IPAD 2 freezes on Shutdown and is now stuck, how do I unlock it?
Hi Folks,
My shiny new engraved iPad2 freezes during shutdown and it now stuck with spinning shutdown icon :-( I left it over night and it's still spinning 8 hours later. There's no way to force power it down and unlock it. When I connect it to itunes I get a dialog that states "unknown error occurred (0xE8000065)".
Thanks,
Tom.
Ok, I called the tech support. The solution to unfreeze the iPAD 2, is to hold down the HOME and the POWER buttons simultaneously for over 16 seconds. This will reset the iPAD and you should see the metallic Apple Logo as the iPAD basically reboots itself.
Why the iPAD got frozen in the first place is still a mystery :-( But anyhow, it's all working just fine now :-)
Thanks,
Tom.
Similar Messages
-
So I was updating iPAD and while updating it stopped and gave me a typical error message but with error 4013. It worked fine before and is now stuck in the "connect to itunes mode" recovery mode. I have tried updating and no luck. I have even tried updating in DFU mode and no luck. Anyone git any solutions
Are you following these instructions?
Disconnect the USB cable from the device, but leave the other end of the cable connected to your computer's USB port.
Turn off the device: Press and hold the Sleep/Wake button for a few seconds until the red slider appears, then slide the slider. Wait for the device to shut down.
While pressing and holding the Home button, reconnect the USB cable to the device. The device should turn on.
Continue holding the Home button until you see the Connect to iTunes screen.
iTunes will alert you that it has detected a device in recovery mode. Click OK, and then restore the device. -
Hi, my iphone 5 encountered an unknown error while updating to iOS 7 via itunes and is now stuck in recovery mode and prompts me to restore the phone when I connect it to itunes but then I would lose all my data. I DO NOT have any back ups on itunes. Is there anyway to get out of recovery mode without restoring or recover data after a restore?
Or any other suggestions please? ThanksAs pdroth said, you should have gotten a backup made when you started the update of iOS. If you cannot find a backup, and the phone is in recovery mode, there are no futher suggestions to make. To get the phone working again you have to restore. You cannot force a backup at this time since it is already in recovery mode. It will not allow anything else but a restore at this point.
-
I have never had a passcode to lock my iPad. Now that I have updated it with IOS7 it is asking for one and is locked. How do I unlock this without having to reset the whole thing through iTunes????
Unfortunately, if the iPad is insisting that you use a passcode, there is no way around it other than to restore the device using iTunes on a computer, or by erasing it in iCloud.com via Find My iPhone.
You could try resetting the iPad and cross your fingers and hope this is just a blip on the radar....hold down on the sleep and home buttons at the same time for about 10 seconds until the Apple logo appears on the screen. -
I have a web site that I subscribe to and when I pulled it up Firefox asked me if I wanted to allow it or not. Accidently I pressed never allow for this site. Opps . . How do I undo this? I tried restarting and am now stuck as I can not access my website
Do you mean saving a password?
If you clicked "Never" then you have created an exception that you need to remove.
Remove site(s) from the Exceptions:
* Tools > Options > Security: Passwords: Exceptions
* https://support.mozilla.com/kb/Remembering+passwords -
while charging ipad, not enough storage message appeared. Now ipad is locked and is unresponsive. How can I unlock ipad?
Not enough storage space. Do you backup to icloud? When you plug your ipad into charge it backs up to icloud. Your out of icloud storage. Could be the reason.
Locked....hmm... Did you try a reboot? Hold the home and power button(same time) till the screen goes black and apple logo appears. Ignore red sliders. -
My ipod touch wouln't turn on because I dropped it, so I plugged it into the computer. It went into recovery mode and is now stuck on a waiting for ipod screen. The ipod shows the apple logo and and an empty loading bar. Please help. Thank you.
Try:
- iOS: Not responding or does not turn on
- Also try DFU mode after try recovery mode
How to put iPod touch / iPhone into DFU mode « Karthik's scribblings
- If not successful and you can't fully turn the iOS device fully off, let the battery fully drain. After charging for an least an hour try the above again.
- Try on another computer
- If still not successful that usually indicates a hardware problem and an appointment at the Genius Bar of an Apple store is in order.
Apple Retail Store - Genius Bar -
I tried to remember the password for the iPod and introduced several times and is now locked How do I open the lock
iOS: Wrong passcode results in red disabled screen: http://support.apple.com/kb/HT1212
If you cannot remember the passcode, you will need to restore your device using the computer with which you last synced it. This allows you to reset your passcode and resync the data from the device (or restore from a backup). If you restore on a different computer that was never synced with the device, you will be able to unlock the device for use and remove the passcode, but your data will not be present. Refer to Updating and restoring iPhone, iPad and iPod touch software.
iOS: Unable to update or restore -
I update my iphone4 to ios7 .but my phone locked and message sim invalid.how can i unlocked it.
Hi there Kouroshiphone,
You may find the troubleshooting steps in the article below helpful.
iPhone: Troubleshooting No SIM
http://support.apple.com/kb/ts4148
-Griff W. -
HT4623 I tried to install iOS7 and am now stuck with the this message on the screen send via mail
I have hust installed iOS7 and followed all the steps. I am now stuck with a message on the screen which doesn't move. Licence agreement and when I say I agree noting happens. What am I doing wrong??
Reset iPad and start again.
Hold down the Sleep/Wake button and the Home button at the same time for at least ten seconds, until the Apple logo appears
Note: Data will not be affected. -
I would like to order more than one photo on iPhoto. I have downloaded one picture, and then my choices are cancel and buy now. I would like to download other photos to have them printed, too. How do I do that?
Wich version of iPhoto do you have? You need iPhoto '09 or '11 to order prints.
Make an album of all photos you want to order in the same order.
Then select all photos at once, when you use Share > order prints.
You should see a panel like this, where you can mark the quantities. The screenshot is from iPhoto 9.6: -
My iPad is locked and shows that Please connect iTunes since iPad has been stopped to be used. How to unlock it?
Force iPad into Recovery Mode. Follow step 1 to 6 very closely.
http://support.apple.com/kb/HT1808
Note: You may have to repeat the above a few times. -
HT1414 i phone was stolen has been recovered but is now locked, How do I unlock it ?
My I phone was stolen 3 days ago , it has now been recovered but is locked , How do I unlock it ?
Force the phone into recovery mode, as described here, and restore it:
http://support.apple.com/kb/ht1212 -
HT4623 not used for over 2 weeks now locked how do i unlock please
my i pad has locked i have been away just returned to find it has locked has anyone got ideas?
Connect your iPad to iTune (computer) and do a restore.
http://support.apple.com/kb/ht1414
Note: Data will be lost -
My i pad has frozen and has locked up, how do I unlock it?
My I-Pad has frozen and I cannot get my screen back. How can I unlock it?
Restore, if iTunes will let you. Everything except the password will be restored. Connect via cable to the computer that you use for sync. Be forewarned that it takes a long time. From iTunes, select the iPad/iPod and then select the Summary tab. Follow directions for Restore and be sure to say "yes" to the backup. You will be warned that all data (apps, music, movies, etc.) will be erased but, as the Restore finishes, you will be asked if you wish the contents of the backup to be copied to the iPad/iPod. Again, say "yes."
At the end of the basic Restore, you will be asked if you wish to sync the iPad/iPod. As before, say "yes." Note that that sync selection will disappear and the Restore will end if you do not respond within a reasonable time. If that happens, only the apps that are part of the IOS will appear on your device. Corrective action is simple - choose manual "Sync" from the bottom right of iTunes.
If you're unable to do the Restore and you have IOS-6 or lower, go into Recovery Mode per the instructions here. If you have IOS-7, read this.
Maybe you are looking for
-
Hi all, I got two query which link to together in order to get the cost, however, now I want to show on my report if there is not found in the link it will return null. What I use if the value is null in the field level however when display it still
-
Can't seem to open my world on blackberry app to enable me to create a new blackberry ID!
Helo there I have been struggling for days now, surfed the web and I just can't seem to find any answers for my problem! I don't know could it be my software that needs to be updated or what the exact problem is. I download app world with ease but th
-
I have split my domains and decided to publish one. Well everytime I publish one.....the rest go away. I get 404 error on the web. The files are also gone from iDisk. Yesterday someone posted about this: http://discussions.apple.com/message.jspa?mess
-
Organising photos in photoshop elements 11
I am new to the process. I have just downloaded hundreds of photos in their new files. Whe opening up it suggests I should do a back up. If I follow that procedure, the programme goes on a search in my laptop finding certain photos. Is this necessary
-
[Solved] Can't get MPD to work with PulseAudio
After a long time using straight Alsa I've been setting up Pulse because I want to send my laptop's audio to a networked device. So far I have audio output working (through my laptop) with everything except MPD. MPD won't output audio with Pulse ena