I recently upgraded toSnow Leopard, after that I was given a continual message that I had to reinstall my Internet Cleanup. So I did. Then I turned my computer off and now it will not turn on at all. Help!
I recently upgraded toSnow Leopard, after that I was given a continual message that I had to reinstall my Internet Cleanup. So I did. Then I turned my computer off and now it will not turn on at all. Help!
See if your Mac will boot from the install DVD.
Then uninstall Internet Cleanup.
Allan
Similar Messages
-
HT1430 I turned my IPad off and now it will not restart. Apple logo comes up but no other screen.
I turned my IPad off and now it will not restart. The apple logo comes up but then it stops????
Did you try rebooting the iPad?
Reboot the iPad by holding down on the sleep and home buttons at the same time for about 10-15 seconds until the Apple Logo appears - ignore the red slider if it appears on the screen - let go of the buttons. Let the iPad start up.
If that doesn't work, see this.
iTunes: Restoring iOS software - Support - Apple -
Iphone is frozen on the apple screen. Was freezing and so turned it off and now it will not reboot?
My iphone started acting slow and would become frozen as I tried to re-download facebook. I turned the phone off and now it will not turn back on and stays frozen on the apple screen. Is it possible that viruses can be downloaded on the iphone?
Try a force restart by holding the power and home button down at the same time. One of two things will PROBABLY happen; 1) It will boot into iOS as normal. 2) You will get an iTunes logo with a USB cable at the bottom. If the second happens you will need to plug it into iTunes to do a restore. If neither of these happen, force restart again. Once the phone powers off, let go of both buttons and push and hold the home button and plug the phone into iTunes. This will force the phone into recovery mode. Proceed with a restore at that point.
-
I pressed the find my iphone delete button and then my phone showed the apply logo. I then got worried and turned it straight off and now it will not turn back on. The apple logo just comes up for about 10 seconds and it goes back off.
Connect your phone to itunes on the computer you use itunes on and open up itunes.
-
Updated my iTunes to the recent one and now it will not open on my MacBook Pro, got a new iPhone so tried to connect it and said i needed the new iTunes (which i did) and now i can't start my phone as i can't open iTunes which means i can't access anything on my phone!!?? HELP???????
You supply little pertinent about the MBP and the iPhone.
First... on the MBP... Click on the Apple icon.. Top left in Finder...
> About this Mac > Version...what does it say?
Which iPhone and what is its' iOS Version. -
I downloaded the new iphoto and the upgrade and now iphoto will not open correctly anymore. it stays on the opening screen and the message
shows up that I must update the mediathek. If I click on update the program shuts down. How can I fix this?I downloaded the new iphoto and the upgrade
Does that mean, you are running iPhoto 9.6 on MacOS X 10.10.1 Yosemite? Or are you using an older MacOS X? "New" iPhoto is relative and depends on your system.
If I click on update the program shuts down. How can I fix this?
Does "shut down" mean it crashes? Then post please the error log from the error panel here - copy and paste the report into your next answer (the first 50 lines should suffice)
Where is your iPhoto Library (Mediathek) stored? Have you moved it to an external drive, or is it still in your Pictures folder (the order "Bilder")? -
I had instagram but it keep saying waiting so I stop it on the App Store and now it's not popping up at all
Hello LilMimi,
The article linked below provides some useful troubleshooting steps that can help resolve this issue.
iOS: An app you installed unexpectedly quits, stops responding, or won’t open
http://support.apple.com/kb/TS1702
Cheers,
Allen -
I have an iPad mini that is exactly one year old. I plugged it in to charge it. The next morning it ws completely dead. I can't get it to come on no matter what I try. I have tried a different cable to see if my cable was faulty, but that id not resolve the issue. No matter what I try, I can not get it to power on. I cannot get iTunes, nor my computer to recognize it when it is plugged in.
Has anyone else had this issue? What can I do? Any help would be appreciated!Try this - Reset the iPad by holding down on the Sleep and Home buttons at the same time for about 10-15 seconds until the Apple Logo appears - ignore the red slider - let go of the buttons. (This is equivalent to rebooting your computer.) No data/files will be erased. http://support.apple.com/kb/ht1430
Frozen or unresponsive iPad
Resolve these most common issues:
• Display remains black or blank
• Touch screen not responding
• Application unexpectedly closes or freezes
http://www.apple.com/support/ipad/assistant/ipad/
iPad Frozen, not responding, how to fix
http://appletoolbox.com/2012/07/ipad-frozen-not-responding-how-to-fix/
iPad Frozen? How to Force Quit an App, Reset or Restart Your iPad
http://ipadacademy.com/2010/11/ipad-frozen-how-to-force-quit-an-app-reset-or-res tart-your-ipad
Black or Blank Screen on iPad or iPhone
http://appletoolbox.com/2012/10/black-or-blank-screen-on-ipad-or-iphone/
What to Do When Your iPad Won't Turn On
http://ipad.about.com/od/iPad_Troubleshooting/ss/What-To-Do-When-Your-Ipad-Wo-No t-Turn-On.htm
iOS: Not responding or does not turn on
http://support.apple.com/kb/TS3281
iPad: Basic troubleshooting
http://support.apple.com/kb/TS3274
Cheers, Tom -
I have an iPhone 4 thats i was trying to fix and now it will not turn on at all is there anyway that i can access my pictures and contacts from my new phone or pc? Aslo the are both on the same apple id but i dont know if that would help or not.
Contacts are designed to be synced to a supported application on the computer or a cloud service.
Pictures taken with the device are designed to regularly be copied off the device to a computer as would be done with any digital camera.
If you have failed to use the device as designed it may be too late to recovery anything.
Is the device regularly backed up to a computer via iTunes? If so, the most recent backup (when restored to a replacement iOS device) should contain all contacts and pictures as of when the backup was created. -
I turned off the power to my apple tv whilst updating and now it will not work, i have tried to restore using usb but it says unable to find. any help please?
Welcome to the Apple Community.
Are you following these instructions.
Remove ALL cables from Apple TV. (if you don't you will not see Apple TV in the iTunes Source list)
Connect the micro USB cable to the Apple TV and to your computer.
Reconnect the power cable (only for Apple TV 3)
Open iTunes.
Select your Apple TV in the Source list, and then click Restore. -
My iphone will not turn on.... it froze earlier today and now it will not turn on all i get is a black screen with the apple symbol every once in awhile... also it will not connect to my computer so i can reset it to factory settings
Sammyhunter lets get you back in action! Has there been any physical/water damage to the device? Try pressing and holding the home and power button together. Once the Apple symbol appears release both buttons. Keep us posted!
AshleyS_VZW
Follow us on Twitter @VZWSupport -
I purchased a one year subscription to Rolling Stone magazine . I got two issues and now it will not allow me to view the current issue, I have to pay again. Can someone help me, how do I get my purchase ? I have the automatic download turned on.
Try contacting apple
-
Updated iPod (4th generation) to iOS 6 and now it will not turn on...
Updated iPod (4th generation) to iOS 6 and now it will not turn on...
It sometimes has the apple on the screen, or says it needs to be charged, or is all white, black, or yellow. I have tried charging it, leaving it alone for a while and turning it off and back on. Nothing has worked. What should I try to do??? Help please!!!Try:
- iOS: Not responding or does not turn on
- If not successful and you can't fully turn the iPod fully off, let the battery fully drain. After charging for an least an hour try the above again.
- If still not successful that indicates a hardware problem and an appointment at the Genius Bar of an Apple store is in order.
Other uses have had same problem. -
I just put itunes upeate 11 on and now itunes will not run. I get an error that sys iTunes has stopped and windows is sutting it down. I reinstalled 10.7 and it will not run eather now.
C Mawle wrote:
Thanks. I have followed all the instructions as recommended and nothing has worked so it looks like the restore/update may have been interrupted - would loss of internet connection do this?
Yes it would, possibly even brick it.
Have successfully connected my ipod nano with iTunes so looks like the device driver is working.
Can I use my ipod nano USB connector to check?
It is not much help to you, since the device that you need still not recognized.
Anyway looks like I may have to swallow the loss of data. Have set-up a call for tomorrow with Apple support so will wait until after this before doing the factory restore!
Good luck, but if you expect miracle from that call good luck again. -
Hello, I just downloaded ios 8 for my 4s iphone and now it will not connect to itunes on my mac. Any help will be greatly appreciated.
Hello wedge60,
After reviewing your post, I have located an article that can help in this situation. It contains a number of troubleshooting steps and helpful advice concerning device recognition issues:
iOS: Device not recognized in iTunes for OS X
Follow these steps to resolve your issue:
If you haven't connected your iOS device to this computer before, unlock the device and tap Trust. Learn more about the Trust This Computer alert.
Restart your iOS device.
Restart your Mac.
Make sure that your Mac meets the minimum system requirements for your iPhone, iPad, or iPod touch.
Install software updates on your Mac.
If an iTunes update is available, apply the update.
Check USB connections. iOS devices need USB 2.0 to work properly. If you're not sure your Mac has USB 2.0 ports, check the computer's specifications.
Disconnect other USB devices and connect your device directly to a USB port on your Mac.
Try another USB cable.
Thank you for contributing to Apple Support Communities.
Cheers,
BobbyD
Maybe you are looking for
-
Hat jemand Erfahrung, ob ich weiterhin die Programme auf meinem Computer anwenden darf, nach dem ich bei Adobe mein Creative Cloud-Abonnement gekündigt habe?
-
Help needed with populating a drop-down list from an Access Database
Topic data drop-down list Jason Murthy - 11:39am Feb 14, 2005 Pacific Hello, I am trying to use the data drop-down list from the custom library. I enter the name of my data connection and the other 2 variables in quotes when they are initialized, jus
-
Where can you compare 2 photos side by side in Full Screen in Elements 11?
Where can you compare 2 photos side by side in Full Screen in Elements 11? Version 9 has this feature under Display View.
-
How to set a reason for locked account throught source code with the API
Hi all, I need to set the lock reason of an user account. When we lock a user account at identity management, the system shows us a text edit and keep that lock reason on the account data tab. I need to simulate that, anybody could help me with this?
-
Netweaver CE 7.1 gives Invalid credentials
Hi, I am new to SAP NetWeaver Composition Environment 7.1. I tried to install the CE 7.1. when I try to start, it asks me for OS user id and password. The OS user by default is my laptop user id which has admin rights and I don't have a password set.