ID Point for Storage Type V.S. Value in Storage Type Search Table.

Question

I am trying to perform a GR without PO (MVT 501) for material ABC into Plant 1000, Warehouse number 100, Storage Location 0100.
During creation of Transport Order, the Destinated Storage Type appeared
is 011  (ID point for st.ty.010). However, the desired Destinated Storage Type should be 015 (High Rack) instead of 011.
I have checked the following configuration:
1. At the SPRO->LE->WM->Master Data->Define Storage Type, the value set for Field: Assigned ID (Identification point) for storage type under the Stock Placement Control = 011 (ID point for st.ty.010).
2. At the Storage Type Search Strategy, 015 is put as the first Storage Type, followed by Storage Type 001 (high Rack Storage)
3. And I found out that using LX03 (Bin Status Report) that there is no
Storage Bin created for the combination of the following
Plant 1000, WN 100, SLOC 0100, Storage Type 015, Storage Section 001
Since we do not have any Storage Bin created for Storage Type 015, it will display 011 as the destinated storage type during TO creation.
My question
After I have manually created a Storage Bin 03-01-01 for storage type 015, during the TO Creation, system still suggests 011 as Destinated Storage Type instead of the 015 I put in the 1st column of the Storate Type Search.
I already have the Storage Bin created for Storage Type 015, why the system still fails to pick it but suggests 011 from Assigned ID (Identification point) for storage type.

Answer 1

Dear Karthik
You are right, I did activated Indicator: Activate Storage Unit Type Check for Stock Placement in SPRO->LE->WM->Master Data->Define Storage Type
The Indicator: Storage type with storage unit management was also ticked automatically by system when I selected Indicator: Activate Storaget Unit Type Check for Stock Placement.
Are you trying to say the ID Port defined in Storage Type will have higher priority over the Storage Type value I maintained in the Storage Type Search Table?
I have already maintained the Storage Bin and I still do not understand why system still go for ID port. As far as I know, system will suggest the Storage Type from ID Port ONLY if storage bin in this storage type as their destination are not maintained in first in the other setting.
Quoted from SAP HELP
Identification point for storage type
Identification point (storage type) of the current storage type.
All goods movements that do not have a specific storage bin in this storage type as their destination are first directed to the identification point.
Here the goods are identified and a transfer order is generated for the actual transfer of the goods into the storage type concerned.
Please help.
Edited by: Daimos on Nov 4, 2011 3:25 AM