IN FRANCE WHAT DO I PLUG INTO, a converter or just plug?

I'm going to France, Do I need a converter or just a plug adapter?

All you need is a plug pin to outlet adapter...there are shops at DeGaule Airport that used to sell them, other stores in Paris carry them. The Apple chargers are 100-240 volts.

Similar Messages

My iPad 4 wifi 3G keeps charging slowly takes half a hour to get to 15% when plug into the wall with the plug and the lead what come with the iPad just wondering as I think some thing is wrong with the iPad

My iPad 4 wifi 3G keeps charging slowly takes half a hour to get to 15% when plug into the wall with the plug and the lead what come with the iPad just wondering as I think some thing is wrong with the iPad

Using the battery level meter in this manner is comparable to using your car's fuel gauge to calculate miles per gallon. The only thing that matters is the total amount of operating time from full charge to auto-shutdown.
Use the wall-mount charger that came with the iPad and charge overnight. Do NOT use an iPod/iPhone charger. Do NOT use a computer's USB port. Then, operate it normally until auto shut-down (ignore any low level alerts that may appear). An irony is that doing that test to determine the total operating time is also the procedure necessary to calibrate the battery level meter.
I'm not claiming that you do not have a problem. I am stating, however, that we don't yet know. If the above test does, in fact, indicate a problem, read this.
Also, according to Apple:
Use Your iPad Regularly
For proper reporting of the battery’s state of charge, be sure to go through at least one charge cycle per month (charging the battery to 100% and then completely running it down).
Elsewhere, Apple elaborates and explains that two half-discharges (or four quarter-discharges, etc.) equals one full discharge.

My ipad is flat and when I plug it in to charge it just repeatedly turns on and then turns off but isn't charging. I tried to plug into itunes but it just goes through the same ritual and can't maintain connection to itunes. What should I do ?

My ipad is flat and when I plug it in to charge it just repeatedly turns on and then turns off but isn't charging. I tried to plug into itunes but it just goes through the same ritual and can't maintain connection to itunes. What should I do ?

1. Reset iPad
2. Try another wall socket
3. Try another cable (make sure it's an original Apple cable)
4. Try another charger (make sure it's an original Apple charger)
5. Clean Lightning port with compress air or new paint brush

I tried to update to ios7 but it said to plug into itunes. I've plugged it in several times but the update fails everytime and my phone continues to say plug into itunes

I tried to update to ios7 but it said to plug into itunes. I've plugged it in several times but the update fails everytime and my phone continues to say plug into itunes. Any help is greatly appreciated

Your iPhone was hacked at a "small phone unlocking shop "
Only the carrier who locked the iPhone from new can unlock it no-one else
Anything else is hacking which forfeits any help from Apple and this forum
I also doubt that Orange will touch it
For an understanding what hacking does see here
http://support.apple.com/kb/HT3743..
Since all the UK carriers ( I assume you are in the UK )
offer unlocking you have trashed a perfectly good iPhone

TS3694 I update my Iph to version 6.1 and then a picture of usb to plug into itunes and it just stays there

I update my Iph to version 6.1 and then a picture of usb to plug into itunes and it just stays there

Connect to iTunes on the computer you usually Sync with and “ Restore “...
http://support.apple.com/kb/HT1414
If necessary Place the Device into Recovery mode...
http://support.apple.com/kb/HT1808
Recovery mode..
You may need to try this More than Once...
Be sure to Follow ALL the Steps...
But... if the Device has been Modified... this will Not necessarily work.

K8NGM2-FID : can a DVI-I plug can be plugged into the motherboard DVI-D plug ?

Hello,
I intend to buy a flat panel for the MSI K8NGM2-FID motherboard. Can the screen DVI-I plug can be plugged into the motherboard DVI-D plug ?
Thanks.

Quote from: passionne on 31-January-06, 23:59:24
OK, thanks. I was not able to modify the RAM voltage beforehand, since I pressed the "enter" key first.
But, now that I have applied 2.6 V, I don't know how to make the RAM work at 400 Mhz. Indeed, CPUz shows me that it runs at 333 Mhz.
In the chipset configuration, I can change the RAM frequency but the allowable values are 100, 133 and 166 Mhz. Not 200 Mhz.
And I noticed that the command rate is 2T. I changed it to 1T and no boot. I was forced to clear CMOS.
I looked at the RAM specifications (http://www.ec.kingston.com/ecom/configurator/PartsInfo.asp?ktcpartno=KVR400X64C25/512) but it is not told if these DIMMs can run at 400 Mhz, 1T.
Would you have an idea ?
Thanks.
I use A64 3700+ with Corsair XMS 1G x 2. All RAM setting is auto and CPUz read 200MHz (3-3-3-8). RAM is at 2.6V
May be you can try using auto RAM setting and slightly increase the RAM voltage to 2.65V or 2.7V. If it work, you may try other custom RAM setting.

Just moved to Jakarta, Indonesia with my iMac. Do I need to plug it into a converter or just put an adaptor on the end of the existing plug?

Just moved to Jakarta, Indonesia from the US with my new iMac. Do I need to plug the iMac into a converter or just put an adaptor on the end of the existing plug?

http://bali.angloinfo.com/information/housing/setting-up-home/electricity/
This, above, is a UK set of notes.
Your iMac is made to operate on anything between 100 and 250v. Indonesia is generally 220v so you will only need an adapter but beware; the power supply is not terribly reliable. Out of interest, your iMac cannot be iOS 7.1.2. Go to 'about this mac' and find the actual version number to enter in your profile.

All it shows is to plug into itunes but when i plug it into my computer it doesnt show up?

i was able to restore it but now all it shows is to plug into itunes but when i plug it into my computer it doesnt show up? and it doesnt come up under my computer as a hard drive either.

Try again to connect in recovery mode, explained in this article:
iOS: Unable to update or restore
If still not recognized in iTunes, try the tips mentioned in this article:
iOS: Device not recognized in iTunes for Windows

HT4623 my iphone 3 has has the usb plug that says plug into itunes on it, its plugged in, now what?

i cant get my iphone 3 to get the "plug into i tunes" picture to go away

CarlaRobinson11 wrote:
i cant get my iphone 3 to get the "plug into i tunes" picture to go away
See Here > http://support.apple.com/kb/HT1808
You may need to try this More than Once...
Be sure to Follow ALL the Steps...
But... if the Device has been Modified... this will Not necessarily work.

HT1923 Hi, I have a iPod touch 4th generation and I does not show in iTunes. It comes up as charging when it is plugged into the computer but just not in iTunes. I have everything up to date and have restarted both computer and iPod. Help please?

Hi, I have a iPod touch 4th generation. It comes up as charging when it is plugged into the computer but it does not show in iTunes. I have everything up to date and have restarted both computer and iPod. Help please?

Try here > - http://support.apple.com/kb/TS1369.

What do you do if your ipod is disabled and it says plug into itune and when you plug it in to itunes it says the ipod must be unlocked for itunes to work

i need help

Place the iPod in Recovery Mode and then connect to your computer and restore via iTunes. The iPod will be erased.
iOS: Wrong passcode results in red disabled screen
If recovery mode does not work try DFU mode.
How to put iPod touch / iPhone into DFU mode « Karthik's scribblings

My ipod just shows the apple logo and won't do anything...won't even shut off. Anyone knows what may be going on Here? I just plugged it in to recharge it and now nothing.

I plugged in my ipod to recharge it and for some reason, it just stopped and only the apple logo is showing. I may have unplugged it before it was done, not even sure at this point but now only the apple logo and I can't even shut it off. Any ideas of what I can try now? Thanks much.

Have you tried a reset ? Press and hold both the sleep and home buttons for 10 to 15 seconds and see if it then reboots - you won't lose any content, it's the equivalent of a computer reboot. If that doesn't work then you might better help in the iPod forum (this is the iPad forum)

I am having problems getting connection with my itouch. When I plug into the computer it just shows usb symbol.

My main concern is it is not connecting, and how to reset.

Welcome!
It would be very useful if you posted your Mac OS version, your version of Safari, and your model/version of iMac. That info can affect the responses you get. Also remember that there is a special forum area for Safari here:
http://discussions.apple.com/forum.jspa?forumID=876
People in that forum would need the same additional info.

Cannot back up to iCloud. get message my device has not been backed up in 14 weeks you need to be connected to wifi, plugged in and locked" I am all three. I am plugged into the wall via my charger, my wifi is on and i have a pass code what else?

New to iCloud. I only bought the storage to stop getting not enough storage messages. Now I can't back up to iCloud. I get the message "you have not backed up this device in 14 weeks, your device needs to be connected to wifi, locked and plugged in" I connected to wifi and am sitting with my phone about 10" from my modem. I am plugged into my charger which is plugged into the wall. I created a passcode for my phone as I an guessing thats what locked means. However if I am locked I cannot get into the phone to see if it is backing up. So I ask it to back up then let it go off to lock, give it 5 or 10 min to back up and then get back into it only to find its still on estimating time remaining. It won't go any further then that.. What am I doing wrong??

This may not solve your problem but may clear up a couple of things.
1: Re the connected to wi-fi, plugged in and locked thing is for automatic backups. It doesn't need to be plugged in or locked for it to work when you go to Settings > iCloud > Backup and tap Back Up Now. Mine completes the backup quickly without being plugged in or locking (but I don't have a lot to backup).
2: Locked just means the lock screen is on (press the sleep/wake button on top) -- it will work without a passcode (& again, the lock screen on is only required for the automatic backup).
3: You can see what is using your storage and maybe reduce some of it so that you don't have to pay for storage. Instructions in Manage your iCloud storage - Apple Support

HT5299 can two computer monitors plug into the mac?

Is there a way to plug in two regular pc based monitors to the mini mac? I am looking for adaptors or something to plug in two monitors. I currently have one monitor and I used the DVI adaptor to connect it to the thunderbolt plug in thingie.
Thanks in advance for your help.
Maggie

Yeah I have the latest version of the Mac Mini with 2.5 GHz Intel Core i5. It normally comes with 4 GB 1600 MHz DDR3 memory but I upgraded it to 16 GB. I have an old monitor with two different ports one is DVi-D and the other is VGA input - DVI A.
SORRY FOR CAPS MY KEYBOARD IS STUCK ON CAPS- THAT IS WHAT I GET FOR USING PC WIRELSS KEYBOARD BLAH....
ANYWAY I WILL HAVE TO GET A DVI-D CONNECTOR CABLE TO PLUG INTO MY HDMI ADAPTOR TO PLUG INTO THE MAC.
THANKS FOR YOUR HELP AGAIN SORRY FOR THE CAPS
MAGGIE

IN FRANCE WHAT DO I PLUG INTO, a converter or just plug?

Similar Messages

Maybe you are looking for