Ipad will not boot up after 7.1.2 update
updated to 7.1.2 yesterday and I pad will not boot up. it turns on and I get the logo but will not completely boot back on into home screen. I tried hold both button down and it would turn off but when turn on it did the same time. let it run all night while plugged in to see if it would boot but would not. don't want to have to restore because of loosing all my data I have on ipad. What can I do?
If the reboot by holding both the power and home buttons until the apple logo appears does not help, there is not much you can do except restore via the recovery mode per the instructions in http://support.apple.com/kb/HT1808
Similar Messages
-
Ipad mini will not boot up after charging
ipad mini will not boot up after charging
Hi luckysue,
If your iPod mini isn't booting up or responding after charging, you may find the troubleshooting steps outlined in the following articles helpful:
Reset your iPod - Apple Support
iPod only shows an Apple logo and doesn't start up - Apple Support
Regards,
- Brenden -
Macbook will not boot up after running Software Update
My MacBook will not boot up after running Software Update (Security update + Java?) earlier today. I have only the gray start up screen + Apple logo + gear wheel constantly rotating. I have tried restarts several times and tried to start up from my original system DVD - this makes no difference.
I called Apple support, tried resetting the power and PRAM - still no difference. He had no knowledge of other problems reported; although I note recent post may have same issue.
I cannot get an appointment at my Apple Store before Monday.
Any suggestions?Still no success. When I hold down the option key when powering up I get the hard disk icon plus arrowhead (only). When clicking the arrowhead it goes to the gray screen + apple logo+ rotating gearwheel.
This happens both with DVD in slot and without DVD. the DVD image is not coming up on screen. When I start up without DVD the hard disk icon appears promptly. When I start with DVD in the DVD is spinning for a short period before the hard disk icon appears. On clicking the arrowhead to hard disk icon the DVD spins again for a while then stops. Apart from the DVD spinning, both situations result in gray screen + apple logo+ rotating gearwheel. -
Windows xp will not boot up after installation of desktop software 4.3.
windows xp will not boot up after installation of desktop software 4.3. Where do I start to get my p.c. going again ???
I get the message that a recent hardware or software change might have caused this.
The computer does not boot up in safe mode or last known good configuration.
I'm glad you think the software has nothing to do with it, but perhaps you can also explain why this problem started as soon as I downloaded the desktop software and tried to restart the computer. -
Imac has white screen and spinning wheel and will not boot up---after lion install
imac has white screen and spinning wheel and will not boot up---after lion install
Please read Gray screen appears during startup.
-
My Ipad will not boot up, has a think logo running all the time...any ideas. Also had trouble upgrading to ios.6 the computer is not the original one I synved my ipas too. It started OK then failed. Now it will not connect at all to computer...comes up with an error.!!!
Try DFU Mode Restore. Open iTunes on computer, connect iPhone to computer. Hold both Home and Power buttons for exactly 10 seconds, release Power button, keep holding Home button until iTunes recognizes iPhone in Recovery Mode. Usually about 20 seconds time. Restore iPhone Firmware.
-
Cisco 7941G phones will not boot up after factory reset.
Cisco 7941G phones will not boot up after factory reset.
The following happens.
1. Speaker light lit (Green)
2. Phone displays a firmware upgrade page (see attachment) for a few minutes. (Doesn't seems to be upgrading, but it "saids" upgrading)
3. Saw Cisco logo with a Java Powered page.
4. The whole thing loops again and again...
I think the reason why the phone isn't booting up is because the phone needs to know where to find the configuration/firmware files from a tftp server. I do have a TFTP server, but normally I need to go in settings to change the alternative tftp server, but the thing is that now I can't even press the settings button...
Please help.How many phones were reset and upgrading at one time? What is the setting of the TFTP Maximum Serving Count (Advanced TFTP Service Parm) on each of the TFTP servers?
Sounds like too many devices trying to use TFTP at once. -
My first genteration ipad will not power on after update. I have tried connecting to the authorized computer which won't recognize it - does not acknowledge a device is plugged in. I have pushed top and circle buttons at same time. It had a battery charge before it died. I tried to stop the upload midway and am afraid it 'crashed'
Try putting it into recovery mode.
Connect iPad to your computer via USB while it's turned on.
Open iTunes
Hold the iPad's Sleep/Wake switch (power button on the top of the iPad) down until the "power off" slider appears.
Power off the iPad completely (wait for the progress spinner to disappear).
Hold the Sleep/Wake switch AND the Home button down for a full 10 seconds.
After 10 seconds (the second time you'll see the Apple logo on the screen) release the Sleep/Wake switch while still holding the Home button.
Continue to hold the Home button for another 10 seconds until the USB connection image appears on the iPad's screen, then release the Home button.
A pop-up message will appear on iTunes saying it has detected an iPad in recovery mode, you must restore...
Click on the "Restore" button and the process will begin. -
My Ipad will not come on after reset. All i get is the little white apple to appear that is it. Any suggestions ?
Hi Dawg70,
Welcome to the Support Communities!
The article below may be able to help you with this issue.
Click on the link to see more details and screenshots.
iOS: Not responding or does not turn on
http://support.apple.com/kb/TS3281?viewlocale=en_US
Cheers,
Judy -
My ipad will not boot up. Hard reset just gives the Apple Logo. Help
My ipad will not respond to hard reset
Hello Ridgeway57,
Thanks for using Apple Support Communities.
At this point since the iPad will not boot nor respond to a reset, go ahead and restore your iPad by following the article below.
Use iTunes to restore your iOS device to factory settings
http://support.apple.com/kb/HT1414
Take care,
Alex H. -
My Ipad will not come on after I charged it.
My ipad will not come on after I charged it.
Try reset iPad
Hold down the Sleep/Wake button and the Home button at the same time for at least ten seconds, until the Apple logo appears
Note: Data will not be affected. -
My iPad will not boot up. When I press the on/off button, nothing black screen. Does anyone have a suggestion?
Try reset iPad
Hold down the Sleep/Wake button and the Home button at the same time for at least ten seconds, until the Apple logo appears
Note: Data will not be affected. -
My iPad4 will not turn on after i OS 6 update
My iPad4 will not turn on after i OS 6 update and it keep asking to connect to iTunes?
What to Do When Your iPad Won't Turn On
http://ipad.about.com/od/iPad_Troubleshooting/ss/What-To-Do-When-Your-Ipad-Wo-No t-Turn-On.htm
iOS: Not responding or does not turn on
http://support.apple.com/kb/TS3281
iPad Frozen? How to Force Quit an App, Reset or Restart Your iPad
http://ipadacademy.com/2010/11/ipad-frozen-how-to-force-quit-an-app-reset-or-res tart-your-ipad
iPad: Basic troubleshooting
http://support.apple.com/kb/TS3274
Update and restore alert messages on iPhone, iPad, and iPod touch
http://www.buybuyla.com/tech/view/012953a0d412000e.shtml
iOS: Resolving update and restore alert messages
http://support.apple.com/kb/TS1275
iPad: Unable to update or restore
http://support.apple.com/kb/ht4097
Cheers, Tom -
Lenovo G780 will not boot up after windows update
My friend's G780 will no longer boot up after installing a windows update, one for which she cant remember, and ever since she updated it, the lenovo boot screen will appear, then turns black, and stays black. It will, occasionally, give her the option to go to the "windows did not boot properly" screen, giving her options to refresh the pc, restore the pc, advanced options, etc.
Changing boot priorities, using "repair" did not work, and neither did trying to find a system image.
She is unsure what to do, and I am as well.
Any recomendations?hi connorjacob,
Thanks for Posting!
If you can try and get the screen again where it gave you options like Refresh PC, Restore the PC and Advanced option.
Choose Advanced option to pull up a new page with options
With the options, You can try:
Try Selecting System Restore and see if you can find a restore point prior to to insalling the said updates.
Select Windows Start up Settings and Find two options that can help
- Boot to Safe Mode (See if the computer boots in safe mode)
- Last Known good configuration
Let me know your findings
Hope this helps
Cheers!
Did someone help you today? Press the star on the left to thank them with a Kudo!
If you find a post helpful and it answers your question, please mark it as an "Accepted Solution"! This will help the rest of the Community with similar issues identify the verified solution and benefit from it.
Follow @LenovoForums on Twitter! -
G4 will not boot up after installing latest update
Just installed latest OS 10 update (10.4.8 or 9?) Mac will not boot up. The ring sounds on start up and the apple shows on video but it never gets to the rotating circle. It has been over an hour. I have restarted twice to no avail. I have also disconnect all peripheral. Do you have any suggestions as to what to do next?
Hi-
Welcome to Discussions!
Try a boot in safe mode (startup holding"shift" key after chime). This will help determine if you have conflicting drivers, fonts,etc. present, and helps bypass damaged software components:
http://docs.info.apple.com/article.html?artnum=107393
If successful, run Disk Utility. If not, try a single user boot, and run fsck:
http://docs.info.apple.com/article.html?artnum=106214
Alternatively, boot from your OS install disk, and run Disk Utility.
Post back with your results, please!
G4 AGP(450)Sawtooth Mac OS X (10.4.8) 2ghzPPC,1.62gbSDRAM, ATI9800, DVR-109,(IntHD)120&160,LaCie160,23"Cinema Display
Maybe you are looking for
-
Dump while supplying Reason for Rejection in sales order
Hi Gurus, when I am suppling the Reason for Rejection ("Cancelled") for a line item in existing Sales Order, the sales order is going to dump,this is the case with production system where as the same is working fine with testing system,ofcourse I am
-
How do i sync the iphone with a new computer without losing pictures?
my laptop was stolen and i've recently replaced it. now when i try to sync my iphone with the new laptop, it gives me messages saying that it will replace what's on the iphone by whatever it currently has on the itunes library. i can't have this happ
-
When ever I go on the calandar to enter in times, I can't click on MARCH as it crashes the app
January and February works perfectly, but when ever I click on march it crashes the app.
-
How do I change the country and city on my Apple ID as I have moved to UK
I Have recently moved from India to London , UK but my apple id has been registered to the older address in India. I want to update it to the new address in London
-
Hi all I need to add a button/icon at the end of each row of an ALV. When the user clicks on a button it will send a mail. Can you help me? Specially on the first issue. Many thanks.