I need to install application and driver for Nomad IIc but computer says I'm not connect
I tried downloading the application, driver, and plug-in for Nomad IIc. When I try to install the driver my computer says my player is <EM>not</EM> connected but my player says it <EM>is</EM> connected. Help!
Bfd96
Did you download the correct driver and appllication?
Check that you have the following files.
. Driver - Drv_nm2.exe
2. MediaSource application - CMS_PCAPP_LB_2_03_29.exe
3. Nomad Pack - CMS_N2Plugins__00_0.exe
Do not connect the player when installing the driver. You will be prompted to connect the player when the installation is near to completion.
After which, install the MediaSource application follow by the Nomad Pack.
Jason
Similar Messages
-
I have installed itunes and my internet is working however it says I am not connected to internet\
I have installed itunes and my internet is working however it says I am not connected to internet\
Hi there,
You may want to take a look at the troubleshooting steps found in the article below.
Can't connect to the iTunes Store
http://support.apple.com/kb/ts1368
-Griff W. -
In need of a new hard drive for my old G5 computer
Hello there, I'm not as savvy as you are with computers but I am in need of a new hard drive for my old G5 computer that my husband uses. His crashed. If you did it all over again would you buy the same new hard drive? If so, where did you buy it? I don't even know where to start and was SO happy to find this recent post on installing new drives into the G5. Any advice would be much appreciated. Thank you!
<Title Edited by Host>I actually just ran across this hard drive oddity for the first time myself just yesterday. It seems that some older Macs may not be able to use the newest SATA interfaces on some hard drives.
I an attempt to not get overly technical, SATA is the current interface type on computer hard drives. You can get some additional information from Wikipedia at http://en.wikipedia.org/wiki/Serial_ATA. There are currently three revisions, SATA-1 (the oldest), SATA-2 (the current version), & SATA-3 (the latest and greatest).
So what happened was that my G5 could not use the SATA-3 drive I purchased because the computer could not support the SATA-3 standard. It was possible to "slow down" one of the other test SATA-3 drives to make it work like a SATA-2 and so it may be possible to do the same to other hard drives.
To answer your question, I would NOT purchase the saem hard drive for my Mac as it does not work for this older Mac.
My suggestion, if you can find one purchase the same hard drive that was in the computer. That way you know it is compatible. If you would like to upgrade, you will have to do some looking. Although I cannot recommend a specific drive, my two favorite companies are Seagate, www.seagate.com and Western Digitial, www.wdc.com. You most likely have a 3.5" drive, if you have a desktop, 2.5" for a laptop. WD has the Cavier line and Seagate has either Barrcuda or Momentus. What you are looking for is capacity.
So, both Seagate and Western Digital are good. You need a 3.5" drive for a desktop or 2.5" drive for a laptop. Stick with a SATA-2 drive also known as a SATA 3Gb/s drive for compatibility. Get a drive that is 7200 RPM or higher. Finally purchase the largest capacity at you can afford. Amazon is a good general place to been looking.
KWCitizen_Apple -
I am running OSX 10.6.8 Snow lepard I am trying to install windows on my intel imac 20in late 2006 via bootcamp, and it says I need to download Windows Support Software. I tried, but it says "Download can not continue. The Windows Support Software is not available. I bought the Imac secend hand and did not get the install dvd's with it What can I do?
You don't need to download the Windows support software, because in Snow Leopard, they are only available as a download for the Late 2010 MacBook Air.
Instead, you have to buy Mac OS X Snow Leopard. The Snow Leopard disc contains the Windows drivers for your Mac, so you have to install them after finishing the Windows installation -
I have a new iPod and cannot get my music loaded on to it. The computer says it's not connected, and then it says it is synced but there's still no mucis on it.
If that's not a real email, you need to ask Apple to reset your security questions; ways of contacting them include clicking here and picking a method for your country, phoning AppleCare and asking for the Account Security team, and filling out and submitting this form.
(99730) -
I recently got an IPad 2 and when I first set up the wifi connection the safari and facebook worked but suddenly whenever I attempt to get onto facebook it says Unable to connect and whenever I go on safari it says I am not connected to the internet. yet when I go on settings-- Wi-fi The network I should be cnnected with is ticked and it says I have connection, but once i try to go on the internet I have the same problem. Is there a way I can solve this by resetting or do I need to go into the apple shop to get it sorted. Any help? Thanks.
I recently got an IPad 2 and when I first set up the wifi connection the safari and facebook worked but suddenly whenever I attempt to get onto facebook it says Unable to connect and whenever I go on safari it says I am not connected to the internet. yet when I go on settings-- Wi-fi The network I should be cnnected with is ticked and it says I have connection, but once i try to go on the internet I have the same problem. Is there a way I can solve this by resetting or do I need to go into the apple shop to get it sorted. Any help? Thanks.
-
when i try and open itunes a memo pops up saying "itunes could not connect to this iPhone. This device is no longer connected" my iphone is not plugged into my mac so i dont know why its mentioning an iphone nor why i cant open my itunes library?
Each time you connect your iPhone to iTunes, you need to eject it before closing iTunes by clicking on the little "eject" icon shown in iTunes. It seems that sometime in the past, you did not do that.
I'm not sure how to undo the previously done damage, but maybe a reboot of your Mac would help. -
i am trying to sync iphone 5 to itunes but it says "iTunes could not connect to the iphone as an error occured while reading from the device " and the iphone is not seen on itunes........
First thing to try is to reset your device. Press and hold the Home and Sleep buttons simultaneously ignoring the red slider should one appear until the Apple logo appears. Let go of the buttons and let the device restart. And then reboot your computer.
See if that fixes your problem. -
I try to connect to iTunes and it comes up with a box saying "iTunes could not connect to the iPad because it is locked with a passcode. you must enter your code on the iPad before it can be used with iTunes", but i cant enter the code on the iPad because it is saying "connect to iTunes". Can anybody help?? It is on the new iPad.
FORCE IPAD INTO RECOVERY MODE
1. Turn off iPad
2. Turn on computer and launch iTunes (make sure you have the latest version of iTune)
3. Plug USB cable into computer's USB port
4. Hold Home button down and plug the other end of cable into docking port.
DO NOT RELEASE BUTTON until you see picture of iTunes and plug
5. Release Home button.
ON COMPUTER
6. iTunes has detected iPad in recovery mode. You must restore this iPad before it can be used with iTunes.
7. Select "Restore iPad"...
Note:
1. Data will be lost if you do not have backup
2. You must follow step 1 to step 4 VERY CLOSELY. -
I have a 4th gen. Itouch wiht IOS4 and i want to update it, but when i click the update button in ITunes it says "contacting IPod software server" and it looks like it is loading. However, after about 5 seconds it stops and says "ITunes could not connect to the IPod software server". I found the apple webpage that is supposed to help me, but when i went to the LAN settings in the control panel i found that 'Automatically detect settings" was already checked. I do not know what to do, Please help.
If yo mean the iPod will not connect to your wifi network:
Does the iPod connect to other networks?
Do other devices now connect?
Try:
- Reset the iOS device. Nothing will be lost
Reset iOS device: Hold down the On/Off button and the Home button at the same time for at
least ten seconds, until the Apple logo appears.
- Power off and then back on the router
- Reset network settings: Settings>General>Reset>Reset Network Settings
- iOS: Troubleshooting Wi-Fi networks and connections
- iOS: Recommended settings for Wi-Fi routers and access points
- Restore from backup. See:
iOS: How to back up
- Restore to factory settings/new iOS device.
- Make an appointment at the Genius Bar of an Apple store.
Apple Retail Store - Genius Bar -
I have a PC, Iphone and Ipad. The IPhone synchs but an IPad sync generates a "could not connect to Iphone 0xE8000065" error!
It thinks I am syncing the Iphone again as opposed to the Ipad.
I rebooted both but Apple failed to sync the Ipad again.
Thoughts?I have been syncning fine until this so I was relcutant to believe anyhting need to be changed.
Howver I control - alt - deleted to get MS task manager and then disabled all Apple processes and then rebooted. I also renamed "Ipad" as Ipad1.
Not sure then which if either was responsible for the cure but it is now working.
Why do Microsoft and Apple find it so difficult to play together? -
I have a Canon 20D and wish to download to my ipad when traveling- I have the camera attachment, but when I connect it- I get a message saying it does not support the device. Is there anything I can do?
Kelli-
Another solution would be to find a Compact Flash-to-USB card adapter that is compatible with the USB adapter in the Camera Connection Kit. Some such adapters draw too much current from the iPad.
You can also get a Secure Digital-to-Compact Flash adapter that would allow you to use SD cards in your camera.
Fred -
After downloading the new version of Shockwave
flash the message in the box said the download was completed; however, the information on the Firefox plugin page keeps saying "potentially vulnerable" and "update now" as though no download took place. I repeated the download 2 more times and got the same results.Your plugins list shows outdated plugin(s) with known security and stability risks.
# Shockwave Flash 10.0 r32
# Java Plug-in 1.5.0_06 for Netscape Navigator (DLL Helper)
Update the [[Java]] and [[Flash]] plugin to the latest version.
See
http://java.sun.com/javase/downloads/index.jsp#jdk (you need JRE)
http://www.adobe.com/software/flash/about/
Start Firefox in [[Safe Mode]] to check if one of your add-ons is causing your problem (switch to the DEFAULT theme: Tools > Add-ons > Themes).
See [[Troubleshooting extensions and themes]] and [[Troubleshooting plugins]] -
I am trying to update my macbookpro which shows as needing 15 upgrades. when process is completed it asks to for a restart which takes place. once restarted it does not register any of the updates and repeats the process. Has anyone encountered this issue?
Hi,
The 10.6.8 is listed in the list of updates that need to be installed, but the same issue keeps re-occuring - I click to do the updates, restart the computer as directed, but the update doesn't take place and it's still listed when I go to show the software updates! Am I doing something wrong?
Thank you for your help.
Steph -
It is an iPhone 4s. It used to be set to sync wirelessy but that became annoying and I reset the phone so I could just sync it with the cord. Apparently that was a bad idea.
Hello robh53,
The following article provides some useful troubleshooting steps that can help get your iPhone to cooperate with iTunes.
iOS: Device not recognized in iTunes for Windows
http://support.apple.com/kb/TS1538
Cheers,
Allen
Maybe you are looking for
-
Need user-exit or BTE on save of a FI-document in 4.6D
Hi, I need a Business Transaction Event or user-exit on save of a FI-document (transaction FB01, or any other possible posting - for example as a follow-on document after SD purchase or sales invouce). The trick is, that I must have an internal FI-do
-
Adding attachments to a reply mail
Hi, I need to reply to an email by attaching a word document or a excel sheet to it. I don't want to create a new mail for this, i just want to reply with attachment to an existing mail chain. Is this possible in Iphone 5s, Please share your views on
-
PS CS6 PHOTODHOP EXTENDED, Student and teacher edn.
PS CS6 PHOTOSHOP Extended Student and Teacher edn. from: http://helpx.adobe.com/x-productkb/policy-pricing/cs6-product-downloads.html. AND http://helpx.adobe.com/creative-suite/kb/find-download-link.html#main_I_just_purchased_an_ Adobe_product_from_t
-
How to show SharePoint list items in tab view?
Hi All, I would like to show list items in tab or metro tiles like: How to achieve this? Thanks in advance!
-
Hey guys, just a quick question because I forgot. I have an updateable report and I want to keep pagination when I edit something and click on Save but I'm always transfered back to page 1(set of results) Any help?