on what to try next as i have tried turning off firewalls etc. I have wiped the computer and reloaded everything again but still i cannot get itunes to load
-
I have an ipad 2 I have tried everything to get it to power on and unfreeze
I have done the Sleep/home button holding it down over and over and still get the same apple logo that will stay on and then finally goes away. I have tried over and over to connect to itunes and it keeps giving me an error that it can not connect. It acts like it will sync but then won't I have even tried to connect to a different computer that uses windows (I have a mac) and it still is giving me an error you can hear it sync the apple logo comes on then it goes off. Is there anything else that any knows to do? All i did was plug it in to charge it and it came on for a few seconds froze up and won't work from then on. Worked fine the day before.
Frozen or unresponsive iPad
Resolve these most common issues:
• Display remains black or blank
• Touch screen not responding
• Application unexpectedly closes or freezes
http://www.apple.com/support/ipad/assistant/ipad/
iPad Frozen, not responding, how to fix
http://appletoolbox.com/2012/07/ipad-frozen-not-responding-how-to-fix/
iPad Frozen? How to Force Quit an App, Reset or Restart Your iPad
http://ipadacademy.com/2010/11/ipad-frozen-how-to-force-quit-an-app-reset-or-res tart-your-ipad
Black or Blank Screen on iPad or iPhone
http://appletoolbox.com/2012/10/black-or-blank-screen-on-ipad-or-iphone/
What to Do When Your iPad Won't Turn On
http://ipad.about.com/od/iPad_Troubleshooting/ss/What-To-Do-When-Your-Ipad-Wo-No t-Turn-On.htm
iOS: Not responding or does not turn on
http://support.apple.com/kb/TS3281
Home button not working or unresponsive, fix
http://appletoolbox.com/2013/04/home-button-not-working-or-unresponsive-fix/
iPad: Basic troubleshooting
http://support.apple.com/kb/TS3274
Cheers, Tom
Maybe you are looking for
-
Mac Air takes a very long time when manually putting to sleep
I put my Mac Air in sleep mode from the apple icon after Im dont using it but sometimes takes a very long time to shut down. Then Im not sure if sometimes it goes into sleep mode by itself first. My mac notebook as soon as you hit sleep it shut down
-
Creative Media Player does not work on my
I have removed audio card rebooted and then istall the drivers but I can't get Creative Media Player to show up on my PC I'm using the following on my PC: Wlindows XP Professional SP2 Microsoft Office Professional Enterprise Ed. 2003 SP Microsoft Off
-
Error 472 in job queue process + ORA-472: PMON process terminated with err
Hi, I've an Oracle Database 11g Release 11.1.0.6.0 - 64bit Production With the Real Application Clusters option. Yesterday instance on node1 crashed. This is the extract of alert log: Errors in file /u01/app/oracle/diag/rdbms/evodb/EVODB1/trace/EVODB
-
Windows Integrated Authentication to SAP R/3
Hi, I dont know weather this issue has to be posted here or in WAS or GUI. Is there any way to do the Integrates Windows Authentication to SAP R/3. Once the Users logs in to the Network domain adn then to SAP GUI, the User should not prompt for User
-
My Macbook Dvd rom has stopped working. It is not reading any DVDs or CDs. When I insert a DVD it tries to read it but after a minute or two it spits it out. I don't know what the problem is? Even though the system profiler shows it working fine and