I kep loosing my Wi-Fi conection on my new ipad, I kep loosing my Wi-Fi conection on my new ipad
I keep loosing my Wi-Fi conection on my new ipad, I kep loosing my Wi-Fi conection on my new ipad
Try the suggestions here: http://support.apple.com/kb/TS1398
Similar Messages
-
IPad 2 loosing conection with printer
Hello everybody,
I got my iPad 2 since a few months, bought an HP Officejet 6500 E710N printer to be able to print from my iPad.
I've gone through most of the web discussions, done most of all suggestions from everybody and nothing solved the problem.
The only time i can print from my iPad to the printer is during a short 60 seconds after i powered up my printer, after this time my iPad looses connection. My printer works every time when i print in wifi mode via my computer.
All my drivers for the wifi router, printer and iPad are up-to-date.
I have a D-Link router, model DIR-825 with the 5GHz band disabled.
I contacted D-Link, HP for the printer and Apple (without feedback from Apple) and everybody says it's not their fault !
Can somebody help, i'm discouradged and disapointed !
Many thanks for your support !
SamDear rbii,
I just solved my problem: I just purchased an Apple AirPort Extreme router.
I had enough searching the internet for solutions that probably don't exist.
I'm stuck now with a D-Link router and had to pay the big price for the Apple device, but now I can print from my iPad to my HP Officejet A printer without any disconnection.
To all those who have the same type of problem, chances that the router is the cause are very high, if you don't want to loose your mind on trying to find a solution, you should think about the Apple router !
Please note that this router is much faster than the D-Link, at least twice the speed and videos are flawless !
With regards,
Sam -
TS3048 wireless mouse loosing conection
I have problems with wireless mouse, frequently loosing connection
Apple's build-in bluetooth connection for peripherals isn't all that great.
As a result of this it is possible that your mouse disconnects from time to time. I've experienced through the years, that their signal is indeed very weak.
If this is not an experience threatening problem, I would not worry about it too much.
Another cause of this problem might be your batteries. I myself am unaware of the exact link between batteries and your connection, but googling the internet might provide some insight on the situation. -
iPhone5 is a perfect phone, but it holds one critical error. It is to demanding on the signal requirements for maitaining a call..
Many places i travel there is just 2 and 3 marks on signal strenght that should be more than enough, but the phone just goes anoyingly silent and cuts the call..
I have red that the iphone5 has an antenna issu, and that is completly true.. I have other tlfns to compere with on the same places were it is impossible to make phonecalls with my iPhone... As with my other phones i talk nice and good on these places, but with my iPhone the call just conects and then goes silent and break.. This happens everytime, over and over again.... How in 2013 production can this be a production problem? I know it just not my iPhone , but many others i talk to as well that has the same problem with their iphone5... I read about it around on the Internett as well, as a common problem for this phone...
Why is it not fixed by an uppdate on the phone, when its for sure an software weaknes?
I seriously considering leaving in my phone back for getting my money refounded if this problem dosent get fixed...
Shame on u Apple for beeing this incompentent, when mobilphones not actually is any young baby anymore...
Fix it!!My daughter has had her Razr for about 9 months now. About two weeks ago she picked up her phone in the morning on her way to school when she noticed two cracks, both starting at the camera lens. One goes completely to the bottom and the other goes sharply to the side. She has never dropped it and me and my husband went over it with a fine tooth comb. We looked under a magnifying glass and could no find any reason for the glass to crack. Not one ding, scratch or bang. Our daughter really takes good care of her stuff, but we still wanted to make sure before we sent it in for repairs. Well we did and we got a reply from Motorola with a picture of the cracks saying this was customer abuse and that it is not covered under warranty. Even though they did not find any physical damage to back it up. Well I e-mailed them back and told them I did a little research and found pages of people having the same problems. Well I did not hear from them until I received a notice from Fed Ex that they were sending the phone back. NOT FIXED!!! I went to look up why and guess what there is no case open any more for the phone. It has been wiped clean. I put in the RMA # it comes back not found, I put in the ID #, the SN# and all comes back not found. Yet a day earlier all the info was there. I know there is a lot more people like me and all of you, but they just don't want to be bothered so they pay to have it fix, just to have it do it again. Unless they have found the problem and only fixing it on a customer pay only set up. I am furious and will not be recommending this phone to anyone. And to think I was considering this phone for my next up grade! NOT!!!!
-
The new iPad looses conection to cell every once in a while
The New iPad looses cell connection every once in a while even thought my iPhone stays connected constantly. M carrier is AT&T for both the iPad and the iPhone. It just goes into searching more for a couple of minutes and then it connects again.
First, try bringing up Control Center by swiping up from the bottom of the home screen. Turn on the flashlight by tapping the icon in the lower left. Does the flashlight work? If not, perhaps you have a hardware issue.
If it works, check the top of the screen when you open the Camera app to make sure you have the flash on. -
Pc suite always looses conection with cable N78
when i try to send applications to my n78 via the data cable it gives a error message lost connection with phone it will work fine to update software or use in data mode so its not the cable. its the latest pc suite im useing.
I can send applications via bluetooth no problems, has any one got any ideas? i have even tried a different cable.
Solved!
Go to Solution.I have alredy got that version, I have 2 genuine nokia data cables the one that came with the phone and the one I got with my 6500 slide neither with transfer applications but will do all the other jobs, but the cheap chinese copy works fine. This does not inspire me to buy genuine spares if they are not as good as the copys.
-
When RSPAN enabled in destianation port UCCX loose conectivity
dear all
i connect my uccx8.5 to core 3560 x switch and i have agents connected to 2960 edge switches
when i put the destination port in remote span my uccx 8.5 lose its connectivity and i cannot ping it
i have the following configuration on my edge 2960
monitor session 1 source interface Fa0/3 , Fa0/7 , Fa0/9
monitor session 1 destination remote vlan 10
in my core 3560x
monitor session 1 destination interface Gi0/2 encapsulation dot1q ingress .....
monitor session 1 source remote vlan 10
after inggress which vlan should i put....
my phones vlan 3
remoate SPAN vlan 10
my server vlan 2 uccx8.5concord_83,
do you have a network topology in a document that you could send over? Actually, what are you trying to achieve? Recording? Monitoring?
I guess you want to do SPAN on the access layer only, where phones _should_ be on a separate (voice) VLAN (so to say, switchport voice vlan V), then I'd do:
monitor session 1 source vlan V
monitor session 1 destination remote vlan X
! V is the voice vlan number
! X is the vlan number for monitoring
On the core layer, I'd write:
monitor session 1 source remote vlan X
monitor session 1 destination interface fa0/2
! interface fa0/2 is where UCCX server or recording server is connected to
There's also a technote on SPAN.
G. -
Does anyone know how to reset a iphone without looosing messages and photos
A reset does not affect any data on the device.
A restore does affect data on the device.
What are you actually trying to do? -
Router looses conection when rebooting laptop
Hi, i have a wrt54g, with a cable modem connection, and every time y reboot my laptop the internet connection is lost. I get a message "connection limited or null", my IP address is not static, can these affect? Thanks
hEy!
actually,,even if your laptop is not set to static it is supposed to get the connection automatically after reboot....
when you hardwire the laptop to the router is it behaving the same way? or if you are connected to another wireless network is it also behaving the same way? -
Loosing wireless conection from hub
Hi I`m having problems with the connection from my lap top to the hub. Have changed signal, and it does not matter how close or how strong the connection is, the connection goes and only way I can reconnect is to press reset on hub, it resets and I`m away again. Pain having to do this two to three times aday. Anyone got any advise, will try anything or do you think I need new hub?. Thank you, Paul.
Which hub do you have? There are known problems with the hh2
is uou driver for the network card/ wireless card up to date from manufacturers website not windiws update?
If you like a post, or want to say thanks for a helpful answer, please click on the Ratings star on the left-hand side of the post.
If someone answers your question correctly please let other members know by clicking on ’Mark as Accepted Solution’. -
What happend if i loose internet conection during an icloud restore made over the air?
My restore is taing too much and i have an backup on pc can i shut my wifi down?
you have to start over by going to setting > general> reset> erase setting and content and then resotre form icloud back up
-
Please, please PLEASE help. I don't want to loose my pics of my sons birth and the newest update is directing me to restore my phone. I can't get out of the "conect to itunes screen" Can I still save my pics???
You should never update without importing your photos as you would with any digital camera.
The pics are very likely gone.
Sorry.
You can try restoring from backup -
all of a sudden i can not conect wirelesly when i click on the wireles icon it says airport card not conected and if i try to turn on airport nothing happens can the card come loose or is it a more serious problem
(10.5.3)
Use Software Update to update your OS to last version of Leopard. Install all the other updates that goes along w/it. Don't remember if any Airpport updates for Leopard.
After the installations, repair permissions and restart your computer.
Please post back your results. -
I need to know how to open the laptop to replace the card that controls the wlan and treble. I tried to find a manual to show how to get the laptop open and then be able to get the card number so I can order one. I have removed the screws but can't get it appart. Can you tell me the type of card that I would need to resolve the problem so I don't loose the wireless conection every 5 minutes.
Thanks
highdiverThe Maintenance and Service guide, which you can find here, can show you how to replace your wlan card.
I am an employee of Hewlett Packard.
- - Please mark Accept As Solution if it solves your problem so others can more easily find the answer - -
- - Please click the Kudos star if you would like to say thanks - - -
Everytime i try to set up my ipad i loose my wi-fi connection why is this?
I have just got an Ipad 4 and cannot get started as I keep loosing my wi-fi conection when I try to set up the ipad. Does anyone have any suggestions to help? Thanks
I had an issue where my router was dropping the wifi and the iPad was losing the connection. It was the router's fault. Try rebooting your router first. Otherwise, plug your iPad in with a USB cable for the initial setup.
Persoanlly, I've found the wifi syncing to be particularly flaky; good wifi signal on both the iPad and MBP, but no connection between the two in iTunes.
Maybe you are looking for
-
Alum BT keyboard does not work after wake up - but BT trackpad does!
Here is my set up: MBAir 2011 model (13", i7 4GB, Lion.. all up to date) Desktop set up (same at work and home) - Thunderbolt display - Aluminum Bluetooth Keyboard - Aluminum Bluetooth Trackpad What I do: - Plug in the sleeping mbair into my display
-
Photos missing when syncing from iPhoto to iPod touch 3G
OK, I'm trying to upload photos from iPhoto to my G3 iPod Touch. They're in a specific album within a folder. There are 84 pictures in the album, but only 32 are uploading. Anyone know why?
-
My company has used SAP for a couple years now and is looking into WM. So I am in the initial stages of setting up the WM module. Having created the Warehouse Number, Storage Type, Storage Section and Storage Bins, I'm now having difficutly adding
-
How to create a global query view
Hi, How to save a query view as global,if user A was to create a view 'V1' , user B should be able to see 'V1' in his list of query views. Currently i have created views using bex Analyzer and using the save function in the query designer,but these v
-
How does one use the middle and right buttons in AIR without the cursor showing?
All I want to do is use all three botton clicks without the cursor showing (assistive technology situation). So I use Mouse.hide(). All works fine with the Left mouse button. With the middle and right buttons the cursor reappears as soon as the middl