I tried to update my ipad from ios 4 to 5 and now it won't connect to my computer - it is fully restored and can't connect - getting an error message. Help!
I just recently tried to update my ipad from ios 4 to 5 and now I am getting an error message when I try to connect it to the computer so that I can download all of my apps, etc. please help! Error message says iTunes could not connect to this iPad. An unknown error occurred (oxE8000000A).
Help!
Syncing with iTunes on a Mac or PC requires:
Mac: OS X v10.6.8 or later
PC: Windows 7; Windows Vista; or Windows XP Home or Professional with Service Pack 3 or later
iTunes 10.7 or later (free download from www.apple.com/nz/itunes/download)
Similar Messages
-
I am trying to update my ipad 2 from iOS 4.3.5 to 6.1.3. 6 hours ago it said 49 hours and now says 53. I am making no progress. Please help. I am using wifi connection.
You have to connect the iPad to your computer to update.
If you have an iPad 1, the max iOS is 5.1.1. For newer iPads, the current iOS is 6.1.3. The Settings>General>Software Update only appears if you have iOS 5.0 or higher currently installed.
iOS 5: Updating your device to iOS 5 or Later
http://support.apple.com/kb/HT4972
How to install iOS 6
http://www.macworld.com/article/2010061/hands-on-with-ios-6-installation.html
iOS: How to update your iPhone, iPad, or iPod touch
http://support.apple.com/kb/HT4623
If you are currently running an iOS lower than 5.0, connect the iPad to the computer, open iTunes. Then select the iPad under the Devices heading on the left, click on the Summary tab and then click on Check for Update.
Tip - If connected to your computer, you may need to disable your firewall and anitvirus software temporarily. Then download and install the iOS update. Be sure and backup your iPad before the iOS update. After you update an iPad (except iPad 1) to iOS 6.x, the next update can be installed via wifi (i.e., not connected to your computer).
Tip 2 - If you're updating via wifi, place your iPad close to your router to preclude getting a corrupted download.
Cheers, Tom -
Hi
I am trying to update my ipad from ios 4.3 but when connected to itunes I get an error message saying that the internet is not accessible when it is. How do I resolve this?Disable your firewall and antivirus software, restart your iPad, quit iTunes, restart your computer and then try to update again.
-
Since last few months i am trying to update my ipad from iOS 3.2.2 to 4.1.2 or 5.1, but it always shows error 3002, 3194 etc. I have checked & resorted to all the given troubleshooting steps , but they didn't help.
Somebody please help meConnect the iPad to iTunes, and do the update with iTunes.
The 4.1.2 ipsw file will not work, no longer supported.
The incremental update directly on the iPad does not work either, unless you are already on iOS 5.
Let iTunes do the job, you already lost too much time by doing it yourself. -
Hi, I am trying to update my ipad2 from ios 4.3.3 to ios 7.0.4 after i have downloaded the update it cant update my ipad it gave me error 3194
what can i do. ThanksiPad: Basic troubleshooting
http://support.apple.com/kb/TS3274
Update and restore alert messages on iPhone, iPad, and iPod touch
http://www.buybuyla.com/tech/view/012953a0d412000e.shtml
iOS: Resolving update and restore alert messages
http://support.apple.com/kb/TS1275
iPad: Unable to update or restore
http://support.apple.com/kb/ht4097
iTunes: Specific update-and-restore error messages and advanced troubleshooting
http://support.apple.com/kb/TS3694
Cheers, Tom -
I am trying to update ipod touch from ios 4.3.2 to ios 6.1.3. I have it connected to my computer, and the summary in itunes indicates the update is available. However, when I click "update", it opens Windows Explorer and waits for a file name to open.
I am not at that computer now, but I did check via windows update & with the check updates menu choice in the itunes program - neither indicated a newer version of itunes is available. (it is a vista computer).
The itunes software on the computer displays my ipod & the current ios (4.3.2), and indicates a newer ios is available (6.1.3). When I choose "update", I am taken to Windows Exploer and prompted to choose a file to open. it is as if the "update" button has the incorrect code attached to it.
The ipod is working, but there are several app I would like to install, but I can't with the current ooperating system. -
I am trying to update my ipad to ios 6 but the update software tells me that my 5.1.1 is the current version
If your iPad is the first generation then 5.1.1 is the highest it can go. iOS6 is for iPad 2+
-
I'm trying to update my iPad to iOS 8.1.2 and it won't update?
I'm trying to update my iPad to iOS 8.1.2 and it won't update?
Is it perhaps downloading the update?
Have you tried rebooting the iPad? Hold down the home and power/sleep buttons for 10 to 15 seconds or until the Apple logo appears. This should reboot the iPad. Then try the update again.
If all else fails, you can try to update through iTunes on a computer. -
I was trying to update my Ipad to IOS 8, the screen is all black with the apple logo on it and the progress bar is stuck.
I can't turn it off, and when i connect it to itunes, it doesn't displayTry putting the iPad in restore mode and see if iTunes recognizes it. The steps are below:
Turn your iPad off.
Hold down the Home button and plug it into your computer. Keep holding the Home button until you see a screen telling you to connect to iTunes.
iTunes should show you a popup saying that there is an iPad that is in Recovery Mode and needs to be restored before you can use it. Click OK.
Click on Restore iPad -
hi i when i am trying to update my ipad to ios i receive an error message 4005 please help.
Read through this for solutions to error 4005:
http://support.apple.com/kb/TS3694 -
HT4623 Can I update my iPad from iOS 5.1 to 6?
Can I update my iPad from iOS 5.1 to 6? It says there are no updates available when I check but there are apps I want that require the newer iOS.
If yours is an iPad 1 then it can only update as far as iOS 5.1.1
-
Since updating my iPad to IOS 7.1.2, individual Apps won't update from with Apps. Has anyone else had this issue
Thanks SerZak! I lost my reply to your post. But I discovered I was logged out after the update. I logged back in and it was sorted. I wouldn't have worked this out on my own, so thank you for you help. Much appreciated.
-
Updating my iPad to iOS 6.1.2 now that iOS 6.1.3 update is out
How can I update my iPad to iOS 6.1.2 now that iOS 6.1.3 update is out
You can't. THe time to update to 6.1.2 was before 6.1.3 came out. All you can access is the latest update.
-
I downloaded the latest update for my ipad and now it won't open. the screen shows the itunes icon and a pic of the usb cable
That message means that you have to restore the iOS software because something went wrong. Follow the instructions here. I hope that you have a backup.
iTunes: Restoring iOS software - Support - Apple -
I have an iphone 4 that I use as an iPod. It is not connected to a wireless network. I have updated to the IOS 7 and now it won't sync with my computer. Does anyone know what could possibly be the problem?
Contacts are designed to be synced to a supported application on the computer or a cloud service.
Pictures taken with the device are designed to regularly be copied off the device to a computer as would be done with any digital camera.
If you have failed to use the device as designed it may be too late to recovery anything.
Is the device regularly backed up to a computer via iTunes? If so, the most recent backup (when restored to a replacement iOS device) should contain all contacts and pictures as of when the backup was created.
Maybe you are looking for
-
How to download a file from a folder
hello frnds.. i've uploaded a file to a folder in tomcat server. Now how to download that file at the client side.. pls help me out... it would be better if you gimme the related code for it..
-
AMD Troubleshooting guide! UpToDate version in VIA forum.
[size=11](Revision 4-9-2003)[/SIZE] Hi there, Follow everything on the list, even if it doesn't look like it would solve your problem, most problems are created somewhere else! To give some examples: CPU won't run FSB133....mostly powersupply or CP
-
How to run report without report server
hi my question : how i can run report without using the report server; by simple URL to the report stored in directory and accessing by HTTPserver; and the report is running by the local client runtime. thinks for replay
-
"My Alerts" quicklink missing (9.0.1)
Upgraded to 9, then immediately to 9.0.1. Love the new layout, but can't find "My Alerts" or "Complete My Album" quick links. I've quit iTunes & restarted the Mac. Nothing. Jumped around the various store sections. Nothing. Searched the forum I found
-
Is anyone else having issues with the Hyperlink for chapters in eBooks? I have "created a new Hyperlink Destination" in the chapter, then assigned the appropriate destination in the table of contents. However, when I convert to ePub and display the