Ipad screen has gone stripey grey and black lines .

Hi my iPad has gone stripey with black and grey lines ,and non responsive .Can anyone advise please.

Hi kon and kathy,
Welcome to Apple Support Communities.
The article linked below provides a lot of great information and troubleshooting tips that can help you resolve the display issue with your iPad.
Get help with the screen on your iPhone, iPad, or iPod touch - Apple Support
If you see lines, missing sections, discoloration, or poor image quality
Try to restart your device. If you can't restart, reset your device.
If restarting or resetting doesn’t fix the issue, restore your device.
If you still see the issue after you restore, contact Apple Support.
So long,
-Jason

Similar Messages

  • IPad screen has gone blue/green and will not work

    My iPad 1 screen has gone to black when it is turned on and willl not work. Screen stays blue/green for about 30 seconds and then turns off. Unit is charged fully and has been updated to current operating software. Gerry

    Have you tried a reset ? Press and hold both the sleep and home buttons for about 10 to 15 seconds (ignore the red slider if it appears), after which the Apple logo should appear - you won't lose any content, it's the iPad equivalent of a reboot.
    If that doesn't work then you could see if you can get it into recovery mode and restore it to your last backup : http://support.apple.com/kb/ht1808
    But you might need to contact Apple.

  • My ipad screen has gone black but I can still touch the screen and unlock it and do things. I don't know what's wrong can someone help

    My ipad screen has gone black and I don't know what to do the screen still works and I can still unlock it and I can still type. But I don't know what to do can anyone help me it will be much appreciated

    If the reset doesn't do it then it's possible that the backlight or another part of your screen has broken. Unfortunately it's not really user servicible. I'd make an appointment at your local apple store and have them check it out. If your device is still under warranty and they don't determine that the damage was the result of 'abuse or neglect' (their words) then it could be a free replacement.
    I'd just do a backup before you take it in, just in case.

  • My iPad screen has gone black.  I have tried resetting it with the sleep and home buttons and it only flashes the apple on the screen for a nano second and then it goes black again.  I can even hear notifications arriving, but I cannot see anything...

    My iPad screen has gone black.  I have tried resetting it with the sleep and home buttons and it only flashes the apple on the screen for a nano second and then it goes black again.  I can even hear notifications arriving, but I cannot see anything...I'd rather not reset it to the factory settings as I have a lot of things I worry about using.  Either way seems to me that the system itself is working since I can hear it working, but its the screen that isn't.  It has not been dropped and has been in a case for years!  Please help!

    When the power is on and I press the home button, I can slide my finger where the slider bar "would be" and it makes the noise as if its "opening" flashes a blue screen then returns black...

  • My iPad screen has gone gray/black. I have tried both reset and restore, to no avail. Suggestions?

    My iPad screen has gone gray/black. I have tried both reset and restore, to no avail. Suggestions?

    Take it to an Apple Store for evaluation. It sounds like a hardware problem.

  • My iPad screen has gone to a fuzzy grey and the machine won't operate. Any suggestions?

    My iPad screen has gone to a fuzzy grey and the machine won't operate. Any suggestions?

    FORCE IPAD INTO RECOVERY MODE
    1. Turn off iPad
    2. Turn on computer and launch iTunes (make sure you have the latest version of iTune)
    3. Plug USB cable into computer's USB port
    4. Hold Home button down and plug the other end of cable into docking port.
    DO NOT RELEASE BUTTON until you see picture of iTunes and plug
    5. Release Home button.
    ON COMPUTER
    6. iTunes has detected iPad in recovery mode. You must restore this iPad before it can be used with iTunes.
    7. Select "Restore iPad"...
    Note:
    1. Data will be lost if you do not have backup
    2. You must follow step 1 to step 4 VERY CLOSELY.
    3. Repeat the process if necessary.

  • My ipads screen has gone black you can see when it turns on because the screen glows but thats it it wont come on at all?

    My iPads screen has gone black.  Ive tried to turn fixing it by holding in sleep and home button for 15 seconds but it hasnt worked
    what else can i do??

    Frozen or unresponsive iPad
    Resolve these most common issues:
        •    Display remains black or blank
        •    Touch screen not responding
        •    Application unexpectedly closes or freezes
    http://www.apple.com/support/ipad/assistant/ipad/
    iPad Frozen? How to Force Quit an App, Reset or Restart Your iPad
    http://ipadacademy.com/2010/11/ipad-frozen-how-to-force-quit-an-app-reset-or-res tart-your-ipad
    iPad: Basic troubleshooting
    http://support.apple.com/kb/TS3274
     Cheers, Tom

  • TS3274 My iPad screen has gone dark, but when I use internet it goes light please advise

    My iPad screen as gone. Funny greeny colour, everything including pictures are that colour, but when I use the internet it is normal. Please could you help. I've rebooted but no change

    Some folks here have reported that giving the back of the iPad a couple of sharp whacks has solved this issue - but you do this at your own risk. Best of luck.

  • My ipads screen has gone half black

    this is my cousins ipad that he asked me to take a look at to see, if i could fiqured out what was wrong with it no luck yet,  from what my cousin told me is that it has never been dropped or left in the car to long, there are no real stractches or definable marks anywhere on the pad to make me think other wise.  Any way he said one day just out of the blue the screen just went half black and the other part was perfectically norrmal and you can still touch and operate where you can see or best guess. Originally i was thinking that i wouild just replace the lcd and maybe that was causing some kind of bleeding from the lcd.  but when i turn the ipad, the bad side and good side shift when you rotate them. so that made me reconsider that it was more a software or hardware problem.  So i did the basics i could think of:  a reset of the device, with no result, so from there i followed up with plugging the ipad up to my computer and doing a erase and resync to the older back up software which in turn only made it worse and now you can only see on the left bottom corner, blue, white, black. and i think it was green,  any way this stripes only show up in the bottom right corner taking up about a quarter of the ipad
    Any suggestions on how to fix this the guys at apple store did there normal response to say i needd to buy a new one, which is not a finiacial option at this point in time!!!!!!!!!!!!!!!!!!!!!!!!!!!
    ANY SUGGESTIONS WOULD HELP

    If you are up to the challenge look here for help.
    http://www.ifixit.com/
    This is not a software issue with the iPad - and you may find that by the time all is said and done, you would be better off with an out of warranty replacement iPad when you measure the time and cost factors involved.

  • What causes my mac computer screen to flash scramble words and black line across the screen when on the internet

    my computer when on the internet cause black lines to show up accross the cuputer screen and word scrambled. How can I stop this from happening

    Reset SMC.     http://support.apple.com/kb/HT3964
        Choose the method for:
        "Resetting SMC on portables with a battery you should not remove on your own".
    Sleep function OS X Mavericks:
       http://support.apple.com/kb/HT5869

  • Ipad screen has a massive grey bar through it??

    I turned on my Ipad this morning, and it seemed to be working just fine, except that there was a thick, pixilated grey bar right through my screen. I tried restarting it several times, but nothing changed. I connected it to power and it didn't go away. I haven't tried connecting it to my computer yet, as my computer is broken at the moment (not my fault, I'm just really unlucky) but I'm pretty sure this is a hardware problem, so that wouldn't help anyway. I haven't dropped my ipad, put it in heat or humidity, got water on it, put it in extreme cold or treated my ipad roughly. It stays in a case safely on my desk whenever its not in use. I have only had it for just over two months, so I am very annoyed that it has broken after such a short time. Anyone have any advice?

    Well mrdoozie, you're lucky. I bought an I pad in dec 2010 and had the same issue (grey,black bar about 2 inches thick just above of centre  across the screen with multicolored thin lines in some place inside the bar) develop about 20 days ago. I took it to the apple authorized service centre in mumbai, India and they said apple has not authorized anyone in India to open it and repair and given its a hardware issue  and warranty expired in december 2011 they can replace it for a cost of Rs 23,000 eq to $ 480!
    I did not think it was worth it. First I did not expect apple to make hardware that could develop such kind of issues. And if it such a regular thing then they should repair or replace if it's not the fault of the user. .
    So I took it back and decided I will buy a new galaxy tab instead. With samsung, don't have this kind of support issues in India.
    I can't use this I pad because all the messages come in the centre and do not move up or down so get covered by he bar.
    I should have realized this early when within 3 months my adapter got burnt. I ignored it. For those who may think it may be a voltage issue in my house, I charge my iPhone thro the same socket with the same chargers

  • HT201412 My ipad screen has gone blank ?

    I tried to switch on my ipad but its just blank what is wrong it help pls

    Perform a Reset...
    Reset  ( No Data will be Lost )
    Press and hold the Sleep/Wake button and the Home button at the same time for at least ten seconds, until the Apple logo appears. Release the Buttons.
    http://support.apple.com/kb/ht1430
    If no joy...
    Connect to iTunes on the computer you usually Sync with and “ Restore “...
    http://support.apple.com/kb/HT1414

  • My Ipad screen has gone dark on Safari.

    I can still read it, but it's as if I've highlighted the whole screen.  How do I reset?

    This just happened to me. Resetting my settings back to default helped me. I was able to keep all my apps/photos/data.

  • TS3274 My Ipad screen has suddenly gone color negative.  What's up, and how do I correct it?

    IPad screen has gone color negative.  How do I reset this?

    Goto... Settings > General > Accessibility > White on Black > Off

  • My Ipad screen has been freezing and now the ipad will not charge

    My Ipad screen has been freezing up and now will not charge

    Not charging
    1. Reset iPad; hold the Sleep/Wake and Home button down until you see the Apple Logo
    2. Try another wall socket
    3. Try another cable (make sure it's an original Apple cable)
    4. Try another charger (make sure it's an original Apple charger)
    5. Clean Lightning port with compress air or new paint brush

Maybe you are looking for

  • HT204053 Can I use one Apple ID for different itune stores in different regions?

    I have itune store account in the UK. I can I  use the same account to download an app. from a different store in a different region?

  • Receiver determination Condition. XPATH suggestion

    Hi All, I got a condition to put in receiver determination like.. Condition 1 --> System_A //ZORDER03/IDOC/E1EDKA1(PARVW='LF')/ILNNR = SA       AND //ZORDER03/IDOC/E1EDKA1(PARVW='LF')/PARTN = 0000050570      AND //ZORDER03/IDOC/E1EDKA1(PARVW='WE')/LI

  • Select top row in Single Query?

    Hi Can somebody help me to write a query to get the first row after order by clause using single query alone. Example: I can write following query to select first row select * from (selec * from t order by col1) where rownum = 1; But here I should no

  • Iphone 5c Screen

    I currently have the Iphone 5C 8GB that I got on contract in July 2014. I had put a case on my phone to protect it from any damage. However, when i have gone to take off this case it has pulled my original casing away from my screen. The phone now lo

  • Photoshop CS5 not recognizing EPSON 2450 flatbed scanner

    I am on a MacPro....OS X 10.6.8. I am running Adobe Photoshop CS5. I need to be able to run my EPSON 2450 flatbed scanner through Photoshop. But when I go to File > Import > it's not there. Please explain where I can find the TWAIN plug-in, where to