Instaling Iphone in car sound system to answer calls

Is it possible to install the iPhone with the sound system of the car, to be able to answer phone calls? Is this complicated?

Yes, it is possible. Like the above poster mentioned, though, it depends on the Bluetooth of your car, and if it's compatible with the iPhone.
I personally have had my iPhone 3G connected via bluetooth with my car, but it was a mediocre experience. Perhaps you will have better results.
As for the complexity of pairing your phone, it depends more on your car's system. Consult your car's user manual for guiding you through the bluetooth pairing process.

Similar Messages

  • Connect Iphone to car radio system

    I try to find a way to connect my Iphone to my car radio. I wan to listen my mp3 and use my phone with the car radio system.
    annuaire et actualité

    There are many ways to do this (I use the MonsterCable ipod adapter in rental cars, and the Pioneer Ipod Interface for my P7500DVDII) both with decent results. (great results if you turn on airplane mode). All GSM phones can effect stereo equipment to some degree, and the iphone is no exception. Alot of the 3rd party kits do not use shielded connections which just makes the problem that much more obvious. I found if I adjust the location of my phone in relation to the transmitter and the radio the Monster fm modulator gives satisfactory results without disabling my ability to recieve phone calls. The pioneer is the best, however I can't place the phone in the holder which was installed with the kit since it is in the DIN above the stereo (VW Jetta) and the phone constantly interferes with the amplification circuits. Moving the phone 3-4 inches fixes it.

  • HT3310 Connecting new iPhone 5 to sound system.

    I just got new iphone 5's.  i also have several "computer sound systems" throughout our home we connect our phones and iPads to.  The new 5's wont play when connected.  Is there an adapter now required for this? 

    These are computer amplified speaker systems you would hook up to you desktop computer using a mini audio cable usually supplied with the system.  The mini cable ends plug into the old iPhone 4's and the iPads and allow the music to be heard like a good stereo system.  The cable fits into the new iPhone 5, but no sound is played.  Is this any clearer?

  • Connexion with a car sound system

    Hello
    I have no problems when I plug my Nano on my house sound system.When I try to connect it to my car system (mini jack to mini jack) : The sound is very 'poor' and I don't listen clearly the voice.
    What do you think ?
    Is it a question of cable, configuration on the Nano or on my car system ?
    Thanks in advance for your help !
    PC   Windows XP Pro  

    Same here in my Mazda 3. *****!

  • HT204368 i connect my iphone into car bluetooth but its answering automaticly after 3rd ring how to make it manually

    I connected my Iphone 5 with my car Bluetooth but its answering automatically, how I can set it to answer manually?

    I should also point out that when I connect my iPhone, it DOESN'T appear as a connected drive on the desktop. Not sure how this can be so, since the iPhone also has a drive and also functions as an iPod if I want it to. I must have changed some setting to achieve this non-appearance, but don't remember what I must have done.
    What's the secret?

  • Car sound system (tape deck)

    I was just wondering if you can get some sort of connection to connect your ipod to your cars sterio system? to be specific it is a tape player, some sort of cord like you could use with a portable cd player, you would have a tape that pluged into the headphone section of the player, does ipod have something similar, or do you have to pull out the head unit and get a new one that is compatable?

    You just need a standard cassette tape adapter. Apple sells one, Radio Shack sells them, etc. I use my old one that came with my Sony Carman (portable CD player) and it works fine.
    Like this one...
    http://tinyurl.com/yj7m25
    or...
    http://tinyurl.com/282u6o
    or...
    http://tinyurl.com/2ybe84
    You get the idea.
    Patrick

  • Can one use  the iphone with car  stereo systems as one does an ipod?

    My car has a "jack" for mpegs/ipod to interlace with the existing stereo. Is there an accessory that will allow me to use my iphone as one would an ipod with such systems?

    Dewey Cheatum,
    Apple doesn't make most of the adapters out there. Instead Apple provides the specifications so that other manufacturer's can make products that are labeled as "Works with iPhone".
    I would contact the manufacturer of the car stereo to see if they have one that is certified by them to meet the "Works with iPhone" standard. If the radio came with the car, then the dealer and car manufacturer would be the resource to utilize.
    This link described how manufacturer's can get their products labeled as "Made for iPod" or "Works with iPhone".
    http://developer.apple.com/ipod/accessories.html
    Hope this helps,
    Nathan C.

  • Iphone 4 no sound at all during calls

    I recently purchased an iPhone 4. I found that everything was working great, apps worked sound worked and music etc. I was very happy with my purchase until i made my first phone call. Whenever i recieve or make a phone call there is no sound apart from a faint crackling at all. The person on the other end can not hear me ether. It doesn't work when the headphones are in or when it is on load speaker also, which is making me believe it is a software issue, not a hardware issue? I have read that when making calls the phone uses seperate speakers, but surely this wouldn't affect headphones and loud speaker as well?
    I have restored many times on 5.0.1 with no luck, rebooted, reset settings and nothing seems to work. There is no way i can downgrade to see if it is software issue :/
    I can't take it to apple because the warrenty has ran out.
    If anyone can offer any help it would be greatly appreciated!!

    Seems like your choices are to either restore as new (see http://support.apple.com/kb/HT4137) or have the Apple Store evaluate it to see if it's a hardware issue first.  If you choose to restore as new be sure to save any Camera Roll photos to your computer (see http://support.apple.com/kb/HT4083) and backup your contacts, either in a supported client (Outlook 2003/2007/2010, Mac Address Book, etc) or using an app like My Contacts Backup, before wiping your phone since these are not included in your iTunes library.  Good luck!

  • HT1665 how can I connect my iphone 4S to my car stereo system?

    I'd like to be able to listen to my itunes from my iphone 4s through my car sound system. Is there an accessory that I need for the connection? How do I do this?

    any minijack to aux cable would work depending on your car sound system

  • Need help Using iphone5 with Bluetooth in 2006 Volvo xc90. I have paired my phone and can make calls. I want to play music on my iPhone using the car's sounds system.

    I have just purchased a 2006 Volvo with Bluetooth. I have paired my phone with the car to make phone calls. I don't have a way to play my iTunes music through the cars audio system. Is there a special auxiliary adapter that I need to buy?

    Nobody have notice this problem or have a tip for that?

  • IPhone 3GS and Nissan 2010 Bose Sound System Issue

    I have a 2010 Nissan Altima Coupe with a Bose sound system and iPod intergration. Until recently everything worked well with my iPhone 3G S, however now on occasion, the iPod function stops dead in the middle of a book or sound. When I turn the power on an off, the car iPod system is still locked. The other functions of the sound system like regular and sattellite radio work fine. When I disconnent the iPhone there is a "Check Device" message on the car system screen. The only way to unfreeze the system is to turn of the ignition and restart the car. It seemed to start doing this after I installed the iPhone iOS4 upgrade last month. Anyone else seeing this?

    Same here. Brand new Nissan Altima Coupe with the Bose PY05F premium sound system. Stuttering, staggering and flat out freezes up.

  • I have an Iphone 6 plus. Can the bluetooth connect to the cars speaker system and a Garmin HUD unit at the same time?

    I have an Iphone 6 plus. Can the bluetooth connect to the cars speaker system and a Garmin HUD unit at the same time?

    Hi,
    Normally yes, Bluetooth can connect to multiple devices at the same time, so yes.
    The only thing is that you'll be able to send sound/music to only one at a time, but I understand the Garmin HUD doesn't play sounds.
    cheers

  • IPhone 5S with ios8 fail to connect my Bluetooth car audio system

    Dear apple users and developers,
    I have read many threads about this issue mostly for iPhone 5 (ok i have the 5S) perhaps this makes a difference. With the ios7 i had no issue and always connected to my MHV-8300BT Pioneer device in my car. After update, when i get connected, i says "Calling My number" and when i push the button on my device to answer it drops the line, it keeps the connection but i do not hear, speak. Then i have to change the source voice system and i set the speaker or the iPhone.
    On my fathers Bluetooth, a Motorola, it works, at the beginning i made a reset only for the Network settings,
    Do not know what else to do
    Thanks for reading my post
    Nikos

    Hi MJM 1,
    If you are having issues pairing your iPhone 5s to your car audio system via Bluetooth, you may find the following articles helpful (the first article also includes instructions on removing paired devices):
    iOS: Third-party Bluetooth accessories
    http://support.apple.com/kb/ht1664
    iOS: Troubleshooting car stereo connections
    http://support.apple.com/kb/ts3581
    Regards,
    - Brenden

  • My sound system does not work AFTER installing pc to tv wireless connection

    my sound system does not work after installing hp pc to tv wireles device when I am using lap top for other purposes.

    Hi,
    You don’t install VS2010 on the client PC, then where did the Form Invoice not work? When you run it from another version of VS? Or when you run the application with application.exe?
    Based on your description, one form works well, another form does not. I assume that two forms are in two different projects, then please check the .Net Framework used by the two projects. If they are different, you can use the
    one used by the Form contact for Form Invoice.
    Because this issue is a project issue, I recommend you to consult it on some application forum such as Windows Forms General forum for better support.
    VS General Question forum mainly discusses
    the usage of Visual Studio IDE such as
    WPF & SL designer, Visual Studio Guidance Automation Toolkit, Developer Documentation and Help
    System and Visual Studio Editor.
    Thanks,
    We are trying to better understand customer views on social support experience, so your participation in this interview project would be greatly appreciated if you have time. Thanks for helping make community forums a great place.
    Click
    HERE to participate the survey.

  • Iphone 6 iOS 8.1 no longer playing properly with car audio system

    Hi there,
    I have an iphone 6 running ios 8.1 and it is no longer allowing me to play/pause songs through the car's audio system. I have a USB port in the car that allows me to plug my iphone in and control the Music through the car audio system.
    I have a 2011 Holden Cruze.
    Prior to the iOS upgrade, the function worked fine.
    Bluetooth connectivity is still OK and if I control the music via the iPhone it will play.
    Is anyone else having this issue and are apple aware of it?
    Thanks.

    Hi Darren,
    I'm experiencing the exact same issue with my Volkswagen Golf 2015. Since the update I'm unable to use the play/pause button. When I press the button while my phone is connected through the MDI cable it does nothing. But if I use Bluetooth I can control it without issue. That said, in my car I don't want to use Bluetooth while I'm playing music because I want to charge my iPhone at the same time so I need to use the cable. I think this is a really issue and Apple should advise.
    Update:
    I did a full restore without using a backup of my old phone. Oh surprise... It seems to work now. But the worst now, is that I have this album of U2 showing in my playlist. I don't know if it's related, but that album was not showing when I used my back-up the first time. Seriously, I think Apple succeed at messing up enough with iOS 8.1 and this U2 album to break the playlist and the playback functionality with cars and radios.
    To resolve the issue I tried:
    Restore to iOS 8.1 with back-up - FAILED
    Restore to iOS 8.1 without using any back-up - SUCCEED but fail at the same time because I need to re-setup my iPhone manually and try to get rid of this U2 album.

Maybe you are looking for

  • How do I stop a blinking cursor?

    I have a blinking cursor/mouse pointer when I am using Firefox for the past two or three days. The blinking cursor only happens when I surf; all other programs do not have this problem. I have the latest version of Firefox installed (17.0.1). Using t

  • Inkjet 1100 wont print photos and graphics on windows 7 64bit

    Hi, I have installed the alternative driver inkjet 1000 for inkjet 1100 because there is no 64bit driver available. Sometimes ago the printer worked well in Windows 7 64bit. I don't know when the problem first occured, maybe after installation of IE

  • HT4236 Photo sync missing in new iTunes

    I just downloaded the latest version of iTunes, and the BOOKS and PHOTOS tabs no longer exist. See white X in below screenshot.  iTUNES U is the last one.How do I sync my photos?

  • Chase Banking app not supported on Windows Phone

    I used to check my bank account on my Nokia Lumia 925 smartphone, but it is no longer available. I asked at my local Chase Bank and was told that Microsoft no longer wanted to support this app. This is a major inconvenience for me, enough for me to c

  • Bex to ECC/CRM via key field

    Hi We have a unique requirement of trigerring a ECC/CRM transaction screen from Bex report when the user clicks on context menu or a key field. Ex BP Number. We are using ECC 6.0 and CRM 5.0 Any sugesstion ideas on how to go about doing it. Thanks