I tried to restore my ipad and I got this message

[NAND] _FindFlashMadiaAndKeepout; 429 physical nand block offset 16
[NAND] start:220 this 0x84646c00 PROVIDER 0x845b3900 FlashMedia=0x845b3900
[NAND] wmr_start:149 Apple PPN NAND Driver, read/write
[NAND] WMR_Start:174 FiL_Init  [OK]
How do I fix it or is it a paper weight now.

Hi, my ipad 2 just got the same problem and after reading all relative post, finnally i figrue it out, that is no software issue at alll just hardware,
I did attemp replace the power button cable on my ipad so i must disconnect the back camera cable so there is my problem. Because the connect some how not exact in place, i took the camera out and the issue is gone. So, in your case, if you did try to replace anything look at them again or you just take them out one by one and reboot ipad until it work.
Hope this help
Binh

Similar Messages

  • HT201412 I have tried to restore my ipad and it cant be found in itunes

    I have tried to restore my ipad and it cant be found in itunes

    iPad: Basic troubleshooting
    http://support.apple.com/kb/TS3274
    Update and restore alert messages on iPhone, iPad, and iPod touch
    http://www.buybuyla.com/tech/view/012953a0d412000e.shtml
    iOS: Resolving update and restore alert messages
    http://support.apple.com/kb/TS1275
    iPad: Unable to update or restore
    http://support.apple.com/kb/ht4097
     Cheers, Tom

  • TS1363 im trying to restore my iphone and it got disconnected and wont reconnect to restore again, what do i do

    im trying to restore my iphone and it got disconnected and wont reconnect to restore again, what do i do

    Hi Troy,
    Thanks for visiting Apple Support Communities.
    You may find the troubleshooting steps in our iPhone assistant helpful if your device isn't recognized by iTunes:
    http://www.apple.com/support/iphone/assistant/itunes/
    Best Regards,
    Jeremy

  • I just tried to open my last Soundtrack Pro Projet and I got this message :  "NS InternallnconsistenceException Invalid parameter not satisfying:m_splitViewer". Curiously, I can't open any other project. Help! Please!

    I just tried to open my last Soundtrack Pro Projet and I got this message :  "NS InternallnconsistenceException Invalid parameter not satisfying:m_splitViewer". Curiously, I can't open any other project. Help! Please!

    Did this just happen after upgrading to 10.9?
    Try using Preference Manager by Digital Rebellion (it's free) to delete your preference files for Soundtrack.
    x

  • TS3212 Tried to install itunes and I got this message. Policy 8.0 microsoft VC80.CRT type="win 32-policy' version=8.050727 6195 public key token='1fc8b3b9a1e18e3b processor architecture='x86'

    Tried to install itunes and I got this message. Policy 8.0 microsoft.VC80.CRT type=win32-policy version=8.050727.6195 public key token=1fc8b3b9a1e18e3b. Processor Architecture='x86'

    Hi M2i7guel,
    Welcome to Apple Support Communities.
    It sounds like there is an issue installing iTunes and other Windows updates on your PC. The article linked below provides troubleshooting suggestions that will resolve most issues like the one that you've described.
    Issues installing iTunes or QuickTime for Windows
    http://support.apple.com/kb/HT1926
    I hope this helps.
    -Jason

  • I bought my I pod touch 3-4 months ago and I got this message all of a sudden, it said something along the lines of provisonal complete_Distrib... will expire in 30 days. What is this it's under setting-general-Profile should I be worried?

    I bought my I pod touch 3-4 months ago and I got this message all of a sudden, it said something along the lines of provisonal complete_Distrib... will expire in 30 days. What is this it's under setting-general-Profile should I be worried? Should I just let it expire.

    Unless you have a company or school iPod, that profile was installed by an app you installed. It is likely that the app will no longer function when that date is reached. You can Google the name of the profile and that may provide some more information.

  • Where can I find this download...I just updated to Yomesite and I got this message:What is says is To open "Adobe Dreamweaver CS5.app" you need to install the legacy Java SE 6 runtine.

    Where can I find this download...I just updated to Yomesite and I got this message:What is says is To open "Adobe Dreamweaver CS5.app" you need to install the legacy Java SE 6 runtine.

    Hi zimieh. Do you get it by going to the app store and run update,. If not here is a link for the only java update I find for Yosemite.  http://support.apple.com/kb/DL1572?viewlocale=en_US&locale=en_US

  • I attempted to upgrade the software on my iPad and I got a message that said it couldn't restore the iPad software due to an error. Now the iPad has a black scrren with the apple symbol and the processing symbol going around.

    I attempted to upgrade the software on my iPad 2 and I got a message that said "unable to restore Ipad due to error". Now the iPad had a black screen with the Apple symbol and the processing symbol going around and around. When I tried to re connect it to iTunes is says "cannot connect to this iPhone due to error". How do I reset the ipad?

    Please Get the iPad User Manual for iOS 5.

  • HT201263 have tried to restore my ipad and it does not complete the restoration and gives me an error code

    I have tried many times to restore my ipad to factory settings with no luck.  It does not get through the whole process and gives an error code of 3194 cannot restore.  It then directs me to a website that does not help and is very hard to get rid of.  I am ready to send my ipad back and get a new one.  Is there any solution to saving my current model?

    iPad: Basic troubleshooting
    http://support.apple.com/kb/TS3274
    Update and restore alert messages on iPhone, iPad, and iPod touch
    http://www.buybuyla.com/tech/view/012953a0d412000e.shtml
    iOS: Resolving update and restore alert messages
    http://support.apple.com/kb/TS1275
    iPad: Unable to update or restore
    http://support.apple.com/kb/ht4097
    iTunes: Specific update-and-restore error messages and advanced troubleshooting
    http://support.apple.com/kb/TS3694
     Cheers, Tom

  • HT201210 Im trying to restore my IPAD and i keep getting the message (-1)

    I can't restore my IPad.

    Hey ehspecial,
    Thanks for the question. Error -1 usually indicates a possible hardware issue. To isolate the issue, see this article:
    Resolve specific iTunes update and restore errors
    http://support.apple.com/kb/TS3694
    Check for hardware issues
    Related errors: 1, 3, 10, 11, 12, 13, 14, 16, 20, 21, 23, 26, 27, 28, 29, 34, 35, 36, 37, 40, 1000, 1002, 1004, 1011, 1012, 1014, 1667, or 1669.
    Try to restore your iOS device two more times while connected with a cable, computer, and network you know are good. Also, confirm your security software and settings are allowing communication between your device and update servers. If you still see the error message when you update or restore, contact Apple support.
    If your issue persists after following the above instructions, your iPhone may need to be serviced. The following link should help you get started with the process. Included, you will find information on topics such as warranty & service pricing.
    Apple - Support - Service Answer Center
    http://www.apple.com/support/ipad/service/faq/
    Thanks,
    Matt M.

  • HT3960 unknown error (1604) i am trying to restore my ipad with no luck this only happened on the las toperating system upgrade ?

    error unknown (1604) is coming up as i try to restore my ipad any ideas help !!!!

    When I restart my iPad the connect to iTunes comes up and stays on until it shuts down again, I have read a report from Apple support suggesting I reinstall iTunes so I might try that again and also your suggestion which i shall also try, but thanks again - rg1547

  • HT1212 i just tried to restore a ipod and it got half way through and is now stuck on restore screen???

    i just tried to restore my ipod touch and its stuck on restore screen??

    What exactly happens?
    What does the status bar in iTunes say?

  • I can't restore my Ipad and keep getting NAND messages running along the type left of the screen

    I can't restore my Ipad mini.....it begins the process and then stops midway through and shows NAND messages along the top left of the screen. Then all I get is either a blank screen or Apple logo......unable to turn it on or off.

    Recovery Mode:
    1. Turn off iPad
    2. Connect USB cable to computer; leave the other end alone
    3. Press and hold the Home button down and connect the docking end of cable to iPad
    4. Continue holding the Home button until you see the "Connect To iTune" screen
    5. Release the Home button
    6. Open iTune
    7. You should see "iTunes has detected an iPad in recovery mode"
    8. Use iTune to restore iPad
    Note: You need to be patient and repeat the above many times to recover your iPad

  • HT1386 Cant connect to iTunes and I got this message when i connect my iphone to my itunes

    cant onnect my i phone to mu itunes and this message appear "Itunes could not connect to this iphone, Could not allocate a resource."

    HOW TO FIX CANNOT ALLOCATE A RESOURCE ERROR!!!
    I found a fix that worked for me after failing with all the others:
    IF your computer has an old cydia app called Wi-Fi Sync (you'll recognize it on your toolbar as a black silhouette of an iphone that NEVER goes away), then this is probably your main culprit.  Simple fix.
    1. Goto your hard drive in the finder
    2. Goto Library
    3. Goto Launch Daemons
    4. Throw this in the trash:  com.ghughes.wifisync.root.plist
    5. Goto Library
    6. Goto Application Support
    7. Throw this in the trash:  Wi-Fi Sync (it's an entire folder).
    8. Restart.
    9. Thank me.
    Peace and Love, Peace and LOVE!
    Kendrick

  • Trying to restore the phone and I get error messages 4005, or 4013.

    My phone spontaneously died and went to the white apple with black background screen.  I hooked it up to iTunes and it said it needed to be restored, which I then started to perform but the phone seemed unresponsive after a while and a few times I got the error # 4005 and once 4013.  I'm not sure what else I can do to get the phone back to working condition.

        Hello dontknownuttin,
    Help is right here, front and center! Let's get your iPhone 5s working properly again. May I ask what's the last action done on the device before you received the error messages? Also, is there any physical or liquid damage on the phone? What version of iTunes do you have installed? As you share the details then we can get your device working again.
    Thank you…
    ArnettH_VZW
    Follow us on Twitter @VZWSupport

Maybe you are looking for