IMessage registration on Wind Network - possibly easy solution

Question

Hi everyone who is a Wind Customer as well,
Little disclaimer before I start: I have read parts of the thread that mentions the method where hex code is copied to a website in order to active iMessage on Wind, so if the following was mentioned somewhere in this (long) thread, my apologies in advance.
I tried the method described but couldn't find the Baseband folder on my two Macs (10.7 and 10.8), so shortly before I gave up, I found a Youtube video that suggested that after activating iMessage and the usual wait with no success, to reset the network settings.
I did this (Settings -> General -> Reset -> Reset Network Settings) and voila - iMessage is working now!
The message underneath the switched on iMessage switch (bad English ...) says "Activation unsuccessful. Turn on iMessage to try again", however, iMessage works!
Please try and let me know if it works for you as well.
Once again, if this was mentioned somewhere already, my apologies. Also: if the other method works for you, good. It didn't work for me, so I am happy I found this solution.

Answer 1

I assume you mean that you have several wireless access points, not wireless routers.
Have your IT Dept disconnect the ethernet cable that connects the Access Point to the main switch or router, and then "tone" the wire to trace it.
Use one of these:
http://www.iautomate.com/kp100.html
Another option is to flash the firwmare over the LAN, BUT that will probably default the Access Point to an address already in use and that may create a bigger problem.
Peter