I tried to restart my iPad due to problems with a Pinterest app that took up a lot of storage in the cache...now the apple logo comes up but will not start...it has recently been charged
I tried to restart my iPad due to problems with a Pinterest app that took up a lot of storage in the cache...now the apple logo comes up but will not start...it has recently been charged
Try this - Reset the iPad by holding down on the Sleep and Home buttons at the same time for about 10-15 seconds until the Apple Logo appears - ignore the red slider - let go of the buttons. (This is equivalent to rebooting your computer.)
Cheers, Tom
Similar Messages
-
My Ipod 5th gen. has been detected by itunes, but could not identified properly, and its been charging for a week and still hasn't come to a full charged. What should I do?
but could not identified properly
Please clairify.
charging for a week and still hasn't come to a full charged
Sounds like you need a new battery. Take the iPod Nano to an Apple store or an AASP. Whichever is more convenient for you.
iPod Repair Pricing -
PSE 9 was running fine but will not start now and I get the following message: This application has requested the Runtime to terminate in an unusual way.
I have an HP Desktop running XP Professional and tried Restore but it didn"t help. I was just going to uninstall and re-install but I can't get in to deactivate.See if anything here helps:
Troubleshoot C++ runtime errors | Adobe products | Windows -
I turned my IPad off and now it will not restart. The apple logo comes up but then it stops????
Did you try rebooting the iPad?
Reboot the iPad by holding down on the sleep and home buttons at the same time for about 10-15 seconds until the Apple Logo appears - ignore the red slider if it appears on the screen - let go of the buttons. Let the iPad start up.
If that doesn't work, see this.
iTunes: Restoring iOS software - Support - Apple -
Apple logo comes up but ipod doesn't start
When I turn on the device the Apple logo comes up but the ipod doesn't start and go to the menus it just stays with the logo. When I hold down the play/pause on the click wheel to put it to sleep a symbol of a triangle with an exclamation point in the center comes up along with "www.apple.com/support/ipod." I tried rebooting it with Menu/select but nothing happens.
Unfortunately, on a "classic" iPod that uses a hard drive for storage, the most likely cause is a faulty hard drive.
You can try putting the iPod into Disk Mode
http://support.apple.com/kb/HT1363
If that works, connect it to the computer and run iTunes. iTunes may prompt you to do a Restore. This will erase the iPod, re-install its software, and set it to default settings. If the cause is data corruption or a software issue (and the hard drive has no physical problem), the Restore should fix it. -
Dowload help queues up but will not start. Any ideas?
My download helper places a download in the queue but will not start. I have a linux machine and a windows machine they are both doing the samething. A friend who has three computers has the same issue on all three. Any ideas. We have refreashed firefox. Reinstalled download helper and set all the updates. I have set all the conversion points as directed as well.
See:
*https://addons.mozilla.org/firefox/addon/video-downloadhelper/
<blockquote>We are aware of downloading issues when using Firefox 36.
We have been working for months on a 100% new version which works on Firefox 36+ (it does not work on Firefox 35 and below) and we just released a first test version. If you want to test this version and provide feedback on it, please follow this link.</blockquote>
You can find a beta version here:
*https://groups.google.com/forum/#!forum/video-downloadhelper-5 -
I am running Windows 7 and have tried to install iCloud. No matter what instructions I follow, I still get the error message "This Apple ID is valed but is not an iCloud account." How can I resolved this?
I've tried both. First, I tried on my pc, where iTunes had installed iCloud when it last updated. I have iTunes installed on this computer (and on my iPad and iPhone), but that wasn't the issue.
So I went online, thinking I needed a separate iCloud Apple ID, but it prompted me for my current Apple ID and gave me the message about my ID being "valid" but not an iCloud account," which, lol, was what it had asked me to do in order to create one. I checked, and at least one other user is having the same issue. I'll attempt to copy/paste the Support request url: https://discussions.apple.com/thread/4430653?tstart=0
Thank you for any help you can give.
Trish -
After interrupting an installation of a program downloaded from the internet on my mac in a reboot cycle will not start, I've already done the disk check and it's ok and I reinstalled the OS 10.8 Lion
In this case, I think that there's something damaged that can't be fixed just reinstalling OS X.
If you don't want to lose files, you will have to create a second partition in the hard drive and install OS X there, so you will be able to recover everything you need. Then, you will have to erase the first partition and reinstall OS X. Follow these steps:
1. Hold Command and R keys while your Mac is starting to start into OS X Recovery, and open Disk Utility.
2. You can follow the steps of this site to create a second partition > http://pondini.org/OSX/DU3.html
3. After creating the second partition, close Disk Utility and install OS X on the second partition.
4. When the installation finishes, open Finder and, in the sidebar, you will see the other partition. Open it and recover the files you need.
5. After doing that, repeat the step 1.
6. Select “Macintosh HD” in the sidebar, go to Erase tab and erase the disk.
7. Close Disk Utility and install OS X on the first partition.
After doing all of these steps (you will need a lot of time to do this), you can delete the second partition you created and add the size of this partition into the first one > http://pondini.org/OSX/DU4.html -
I have a mid-2010 27" Quad Core i5 iMac running 10.8.3. Startup disk recognizes the primary hard drive as a startup volume but will not boot from it. Have tried zapping PRAM, ran disk utility. No errors reported Any thoughts?
My bad Eric. The startup preference recognizes the primary as a 10.8.3 startup volume but when u select it the system does not boot. I can only boot from my external backup drive
-
When install iTunes 11.1.4 It says Apple Mobile Device Service service will not start. It was started when I began the installation. Is this an Apple software bug?
I have this issue. It isn't the MSVCR80 issue. No matter what I do nothing will let me even INSTALL Apple Moblie Device. Further details are in my thread:
https://discussions.apple.com/thread/5831093 -
when the new version will correct the error 10.0.0? program constantly hangs. will not start!
Are you using any VST plug-ins or audio units? Then check, if they are still compatible. You may need to uninstall them.
See this support document:
Unexpected behavior with Audio Unit plug-ins http://support.apple.com/kb/TS5249 -
i have a nano 4th generation 8gb i have tried resetting it, i get the apple logo come up but nothing else happens. It will work in my docking station but as soon as i take it out it will not respond. any ideas, do i need a new battery?
It definitely sounds like your Nano needs a new battery at this point. You can have Apple replace it for a flat fee, send it into a third party service center to be replaced for much less, or you can purchase a new battery online and swap it out yourself if you feel up to it.
B-rock -
Power , but will not start
I have an IBM t43.
Last night left in hibernate and went to sleep.
Will not start today.
When plugged in power light showed yellow, but is now green, but flashing.
I have remove battery, hard drive, cd and memery and rep-laced. but will not start. no power. no noise
Please some suggestions
Steve
[email protected]Welcome to the forum!
Let's try this: remove the battery, hard and media drives. Unplug the AC adapter. Press the "power" button 10 times in a row, holding it down for 10 seconds each time and 30 seconds the last time around.
Plug the AC adapter back in and try to power on.
Good luck and let us know.
Cheers,
George
In daily use: R60F, R500F, T61, T410
Collecting dust: T60
Enjoying retirement: A31p, T42p,
Non-ThinkPads: Panasonic CF-31 & CF-52, HP 8760W
Starting Thursday, 08/14/2014 I'll be away from the forums until further notice. Please do NOT send private messages since I won't be able to read them. Thank you. -
My macbook pro will turn on but will not start up.
My macbook pro ['08 Silver keys] will turn on but will not start up. Screen is black and keyboard is unresponsive, besides power button. Help!
ugh, no chime is not good, as that means it is not getting past the firmware POST phase. Is the sleep light blinking fast?
One thing to try is to access the RAM slots, remove, then replace and reseat the RAM.
http://support.apple.com/kb/TS1365?viewlocale=en_US -
MY ipad will not start. I can only see an apple in the center.
Have you tried this?
Reboot the iPad by holding down on the sleep and home buttons at the same time for about 10-15 seconds until the Apple Logo appears - ignore the red slider - let go of the buttons.
Maybe you are looking for
-
Report on Sales Orders Cancelled
Dear Experts, I have the following TWO Requirements. 1) How to cancel Sales Orders. 2) How to Generate a Report on Sales Orders Cancelled during a given time. The details required in the Report are: Orders cancelled by an User, Depot and by the Regi
-
How can you put an Animated Signature in Mail...
Is it possible to add an animated signature to Mail. I have read if you overwrite an existing signature residing in the ~/Library/Mail/Signatures folder as a .webarchive file it will work. I have an animation I have built in Photoshop and saved as an
-
Regarding calculations in sapscript!very urgent
friends... i have designed a form z_pm_common..which i have copied from standard.pm_common. i have made some changes to the layout. now at the header i have a field : DURATION OF JOB :&AFVGD-ARBEI& &AFVGD-ARBEH& AFVGD-ARBEI IS WORK DURATION.I.E 6.3
-
Hi I have a problem while doing PO confirmation. The confirmation comes from an IDOC, but I am getting this error "line 30 erred out with quantity marked as 0". I would like to know why this comes and does it have any impact when doing shipment confi
-
IPhone 5 won't take a charge & won't restore from backup
My iPhone 5 stopped taking a charge. So I updated to 7.whatever & backed it up. It still would take a charge so I went through recovery mode. That seemed to complete (I've done it twice now) However, the phone still won't take a charge and it won't r