IPhone 5 stuck in recovery mode loop, get error 9 when trying to update to ios 7 help me

so i have tried every way (except a different computer because that option is not available right now). i wanted to reset (factory reset erase all content) my iphone 5 because it was being really wierd. id be using an app all the sudden it would just turn off, try to restart itself, never get past apple logo screen, crash, attempt restart again etc. only when i would hold home and power button it would start up the right way. anyway i went into my iphones settings> general> reset> erase all content and settings. BIG MISTAKE!!!!!!!! ever since then it just have been stuck in recovery mode. the first time i tried to restore it. i got error 3914 i think. doing a little research i found i needed to update itunes so i did (11.1.5.5). then it said i needed to download iOS 7 so i did. and when i try to restore it, i get error 9. itunes is up to date. my windows is up to date. ive tried everything i can think of and im gettin to the point where im gona throe it at the wall
SOMEONE PLEASE HELPME

And you have done all include here?
http://support.apple.com/kb/TS3125

Similar Messages

  • Iphone 5 stuck in recovery mode.  Unknown error 9 when trying to upgrade to ios7.

    My phone is stuck in recovery mode. Says error number 9 when trying to dl ios7,

    I had the same problem. After itunes extracted the new firmware, the apple logo would come on on my phone and then itunes would give me the unknown error (9). I tried everything I could think of to get ios 7 to download onto my phone but it kept going in a loop. What finally worked for me was after the firmware finished extracting on itunes and the apple logo appeared on my phone, I pressed the home button a few times. After that ios 7 started to load onto my phone. I don't know if it will work all the time, but it worked for me. Hope this works for you.

  • My iPhone is stuck in recovery mode. Getting Error 37 from iTunes

    My iPhone4 is stuck in recovery mode. When I try to restore it through iTunes I get the message that it couldn't be restored. It's either Error 37 or Error -1

    Hi again,
    I tried that, changing the firewall settings, and I got the -1 Error message.
    This problem began a few months ago.
    My hard drive died on my laptop, and I got it replaced and reinstalled iTunes on it. At that time I had an iPhone3.
    From then on, all of my music had glitches, quiet patches, and some tracks which would not work.
    I took my phone back to my service provider, who replaced it with an iPhone 4.
    When I set that up, I had the same problems with the music. I could download an album on the iPhone, and it would be fine, but when I sync the phone with the laptop the album becomes glitchy again.
    Now it's stuck in recovery mode again.

  • Stuck between "Recovery Mode" and "an error occurred while trying to update

    My iPod touch is stuck in Recovery Mode (meaning it has become a $500 paper weight) and when I plug it into iTunes and try to restore and update it the message is something like "an error occurred while trying to update your iPod (14)". Everything was just fine until I downloaded software 2.2 and try to install it. I've tried disconnecting other USB devices and changing the USB port (as I read about this in other forums) but still no success. I've been trying since yesterday now, and I am beginning to get desperate. I'd appreciate any help. These updates seem to have become a "plug and pray" kind of thing...

    if if makes you feel any better, i received my ipod touch and two hours later it did the same exact thing. i've followed everything on the apple website and nothing works. it does make a great paperweight though.

  • Getting error 3194 when trying to update to iOS 5

    I am running iTunes 10.5 and am trying to update my iPhone 4 to iOS 5. The error im getting is 3194 which is defferent to everybodys 3200. Does anyone know why this may be or how I can overcome the error?
    Thanks in advance.
    Phil

    Phil,
    Same here, tried all the suggested steps in the 'more info' link but still gave the 3194.
    A quick search of iPhone 4 discussions suggested these steps (thanks MacMan TommyC)
    Do a HARD reset of the iPhone - holding the Lock/Power button and Home Buttons until the iPhone powers down and the Apple Logo reappears.
    Make sure that your Mac (I'm assuming) has all recent security and iTunes updates completed; Safari, too, made a diff here as well.
    Do a HARD reset on the computer as well.
    Launch ITunes FIRST then connect the IPhone to the USB again.
    Upon recognition, hopefully, ITunes will want to do the Update to iOS 5 for you, do its LOOOOONG back-up, and then install the update for you and then put everything back on.
    Also added the following to the host file, not sure if it actually helped but it was came up quite frequent on a Google search
    #74.208.10.249 gs.apple.com
    Hope the above helps

  • HT1414 My ipad has gone into recovery mode after an "error occured" whilst trying to update it. Will it come out of recovery on its own? There is a lot of data I want to save

    My ipad has gone into recovery mode after an "error occured" whilst trying to update it. Will it come out of recovery on it's own? There is a lot of data I want to save before restoring it to factory settings

    FORCE IPAD INTO RECOVERY MODE
    1. Turn off iPad
    2. Turn on computer and launch iTunes (make sure you have the latest version of iTune)
    3. Plug USB cable into computer's USB port
    4. Hold Home button down and plug the other end of cable into docking port.
    DO NOT RELEASE BUTTON until you see picture of iTunes and plug
    5. Release Home button.
    ON COMPUTER
    6. iTunes has detected iPad in recovery mode. You must restore this iPad before it can be used with iTunes.
    7. Select "Restore iPad"...
    Note:
    1. Data will be lost if you do not have backup
    2. You must follow step 1 to step 4 VERY CLOSELY.

  • TS3694 getting error 3004 when trying to update to ios7

    I keep getting error 3004 when trying to update to ios7

    I was trying to update my iphone 5 to IOS7 and couldnt do it for 5 times then I did the following and was able to update it right away
    Clearing your DNS cache may resolve the issue and enable you to connect to the iTunes Store.
    The easiest way to clear your DNS cache is to shut down your computer completely and then restart. If you can't shut down, you can clear your DNS cache manually.
    Click Start and choose Run.
    In the dialog that appears, type “cmd” (don’t type the quotes) and click OK.
    After the DOS prompt (C:\), type “ipconfig /flushdns” (without the quotes) and press Enter. Make sure you enter a single blank space after “ipconfig.”
    Let me know if it solved the issue for you

  • I keep getting Error 17 when trying to update to 7.0.4 iPad Air

    I keep getting Error 17 when trying to update to 7.0.4 and the Ipad stays in USB Mode

    iPad: Basic troubleshooting
    http://support.apple.com/kb/TS3274
    Update and restore alert messages on iPhone, iPad, and iPod touch
    http://www.buybuyla.com/tech/view/012953a0d412000e.shtml
    iOS: Resolving update and restore alert messages
    http://support.apple.com/kb/TS1275
    iPad: Unable to update or restore
    http://support.apple.com/kb/ht4097
    iTunes: Specific update-and-restore error messages and advanced troubleshooting
    http://support.apple.com/kb/TS3694
     Cheers, Tom
    Check for hardware issues
    Try to restore your iOS device two more times while connected with a cable, computer, and network you know are good. Also, confirm your security software and settings are allowing communication between your device and update servers. If you still see the alert when you update or restore, contact Apple support.
    Common errors: 1, 10-47, 1002, 1011, 1012, 1014, 1000-1020.
    Message was edited by: Texas Mac Man

  • Keep getting error 4002 when trying to update Genius

    I haven't seen anyone write about getting error 4002 when trying to update genius in itunes. I select update genius and it gathers information and sends it to the itunes store I assume. And then waits a few seconds and then I get the following message "Genius results can't be updated right now. An unknown error occurred (4002) Please try again later." I've been getting this message for well over a month and I keep hoping they'll be an update or somehow it will magically be fixed, but nothing has changed. Anyone have any insight on this one?
    The current ituned library it 123GB and is stored on external drives. It should also be noted that when I first turned on genius when it was released it went through this whole problem without a hitch. I just can't update Genius with any of the music I've added since then. I can't even get genius to recognize music that I got from the itunes store since I've had the problem.

    Be careful - this was a disaster for me. Once I did this, I got a different error - an error 4010 and in trying to recover, caused a lot of library issues that forced me to go to a backup to fix. You'll find a lot of people having the 4010 problem. Basically iTunes Genius is a disaster and Apple isn't fixing it.

  • Why do i get error 43 when trying to update iphone3

    why do i keep getting error 43 when trying to update iphone3? very frustrating please help!

    If you back up your device manually before syncing, you can restore it from that backup again. A manual backup does not include the sync process.
    To backup manually do this:
    Connect your iPod to your computer and right click on it in the device list and choose backup. iTunes will backup your iPod without syncing.
    Transfer your purchases the same way, choosing "transfer purchases" this time.
    When you connect your iPod let iTunes erase all media content and  restore your settings and app data from your manual backup afterwards.

  • HT201210 keep getting error 3194 when trying to update ,what is this

    keep getting error 3194 when trying to update,what is this

    error code 3194 http://support.apple.com/kb/TS3694  Do you have the lastest version of iTunes? if not update.

  • My iphone 4 stuck into recovery mode and giving error -1

    my iphone 4 stuck into recovery mode. i am not able to restore it . its giving me error -1. in previous months my iphone start loosing network & showing no service . And now when i tried to resore it is showing me this error. Please suggest me some solution . it is a factory unlocked phone from unites states but now out of warrenty.

    Error 1 or -1 indicates a serious hardware issue.
    Take the device to Apple for evaluation and replacement.

  • Has anyone else gotten the error message when trying to update to ios 6 either through iphone or itunes?

    Has anyone else gotten an error message whne trying to update to ios 6 through iphone for itunes?

    Uninstall iTunes, and go to http://support.apple.com/kb/DL1577 and get the 64 bit version.

  • Iphone 4 stuck in recovery mode loop (non-jailbroken)

    This is frustrating me to no end!! I tried to update my iphone 4 to IOS6 via itunes, didn't work because my mac needed at least itunes 6.3.1 but it said everything was up to date. So i tried using a newer mac with an updated itunes, failed after about an hour, & got stuck in the recovery mode loop. Everytime i try to connect to itunes & restore my phone to update, a message pops up saying "could not be restored. this device isn't eligible for the requested build". I've been watching youtube videos for about this for an hour now, nothing. I'm about to go insane, so if anyone has any idea of how i can get out of the loop, that'd be great!!

    Apple doesn't fix phones they replace them.
    The iPhone warranty is NOT international.  You need to return the phone to the country in which it originated (the EU is considered ONE country for warranty purposes)

  • Iphone 3G stuck in recovery mode loop

    okay...i'm sure there a lot of topics on this, but i can't find anything is fixing the issue. i traded my 32gb ipod for a 16gb iphone 3G. i traded it mainly because i wanted to unlock it to t-mobile. i wanted to updated it to ios4 so i wouldn't have to keep unlocking it after each iphone/ipod update. so i updated it, and it went into recovery mode. i tried putting it into dfu mode, and it's stuck in recovery mode. i've tried restoring it and it just loops back into recovery mode. i've tried the whole "hold down the both buttons and release the sleep button but hold the home button until this happens" thing. i'm starting to get really frustrated. i tried uninstalling itunes and reinstalling itunes and the same thing happens. NOW.... i'm getting an error that says that itunes cannot recognize this iphone because of an unknown error. do i need to downgrade os? how do i do that? i just need to be able to get it out of recovery mode so i can unlock it. any suggestions would be greatly appreciated! thanks in advance!

    I had the same issue. After updating to the new OS4, my iphone failed on a restore. It was stuck in recovery mode. You have to hold down the home key for 7-10 secs, connect to PC(if that's what you are using) and plug into iTunes. Keep holding the button down until iTunes recognizes the phone. You will be given an option to restore to old or update and restore as a new phone. I did the update and restore as my old backup file was corrupted somehow. Unfortunately, I lost everything since my last sync. Still trying to figure out how to extract contact and pic data from an old backup i had saved on a thumbdrive. Good luck!

Maybe you are looking for

  • XSLT for ORU Messages

    My Input XML is like below: <ORU> <OBR></OBR> <OBX></OBX> <OBX></OBX> <OBX></OBX> <OBR></OBR> <OBX></OBX> <OBX></OBX> <OBX></OBX> <OBR></OBR> <OBX></OBX> <OBX></OBX> <OBX></OBX> </ORU> Means, <OBR> is a parent & each has 3<OBX> child records. I have

  • Apple TV, Airplay, and Pandora

    I have and Apple TV and an iPad.  I receive Pandora radio on an iPad app.  In the settings on the Apple TV I have turned Airplay on and I have created a password for Airplay.    What do I do to stream the Pandora from the iPad to the Apple TV?  Where

  • How to run dos command on java

    would java run the dos command ? if yes ~would you mind give me some example~please~

  • Return Delivery Form

    Any one tell me the standard Return Delivery form name( smart forms or sap script ) anything? thanks in advance JK

  • How to open the OWB Design Center in Linux

    Hi All, Currently, our OWB10.2. is installed in the Window2003 server, I could login the servers and go to Program -> OWB -> Design Center to open the Design center and create my own project or mapping. We just install OWB 10.2.0.4 in a Linux Ret Hat