IPhone 4 bricked and won't turn on after 4.1 update!

Hey guys
Hoping someone has any tips.
Last night I update from 4.02 to 4.1. The update installed just fine. As soon as I unplugged my phone from the computer, the screen went black, as if it was turned off.
Nothing I have done turns it back on. Neither the power or the Home buttons do anything. I've tried doing a hard reset and nothing. I even held the buttons for over a minute.
So I tried connecting it to the wall charger as well as back on the computer. It still doesn't turn on at all.
Do I just need to get it replaced?
Message was edited by: deathstar1000

Ok, so I went to try that and run the program it said I needed .Net Framework 4.0 installed, so I was on my way to update that so I could try to run the program.
Anyway, before I did that, a coworker comes by and I show her that my phone is dead. I unplug it from my computer (it's not charging or anything) and I start pressing the power button rapidly to show her it's dead. All of a sudden the screen turns on and shows me that the battery is drained and needs to be recharged. I quickly connect my phone back to the computer and it begins charging. After a few minutes the Apple logo appear and it is detected on my computer! It is currently charging and is seen in iTunes. All is well again.
What's weird is that I know for a FACT that the battery was not dead when the update was done. In fact the phone showed FULL battery right before I unplugged it the first time.
I don't know if it was a combination of the steps above or what, but whatever it was, I appreciate everyone's input.

Similar Messages

  • I tryed to update my iphone and now my phone screen show the itunes logo with a wire and won't turn on, i tryed to update my iphone and now my phone screen show the itunes logo with a wire and won't turn on

    i tryed to update my iphone and now my phone screen show the itunes logo with a wire and won't turn on, i tryed to update my iphone and now my phone screen show the itunes logo with a wire and won't turn on

    Did you try to connect in recovery mode to your computer, explained in this article?
    iOS: Unable to update or restore

  • My iPhone shut off and won't turn back on.  What should I do?

    My iphone shut off and won't turn back on.  What should I do?

    sometimes if the battery drains completely you will need to leave it plugged into a charger for 10-15 minutes before you get any activity at all.  this is normal

  • IPhone went dead and won't turn back on

    My iPhone 5 was a refurbished phone that I received under warranty in November. However, it worked fine until last week when it started turning off at 50% and below (which is the same reason why I had to get this refurbished phone in the first place). But because it immediately turned back on, I thought nothing of it and ignored it. However, my phone went dead two days ago and won't turn back on. I've used two chargers that worked the day of, but it wouldn't charge with either of those and those wouldn't even connect my phone to my laptop. So, thinking and hoping it was both of the cords malfunctioning, I went out and bought another cord. My phone still won't turn on, Apple Support refuses to help in any way because my warranty out, and I'm lost.

    Plug it in to a wall outlet so it has power, then do a reboot by holding both the power and home buttons until the apple logo appears, ignore the red slider if that appears.

  • My iphone got wet and won't turn on

    Yesterday, my iphone 4 fell into water .... it was completely submerged for about 10 seconds before I could remove it. It worked for about 5 minutes after it happened, but then it shut off and won't turn on. Now it's sitting in a pot of dry rice (people told me to put it in rice because it dries stuff out). Is there anything I can do? will it work again?? Am I doomed??

    Your phone is fried. You can get an out of warranty replacement at an Apple Store.
    https://www.apple.com/support/iphone/repair/other/

  • Imac dead and won't turn on after lightning storm

    Lightning fried my mac; its dead and won't turn on, in spite of having a surge protector; my question is what part is likely damaged; and what does a repair cost without Apple Care.?
    Thanks

    Hi rasperryaddiction!
    I was wondering if you've tried resetting the SMC (support.apple.com/kb/HT3964). It's very simple to try before considering having the computer repaired. If it really doesn't turn on after resetting the SMC, then contact any Apple Authorized Service Provider or and Apple store near you.  Tell them what happened to check if they can give you a quote or something buy, they might ask you to bring it in to confirm the issue. It really does depend on which part was affected.

  • My iphone is broken and won't turn on. How can i transfer my contacts and music to my new phone?

    My iphone 4s's lock button broke. My phone won't turn on. I ordered an iphone 5s. How can i tun on my iphone 4s and transfer my contacts,music, and other things to my new iphone? Please help

    The following gives instructions on how to transfer to a new device via either iCloud (top section) or iTunes (bottom section). Assuming that you already have a backup via one of those methods you can skip the first few steps and go directly to the restore instructions. http://support.apple.com/kb/HT2109

  • IPhone screen blank and won't turn on/off

    I went to the camera app from the lock screen and the app seemed to freeze, so I pressed the home button. The screen went blank and now won't turn on. Oddly, when I plugged it into iTunes on the computer, I was able to sync, and I can get Siri by holding the home button. Also the phone will ring if called, but I cannot answer it. Please help.
    iPhone 5S. Just installed latest iOS update yesterday. Never had any problems before.

    Try restarting or resetting your phone. You won't lose any data.
    Restart or reset your iPhone, iPad, or iPod touch - Apple Support

  • IPhone Shut off and won't turn back on

    My iPhone 3GS just shut down and won't do anything. I've tried pressing the top button, toggling the top and bottom button, plugging in to charge it, and syncing it, but it just stays black and non-responsive. Any suggestions?

    Home + Sleep does not restore. It simply resets you need to put your iPhone in recovery mode (hopefully you backup your phone frequently):
    1. Open iTunes.
    2. Connect iPhone to Computer.
    3. Press and hold the Home and Sleep/Wake buttons simultaneously.
    4. As soon as the screen goes black release the Sleep/Wake button BUT continue holding the home button until you see a pop up a message in iTunes telling you that it has detected an iPhone in recovery mode.
    5. Sync and restore.
    Hope this helps. Please let me know if it does not so I can provide more help.

  • Iphone 5 won't turn on after 8.3 update

    I just updated to the 8.3 and now my phone won't turn on. I've tried holding the buttons down and nothing. I don't want to do a factory restart!!! So what are my options now?

    Hello PyroTheRedBean,
    Thanks for using Apple Support Communities.
    Please follow the troubleshooting in the article linked to below for your iPhone not turning on.
    iOS: Not responding or does not turn on
    Take care,
    Alex H.

  • Macbook freezes and won't turn on after using itunes and going to standby

    My macbook pro "locks up" when I am using Itunes and I let my computer go to sleep or to standby mode. It won't turn back on without manually shutting it down and restarting the computer. I have had hardware diagnostics done on it and they all report back fine. If anyone knows how to fix this issue it would be greatly appreciated!!!

    The computer may think it is syncing with the iPod while you are attempting to go to sleep, thus is stuck trying to know what to do. Try dismounting the iPod first, and then disconnecting it, and then putting it to sleep.

  • My MacBook Pro won't turn on after the new update.

    I left my MacBook Pro out and open for it to update and install the new software. When it finished, I connected my iPhone 5s with the laptop via the USB cable. And it completely shut down. And it won't turn on, restart, nor charge.

    Did you try this?
    Reset the iPad by holding down on the sleep and home buttons at the same time for about 10-15 seconds until the Apple Logo appears - ignore the red slider if it appears on the screen - let go of the buttons. Let the iPad start up.

  • Ipad 3 won't turn on after ios 6 update

    Hi everyone,
    I'm at a loss!  My Ipad 3 was working fine, and while fully charged I updated to ios 6.  Everything worked fine and I was thrilled.  While at work, I turned the Ipad off, and now it won't turn back on.  I've tried resetting, I've tried holding down the power and home buttons (repeatedly, and for long time periods), and I've tried to restore it using my itunes but my computer now doesn't recognize the device when I plug in the USB. but I never see any reaction by the device. No icons on the screen, no apple logo, no nothing... I updated itunes, still the same problem.  So, for the life of me, this fully charged relatively new working fine 64G Gen 3 Ipad just won't turn on.   Any additional ideas before I dare to go in the crowded apple store for assistance?
    Thanks, Hollie

    Try this...
    Press and Hold the Sleep/Wake Button and the Home Button at the Same Time...
    Wait for the Apple logo to Appear...
    Usually takes about 15 - 20 Seconds... ( But can take Longer...)
    Release the Buttons...
    http://support.apple.com/kb/ht1430
    If no joy... Try a Restore...
    1: Connect the device to your computer and open iTunes.
    2: If the device appears in iTunes, select and click Restore on the Summary pane.
    3: If the device doesn't appear in iTunes, try using the steps in this article to force the device into recovery mode.

  • MacBook (Mid 2009) won't turn on after installing software updates.

    My macbook white (mid 2009) won't turn on. I was going to install mountain lion so I performed a software update. I click install and reboot. It installed within a few minutes, but when it was rebooting the apple logo and the buffering sign popped up, and that went on over night. So I held down the power button to turn it off. It did the same thing, what should I do?

    Not the right time to update and go to sleep. What updates? How much free space was on the hard drive?
    Try inserting the OS installer disk in the optical drive and powering up holding down the c key.

  • Apple TV won't turn off after 2.2 update

    I was just wondering if anyone else has this problem after the new update.
    After updating to the new 2.2 software......I am now unable to turn the device off. I used to just hold the center button down for 5-6 seconds and it would turn off. I didn't want to leave it on all the time since I only use it once or twice a week. But now.......doing the same thing has no effect on it at all. Is this happening to anyone else ? I know a lot of people just leave it on all the time, and I guess I could do that as well. Hahaha.......... seems I don't have any choice now. Is this a new feature that comes with the 2.2 software ?

    Because of Genius and another feature, the ability to put the AppleTV into standby has changed. Either you can go to the main menu and press Play/Pause for 6 seconds (like you used to, but only works from main menu), or you can go into Settings where there is a new StandBy option that can be selected.

Maybe you are looking for

  • IPhone/Exchange Calendar issue

    I have an original iPhone connecting to an exchange 2003 server. E-mail is working correctly but the calendar sync is pushing new events. If an event is created on the iPhone it will push to outlook (2007) however if an event is created in outlook it

  • How to use standard text in sapscripts

    Hi, I want to place a part of text to be displayed in my sapscript in the form of a standard text. I want to make the text bold with italics and also want to set a perticualr size to it. I am new to SAPscripts can anybody please help me with this. re

  • Adobe Air Error message on start-up.

    Hi I have been getting the same error message on start up for some time. (Adobe Air is damaged). I have tried uninstalling, re-installing but still get the message and on certain websites I get 'missing plug-in' messages (usually involving playback o

  • Batch embed image in illustrator CS4

    I am working on about thousands ai files, each file have one image need to embed. My question is: Is there a way to embed the images at once? I usually open one ai files and select "embed image" in the links palette, is there a easy way to do this? T

  • System freeze when trying to install 10.2 (Jaguar) on a biege G3

    I'm trying to install 10.2 on a partition on my G3 hard drive. The machine specs are: 400Mhz G3 384 Meg RAM OS9.2.2 ROM Id $77D.45F2 When I try to restart with the install CD, the machine freezes completely. The only way I've been able to recover is