I just jail broke my iPod and its stuck on the apple logo what should i do?

i just jail broke my iPod and its stuck on the apple logo what should i do?

The same thing happened to me. I assume it is stuck in an endless loop of restarting. You have to put it in connect to iTunes mode (http://www.youtube.com/watch?v=rm2D7-PCTaw) then restore your iPod. Hope it helps!

Similar Messages

  • My ipod touch is stuck in the apple logo, what should I do?

    My ipod touch 4G, iOS 4.2.1, is stuck in the apple logo, and it turns on and off alone, but it is still in the logo, it doesn't proceed. This happened because I restored through the ipod not iTunes. Itunes doesn't find the Ipod, even though if I wait a long time. What should I do?

    Hi,
    Try resetting your iPod:  http://support.apple.com/kb/HT1430. 
    Hope this helps! 
    ---likeabird---

  • , ii reset my ipod and now its stuck on the apple logo what do i do to fix it? reset my ipod and now its stuck on the apple logo what do i do to fix it?

    i reset my ipod and now its stuck on the apple logo what do i do to fix it? reset my ipod and now its stuck on the apple logo what do i do to fix it?

    Try:
    - iOS: Not responding or does not turn on
    - Also try DFU mode after try recovery mode
    How to put iPod touch / iPhone into DFU mode « Karthik's scribblings
    - If not successful and you can't fully turn the iOS device fully off, let the battery fully drain. After charging for an least an hour try the above again.
    - Try on another computer                            
    - If still not successful that usually indicates a hardware problem and an appointment at the Genius Bar of an Apple store is in order.
      Apple Retail Store - Genius Bar                              

  • I have a iphone 4s and its stuck at the apple logo to comes up then fades away and every time i try to restoring with iTunes it gives me a 4013 error i changed the charging port/dock and the battery ive also used a different computer and cable

    i have a iphone 4s and its stuck at the apple logo to comes up then fades away and every time i try to restoring with iTunes it gives me a 4013 error i changed the charging port/dock and the battery ive also used a different computer and cable

    See: http://support.apple.com/kb/TS3694#USB
    However, the most likely reason is your self-repair of a device that is only factory repairable broke something. Note that Apple does not sell replacement parts, so whatever parts you used were not made by Apple's supplier and are of questionable quality.

  • During the last week my Iphone has been switching off/on on its own and now my Iphone got stuck at the apple logo.What should I do?

    During the last week my Iphone has been switching off/on on its own and now my Iphone got stuck at the apple logo.What should I do?A month ago it also happened but then everything got back to normal.A person told me to change th display...what should i do?please help!

    Hey adinat,
    Welcome to Apple Support Communities! I would go through the steps in the iPhone troubleshooting assistant and see if that resolves the issue you're experiencing on your iPhone 5:
    Frozen or unresponsive iPhone
    http://www.apple.com/support/iphone/assistant/phone/
    Regards,
    David

  • I have a macbook air and its stuck on the apple logo

    its o osx 10.8.4 its 126gb 13 inch screen and its stuck on the apple logo

    Take each of these steps that you haven't already tried. Stop when the problem is resolved.
    Step 1
    The first step in dealing with a boot failure is to secure your data. If you want to preserve the contents of the startup drive, and you don't already have at least one current backup, you must try to back up now, before you do anything else. It may or may not be possible. If you don't care about the data that has changed since your last backup, you can skip this step.   
    There are several ways to back up a Mac that is unable to boot. You need an external hard drive to hold the backup data.
         a. Boot into the Recovery partition, or from a local Time Machine backup volume (option key at startup.) When the OS X Utilities screen appears, launch Disk Utility and follow the instructions in this support article, under “Instructions for backing up to an external hard disk via Disk Utility.”
    b. If you have access to a working Mac, and both it and the non-working Mac have FireWire or Thunderbolt ports, boot the non-working Mac in target disk mode. Use the working Mac to copy the data to another drive. This technique won't work with USB, Ethernet, Wi-Fi, or Bluetooth.
    c. If the internal drive of the non-working Mac is user-replaceable, remove it and mount it in an external enclosure or drive dock. Use another Mac to copy the data.
    Step 2
    Press and hold the power button until the power shuts off. Disconnect all wired peripherals except those needed to boot, and remove all aftermarket expansion cards. Use a different keyboard and/or mouse, if those devices are wired. If you can boot now, one of the devices you disconnected, or a combination of them, is causing the problem. Finding out which one is a process of elimination.
    If you've booted from an external storage device, make sure that your internal boot volume is selected in the Startup Disk pane of System Preferences.
    Step 3
    Boot in safe mode. Note: If FileVault is enabled, or if a firmware password is set, or if the boot volume is a software RAID, you can’t do this. Post for further instructions.
    Safe mode is much slower to boot and run than normal, and some things won’t work at all, including wireless networking on certain Macs.
    The login screen appears even if you usually log in automatically. You must know your login password in order to log in. If you’ve forgotten the password, you will need to reset it before you begin.
    When you boot in safe mode, it's normal to see a dark gray progress bar on a light gray background. If the progress bar gets stuck for more than a few minutes, or if the system shuts down automatically while the progress bar is displayed, your boot volume is damaged and the drive is probably malfunctioning. In that case, go to step 5.
    If you can boot and log in now, empty the Trash, and then open the Finder Info window on your boot volume ("Macintosh HD," unless you gave it a different name.) Check that you have at least 9 GB of available space, as shown in the window. If you don't, copy as many files as necessary to another volume (not another folder on the same volume) and delete the originals. Deletion isn't complete until you empty the Trash again. Do this until the available space is more than 9 GB. Then reboot as usual (i.e., not in safe mode.)
    If the boot process hangs again, the problem is likely caused by a third-party system modification that you installed. Post for further instructions.
    Step 4
    Sometimes a boot failure can be resolved by resetting the NVRAM.
    Step 5
    Launch Disk Utility in Recovery mode (see Step 1.) Select your startup volume, then run Repair Disk. If any problems are found, repeat until clear. If Disk Utility reports that the volume can't be repaired, the drive has malfunctioned and should be replaced. You might choose to tolerate one such malfunction in the life of the drive. In that case, erase the volume and restore from a backup. If the same thing ever happens again, replace the drive immediately.
    This is one of the rare situations in which you should also run Repair Permissions, ignoring the false warnings it may produce. Look for the line "Permissions repair complete" at the end of the output. Then reboot as usual.
    Step 6
    Reinstall the OS. If your Mac was upgraded from an older version of OS X, you’ll need the Apple ID and password you used to upgrade.
    Step 7
    Repeat step 6, but this time erase the boot volume in Disk Utility before installing. The system should automatically reboot into the Setup Assistant. Follow the prompts to transfer your data from a backup.
    Step 8
    A dead logic-board battery in a Mac Pro can cause a gray screen at boot. Typically the boot failure will be preceded by loss of the startup disk and system clock settings. See the user manual for replacement instructions.
    Step 9
    If you get this far, you're probably dealing with a hardware fault. Make a "Genius" appointment at an Apple Store to have the machine tested.

  • I reset my whole ipod in the settings and its stuck at the apple logo

    I went to settings and reset the whole ipod to factory settings and its stuck at apple logo and wont turn on what do i do

    Try #2 and #3 in link below.
    Basic troubleshooting steps  
    17" 2.2GHz i7 Quad-Core MacBook Pro  8G RAM  750G HD + OCZ Vertex 3 SSD Boot HD 
    Got problems with your Apple iDevice-like iPhone, iPad or iPod touch? Try Troubleshooting 101

  • I was trying to update my ipod touch but the update failed now it wont sync with itunes and its stuck on the Apple logo with a empty loading bar under it can anyone please help i dont know what to do

    Someone please help

    Try:
    - iOS: Not responding or does not turn on
    - If not successful and you can't fully turn the iPod fully off, let the battery fully drain. After charging for an least an hour try the above again.
    - If still not successful that indicates a hardware problem and an appointment at the Genius Bar of an Apple store is in order.

  • I removed an app on the 3gs, and now my phone is really slow, so i turned it off, and turned it on again, and its stuck with the apple logo any ideas what to do?

    ive also tried holding the home button and the sleep/wake button, it went off and came on and is still stuck on apple logo

    If after you have tried the restart method (Hold down the home button and the power button for at least 15 seconds) then I would advise doing a complete factory reset on the phone.
    Connect the phone to your computer, and once the device appears in the top right bar, click on it (It will be titled something like "Amanda's iPhone, or iPhone").
    Once you have done this, click on the back up iPhone option, (This will save whatever files on your iPhone that aren't on your computer, to your computer.)
    After this is done, click the "Restore iPhone" tab to completely reset the phone. If this option won't work, try the first method again when your phone is plugged into your computer and hold the home and power button the same time.
    Hope one of these will work for you:)

  • What to do when my ipod touch gets stuck on the apple logo?

    My ipod is stuck on the apple logo what should i do.I tryied restoreing it but it still gets stuck.

    Try holding Volume-Up button down when booting. Do you get to Home screen?
    Basic troubleshooting steps  
    17" 2.2GHz i7 Quad-Core MacBook Pro  8G RAM  750G HD + OCZ Vertex 3 SSD Boot HD 
    Got problems with your Apple iDevice-like iPhone, iPad or iPod touch? Try Troubleshooting 101
     In Memory of Steve Jobs 

  • I powered off my ipod touch and turned it back on and now its stuck on the apple logo

    I turnred ipod touch off and few seconds later, i turned it back on. Now its stuck on the apple logo for more than 6 hours.. :/ anyone knows the proble? D;

    Can't connect to the iTunes Store

  • My ipod touch get restart by itself and just get stuck with the apple logo, What can i do?

    my ipod touch get restart by itself, and just get stuck with the apple logo, What can i do?

    Try connecting it to your iTunes library in recovery mode using the instructions in this Apple support document.
    http://support.apple.com/kb/ht1808
    Otherwise, try connecting in DFU mode.
    http://www.iclarified.com/entry/index.php?enid=1034
    B-rock

  • How do I restore my ipod 4g when its stuck in the apple logo and the sleep button is broken?

    I really need help! Its stuck in the apple logo and my sleep button is broken. So i cant go into recovery mode.

    Try:
    - iOS: Not responding or does not turn on
    When it says try recovery mode use one of these programs
    For PC
    RecBoot: Easy Way to Put iPhone into Recovery Mode
    If necessary:
    Download QTMLClient.dll & iTunesMobileDevice.dll for RecBoot
    For MAC or PC       
    The Firmware Umbrella - TinyUmbrella
    - If not successful and you can't fully turn the iOS device fully off, let the battery fully drain. After charging for an least an hour try the above again.
    - Try on another computer
    - If still not successful that usually indicates a hardware problem and an appointment at the Genius Bar of an Apple store is in order.
      Apple Retail Store - Genius Bar

  • I turned off my ipod touch but it wont turn back on its stuck on the apple logo

    i turned off my ipod while there were apps dowloading. but its taking a long time to turn back on its just stuck on the apple logo what do i do or do i wait?

    Try:
    - iOS: Not responding or does not turn on
    - Also try DFU mode after try recovery mode
    How to put iPod touch / iPhone into DFU mode « Karthik's scribblings
    - If not successful and you can't fully turn the iOS device fully off, let the battery fully drain. After charging for an least an hour try the above again.
    - If still not successful that usually indicates a hardware problem and an appointment at the Genius Bar of an Apple store is in order.
    Apple Retail Store - Genius Bar       

  • My ipod touch is stuck on the apple logo. i restored and updated it with itunes and now it wont get off the apple logo. what does this mean and what do i need to do?

    i was trying to delete some songs from my ipod. so i plugged it into itunes and it froze. i help the home and menu button to reset it and now its stuck on the apple logo. i plugged it back into itunes, it updated the software i dont know if it restored the ipod. but now its stuck on the logo and it keeps going to the white screen and then back to the logo. what do i do?

    Try restoring. Make sure you have a backup first.

Maybe you are looking for

  • Free goods+ discounted item

    Hello all, Could you help in configuring the scenario wherein : <b>.</b> we give a shirt free on purchase of two shirts and a discounted price of 30% on the pants. i.e. 1 item free on purchase of 2 and the 3rd item at discounted rate. If not clear pl

  • Urgent  regarding table names

    Hi All, can anyone tell me the names of the fields or tables from which i can refer the fields for the following Pick status --date n time WM activities ---date n time Confirmation ---date n time Packed ---date n time it is related to  SD Points will

  • How to create .exe file of the java program you create?

    This must be the qustions asked several time on the forums.So here it is again. This sounds absurd to some developers here cause you'll say just create jar file and distributre to usr but sometimes there is not possiblity of having runtime environmen

  • Can i order my pictures and creat albums via nokia...

    hi ,can i creat albums and put my pictures in albums in my phone 6720  with nokia pc suite?

  • Prime 2.0: Disable HTTPS (GUi)

    Hi, Howto disable HTTPS by default in Cisco Prime 2.0? I cannot see that it's stated in the Documentation. This function was able to set in LMS 4.2 & PI 1.3. Best Regards, / W