IPad won't charge in ITunes

I'm still using the cord that came with the Ipad (2) I just got it for Christmas so it's not old. The cord works when I plug it into the wall but when it's plugged into my computer it simply won't charge. The IPad shows up in ITunes and I can download and upload content from ITunes. I don't know what to do.

The USB port on your computer does not supply enough power to charge the iPad and that is why Apple includes a power adapter. Plug the iPad into the power adapter and the adapter into a wall socket and charge the iPad that way.
Read this about charging the battery.
http://support.apple.com/kb/HT4060

Similar Messages

  • My ipad won't charge.  All I get is picture of white USB cable and iTunes Logo.

    My ipad won't charge.  I must admit, I did use it until there was only 2% power left and then went and plugged directly into power and not through PC... but it won't charge.  All I get is picture of white USB cable, an arrow and the iTunes Logo.  I have turned off and on again as previous posts but all I get is the picture of the USB cable, arrow and iTunes logo.  Please help...

    I have been relatively patient - 3 hours on charge but all it does is show picture of USB cable and itunes logo. It it were charging you would think that a picture of the charge would come up to indicate status of charge - wouldn't you think?

  • Ipad won't charge -- need to back it up

    My iPad will not charge and itunes will not detect it. I called Apple and they sent me a replacement cord but still nothing. I am reading on many sites that they will replace it so I need to get my stuff off my ipad. What is going to be the best way since it will not connect to anything?

    As stated in the article itself, it won't affect the library. Back it up anyway.
    (70163)

  • TS3274 My iPad won't charge. Tried more than one charger.

    My IPad won't charge. I tried more then more charger...help. Plus the sound is missing for general purposes...lock sound, etc. already tried to turn on an off.

    Have you tried a reset to see if it charges after the iPad has restarted ? Press and hold both the sleep and home buttons for about 10 to 15 seconds (ignore the red slider), after which the Apple logo should appear - you won't lose any content, it's the iPad equivalent of a reboot.
    In terms of the sounds, have you got notifications muted ? Only notifications (including games) get muted, so the Music and Videos apps, and headphones, still get sound.
    Depending on what you've got Settings > General > Use Side Switch To set to (mute or rotation lock), then you can mute notifications by the switch on the right hand side of the iPad, or via the taskbar : double-click the home button; slide from the left; and it's the icon far left; press home again to exit the taskbar. The function that isn't on the side switch is set via the taskbar instead : http://support.apple.com/kb/HT408

  • My iPad won't charge after plugging into my computer and after holding down the power and home button at same time for 10 seconds- Can anybody help? Has IOS7.0 but the most up-to-date version

    My iPad won't charge after plugging into my computer and after holding down the power and home button at same time for 10 seconds… Can anybody help? Has IOS7.0 but not the most up-to-date version

    It's just the battery sign - nothing else. I've tried to reboot by holding down both power and home key for 10+ seconds, waiting for the apple logo - but nothing happens. It's plugged into the imac at the moment. I tried to recharge it overnight using the normal charger - but no luck. It went dead during a Skype call with a friend - even though it was powered into the mains - albeit at a low battery level at the time

  • IPad won't connect to itunes why?

    My iPad won't connect to iTunes, iPhoto recognises the connection but the photos don't display! iTunes tells me it can't connect to the device. I'm using iOS 5.1.1 on te iPad which it tells me is up to date when I look for software updates, iTunes 11.0.1. Please help.

    Is itunes updated to 11.1

  • Ipad won´t charge to use the mains charger, What's wrong?

    ipad won´t charge to use the mains charger, What's wrong?
    the usb cable will work to conect to itunes

    Sounds like it is dying. Is it still under warranty? If it is, I suggest you take it to Apple and ask them to repair it.
    Allan

  • Had to reset Ipad to factory settings, now Ipad won't sync to Itunes and apps that aren't factory installed will not open. Is there anything I can do?

    Hi,
    I hope someone can help. There was something wrong with my Ipad so I had to reset it back to the factory settings. Now the Ipad won't sync to Itunes and only factory installed apps will open. Does this mean that this Ipad is DOA and it is time for a new one? Or is there anything else I can do?  It is a 1st generation Ipad.
    Thanks for the help in advance.

    if all that does not work you can always try to do a recovery mode restore back to factory settings and then set it up as a new device then try to redownlaod every thing again
    downlaod past purchases
    http://support.apple.com/kb/HT2519
    recovery mode
    http://support.apple.com/kb/HT1808

  • First, I've read the manual. This new Nano won't sync and won't charge. Itunes does recognize the device. When it's connected to a Windows PC, the battery indictor shows charged. When it's not connected, the indicator shows no charge. I've tried this on t

    First, I've read the manual. This new Nano won't sync and won't charge. Itunes does recognize the device. When it's connected to a Windows PC, the battery indictor shows charged. When it's not connected, the indicator shows no charge. I've tried this on two PCS without success.

    Maybe the Nano you got is defective. Have it replaced.

  • My ipad won't sync with itunes, can anyone help

    My ipod tpuch and ipad won't sync with itunes even though they are recognised by my comuter. i have uninstalled and reinstalled itunes but still won't sync. How can i get my equipment to sync with itunes?

    It has been shown there are problems with the latest update of iTunes and Windows computers. What you need to do is remove and reinstall iTunes, and make sure that you follow the steps in this support document exactly. http://support.apple.com/kb/ht1923. If you do not follow them exactly, you will just compound your problems. Once you do this, you should have no trouble having the phone recognized in iTunes.

  • TS3274 My IPad won't charge.

    My IPad won't charge. I plugged the adapter into the wall per usual. But even after sitting overnight it was still only 12% charged. Someone said you have to re-set. (How ever you do that.) But that means losing stored photos, videos, etc. Yes?
    Any answers?
    Thanks.. Val

    Using the battery level meter in this manner is comparable to using your car's fuel gauge to calculate miles per gallon.  The only thing that matters is the total amount of operating time from full charge to auto-shutdown.
    Use the wall-mount charger that came with the iPad and charge overnight.  Admittedly the labeling is hard to read but, if you use a magnifier and squint your eyes, you'll see "Output 5.1V, 2.1A."  The symbol between volts and amps is the symbol for DC.  Do NOT use an iPhone charger.  Do NOT use an iPod charger.  Then, operate it normally until auto shut-down (ignore any low level alerts that may appear).  An irony is that doing that test to determine the total operating time is also the exact procedure necessary to calibrate the battery level meter.
    I'm not claiming that you do not have a problem.  I am stating, however, that we don't yet know whether or not a battery problem exists.
    According to Apple:
    Use Your iPad Regularly
    For proper reporting of the battery’s state of charge, be sure to go through at least one charge cycle per month (charging the battery to 100% and then completely running it down).
    Elsewhere, Apple elaborates and explains that two half-discharges (or four quarter-discharges, etc.) equals one full discharge.

  • Ipad won't turn on itunes can't connect error OxE800024

    ipad won't turn on itunes can't connect error OxE8000024

    This Apple doc has some tips that can help you fix that problem -> iOS: Unknown error containing '0xE' when connecting to a Windows PC
    If it won't turn on, you could try connecting it to another power outlet or computer.

  • My iPad won't charge using the charger brick

    My iPad won't charge using the charger brick

    you can try giving your device a reset and see if that helps. Hold down the sleep and home keys, past when you see the red power down slider and until you see the silver apple. Let it reboot and try. If that doesn't fix it, then time to move onto other trouble shooting.
    Usually if an iPad won't charge (presuming you're using the supplied charger plugged into the wall), it's:
    bad brick
    bad cable
    bad outlet
    bad port on the iPad
    you can eliminate the first three by swapping out chargers if you have another, swapping out cables and trying a different outlet. If you do that and eliminate the first three, then it may be the port on your iPad. If so, and your iPad is still under warranty, make an appointment at your local apple store and take it in.

  • My iPad won't charge , immediately following an IOS7 update.

    My iPad won't charge , immediately following an IOS7 update. what do i have to do

    Tried the wall mount charger, stuck at 5% which I'm keeping just in case someone actually has a solution.

  • TS3274 iPad won't charge while plugged into computer

    My iPad won't charge while plugged into computer

    The quickest way (and really the only way) to charge your iPad is with the included 10W USB Power Adapter. iPad will also charge, although more slowly, when attached to a computer with a high-power USB port (many recent Mac computers) or with an iPhone Power Adapter (5W). When attached to a computer via a standard USB port (most PCs or older Mac computers) iPad will charge very slowly (but iPad indicates not charging). Make sure your computer is on while charging iPad via USB. If iPad is connected to a computer that’s turned off or is in sleep or standby mode, the iPad battery will continue to drain.
    Apple recommends that once a month you let the iPad fully discharge & then recharge to 100%.
    How to Calibrate Your Mac, iPhone, or iPad Battery
    http://www.macblend.com/how-to-calibrate-your-mac-iphone-or-ipad-battery/
    At this link http://www.tomshardware.com/reviews/galaxy-tab-android-tablet,3014-11.html , tests show that the iPad 2 battery (25 watt-hours) will charge to 90% in 3 hours 1 minute. It will charge to 100% in 4 hours 2 minutes. The new iPad has a larger capacity battery (42 watt-hours), so using the 10W charger will obviously take longer. If you are using your iPad while charging, it will take even longer. It's best to turn your new iPad OFF and charge over night. Also look at The iPad's charging challenge explained http://www.macworld.com/article/1150356/ipadcharging.html
    Also, if you have a 3rd generation iPad, look at
    Apple: iPad Battery Nothing to Get Charged Up About
    http://allthingsd.com/20120327/apple-ipad-battery-nothing-to-get-charged-up-abou t/
    Apple Explains New iPad's Continued Charging Beyond 100% Battery Level
    http://www.macrumors.com/2012/03/27/apple-explains-new-ipads-continued-charging- beyond-100-battery-level/
    New iPad Takes Much Longer to Charge Than iPad 2
    http://www.iphonehacks.com/2012/03/new-ipad-takes-much-longer-to-charge-than-ipa d-2.html
    Apple Batteries - iPad http://www.apple.com/batteries/ipad.html
    Extend iPad Battery Life (Look at pjl123 comment)
    https://discussions.apple.com/thread/3921324?tstart=30
    New iPad Slow to Recharge, Barely Charges During Use
    http://www.pcworld.com/article/252326/new_ipad_slow_to_recharge_barely_charges_d uring_use.html
    Tips About Charging for New iPad 3
    http://goodscool-electronics.blogspot.com/2012/04/tips-about-charging-for-new-ip ad-3.html
    Prolong battery lifespan for iPad / iPad 2 / iPad 3: charging tips
    http://thehowto.wikidot.com/prolong-battery-lifespan-for-ipad
     Cheers, Tom

Maybe you are looking for

  • Client settings in R/3 For Extraction to BW

    Can any one provide what client settings on R/3 is required to Extract Data from R/3 to BW. any link or docs will do. can send on [email protected]

  • How do I specify the file extensions when opening a file in Labview?

    When opening a file, the file open dialogue box appears with a drop down box called 'Files of type *.* I want to only display files of type IPC, and I will create all my files to have this extension. I have been using this technique in VB for some ti

  • Don't execute a step in the Operator

    Hi, I'm using a IKM file to Oracle(SQLDLLR) and IKM SQL control Apend, it's an obligation. In the operator there is a step called delete previous error which take a lot of time , you can watch a movie and the step still running. Can someone provide m

  • Powershell Test-Path of HKEY_USERS

    Hello Folks, I'm attempting to write a script that will update a non logged in users NTUSER.dat registry setting. I load the hive with: REG load "hku\temp" c:\users\${username}\NTUSER.dat.  That occurs successfully, but when I attempt to do a test-pa

  • Scanjet G4050, scanning 35 mm slides

    I have just bought a Scanjet G4050, because it was able to scan many slides in one scan. Using a PC wind OS Windows 8.1 x64, and downloaded the driver from HP homepage. What I experience is, when loaded the frame with 16 slides, that not all slides a