Installing flash on new pc, but only getting a blank installation screene

Trying to install in new pc, but when I click on the download, the setup runs - but the installation screen pops up but stays blank. Nothing happens thereafter.
I've tried IE, Chrome, and Firefox. Lost.

Hello,
We have received numerous reports of this behaviour, but have been unable to reproduce.  You can bypass the online installers by using the offline installer posted at the bottom of the Installation problems | Flash Player | Windows page.
@taco1085,
You indicate the problem began for you after installing a critical update.  Do you recall which update this was?
Thank you in advance.
Maria

Similar Messages

Maybe you are looking for

  • All my photos have disappeared from iphoto!!! I can find them in spotlight

    Hello All! Help! I was importing photos from a compact flash card into iphoto which was successful. I powered down for the night, the next time I opened up iphoto my entire library seemed to have disappeared(about 5000 images!) All that was left was

  • Starting Photoshop CC/mini bridge is returning an error message

    With Bridge CC open, I select Browse in Mini Bridge and receive the following: "Cannot complete the command because the extension could not be loaded" Photoshop CS6 works fine, but this is with Photoshop CC.

  • What is the best way to take care of the battery?

    What is the best way to charge and use the battery so it lasts the longest over time? Does wall charger versus USB make a difference? Does topping off versus draining make a difference? Thanks!

  • Creating thumbnail images and storing it as gif or jpg

    Hi all, Iam new to this forum. I need a solution for the problem iam facing in building my site. I have groups and briefcase section in my site. I allow users to upload files and pictures. When they upload pictures i need to create thumbnail for them

  • Problem in Dynamic Where clause..

    Hello All, I have a requirement in which i have to do a select statement where (Field1 = 'X') and (Field2 = 'A' or Field2 = 'B'). But if i write it directly, select * from Ztable into table itab where Field1 = 'X' and Field2 = 'A' or Field2 = 'B'. Th