I restore my ipod touch and the apple logo stills there
anyone who knows how
First try restoring the iPod from backup.
Next try restoring the iPod to factory defaults/new iPod.
Similar Messages
-
I restore my ipod touch and the apple logo stills there like loading
can someone give me an advise??
First try restoring the iPod from backup.
Next try restoring the iPod to factory defaults/new iPod. -
I tried to reset my ipod touch but the apple logo wont go away and isnt responding to my computer HELP!!
Try:
- iOS: Not responding or does not turn on
- Also try DFU mode after try recovery mode
How to put iPod touch / iPhone into DFU mode « Karthik's scribblings
- If not successful and you can't fully turn the iOS device fully off, let the battery fully drain. After charging for an least an hour try the above again.
- Try another cable
- If still not successful that usually indicates a hardware problem and an appointment at the Genius Bar of an Apple store is in order.
Apple Retail Store - Genius Bar -
My iPod Touch shows the Apple logo splash screen and then turns off.
When I turn my iPod Touch on, the Apple logo is shown and then it turns off. After a few seconds, it shows up again. It continues to do this non-stop. Is there anything I can do? Any help would be greatly Appriciated
Let the battery fully drain. It may take awhile. After charging for at least an hour. If the iPod does not cycle on and off any more try:
iOS: Not responding or does not turn on
Otherwise it appears you have a hardware problem and an appointment at the genius Bar of an Apple store is in order. -
My Iphone 3gs wont charge, turn on, or restore itself in Itunes, but the apple logo still appears when I hold the sleep botton. How can I make my Iphone work???? I know it is not dead because I can see the apple logo on, and every time I connect it to a USB port to charge, or a wall charger, the battery appears with a bit of red. Still, it wont turn on. It's been like this for three days now and I haven't stopped charging it. IT just WONT charge? Any tips I can use to solve the issue?
-EstebanHello estebie67,
Thanks for the question, and welcome to Apple Support Communities.
It sounds like the iPhone is experiencing issues upon startup, and may not be loading the firmware or operating system correctly. If you have not already done so, try resetting the iPhone while connected to power:
iPhone, iPad, iPod touch: Turning off and on (restarting) and resetting
http://support.apple.com/kb/HT1430
If the above does not resolve your issue, it will be best to restore the iPhone in recovery mode:
iOS: Unable to update or restore
http://support.apple.com/kb/HT1808
Thanks,
Matt M. -
My ipod touch flashes the apple logo and the lock screen. How do I fix it?
My ipod touch 4th Generation will flash from the Apple Logo to my locked screen. Although when I plug in my headphones everything works perfectly. I have not had this ipod very long and i have already recieved a new one from Apple before. I have also tried reseting it as well.
First try restoring the iPod from backup.
Next try restoring the iPod to factory defaults/new iPod. -
I plugged my iPod into my computer to retore it and proceeded to do so as told. The only thing that happened after that was that the Apple logo keeps showing up and nothing else. My computer/iTunes no longer recognizes my iPod either.
Try:
- iOS: Not responding or does not turn on
- Also try DFU mode after try recovery mode
How to put iPod touch / iPhone into DFU mode « Karthik's scribblings
- If not successful and you can't fully turn the iOS device fully off, let the battery fully drain. After charging for an least an hour try the above again.
- If still not successful that usually indicates a hardware problem and an appointment at the Genius Bar of an Apple store is in order.
Apple Retail Store - Genius Bar -
It isnt working...it is a 4th generation and all it has is ablank screen..plz help!!!!
Hi hellomynameisbrooke,
Try rebooting the iPod by pressing and holding the on/off and home buttons simultaneously until the screen goes blank and you see the apple logo. It should take about 10-15 seconds to reboot.
If that doesn't work, connect it to your computer and try restoring it via iTunes.
Hope this helps!
Cheers,
GB -
My dad dropped his iPod and when he went to try and play a song all it did was cycle through the playlist. I took a look at it and decided I needed to reset it. And there was my mistake, now after I did what the manual told me to do the apple logo will not go away. I have no clue on how to get the iPod to respond. Please help me.
Have you plugged your iPod into the wall or your computer? Does the Apple logo go away now? Try to restore the iPod to factory settings
http://docs.info.apple.com/article.html?artnum=60983 -
I have reset my ipod touch 3rd generation and after doing so it is frozen with an apple in the middle of the screen and i have already tried the apple support page steps and still doesnt fix it, please help me out
The warranty does not cover accidental damage like that cased by dropping the iPod. However, Apple has known to make acceptions. Make an appointment at the Genius Bar of an Apple store. Otherwise Apple will exchange your iPod for a refurbished one for $99
-
please help me ? ):
Hi there Binilou,
You may find the troubleshooting steps in the article below helpful.
iPod Displays a Red "X" Icon
http://support.apple.com/kb/ts1463
-Griff W. -
I have had to restore my Ipod Touch and now I can't connect to anything on it. When it asks for my Apple ID it comes up with an error message and says that it can't connect to the server. I have checked my WiFi connection and its connected.
Hi there,
I would recommend taking a look at the troubleshooting steps found in the article below.
Can't connect to the iTunes Store
http://support.apple.com/kb/ts1368
-Griff W. -
My ippd touch isnt working i tried to reset it and the apple logo comes up then goes to a black screen. What else can I do?
Try connecting to your PC in Recovery Mode ane restore it. See this article for help on getting your iPod into Recovery Mode.
iPhone and iPod touch: Unable to update or restore
B-rock -
I have a fairly new iPod touch and the touch screen has suddenly stopped working..... Like the bottom row of apps has stopped working and certain buttons on the keypad are not working at all what so ever I have taken it to the apple store once before they told me to update it I did so and it didn't get better I have also restored it multiple times still nothing I really would like a working I pod please help!!!
If you restored to factory settings/new iPod and still have the problem that indicates a hardware problem.
Make an appointment at the Genius Bar of an Apple store..
Apple Retail Store - Genius Bar -
my ipod touch 4g 8 gigs is not turning on it wont get past the apple logo its not frozen because it turns the screen black and the apple logo please help me
- Try a reset.
Reset iPod touch: Hold down the On/Off button and the Home button at the same time for at
least ten seconds, until the Apple logo appears.
- Then connect to your computer and try to restore.
- See if placing the iPod in recovery mode will allow a restore. For recovery mode see:
iPhone and iPod touch: Unable to update or restore
- If the logo still show all the time, let the battery fully drain. After charging for an hour try the above again.
Maybe you are looking for
-
How can I get a video clup to load last on my page?
Since the entire page is trying to load at once, the quicktime file slows up everything else. If I set it to autoplay it will start playing before the page finishes loading... Is there a way I can go into the html file and change the order of how thi
-
Can I use logical databases in a WebDynpro ABAP program?
can I use logical databases in a WebDynpro ABAP program? I need to build a WDA screen that is similar to the SAPDBPNP selection screen (user can find the personnel number based on several criteria, such as last_name/first_name of the employee). So i
-
Regarding using of BAPI F.M - BAPI_INCOMINGINVOICE_PARK
Hi All, Can any body give example program of using the BAPI Function Module <b>BAPI_INCOMINGINVOICE_PARK</b>. My Program puprpose here is to - <b>Special Charges in Purchase Order's</b>. (or) <b>Payble document for P.O Special Charges</b> Can anybody
-
I have purchased I phone 4S on April 30th 2014. Since I bought this phone, I have been facing issues such as Battery Back up, Software and Hardware issue and hang issue. I had visited I store last month where they just formatted my phone. The issues
-
How can i merge several open windows into one window with multilple tabs?
i open several windows, but would like to merge them into a single window with multiple tabs. not really a problem; more a dilemma!