Installation rollback of Elements 10; nothing seems to work
Windows 7 64 bit, AMD PhenomII, 8 GBRAM.
Trying to install Photoshop Elements 10 (purchased in the store, DVD); every attempt results in something going wrong
with Shared Technologies and then it all rolls back.
I have followed many suggestions on the board to no avail, including:
1. turning off Norton entirely.
2. uninstalling other Adobe software
3. installing the ST installer independently
4. installing from the c drive rather than the DVD.
None of these result in success. And to top it off, the Adobe Support Advisor generates NO information on
the failed installations.
What do I do now? Anything... please!
Please try the solution mentioned on <http://helpx.adobe.com/photoshop-elements/kb/troubleshoot-installation-photoshop-elements- premiere.html>
Also look once at <http://feedback.photoshop.com/photoshop_family/topics/what_is_the_best_way_to_get_help_dow nloading_installing_or_activating_my_product>
Thanks
Andaleeb
Similar Messages
-
Regarding Pages: I was writing using the app Pages when I left the page I was writting on but now I can't access it at all. I have tried to send the document to my email, I've tried to make a copy but nothing seems to work. The document still exists and I can see my writting as I can with all other documents but I can't open that page.
Try:
- Reset the iOS device. Nothing will be lost
Reset iOS device: Hold down the On/Off button and the Home button at the same time for at
least ten seconds, until the Apple logo appears.
- Connect the iPad to your computer and try to get the document via File sharing
- Try getting the document from iCloud.com if you are using iCloud -
My ipod (version 6.1.3) was connectiong to my home wi-fi just fine until I uploaded new music from my itunes via my laptop. Now my ipod and my iphone will not connect to my wireless network. I've uplugged my wireless network and reset my network settings etc... nothing seems to work. Please help!
Does the iOS devices connect to other networks?
Does the iOS devices see the network?
Any error messages?
Do other devices now connect?
Did the iOS device connect before?
Try the following to rule out a software problem:
- Reset the iOS device. Nothing will be lost
Reset iOS device: Hold down the On/Off button and the Home button at the same time for at
least ten seconds, until the Apple logo appears.
- Power off and then back on the router
- Reset network settings: Settings>General>Reset>Reset Network Settings
- iOS: Troubleshooting Wi-Fi networks and connections
- Wi-Fi: Unable to connect to an 802.11n Wi-Fi network
- iOS: Recommended settings for Wi-Fi routers and access points
- Restore from backup. See:
iOS: How to back up
- Restore to factory settings/new iOS device.
If still problem make an appointment at the Genius Bar of an Apple store since it appears you have a hardware problem.
Apple Retail Store - Genius Bar
Since both iPhone and iPod stopped connecting I suspect a problem with your network. -
I have recently bought a new laptop with windows 7 and when i have tried to install and open itunes i keep getting the message 'itunes has stopped working' itunes then shuts down before i can do anything to fix it. This happens every time I try to open itunes. I have tried uninstalling itunes and reinstalling it, starting itunes in safe mode. Nothing seems to work. Please can anyone help.
If and when I finally manage to open it, as soon as I click on a movie to watch, the message "itunes has stopped working" comes up.
Try the following user tip with that one:
iTunes for Windows 10.7.0.21: "iTunes has stopped working" error messages when playing videos, video podcasts, movies and TV shows -
Every time I open lightroom I get a pop up message saying "Lightroom encountered an error when reading from its preview cache and needs to quit" and it closes. Ive already tried reinstalling, nothing seems to work. Help please!
Open the folder containing your catalog. In that folder you will find another folder with the extension .lrdata, and you need to delete that folder. After you do that, Lightroom should start normally and will create a new preview cache.
-
My Apple TV willl no longer access my "owner's library" in iTunes. It had been working just fine... then nothing. I've been checking discussions, and trying suggestions, but nothing seems to work.
Have you restarted everything including your router?
Don't suppose you've added any new security software or firewalls to the computer? -
Error 21, I have tried everything, nothing seems to work
Today I tried to upgrade my iPhone's firmware to 5.0.1 but ERROR 21 came up so I tried everything to fix it but nothing seems to work at all. Plus my iPhone is on DFU mode so I can not use it either.
Please help me.What security software is running on your computer? Try to change the sercurity software settings or remove it.
Take a look at this Apple article -> iTunes: Specific update-and-restore error messages and advanced troubleshooting
Error 20, 21, 34, 37: These errors typically occur when security software interferes with the restore and update process. If you are using a PC, follow this article to resolve this issue. -
when i plug in my ipod nano (6th generation) a message on itunes saying the ipod is 'detected but not identified'- i've spent all day trying to fix it and nothing seems to work so i can't sync any songs..
Hello beafraser,
Here's an article to help troubleshoot when your iPod is detected but not identified.
iPod nano: Error message saying that iPod 'could not be identified properly'
http://support.apple.com/kb/ts3218
Hope that helps.
Thank you for visiting Apple Support Communities.
Nubz -
A few days ago i small piece of plastic got stuck and subsequently fell out the charger hole of my ipod classic, although it still connects to itunes and syncs itunes says it has synced but there is nothing on my ipod! I have done this a few times and nothing seems to work! HELP! :/
Transfer all of your content to the computer:
Tunes Store: Transferring purchases from your iPhone, iPad, or iPod to a computer
http://support.apple.com/kb/HT1848
Then try turning the device off and on again. I'd leave it off for 10-15 minutes, but that is up to you:
http://support.apple.com/kb/HT1430
If the item is still there, you may need to restore the device:
http://support.apple.com/kb/HT1414
Hope that helps . Worst case scenario, you may need to write into iTunes support to see if they can also help!! -
I can no longer receive or send email via my Yahoo account from my iphone6. I've downloaded several "help guides" from the internet, deleted and re-added the account via imap settings. Nothing seems to work. Any ideas?
Use the yahoo app if available?
-
I have tried everything, but still I can't locate the photos tab in iTunes...I have tried changing the resolution, started iTunes after connecting with the ipad2, nothing seems to work! please advise!
I am also providing you with a screenshot of what appears! I need photos on my iPad2
Message was edited by: anganaYou don't see it on the left-hand side of iTunes - you need to connect and select the iPad on the left-hand side, and then one of the tabs on the right-hand side that you use to select which content to sync to the iPad should be Photos : http://support.apple.com/kb/HT4236
You will need to select and sync all the photos that you want on the iPad together in one go as only the most recent sync remains on the iPad, not including photos in a subsequent sync is how you delete them from it. -
I am trying to backup the movies and TV show that I purchase from Itunes onto a cd or DVD, and nothing seems to work. I tried using CD-R, CD+R, DVD-R, DVD+R, DVD-RW and DVD+RW and they all failed. Is it possible to back up to an external hard drive instead of a CD?
TylerI know this isn't a complete answer because I am not sure why or if your backups to CD/DVD are not working, but one thing I do know is yes you indeed can backup any of your iTunes Media (music, movies, tv shows, podcasts, etc.) to an external hard drive. In fact, it's recommended that you do this anyway (in case of a hard drive crash, computer being stolen, etc.)
You can manually back up your movies by finding them in your iTunes Media folder, or since you have a Mac you can just use Time Machine, which will automatically back up either your entire computer (or only certain folders and items if you want). It's pretty handy. I use a 1TB external and Time Machine to keep everything backed up including my iTunes -
I cannot get scrabble to work on my ipod touch. It only works on my macbook. I've uploaded, deleted, reloaded and nothing seems to work. It asks for a password but will not let me in. Anyone else have this problem?
Hi BDAqua,
I can go to /System/Library/Frameworks/, but JavaVM.framework/Versions/A/JavaVM does not exist!
Hi Linc,
I have already downloaded that updater, and it says 'A newer version of this package is already installed' -
i am not able to set up my ipad2 - tried the regular apple help - did all those routines - but nothing seems to working. itune simply wont detect the ipad
http://support.apple.com/kb/TS1538
-
help!!! i am unable to connect to a wifi network and ive tried everything but nothing seems to work!!! can someone help pls
try connecting to another wifi network to isolate the issue. at this point it's impossible to tell if it's your phone or your network
Maybe you are looking for
-
Java Add-In installation on a existing ABAP System (MSCS Cluster)
Hi all we try to install a Java Add-In for a already existing ABAP System with SAPinst. The ABAP System is a NetWeaver2004s SR1 System in a MSCS Cluster. We have the Problem that we can´t choose the Installation Drive during the SAPInst Define Parame
-
Premeire Elements 13 - can't import files into Project Assets, Expert Mode. Win8.1
Hello there - I've tried uninstalling/reinstalling. Can't seem to figure this out. In other computers, I have imported files into the Project Assets area to "pre-edit" before adding to timeline. I can add media directly to timeline in Quick Mode,
-
Measuring using Adobe Reader x
How do I measure area and linear footage in Adobe Reader X? When I select Tool, the drop down menu does not have any measuring tools. Also, I can only save the drawings as Adobe PDF file.
-
Need a Little Help embedding a Hyper Link in Report based on Dynamic SQL
I am trying to have a column in my report link to a document on my network when the column in the report is clicked. I have a table that contains a row for each document I want to link to. The URL to the document is stored in a column named NDDL.DOC_
-
BUG: import from elements leads to broken directory structure
I want to migrate from Elements 4 to Lightroom. When I start the "Import from elements" function in Lightroom the original folder structure is not presented correctly. I'm sorry, but my directory structure in Elements is not homogeneous. Most directo