Iphone 4 not responding after reset

i have went and reset my iphone 4 via the settings on the phone.
It closed down and went and reset but has been stuck on the black screen witht the white apple for over 3 hours.
I have tried to connect it via the itunes to see if it would resart but i have had no luck

This also happens when the user is restoring a jailbroken device-the Apple logo appears and nothing else happens.
Try putting your device in DFU (restore) mode by holding the power button and home button until the screen goes dark. Release the power button and continue holding the home button until iTunes detects that your device is in restore mode. After iTunes has detected that your device is in reset mode, click on restore and iTunes will download and install the latest iPhone Software file. 
MAKE SURE THAT YOUR DEVICE IS CONNECTED TO iTunes BEFORE DOING THIS!

Similar Messages

  • HT4623 why my iphone are not responding after i update the latest ios? and the screen displaying itunes icon

    why my iphone are not responding after i update the latest ios? and the screen displaying itunes icon

    You are in Recovery Mode. Follow the instructions below to recover your iPad.
    1. Disconnect the USB cable from the device, but leave the other end of the cable connected to your computer's USB port.
    2. Turn off the device: Press and hold the Sleep/Wake button for a few seconds until the red slider appears, then slide the slider. Wait for the device to turn off.
    If you cannot turn off the device using the slider, press and hold the Sleep/Wake and Home buttons at the same time. When the device turns off, release the Sleep/Wake and Home buttons.
    3. While pressing and holding the Home button, reconnect the USB cable to the device. The device should turn on.
    4. Continue holding the Home button until you see the "Connect to iTunes" screen. When this screen appears, release the Home button.
    5. iTunes should alert you that it has detected a device in recovery mode. Click OK, and then click Restore to restore the device.
    Note: You need to be patient and repeat the above many times to recover your iPad. Data will be lost.

  • IPhone 3G not responding after upgrading firmware

    I've been given an old iPhone 3G 16GB but as it hasn't been used for a while, the firmware on it was 2.8.?? something. I have the latest version of iTunes so I connected it to upgrade so I could download apps as nearly all of them needed iOS 3+. It was working fine before but since I have downloaded the latest software version that iTunes put on it two days ago (4.3.2 I think) and since then, the whole phone is running really slow and if not connected to a power supply it dies after about 3-5 minutes. It doesn't even charge when connected to a PC.
    I've tried to do a system restore and it doesn't work as it's still the same. I've followed all the tips on the Apple site and nothing works. The only thing that was suggested was to downgrade the firmware but when I try to do that, I get an error 3194 on iTunes. I've even tried changing the hosts file in Windows but that didn't work and the error is still there.
    As it stands, I have a phone with the latest firmware but I can't use it! Can someone please shed some light on this?
    Thanks

    Thanks for the response, I must have got the firware version wrong.
    I don't think it's battery failure as it was working fine for at least a week before I updated it and now all of a sudden after I've updated it, it's gone rubbish. If I charge it from the plug, it's fine but I've noticed as soon as it goes into sleep mode and locks itself (or if I lock it) then it actually turns itself off.
    This may be a silly question but if it is a hardware failure, how do I go about fixing it if I wasn't the original owner and it has no warranty on it?

  • Some time the network or calls phone not respond after (reset networks)

    Dear apple
    Please take care of a solution to this problem because of its importance because this problem prevent you from receiving calls and send and is the occurring indefinitely and have no time to occur does not return to work only after a make ( Reset Network )
    and It is not reasonable to do this procedure always
    Thanks for all

    I'm sorry, but you are not addressing Apple here. The people on this forum are users just like yourself that take the time to volunteer to try and answer technical questions from other users.
    Your question is somewhat confusing, but I believe I understand that you are having connection problems and they are corrected by you resetting the network, however they return. Am I correct in this assumption?
    If this is correct and you have followed other user troubleshooting procedures, such as powering the phone off/on, reset and restore, then I suggest you make contact with your carrier as there may be an issue with your SIM card. If that is not the problem, the only other recourse after exhausting the troubleshooting is to make an appointment at the Genius Bar to have the phone checked for any hardware failures.

  • Iphone will not respond after trying to put it into DFU mode while in recovery mode.

    I tried to restore my iphone 4 and recieved error 21 in itunes, while in recovery mode I tried to put it into DFU mode and then it turned off and wont turn back on or be recognized by itunes or pc. I tried doing a hard reset and no luck. HELP PLEASE!!!!!

    That does happen.  It depends on how hard the server is being hit, as well as the connection speed of your system.  If you are on a windows system, you will want to disable any antivirus or firewall software during the download.

  • My iphone does not respond after upgrading the operating system

    upgrade the operating system to 7.0.2 and iphone 5 will not start, can you help please

    It reads as though you've managed to break your iPhone.  You should make an appointment with an Apple Genius to discuss.  If need be, Apple will sell you a refurbished handset for about $200 + tax.

  • HT1430 my iphone 5 is not responding after the installation of ios7 ?

    MY IPHONE 5 IS NOT RESPONDING AFTER INSTALLING IOS7 TODAY. NOT EVEN
    ABLE TO POWER OFF.
    Is there anybody to help me?

    Perhaps if YOU STOP SHOUTING someone will help you.
    What have you done to troubleshoot thus far?  Have you taken the steps recommended in the User Guide (restart, reset, restore from backup, restore as new)

  • My iphone 4 is not working after resetting

    My iphone is not working after resettong, it just let me do emergency calls.
    and if i turn it on it saids to connect USB to itunes.

    If you reset to factory that is expected behavior.  You need to connect to iTunes to bring it into the Apple World.  You should then be able to connect to the network of your cell provider. 

  • HT201412 My iPhone will not respond even once it is hooked to iTunes nor will it respond when I hit the power (reset) button. The screen mentions that the system is checking for "borrowed blocks" (small writing in the top right corner).

    My iPhone will not respond even once it is hooked to iTunes nor will it respond when I hit the power (reset) button. The screen mentions that the system is checking for "borrowed blocks" (small writing in the top right corner).

    Are you using the charger and cable that came with the phone?
    Are you using an unauthorized third party charger?

  • IPhone 5s not working after voice over turned on

    iPhone 5s not working after voice over turned on

    Hello ss1997,
    Thanks for using Apple Support Communities.
    To troubleshoot this issue where your iPhone will not boot past the Apple logo please follow the steps in the article below.
    iOS: Not responding or does not turn on
    Take care,
    Alex H.

  • Is anyone having trouble with the "home" button not responding after upgrading to 5.1.1 OS?

    Is anyone having problems with the "home" button not responding after upgrading to 5.1.1?

    You will not belive how I accidently solved this - !!!
    Yes I had the problem immediately after the 5.1.1 'cloud' upgrade, the problems started (on my iphone 4) ... I followed the 'get power down button, then hold HOME for 30 secs' solution, but no result, nothing seemed to work and I was starting to get a bit agressive with the keep it pushed, multiple double click frustrations, icopybot multigesture solutions etc. and paid money ... but this comedy solution now works ...
    I discovered it because I ordered a waterproof case for my iphone for my motorcycle ... I've just fitted it to my iphone and all the problems have gone ??? what! ... so wondering why I looked at what the home button on the casing was doing - it was pressing ACROSS the home button i.e. it converted my finger point into a wider 'PRESS
    so taking the new case off, instead of using the point of my thumb to press HOME, I used the flat of my thumb to emulate it ....and initially nothing, so I wondered if it wa making better 'cross button' contacts, so I licked my thumb, wiped it and then tried again! - it worked!
    I can't explain it but it seems to work - try it! if the double click on HOME doesn't work lick your thumb dry it and try again! I've just done it again
    what a mad techno world we live in! :-)
    Dave

  • My iPhone will not respond to my touch.  Does anyone know what the problem might be or has anyone had this problem before?

    My iPhone will not respond to my touch.  Does anyone know what the problem might be or has anyone had this problem before?

    First thing to try is to reset your device. Press and hold the Home and Sleep buttons simultaneously until the Apple logo appears. Let go of the buttons and let the device restart. See if that fixes your problem.

  • When I try to open firefox it says that it is not responding, after I disabled the adobe flash plug-in it worked, how do I get it to work with flash

    Since I updated my adobe flash player firefox keeps saying that it is not responding after I open it and it loads my home page, I disabled add-ons and went throught the process of figuring out which one it was and it was adobe flash, but without flash I cant access a lot of different sites, how can I fix this. I have tried uninstalling and reinstalling both firefox and adobe flash, but neither works!

    See "Hang at exit":
    * http://kb.mozillazine.org/Firefox_hangs
    * [[Firefox hangs]]

  • I am using Iphone 4 (not 4s) After upgrading to ios 5.0.1. is blocking. I live in Venezuela

    I am using Iphone 4 (not 4s) After upgrading to ios 5.0.1. is blocking. I live in Venezuela

    Without more information, I have to say it sounds like the phone you have was not legitimately unlocked, but had been hacked. Updating iOS will re-lock it to the original carrier.
    ONLY the carrier it is locked to can authorize unlocking it.
    Where did you get the phone?

  • My  suddenly no longer works and dosn't show any sign and when i try to make restore for it iTunes shows me error 4005 and my iPhone does not respond to iTunes

    my  suddenly no longer works and dosn't show any sign and when i try to make restore for it, iTunes shows me error 4005 and my iPhone does not respond to iTunes

    OK, and when you searched for information on iPhone error 4005 what did you find?

Maybe you are looking for

  • Retrieve 4 inputs from one dialog box at a time

    I have a Jframe and when I click a button I want it to open a new Jdialog box. I want 4 different input fields. Two will be for strings, 1 int, 1 double. But I can't get it to open up a dialog with all of those things. Will I have to accept them all

  • How do I swap screens on the fly on a 8 core Mac Pro Westmere running OSX Snow Leopard?

    I'm running two displays a 23" Apple HD display and a 37" sharp LCD. I'm running various audio apps with multiple screens, two main screens (mixer and edit) I usually run the mixer window on the large display and the edit window on the 23"  however I

  • Going back to earlier screen (navigation) in ALV interactive screen

    Hi all, I have requirement of going to 4th alv screen on clicking back on screen 5.(all 5 screens are ALV).But it comes out to selection screen instea going to screen 4(ALV).Please guide me for the same. Thank you. Edited by: sanu debu on Mar 29, 200

  • Where can I find the price list?

    I would like to implement BeeHiv locally in our company, does anyone know where to find the price list and annual support fee? Thanks

  • DNG files have no OS 10.8.4 Finder thumbnails

    I can see thumbnails of the RW2 files imported from my Panasonic DMCG6 in the Mac OS10.8.4 Finder. However, when I convert the RW2s to DNGs after processing, there are no longer any thumbnails. I have installed the latest RAW updates from Apple. At t