Ipad loses charge rapidly after IOS7 install.  It went from 100% to 80% without using it

Why does Ipad and Iphone lose charge so rapidly after the IOS7 upgrade.  I have notifications off and all apps closed. 

Perhaps these suggestions will help:
http://www.apple.com/batteries/iphone.html
also
http://theweek.com/article/index/250098/ios-7-battery-life-6-simple-ways-to-keep -your-iphone-powered-up
http://www.tuaw.com/2013/09/18/how-to-stop-ios-7-from-destroying-your-iphones-ba ttery-life/
One final unconfirmed possibility:
http://ipadnerds.com/fix-battery-drain-issue-ios-7/
Regards.

Similar Messages

  • TS1567 my ipad will not open after ios7 installed

    my ipad will not open after ios7 installed

    kerry236 wrote:
    ipad dissabled
    Connect to iTunes on the computer you usually Sync with and Restore
    http://support.apple.com/kb/HT1414
    2)  If necessary Place the Device into Recovery mode...
    http://support.apple.com/kb/ht4097
    Note on Recovery Mode.
    You may need to try this More than Once...
    Be sure to Follow ALL the Steps...
    Once you have Recovered your Device...
    Re-Sync your Content or Restore from the most Recent Backup...
    Restore from Backup
    http://support.apple.com/kb/ht1766
    NOTE:
    Make sure you have the Latest Version of iTunes Installed on your computer ( v 11.1)
    iTunes free download from www.itunes.com/download

  • Why does my ipad have old wallpaper after ios7 upgrade?

    why does my ipad have old wallpaper after ios7 upgrade?

    Hello there, SunnyGirlLori.
    The steps found in the following Knowledge Base article provide some great troubleshooting:
    iOS: An app you installed unexpectedly quits, stops responding, or won’t open
    http://support.apple.com/kb/ts1702
    Thanks for reaching out to Apple Support Communities.
    Cheers,
    Pedro.

  • Why would my iphone suddenly lose charge rapidly (6-7%/hr) with no use

    Why would my iphone suddenly lose charge rapidly (6-7%/hr) with no use?

    I had the same problem with my iPhone 5 AFTER I had upgraded to IOS.
    Did a good deal of searching on this site and others and found that the main advice being given was to turn off all apps that are running in the background (From the home screen double press the home button and a visual list of all apps running in the background will appear. To turn them off simply swipe your finger upwards on each).
    Found that this definitely solved my problem and now make sure I do this every time I use the phone.
    Hope this helps
    Les

  • After iOS7 install my iCal entries do not show "created by or edited by". Is there a fix?

    After iOS7 install my iCal entries do not show "created by or edited by" also in Twitter I can't see number of retweets or favorites, it's become invisible. Any fixes?

    Well seeing as I'm running Lion on 2 GB of RAM, I can't see how upgrading the RAM will make that much of a difference.    If you are seeing launch times in minutes, it probably indicates your cache got corrupted by some third party cache cleaning software.  To see if some corruption can be fixed, first backup your data:
    https://discussions.apple.com/docs/DOC-1992
    Then boot in safe mode, holding the shift key.  If issues persist in safe mode, run the hardware test that came with your Mac. 
    http://docs.info.apple.com/article.html?artnum=303081
    And if that is unrevealing, and booting into safe mode doesn't solve anything, and you are backed up, try repairing the directory by:
    1. Booting into the restore partition with command-R.
    2. Selecting the installer's Utilities menu.
    3. Selecting Disk Utility
    4. Selecting First Aid
    5. Selecting the boot partition.
    6. Click on repair disk (not repair permissions)
    Do NOT proceed with any install itself.  Just quit the install program
    If the disk is not able to be repaired, purchase Alsoft Disk Warrior, and boot of that to repair the directory.
    If it is able to be repaired, and the machine is still slow, I think you may have run into some RAM that is bad, and need to replace it, not add to it.
    If Disk Warrior can't repair the hard disk, replace the hard disk itself.

  • IMessage not working after IOS7 install?

    iMessage not working after IOS7 install?

    Yep, it has issues. Word is that Apple is working on an update to fix it but no idea when it'll be rolled out.

  • My Safari will not allow me to open my Google calendar with Google Apps. I have to open my email with the older version of Google Apps. This happened after I installed 5.1.4. I tried to use the fix of changing to 64 bit by unchecking the 32 bit box no go

    My Safari will not allow me to open my Google calendar with Google Apps. I have to open my email with the older version of Google Apps. This happened after I installed 5.1.4. I tried to use the fix of changing to 64 bit by unchecking the 32 bit box but that didnt help.

    I assume that there are legal restrictions on the way in which iTunes can get artwork automatically from any source apart from the iTunes Store (which is what the right-click > Get Album Artwork function uses).  For example, even though the Gracenote service that iTunes uses to match CDs and retrieve metadata (artist, album, track titles, etc.) also has artwork functions, iTunes does not make use of these.
    For manual addition of artwork, there are three cases where the image you select may not be correctly embedded in your media files:
    your media are in a format that doesn't accommodate embedded artwork - typically WAV files.  To embed artwork you'll need to convert to another format - Apple Lossless or AIFF if you want to preserve lossless quality, AAC or MP3 otherwise.
    your media files are read only - to fix this, use Windows Explorer to find the folder that contains your files, right-click and select Properties.  On the General tab there's a check box labeled "Read-only" - if this is checked, or is grey (sometimes blue), click the box so that the flag is unchecked and the box is white.  Click OK, and then OK again when the "Apply changes to this folder, subfolders and files" option selected.  Now try adding the artwork again.
    Windows permissions issues are preventing iTunes from updating your media files (there's some anecdotal evidence of a change in this behavior in iTunes 12).  See turingtest2's notes on Repair security permissions for iTunes for Windows for advice on fixing this, then try adding the artwork again.

  • Hi i have a iPod 5th gen it ran out of charge so as you would i put it on charge however after 25 mins i went over to see it and it wont turn on what so ever. I have held in the lock button and theres no sign of it turning on. Can anyone help? Thanks

    Hi i have a iPod 5th gen it ran out of charge so as you would i put it on charge however after 25 mins i went over to see it and it wont turn on what so ever. I have held in the lock button and theres no sign of it turning on. Can anyone help? Thanks

    Try:                                               
    - iOS: Not responding or does not turn on           
    - Also try DFU mode after try recovery mode
    How to put iPod touch / iPhone into DFU mode « Karthik's scribblings
    - If not successful and you can't fully turn the iOS device fully off, let the battery fully drain. After charging for an least an hour try the above again.
    - Try another cable                                                       
    - Try on another computer                                                       
    - If still not successful that usually indicates a hardware problem and an appointment at the Genius Bar of an Apple store is in order.
      Apple Retail Store - Genius Bar                              

  • Battery went from 100% to 0% and won't charge :C

    Hi guys i need some help.
    About 15min ago i was reading an article on a website when the screen 'blinked' it turned off going completly black then turned on again. Then i noticed that it said i had 0% battery but i have my MacBook Pro is plugged in right now, the battery was fully charged and its plugged in?
    So.2 problems
    1. Battery went from 100% charged to 0% in a matter of seconds WHILE PLUGGED IN.
    2. Battery is not charging at all now, just stays at 0%
    Is this a common thing? like has this happened to lots of people before and is a known issue?
    What info do i need to post up so you guys can more effectively help me? also might need to show me how to get this info.

    How old is your Mac?
    Open System Info and look at the battery section. If it says Service Battery then take the system to Apple and have it serviced.

  • Why after update Iso 5 by iPhone and not open, without using Itune. Just screen keep show apple logo for few hours already.

    Why after update Iso 5 by iPhone and not open, without using Itune. Just screen keep show apple logo for few hours already.

    Try to reset - Press both the home and on/off buttons for at least 10 seconds until the Apple logo reappears.

  • HT4623 how to unlock ipad after ios7 installed?

    How do I unlock ipad after ios7 installation?  I didn't set up a passcode, so I can't open up the ipad.

    Try the following:
    1. Restore:
    http://support.apple.com/kb/HT1414
    2. Recovery:
    http://support.apple.com/kb/HT1808

  • Why did my calendar and reminders usage climb to 10 GB after iOS7 install?

    I can't find anyone who has posted this question, or an answer.  I upgraded my iPhone and iPad to iOS7 this week.  The phone seems fine, but my iPad is giving me fits.  After the install, I got the STORAGE IS ALMOST FULL message.  When I checked, my Calendar and Reminder Usage were at 6+ GB (same data on my phone is 600MB).  I tried to turn off calendar and delete data - let it run all night, but the usage was increased to over 8GB.
    Next I did a full factory reset.  First attempt bombed out on the new iTunes update (a known problem from my google search).  I did have another computer with the older iTunes that allowed me to reset the iPad.  When I first checked usage, I was only using a total of 3GB on my 16 GB iPad.  Now, after a couple of hours of use, the Calendar and Reminders usage is over 10GB!
    Anyone have any ideas what is going on?  My settings for calendars are the same as on my iPhone 5 (my iPad is the iPad3).  I don' t want to spend the next 3 hours resetting it to find it does this again.
    Help?

    I am having the SAME EXACT problem on my iPhone. This is really taking a toll on what I am able to do. I have deleted apps i didn't want to. I barely have music on my Iphone since the update. My overall quality of life w/ this phone is taking a nose dive. Really need a solution to this. When i connect my iphone to my computer is says that my documents and data is taking up a bulk of the space; Under the usage section of the settings....my calendar is taking 7GB. Not sure how this is possible since i have nothing stored in my calendars. SMH.

  • IPad2 charging issues after iOS7 upgrade

    I recently upgraded iOS7 in my iPad 2, after the upgrade I find that the charging time has increased greatly!  Not sure if this was due to using the iPad while charging. Yesterday left iPad2 for charging all through the night and more (12-14 hrs) only to find this has charged only 3%. The charging issues seems to have degraded over time. I had atleast charged fully (100%) once after iOS7 upgrade-which also took a lot time than iOS6.
    All the charging I did was over wall Unit, with original chargers. I see from forums that this seems to be experienced by few more users. Anyone found any solution to this problem?
    I have tried resetting, switching off the iPad 2 while charging with no success. I'm now regretting having upgraded to iOS7- which I liked. This is not what I expected from Apple.

    I also have a Mac Air 2012, tried charging from Mac Air and it's now charging! Mac Air is now charging from the same wall unit location which I used for iPad 2 - so nothing wrong with the wall unit. 
    I just wish i could charge as fast from wall unit as with iOS 6.  Any further guidance is greatly appreciated.

  • Will i lose my data after re-installing my iphone ?

    Last night i updated my iphone and i was unaware that its not a Factory Unlock cellphone. Now my iphone got locked. Will i lose my data if i re-install ios or can i restore my data after re-installing ? Please help as i dont wana lose my data. 2nd i dont have backup of my data too

    If there was a backup created prior to doing the update this will be available to you after the update .
    If you did not backup the data to itunes, there may have been a back up created in icloud.
    Without a created back up from either icloud or itunes your data will be lost.

  • Stupid iPad demands security check after confirming install of new app? Why  and can I shut that of somehow  my password should be enough!

    Stupid iPad demands security check questions after confirming install of new app? Why  and can I shut that of somehow  my password should be enough!

    Judging by the number of successful password hack attempts on internet accounts of all types, clearly password security alone is not enough to verify you are the account holder to a dumb computer.
    I'm sure you'd be complaining even more about "stupid iPad" if it allowed anyone who obtained your password easy access without any kind of backup security checks, and spend money on your iTunes / App Store account.
    Apple are actively increasing the security of people's valuable iTunes accounts, not decreasing it. Why would you want to make it easier for someone to steal from you and take over your online accounts?

Maybe you are looking for

  • I have a form, now how do I make it work?

    I built a form using Dreamweaver and I know in order for the form submissions to be e-mailed to me I need to do something with PHP but I can't seem to get any help. Every site I visit offers an easy form builder which then supplies the code, but I li

  • How to create generically styled itemrenderer?

    G'day, This is my first dabble with Flex 4, after we have been using Flex 3 for the past two years. I want to style an ItemRenderer for a list. That is all cool, and the new state syntax makes it really easy for me to create transitions between state

  • How can I retrive the first sender?

    Hi Guru. So this is my scenario: JDBC_System, here starts the process, "sends" some data to a BPM. The BPM call a custom RFC in the R3_System. When the R3_System sends the response, I lost the "original sender" (in this case JDBC_System) because the

  • A button in a region position

    "a button in a region position" - hello, is it possible to place this kind of button among region items? in Button Position options i couldn't find possition i need.. thx, mariam

  • E-studio 160 network printer does not work correctly in my office network

    Hi Toshiba support team, I'v got a Toshiba e-studio 160 network printer/scanner/fax in my office and I want that everybody in the office (network) has access to the printer and scanner functions of the e-studio without using a "Server computer" which