I'm trying to download elements 10 from disc but keep getting error message 1935,
I've tried removing AVG ant virus software but still no joy, any ideas?
It appears you may be experiencing difficulty with the .Net framework installed on your computer. I would recommend try restarting your computer and try the installation again. If you still continue to have difficulties then you will want to complete solution 2 in Error 1935 | Assembly component Microsoft.VC80.CRT | Install | CS4, CS5, CS5.5 products | Windows to resolve your difficulties.
Similar Messages
-
im trying to download itunes 10.5 but keep getting error message that says: There is a problem with this Windows Installer package. A problem run as part of the setup did not finish as expected. Contact your support personnel or package vendor. I am using windows XP 32 bit, all the other computers in my house downloaded just fine, no problems, however this is the computer my iphone is set up to, ive tried doing a virus scan, windows update, downloading other things, updating everything possible, everything works fine, its just itunes that wont download, anyone have any other ideas?
Yes, I had found a similar solution also. I'm running XP Pro, SP3. I went Control Panels/ Add-Remove programmes/apple software update/ change/ repair. Then run the 10.5 exe.
While the programme updated from version 8 of iTunes, my new iTunes is now a mess. Not all of my music was in the same folder previously but it all showed up on iTunes. Now many albums have been left out, some have only a few tracks and some have two copies of some tracks as well as having other tracks missing. I haven't begun to work on that. -
Trying to download Msecer from app store keep getting error code(4) disabled growl
trying to download Msecer from app store keep getting error code(4) disabled growl & enabled gatekeeper to allow download from app store but still cant down load app to mini mac. Anyone have any solutions i havent tryed?
Hi ..
Disable anti virus software if installed
Make sure the firewall is turned off in System Preferences > Security & Privacy > Firewall -
I have an old i phone 3G and do not know the password for it. trying to restore it from itunes so my daughter can use it as an ipod but keep getting error code 1015, any help on how to get passed this please?
Hi ratcat14!
I have an article that can help you troubleshoot this issue:
Resolve specific iTunes update and restore errors
http://support.apple.com/kb/ts3694
Check for hardware issues
Try to restore your iOS device two more times while connected with a cable, computer, and network you know are good. Also, confirm your security software and settings are allowing communication between your device and update servers. If you still see the alert when you update or restore, contact Apple support.
Common errors: 1, 10-47, 1002, 1011, 1012, 1014, 1000-1020.
Thanks for being a part of the Apple Support Communities!
Cheers,
Braden -
trying to download new software for ipad but get the same message coming up which is there was a problem downloading the software the network connection
timed out make sure your network connections is active or try again later. I have tried about 5 times to download this can anyone helpHave you disabled any firewall and security/antivirus programs? This seems to have helped the vast majority of people who have posted the same problem in this forum.
-
I'm trying to open a PDF file but keep getting error message "Access denied." Help.
Every time I try to open a PDF attached to an email I get the error message "Access denied." How do I fix this?
Actually my son directed me to a help site run by a guy named Brian Stevenson. Here is what I did --
1. Launch Adobe Acrobat Reader XI
2. Go to Edit>Preferences
3. Click on Security (Enhanced)
4. Uncheck "Enable Protected Mode at startup"
5. Click Yes when dialog box open to remind closing of application
6. Click OK to save
7. Exit Adobe Reader
Worked like a charm!! -
I am running windows xp. Trying to download latest version of iTunes and get error message: Microsoft Visual C Rundtime Library. Runtime Error. Program:C\ProgramFiles\iTunes\iTunes.exe. R6034 An appliction has made an attempt to load the C runtime library incorrectly. Please contact the appliction's support team for more information.
2nd/ message: iTunes was not installed correctly. Please reinstall iTunes. Error 7(Windows error 1114)
I have removed iTunes serveral time and tried to reinstall many times and get the same results noted above.
Can anyone help me? Thank you. EFS1Hello DrJMDDC,
Thanks for using Apple Support Communities.
For more information on this, take a look at:
Removing and reinstalling iTunes and other software components for Windows Vista, Windows 7, or Windows 8
http://support.apple.com/kb/ht1923
1. Remove iTunes and related components from the Control Panel
2. Verify iTunes and related components are completely uninstalled
3. Reinstall iTunes and related components
Best of luck,
Mario -
Trying to download Photoshop CS3 for Mac but keep getting error message (HTTP ERROR: 404 /support/downloads/dlm/main.jsp, RequestURI=/support/downloads/dlm/main.jsp)
Jessicawaters are you trying to download from Download CS3 products? If so then please try a different web browser.
-
I am trying to download itunes 10.7 and keep getting "error writing to file C\config.msi\6f8a6.rbf" Can anyone help?
Are you running Kaspersky security software on that PC? (There's been a few reports in recent times of Kaspersky interfering with iTunes installs, with that message being produced.)
If there is Kaspersky on board, we should try some general-principles getting-past-security-software-interference troubleshooting.
Download and save a fresh copy of the iTunesSetup.exe (32-bit installer file) or iTunes64Setup.exe to your Hard drive. (Don't run the install on line, and don't start the install just yet.)
http://www.apple.com/itunes/download/
Restart the PC. After the PC restarts do not open any applications. Disconnect from your network and/or the internet. Now switch off all your security software (firewall, antivirus, antispyware).
Now start the install by doubleclicking the iTunesSetup.exe (or iTunes64Setup.exe) file you downloaded earlier.
Reenable all security software prior to reconnecting to your network and/or the internet.
Any better luck with the security software shut down? -
I'm trying to download Photoshop CC. I keep getting error code 302...
I'm trying to download Photoshop CC. I keep getting error code 302...
Please refer:
http://helpx.adobe.com/creative-cloud/kb/troubleshoot-cc-installation-download.html
Regards,
Ashutosh -
trying to burn CD but keep getting error message "The attempt to burn a disc failed. The burn failed because of a medium write error. Tried different speeds with no luck
The burn failed because of a medium write error. Tried different speeds with no luck
Then try to use a different brand of DVD or at least a different batch of DVD. The disk may be defective. -
I have installed Adobe digital additions and have tried to authorize but keep getting error message "Connection error" . The internet connection is working and I do have an Adobe ID can you help please.
I have been using Adobe reader for PC to download my eBooks but the eBook Vendor has switch to Digital Addition,this is from sjpt,
Try completely removing any authorization using ctrl-shift-D to ADE (cmd-shift-D if on Mac).
Restart ADE, and then reauthorize with your Adobe ID. -
priority:
I am trying to facetime on my mac but keep getting the message "The server encountered an error processing registration. Please try again later." I have gotten this multiple times. how can I get around this?
i also have tried downloading "FaceTap" application to get facetime on my ipad and failed too. i thought i failed because i couldnt download latest 6.0 iOS or later. i downloaded latest software update for iOS but was 5.8 I thinkWait until Apple fix it. See: http://www.apple.com/support/icloud/systemstatus/
-
Had message on my iphone 4 this morning that I needed to plug it into itunes. Did this but could only get a blank screen with apple symbol on it. Tried to do a system restore but keep getting the message that it couldn't finish restoring
Try a Hard Reset.....
Press and hold the Wake / Sleep button AND the Home button at the same time, keep them both pressed until the Apple Logo appears on the screen, it can take 10 or more seconds. Ignore the swipe to turn off message. -
I have just downloaded OS X Lion and everything is working apart from Safari. I get error message saying that Safari has quit unexpectedly. Internet connection appears fine. What's the problem?
Welcome to Apple Communities
http://www.reedcorner.net/understanding-upgrade-nightmares/
Maybe you are looking for
-
File Manager unable to open, Windows error message...
When I try to open File Manager from Nokia PC Suite or Nokia Phone Browser in My Computer, a Windows error message suddenly appears and says "Windows Explorer has encountered a problem and needs to close." I don't know what seems to be the problem. I
-
Copy music from one iPod to other iPod using iTunes
Hi, previously I had uploaded some of my private music files n videos on my iPod, which I wanted to transfer to another iPod. Unfortunately I do not have the backup on that music n video on my PC. Can anyone help me out? Regards Rahul iPod Video (30
-
Not automatically marking e-mail messages as read in outlook 2010
Our office has a user with an assistant set as a delegate in Outlook (Exchange 2010 environment). Currently, if the assistant views an email in the user's Mailbox, it is set to "Read" status, which can lead to confusion as to which items have or have
-
HT1904 My iBooks say failed to load book because requested resource is missing? ?
I purchased three books that won't let me have access. Give me an error message that says "failed to load book because requested resource is missing. How do I resolve this problem?
-
My Flash Pro CC 2014 freezes while I'm working every single time and I can't figure out why
I just bought Flash Pro CC about a month ago, and every time I open it and start using it, it freezes and I can't click on anything in the program or even close out of it normally. I have to use Task Manager and force it closed. I doubt that its my