I went to update my ipod touch and restore it. it was working fine and then when it it restarted itself it it stuck onone scren te same one when u first get it, it will not do anythig elts what do i do please help

i went to update my ipod touch and restore it. it was working fine and then when it it restarted itself it it stuck onone scren te same one when u first get it, it will not do anythig elts what do i do please help i whont my ipod touch back

Restore loop (being prompted to restore again after a restore successfully completes): This issue is typically caused by out-of-date or incorrectly configured third-party security software. Please followTroubleshooting security software issues if USB troubleshooting does not resolve this issue.
Error 13 and 14: These errors are typically resolved by performing one or more of the steps listed below:
Perform USB isolation troubleshooting, including trying a different USB port directly on the computer. See the advanced steps below for USB troubleshooting.
Put a USB 2.0 hub between the device and the computer.
Try a different USB 30-pin dock-connector cable.
Eliminate third-party security software conflicts.
There may be third-party software installed that modifies your default packet size in Windows by inserting one or more TcpWindowSize entries into your registry. Your default packet size being set incorrectly can cause this error. Contact the manufacturer of the software that installed the packet-size modification for assistance. Or, follow this article by Microsoft: How to reset Internet Protocol (TCP/IP) to reset the packet size back to the default for Windows.
Connect your computer directly to your Internet source, bypassing any routers, hubs, or switches. You may need to restart your computer and modem to get online.
Try to restore from another known-good computer and network.
Error 50: This error (and error -50) are timeout errors. Follow the steps for errors 13 or 14 above.
Above from:
http://support.apple.com/kb/TS3694

Similar Messages

When I went to update my iPod touch on iTunes, it said unable to update then the iPod shutdown and no longer showed connected in iTunes. I have tried holding down both buttons for up to 3 mins with no luck turning it on, even after a full charge. Help?

When I went to update my iPod touch on iTunes, it said unable to update then the iPod shutdown and no longer showed connected in iTunes. I have tried holding down both buttons for up to 3 mins with no luck turning it on, even after a full charge. Help?

Try:
- iOS: Not responding or does not turn on
- Also try DFU mode after try recovery mode
How to put iPod touch / iPhone into DFU mode « Karthik's scribblings
- If not successful and you can't fully turn the iOS device fully off, let the battery fully drain. After charging for an least an hour try the above again.
- Try on another computer
- If still not successful that usually indicates a hardware problem and an appointment at the Genius Bar of an Apple store is in order.
Apple Retail Store - Genius Bar

How come my iMessages aren't sending anymore I have a iPod touch 5th gen. It was working and then like 5 minutes later it would not send any messages it always said not delivered even when I press retry and it doesn't send at all I even updated my iOS.

How come my iMessages aren't sending anymore I have a iPod touch 5th gen. It was working and then like 5 minutes later it would not send any messages it always said not delivered even when I press retry and it doesn't send at all I even updated my iOS to iOS 7.04 to see if it will send my iMessages but it won't. I tried to send a message to anyone but it won't work even when before I would be able to send messages but something weird happened that made my messages not delivered. Is there any way I change fix it?

iOS: Troubleshooting Messages

I went to use my ipod touch 8GB but it wasn't working, when i looked closer it was on just very very dim. The brightness is turned up all the way and the screen is practically black.. does anyone know how to fix it?

I went to use my ipod touch 8GB but it wasn't working, when i looked closer it was on just very very dim. The brightness is turned up all the way and the screen is practically black.. does anyone know how to fix it?

Try:
- Reset the iOS device. Nothing will be lost
Reset iOS device: Hold down the On/Off button and the Home button at the same time for at
least ten seconds, until the Apple logo appears.
- Reset all settings If yu can see the screen enough to do it)
Go to Settings > General > Reset and tap Reset All Settings.
All your preferences and settings are reset. Information (such as contacts and calendars) and media (such as songs and videos) aren’t affected.
- Restore from backup
- Restore to factory settings/new iOS device.
- Make an appointment at the Genius Bar of an Apple store since you have a hardware problem.
Apple Retail Store - Genius Bar

HT4623 I updated my Ipod touch 4th gen (IO6 or whatever its called) And it has the picture that says to connect my ipod to Itunes, and I did, now it says "ITunes has detected an Ipod in recovery mode. You must restore this Ipod before it can be used with

I updated my Ipod touch 4th gen (IO6 or whatever its called) And it has the picture that says to connect my ipod to Itunes, and I did, now it says "ITunes has detected an Ipod in recovery mode. You must restore this Ipod before it can be used with ITunes." I just updated it and now I have to restore it??! I don't wanna lose all my things on my ipod just for a stupid update! Please someone help!

Once the Device is asking to be Restored with iTunes... it is too late to save anything... and you must continue with the Recovery...
See Here > http://support.apple.com/kb/HT1808
You may need to try this More than Once... Be sure to Follow ALL the Steps...
Take your time... Pay particular attention to Steps 3 and 4.
After you have Recovered your Device...
Re-Sync your Content or Restore from the most recent Backup...
Restore from Backup > http://support.apple.com/kb/ht1766
Note:
Make sure you have the Current Version of iTunes Installed on your computer
iTunes free download from www.itunes.com/download

I have an ipod touch 4th Gen that everything was working perfectly. After the last update of iOs5, the battery have charge 20 minutes. Even after the correction of the iOS 5.0.1 the battery have the same 20 minutes. What I can do?

Hi
I have an ipod touch 4th Gen that everything was working perfectly. After the last update of iOs 5, the battery have charge 20 minutes. After the correction of the iOS 5.0.1 the battery have the same 20 minutes. What I can do? Thanks

Same thing here. Try putting the brightness down all the way (its hard to see at first but you will get used to it) and one more thing is that close all you open apps. So to do that you have to click the home button twice (after you put your passcode in) and you will see some apps in the bottom. Hold it until there is a red - sign. click all of them so they go away. This does not delete your apps it just makes your ipod better.

HT4623 After I update my ipod touch 4g from ios 5.1 to 6.1.5 its always keeping restart until it die. can anyone help?

After I update my ipod touch 4g from ios 5.1 to 6.1.5 its always keeping restart until it die. can anyone help?

Try:
- iOS: Not responding or does not turn on
- Also try DFU mode after try recovery mode
How to put iPod touch / iPhone into DFU mode « Karthik's scribblings
- If not successful and you can't fully turn the iOS device fully off, let the battery fully drain. After charging for an least an hour try the above again.
- Try another cable
- Try on another computer
- If still not successful that usually indicates a hardware problem and an appointment at the Genius Bar of an Apple store is in order.
Apple Retail Store - Genius Bar

Time Capsule error 22 - My time capsule was working fine and didn't notice anything wrong with it until it stopped backing up about two weeks ago. I never changed anything like computer names or the Airport settings. All I get is the following: The backup

Time Capsule error 22 - My time capsule was working fine and didn't notice anything wrong with it until it stopped backing up about two weeks ago. I never changed anything like computer names or the Airport settings. All I get is the following:
The backup disk image "/Volumes/Data/Linda's Computer 1.sparsebundle" could not be created (error 22).
I tried resetting the Time Capsule and connecting with an ethernet cable, although the Ariport Utility says everything is working fine through WiFi.

If the light will not turn on the TC is dead. No matter that the hard disk is running.. it should only run at start up or when it is accessed not constantly.. that means the board in the TC has failed. Apple do not repair them.. They will replace it under warranty or applecare.
If you have gone over the 12month warranty it will still be covered if you have applecare on any computer or an Apple TV. In fact the cost of the apple TV plus apple care is still cheaper than buying a new TC.. so it is a route some people are taking.. certainly depends.. in some places like Europe or Australia now, there is a recognition that statutory warranty must be longer on a product that is premium to the market. 12months is not good enough. Apple will sometimes listen.
They might be fixable but I do not know how.

I need make mac browsers with windows compatibility, because if i try to se priview from Dw to all browsers on windows PC it will look fine, but same file i trying to see on mac all browsers it will not showing proper..... Please help me for that.

i need make mac browsers with windows compatibility, because if i try to se priview from Dw to all browsers on windows PC it will look fine, but same file i trying to see on mac all browsers it will not showing proper..... Please help me for that.

ASk in the DW firum and be much more specific. Web page rendering issues are specific to specific versions of browsers and you may simply be using some bad code that messes up your page.
Mylenium

Acrobat Pro IX License was activated and was working fine. Then it stop working application would not launch. I

My Acrobat Pro IX license was activated and was working fine. Then the application stop launching after an update was by Adobe. After a while I uninstalled the application successfully, logged on to my adobe account, viewed past purchases, re-downloaded the application successfully, activated the license and entered my serial number. The next day I get a pop up message that my trial licenses is set to expire in 29 days. I clicked again to activate my license and this time, the message stated that the license for serial number has been revoked.
How do I resolve this matter?
Darrell Rawlins

[discussion moved to Acrobat Installation & Update Issues forum.]

I have a factory unlock iphone 5 with the lasted version. Since yesterday my sim card stopped working and now says `No Sim`, was working fine and stopped working now, other sim works but just not mine. ¿What can be happening?

I have a factory unlock iphone 5 with the lasted version. Since yesterday my sim card stopped working and now says `No Sim`, was working fine and stopped working now, other sim works but just not mine. ¿What can be happening?

I thought that, but I put the sim card in another device that is not Apple and works. Definitely the sim card work, but no longer in my iPhone 5 or maybe in any other Apple device, i dont know why!! But i gonna get a replacement to see what happen

I am using iphone 3gs since last 4 days. Till yesterday night it was working fine and i have connected this phone for charging . Morning there was apple logo in the screen and every 1mte (approx) it is blinking. I could not restart the phone.Plz help

I am using iphone 3gs since last 4 days. Till yesterday night it was working fine and i have connected this phone for charging . Morning there was apple logo in the screen and every 1mte (approx) it is blinking. I could not restart the phone.Plz help . I have tried to reset even by pressing sleep and home button but it could not help. Please suggest. Still i have connected for charging .

Sounds like you have corrupt backup data, if this occurs from one phone to another. Try restoring the phone as a new device, without a backup. Try using for a day before installing any other apps, etc. See if that improves the battery life. Then try syncing back applications a couple at a time. Something seems to be locking in the processor which is draining the battery.
Do you live in an area where there are Apple Stores? If so, try making an appointment with the Genius Bar to have the device checked out.

My screen wont turn on, and the screen is black. It was working fine, but then it just turned off. The only way it will work is if I close my laptop, and pinch the two screens together

My screen wont turn on, and the screen is black. It was working fine, but then it just turned off. The only way it will work is if I close my laptop, and pinch the two screens together

You have a hardware problem and you should take it into a apple store to be looked at and fixed.

I purchased an adapter for playing videos from my ipod touch on my tv. It works fine for episodes I have purchased from Itunes, but won't play videos from Hulu Plus. What should I do to remedy the situation? Thank you!

I purchased an adapter for playing videos from my ipod touch on my tv. It works fine for videos I have purchased but won't allow me to watch videos from Hulu Plus. What should I do to remedy the situation? Thanks!

The iPod TV out only works for aps that support TV out. The description of Hulu Plus only states that iiPad supports HDMI video out (SD only)

Is it possible to turn off the fluid grid function in dreamweaver during the process of building your site by mistake? It was working fine and simply stopped and I don't see how to correct what is wrong.

Is it possible to turn off the fluid grid function in dreamweaver during the process of building your site by mistake? It was working fine and simply stopped and I don't see how to correct what is wrong.

There is no specific function that turns FGL on or off.
When you say that it has stopped, do you mean that the handles no longer show?
If that is the case, then I think you may have modified the CSS to such an extent that Dreamweaver no longer recognises it as belonging to FGL.
There are a couple of avenues for you
Redo the site and make sure not to touch the FGL CSS
paste the code here so that we can see what has gone wrong.

I went to update my ipod touch and restore it. it was working fine and then when it it restarted itself it it stuck onone scren te same one when u first get it, it will not do anythig elts what do i do please help

Similar Messages

Maybe you are looking for