Installlatest flash-says installation sucessful-go back to view video and doesn't work

adobe flash?
install- says sucessful- back to view and syas i must inatsll flash to view?

What is your operating system, version & edition?
What is your web browser?

Similar Messages

Adobe Flash will not update to a W-2000 system and will not work? Is there a fix? Mozilla has disabled Flash. Do I have to go back to Explore?

Adobe Flash will not update to a W-2000 system and will not work in Firefox? Is there a fix? Mozilla has disabled Flash. Do I have to go back to Explore?

have you tried to install flash
restart imac
go to web site which require flash

Since I downloaded the upgraded software, my charger that came with my phone says "this cable or accessory is not certified and may not work reliably with this iphone" It worked before but now it doesn't...I don't think I should have to buy a new one...

since I upgraded to the new operating system my charger no longer works...
It says"this cable or accessory is not certified and may not work reliably with this iPhone"

Try checking your cable socket/lightning cable for dirt, grime, pocket lint, etc. I could not find the solution to this issue myself and after much searching I found someone stating that cleaning this out helped them immensely.
After taking a wooden toothpick (making sure the phone was OFF first) and gently clearing out the edges and inside of the lightning socket this went away.) It is worth noting that I had a significant amount of dust or lint buildup along the edge rails which I think was causing the iphone to believe it was plugged into something when it was not.
Try it and see, ensure you are very careful and do not use any conductive tools to clean the area in question. Compressed air also does wonders here.

I cal apple from israel i say i gat i phone5 in the philippines and it stop working the say bring it to us apple and i gat ther the say sand it to hong kong ?

i cal apple from israel i say i gat i phone5 in the philippines and it stop working the say bring it to us apple and i gat ther the say sand it to hong kong ?

iPhone warranty is valid only in country of original purchase.
If the iPhone was originally sold in the Philipines, it must be
returned to there for repair/replacement. You must take it or
send it to a friend/relative there to take to Apple repair in the
Philipines. Apple does not accept international shipments for
repair nor does Apple ship out of the country after repair.
If Apple told you that the iPhone had to go to Hong Kong for repair,
then the iPhone was originally sold in Hong Kong and then resold
to you in the Philipines. In that case, take it to Hong Kong.

I have mozilla on Mac os x, The "Back" function for to go back at a previous page doesn't work. WHY?

I have mozilla on Mac os x for about 8 months. The "Back" function, to go back on a previous page doesn't work, the "Back" arrow remains grey coloured, so it can't be pressed like when it's black coloured. It gets you tired to reopen pages all the time. WHY does this happen?
== This happened ==
Every time Firefox opened
== I first downloaded mozilla.

Go here to download Firefox 3.6:
http://www.mozilla.com/en-US/firefox/all-older.html

TS3992 How can I back up an iphone when I haven't set the phone up for back ups & the touch screen doesn't work? The phone can receive calls (not answer) & the pictures & messages can be seen but touch screen doesn't work to unlock the phone or select any

How can I back up an iphone when I haven't set the phone up for back ups & the touch screen doesn't work? The phone can receive calls (not answer) & the pictures & messages can be seen but the touch screen doesn't work to unlock the phone or select anything. We want to save/transfer pictures, contacts, and music to the replacement phone.

Try backing it up to your computer with iTunes. Connect it to your computer, open iTunes, click on the name of the phone in iTunes, go to the Summary tab of your iTunes sync settings and click Back Up Now. Also go to File>Devices>Transfer Purchases to transfer you apps and other purchased media to your iTunes library.

TS1702 My iphone wont download any apps. It lets me enter password but then the app just flicks back to the price and doesn't download. Any idea why?

My iphone wont download any apps. It lets me enter password but then the app just flicks back to the price and doesn't download. Any idea why?
It was fine until i updated to iOS 5

Have you tried:
1. Resetting your iPad; hold down the Sleep and Home button for about 10 seconds until you see the Apple logo.
2. Turn OFF your router for 30 seconds and ON again.

I dropped my phone, it says no sim card and doesn't work, where is the sim card and how can I put it back in.

Hi
I dropped my phone, now it doesn't work says no sim card. Nothing fell out, but how do I pull the sim card out, and put it back in?

See Here for Sim Card
http://support.apple.com/kb/HT2309

I cannot view videos and have downloated Adobe Flash Player several times.

I have downloaded Adobe Flash Player several times and still cannot view videos. I get the error message "you do not have Adobe Flash Player" and the screen for me to download it. Please help.

Hi,
Try the following.
First, download the Flash uninstall utility on the link below and save it to your Desktop.
Flash Player Uninstaller.
When the download has completed, close all browser windows and run the uninstaller. After this has completed, restart the notebook.
Next, ( unless you already have it ), download and install Firefox and then using Firefox, download and install the latest version of Adobe Flash. Note: You may want to deselect the option to include McAfee Security Scan Plus before downloading.
Close all browser windows before running the Flash installer.
Launch Firefox and see if the videos play Ok in this browser - if they do, close Firefox, open Internet Explorer and click on the same Adobe Flash link above to get a prompt to install the ActiveX component. When done, restart Internet Explorer.
Regards,
DP-K
****Click the White thumb to say thanks****
****Please mark Accept As Solution if it solves your problem****
****I don't work for HP****
Microsoft MVP - Windows Experience

Need to back up contacts but touchscreen doesn't work

I have a Samsung Brightside that the touchscreen doesn't work. i want to back up my contacts and can navigate to the Media Center by the slide keyboard but can't go any further

Have you had a chance to look at this troubleshooting page? If not, have a look at the bottom section that covers what to try if the message keeps reappearing: iTunes has detected an iPod in recovery mode - Use iTunes to restore
Towards the end it says "If after restoring your iPod, the message described above reappears, the iPod drive letter may need to be reassigned. See the "Change the Drive Letter" section of this document for steps to assign a different drive letter" which contains a link to this article: Windows confuses iPod with network drive

I want to update Adobe flash player on iMac,though download stops at 30% and doesn't move and finish at all,it stops completely,

I got a notice that I needed to update my adobe flash player,I go to download the file,and the download stops completely at 30% and doesn't move further,it completely pauses and doesn't finish downloading,what should I do ?
I've tried uninstalling adobe flash player and installing again and yet it stops at 30 % and doesn't download any further or finish,
and also It says that the security update on my iMac won't allow me to download adobe flash player ,what can I do to fix this ?

Please helm me, has anyone got an idea?

Back to the last menu doesn't work (bluray)

Hello!
Here's my problem: I have several menus (in different languages) that sometimes leads to the same video (for example, a button in french menu leads to the same track as a button in the german menu). I want that if the user presses "menu" his remote control, he goes back to last menu (if he comes from the french menu, I want the bluray to go back to french menu). To do that, i selected "go back to last menu" in every sequence. It works correctly when i simulize the navigation in the viewer, but when i burn the bluray, when I press menu, the disk don't even goes back to french nor german, it goes back to the main menu of the disk.
I tried to choose "go back to last menu" in the disk asset for the "title button" but it's in grey and i can't choose it.
Do someone have a solution?
Tank you,
Michaël

I used to do it manualy on DVD Studio pro because it allows to use script and to tell to your player from witch menu you come from. but here i don't how to manage the routing to five differents menus. An also, even if route correclty the link after the track, I have to find a way to go back to previous menu and not to the top menu...
I join four screen shots. You have example of 3 differents menu and the las on the bottom "viskose bitkisel" "Oreillers Visco Végétale" lead to the same track (the 4h screenshot) "oreillers memo sensitifs"

After I create a flash swf file how do I edit the video and audio?

I created a nice flash animation, but it appears there are no video editing program which edit swf files.
Why would flash create a file that cannot be edited in video editing programs including their own premiere pro?
I have to get a program to convert the swf to an flv file and then I can use a video editing program?
I tried exporting it to an avi, but much of the functionality was lost. I am looking at a man standing there instead of
moving his lips while talking, for example. Am I missing something? Please advise. Thanks!

If you have an swf file then you don't have a video to edit. You can export to a limited number of video formats from Flash. In order to do that successfully, you need to prepare your file so that it will export as you want. This means that you will have to produce the entire file as a linear sequence using the timeline and with no interactivitiy. You can use a limited amount of Actionscript, but it is a very small subset of the available language. Your audio must be in the timeline.
Here is an Adobe help file for exporting to video: Flash Professional Help | Exporting Graphics and Videos

After updating to ios 7.0.6 i keep getting an error message saying "this cable or accessory is not certified and will not work reliably with this iphone" every two minutes and its annoying

What is up with this error message after updating saying our cables are not reliable?

Thank you for this suggestion, but the message continues to display every couple of minutes. (e.g. "This cable or accessory is not certified and may not work reliably with this iPhone.)
Not only is it annoying and concerning...this is draining my battery, as the iPhone keeps waking up to display the message over and over. Like "MartinLegodi" above, I also have no cable or accessory plugged in and only use Apple cable and products when I do.
It's a disconcerting mystery.

My computer does not have the processor requirements for Flash 14. I can not play any videos or do school work. What version can I get with a processor of 2.1GHz?

I need a version of flash that will allow me to watch videos and have access to school before July 2nd. What version can I download to do this and how do I download it? I am getting frustrated.

here are older versions, Archived Flash Player versions

Installlatest flash-says installation sucessful-go back to view video and doesn't work

Similar Messages

Maybe you are looking for