Installing iTunes 11.0 error message
When I try to update to 11.0 I keep getting this message.
There is a problem with this window installer package. A program run as part of the setup did not finish as expected. Contact your support personnel or package vendor.
I've tried several times....Help, what is the problem.
Try the following user tip:
"There is a problem with this Windows Installer package ..." error messages when installing iTunes for Windows
Similar Messages
-
Every time I try to install iTunes i get error message 2329.
Every time I try to install iTunes i get error message 2329. This is really ticking me off and I would appreciate any help.
Here is an article from the apple support website that might help out.
http://support.apple.com/kb/HT1926?viewlocale=en_US -
Unable to fully install itunes due to error message
I have been trying to install itunes and when I get about three quarters of the way in an error screen pops up telling me that I have an error writing to the file C:/Documents and Settings/All users/Application Data/.../GEARAspiWDM.inf and telling me I need to verify that I have access to this directory. How do I find that file and fix this problem so that I can fully install itunes?
an error screen pops up telling me that I have an error writing to the file C:/Documents and Settings/All users/Application Data/.../GEARAspiWDM.inf and telling me I need to verify that I have access to this directory.
Quite often those messages are caused by disk/file damage rather than a genuine permissions problem.
Try running a chkdsk over your C drive. There's instructions and a guided help in the following Microsoft document:
[How to perform disk error checking in Windows XP|http://support.microsoft.com/kb/315265]
Does the chkdsk find/repair any damage? If so, can you now get your iTunes install to go through properly? -
Unable to install itunes again- getting error message
I'm getting this error message : Service 'Apple Mobile Device' (Apple Mobile Device) failed to start. Verify that you have sufficient privileges to start system services. as I install itunes. I've tried multiple times and no joy.
Hey Kirakitty!
Here is an article that will help you troubleshoot this issue with your Apple Mobile Device Service:
How to restart the Apple Mobile Device Service (AMDS) on Windows
http://support.apple.com/kb/ts1567
Take care, and thanks for visiting the Apple Support Communities.
-Braden -
Installing itunes 8.0 - error messages
Frustrated ! I have been trying to install iTunes 8.0, but keep getting the following error message - C:\Documents and settings\martin bonner\local settings\temporary internet files\content.IE5\DI5KIOYZ\iTunes801Setup[1]exe is not a valid Win 32 application.
I have removed itunes from my programs files.
Probably a simple solution - can anyone help ? Thanks.Have you had a look at this troubleshooting page? It may be of some help: iTunes: Windows reports that iTunesSetup.exe is not a "valid Win32 application"
-
I cannot install itunes. The error message telss me I need a CD
I am unable to install itunes 10.5. I am asked for the CD to provide a needed file. I cannot uninstall the prior version of itunes.
Hey sndlot,
Follow the steps in this link to resolve the issue:
iTunes 11.1.4 for Windows: Unable to install or open
http://support.apple.com/kb/TS5376
When you uninstall, the items you uninstall and the order in which you do so arearticularly important:
Use the Control Panel to uninstall iTunes and related software components in the following order and then restart your computer:
iTunes
Apple Software Update
Apple Mobile Device Support
Bonjour
Apple Application Support (iTunes 9 or later)
Important: Uninstalling these components in a different order, or only uninstalling some of these components may have unintended affects.
Let us know if following that article and uninstalling those components in that order helped the situation.
Regards,
Delgadoh -
Having trouble installing itunes, keep getting error message R6034
I'm trying to install i-tunes and I keep getting a runtime errorr message and a windows message. Does anyone have suggestions on how I can re-install i-tunes?
Hi kstnza,
Thanks for using Apple Support Communities. This article has steps you can take for the errors you're seeing:
iTunes 11.1.4 for Windows: Unable to install or open
http://support.apple.com/kb/TS5376
Cheers,
- Ari -
Please help
For general advice see Troubleshooting issues with iTunes for Windows updates.
The section Install missing components may allow you to install Apple Application Support.
The steps in the second box are a guide to removing everything related to iTunes and then rebuilding it which is often a good starting point unless the symptoms indicate a more specific approach. Review the other boxes and the list of support documents further down the page in case one of them applies.
Your library should be unaffected by these steps but there is backup and recovery advice elsewhere in the user tip.
If the advice above doesn't resolve things you could try this alternate version:
iTunes 12.1.0.71 for Windows (64-bit - for older video cards) - itunes64setup.exe (2015-01-28)
which is a 64-bit installer for the 32-bit version of the core application, similar to previous 64-bit releases.
Or roll back to the previous build:
iTunes 12.0.1.26 for Windows (32-bit) - iTunesSetup.exe (2014-10-16)
iTunes 12.0.1.26 for Windows (64-bit) - iTunes64Setup.exe (2014-10-16)
tt2 -
this is really frustrating ive been googling for hours trying to find the solution! any help would be greatly appreciated. I have windows 7 and the newest gen ipod nano
For general advice see Troubleshooting issues with iTunes for Windows updates.
The steps in the second box are a guide to removing everything related to iTunes and then rebuilding it which is often a good starting point unless the symptoms indicate a more specific approach. Review the other boxes and the list of support documents further down the page in case one of them applies.
Your library should be unaffected by these steps but there is backup and recovery advice elsewhere in the user tip.
tt2 -
iTunes installation problem. Please help. ituneslibary.itel cannot be read because it was created by a newer version of iTunes. Just downloaded iTunes what new version are they talking about? Thanks
See Empty/corrupt iTunes library after upgrade/crash and Troubleshooting issues with iTunes for Windows updates.
tt2 -
Cannot install itunes Keep getting this message:An error occured during the installation of assembly 'Microsoft .VC80.CRT .type="win32" ,version="8.0.50727.6195".publicKeyToken="1fc8b3b9a1e18e3b".processorArchitectu re="x86"'. Please refer to Help and sup
These ones are typically caused by underlying problems on the PC that also often cause Windows Updates to fail to install. If we can fix the Windows Update trouble, we can usually get the iTunes trouble cleaned up en passant.
Go into your Windows update and try to check for new updates. If updates install, stock up on the ones you're behind on, restarting the PC if requested to do so. After the restart, try installing iTunes again. Does it go through this time for you?
If windows updates fail to install, go into your Update History and doubleclick the failures. What alphanumeric codes appear for you? (For example, 8007000B.) -
How do i restore my iphone from "no Service". I tried to update my iphone 3G TO iOS 6.0. But it got stuck and now my itunes is displaying Error message: "there is no sim card installed in the iphone you are attempting to activate" and my iphone is without service. While i am trying to activate my ihone on wifi also it doesnt saying servers are temporary unavailable try after sometime. Kindly suggest
It sounds a lot like your phone was hacked or jailbroken to unlock it prior to your trying to update it.
If that is the case, it is nowpermanently bricked. -
How do i restore my iphone from "no Service". I tried to update my iphone 3G TO iOS 6.0. But it got stuck and now my itunes is displaying Error message: "there is no sim card installed in the iphone you are attempting to activate" and my iphone is without service. While i am trying to activate my ihone on wifi also it doesnt saying servers are temporary unavailable try after sometime. Kindly suggest
tariqrehmani wrote:
How do i restore my iphone from "no Service". I tried to update my iphone 3G TO iOS 6.0. ...
The iPhone 3G is Not Compatible with iOS 6...
It also appears that your phone may have been Hacked and / or Jailbroken...
If this is the case... you are out of luck... Because...
The discussion of Jailbroken Devices is against the Terms of Use of this Forum.
Why Jailbreak is Not Supported > http://support.apple.com/kb/HT3743 -
I was today invited to upgrade my iTunes when I logged on. Update failed. Every time I now try to open iTunes I get error messages. Second message reads "iTunes was not installed correctly. Please re-install iTunes. Error 7. Windows error 126". I now can't sync my iPhoneand I am worried that if I re-install I will lose all my contacts,calendar, notes, etc.
I too had this problems (Windows 8.1). A few weeks ago after the previous update before this version of itunes, I'd had a problem with the itunes store crashing and at that time I followed instructions to copy QTMovieWin.dll to the itunes folder, which fixed the store crashing.
Today I fixed the problem by:
Delete QTMovieWin.dll from C:\Program Files (x86)\iTunes.
Uninstall ALL Apple Software using Control Panel / Programs and Features. I uninstalled:
iTunes
QuickTime
Apple Mobile Device Support
Apple Application Support
Apple Software Update
Bonjour
Delete the folders:
C:\Program Files (x86)\iTunes
C:\Program Files (x86)\Common Files\Apple
Restart the computer
Reinstall QuickTime
Reinstall iTunes
Everything works GREAT now, including the iTunes store. You will not lose your media files, I got everything back, all my settings, playlists, etc. -
and when i try to Re-install itunes i get a message from itunes ERROR 7 (windows error 1114), now how do i sort this out ???
Hey deepakmenonfrompune,
Thanks for the question. I understand that you are experiencing issues with iTunes for Windows. The following resource may help to resolve your issue:
iTunes 11.1.4 for Windows: Unable to install or open
http://support.apple.com/kb/TS5376
Some Windows customers may experience installation issues while trying to install or open iTunes 11.1.4.
Symptoms may include:
"The program can't start because MSVCR80.dll is missing from your computer"
"iTunes was not installed correctly. Please reinstall iTunes. Error 7 (Windows Error 126)”
"Runtime Error: R6034 - An application has made an attempt to load the C runtime library incorrectly"
"Entry point not found: videoTracks@QTMovie@@QBE?AV?$Vector@V?$RefPtr@VQTTrack@@@***@@$0A@VCrashOnOverf low@@***@@XZ could not be located in the dynamic link library C:\Program Files(x86)\Common Files\Apple\Apple Application Support\WebKit.dll”
Resolution
Follow these steps to resolve the issue:
Check for .dll files
1. Go to C:\Program Files (x86)\iTunes and C:\Program Files\iTunes and look for .dll files.
2. If you find QTMovie.DLL, or any other .dll files, move them to the desktop.
3. Reboot your computer.
Note: Depending on your operating system, you may only have one of the listed paths.
Uninstall and reinstall iTunes
1. Uninstall iTunes and all of its related components.
2. Reboot your computer. If you can't uninstall a piece of Apple software, try using theMicrosoft Program Install and Uninstall Utility.
3. Re-download and reinstall iTunes 11.1.4.
Thanks,
Matt M.
Maybe you are looking for
-
REPORT GROUP tcode: gr52
I have created a custom program and added it to a standard report group in GR52. But when i execute the Main Report group and try to drill down to the custom transaction code. The sy-tcode is still START_REPORT. Is there a setting i am missing when c
-
10.3.1.3 Bpel Console Problem
Hi, i have installed the new patch set for upgrading my 10.1.3.1 server to 10.1.3.3.When i try to open my BPELConsole , it gives me the followign error: Oracle BPEL Process Manager Full Cycle An unexpected error has occurred while executing your requ
-
Hello, I want to know about form generators for UDO. The default forms generated when we create our UDO contains only a grid, this forms are very simple and not very useful for big applications. My question is there is any form generator that allow u
-
Jquery Cycle 2 (Options)
I am working on Cycle 2 Slider that is beginning good--(Image, Heading, and Text on one slide). (I have some more styles I may style it with), Before that I am trying to get certain 'Options' to work with the slider ; namely PAGER BASIC, PREV/NEXT, a
-
Safari (and others) not loading pages, DNS issue?
Hi, folks. I've got a Macbook Pro running OSX 10.6.8 and Safari 5.1. A week ago Safari (and Firefox, and Chrome) all stopped completely loading web pages. Sometimes I get a partial page load, sometimes I get a blank page and eternally spinning loadin